环境监测市场化管理工作思考

阐述了我国及其他国家环境监测市场管理的经验,以及我国在推进环境监测市场化管理方面的探索;指出了目前环境监测市场化管理中存在的问题,提出,应加快建立适合国情的监测总体格局;建立完善环境监测社会化监管制度体系;充分发挥行业协会在监管中的作用;强化对社会监测机构监管力度;提高社会环境监测机构能力。     

污泥淤砂分离器再分离底流污泥

研究了污泥淤砂分离器对分离原污泥所得的底流污泥进行再分离时,分离分流污泥的性质。实验结果表明,原污泥MLVSS/MLSS为0.372,1次分离后得到的底流污泥MLVSS/MLSS为0.222,2次分离后得到的底流污泥MLVSS/MLSS为0.126,表明通过底流污泥再分离,能够进一步降低底流污泥中生物有机质的含量,提高底流污泥中无机淤砂的含量。同时,原污泥CST为2.85(s·L)/g SS,1次分离后得到的底流污泥CST为0.98(s·L)/g SS,2次分离后得到的底流污泥CST为0.12(s·L)/g SS,表明底流污泥再分离进一步提高了底流污泥的脱水性能,最终得到的底流污泥脱水性能良好。     

不同酶强化污泥为燃料微生物燃料电池特性对比分析

采用单室无膜悬浮阴极微生物燃料电池(MFC),对比分析了蛋白酶和淀粉酶强化剩余污泥为燃料的MFC(ESMFC)产电特性、酶特性和污泥减量化效果。研究表明,投加蛋白酶的ESMFC最大功率密度比对照组增加106.2%,投加淀粉酶时ESMFC最大功率密度比对照组增加48%。蛋白酶作用主要体现在投加后的前12小时,而淀粉酶作用时间则较长,为投加后的前144小时,但在运行前期,由于高温作用,导致系统内的酶活性较强,投加的淀粉酶作用则不明显。投加蛋白酶的系统内TCOD、TSS和VSS去除率分别为82%、65%和85%,而投加淀粉酶的系统内TCOD、TSS和VSS去除率分别达到86%、67%和88%。此研究对于ESMFC中外加酶的选择具有一定意义。     

Characterization of the extracellular biodemulsifiers secreted by Bacillus cereus LH-6 and the enhancement of demulsifying efficiency by optimizing the cultivation conditions

A highly efficient demulsifying strain, LH-6, was isolated from petroleum-contaminated soil and identified as Bacillus cereus by 16S rDNA gene analysis. It achieved 95.61 and 95.40 % demulsifying ratios within 12 h for water-in-oil (W/O) and oil-in-water (O/W) model emulsions, respectively. Fourier transform infrared spectroscopy (FT-IR) and thin-layer chromatography (TLC) detections indicated that the LH-6’s extracellular biodemulsifiers were different types of lipopeptides for the W/O and O/W emulsions. Optimization of the culture medium composition was conducted to improve the biosynthesis and demulsifying efficiency of the biodemulsifier. The optimal carbon source was liquid paraffin, while waste frying oil could also be an alternative carbon source. The optimal nitrogen sources were ammonium sulfate and yeast extract. To further enhance the biodemulsifier efficiency, the optimal cultivation conditions were determined using response surface methodology (RSM) based on central composite rotation design (CCRD). Using the optimized cultivation conditions, the demulsifying ratios increased to 98.23 and 97.65 % for the W/O and O/W model emulsions, respectively.     

Degradation of aqueous Rhodamine B by plasma generated along the water surface and its enhancement using nanocrystalline Fe-, Mn-, and Ce-doped TiO2 films

The degradation of aqueous Rhodamine B (RhB) was examined using a dual-channel spark switch module designed to regulate the steepness of pulsed high voltage with microsecond rise time. Depending on the energy per pulse, a spark along the water surface (SPWS) or streamer along the water surface (STWS) was formed. STWS was found to have a better degradation effect and energy efficiency toward RhB than SPWS at the same power; however, addition of H₂O₂ amounts resulted in increased degradation, the effect being more pronounced using SPWS. The initial concentration of RhB also appeared to influence the rate constant of the degradation reaction. Furthermore, TiO₂ films doped with Fe, Mn, and Ce were found to enhance the degradation performance of plasma. A possible reaction mechanism of plasma formation along the water surface was concluded by determination of the main inorganic products in the liquid and gas phases.     

电催化氧化处理除草剂异噁草酮废水的效能

为有效处理含异噁草酮除草剂废水,以Sb掺杂Ti／SnO2电极为阳极,不锈钢板为阴极,采用电催化氧化技术对异噁草酮废水进行降解,研究了不同影响因素对异噁草酮去除率的影响,并分析了异噁草酮的降解效果。结果表明,当异噁草酮初始浓度为100mg／L、电流密度为20mA／cm2、电解质投加量为0．10mol／L,反应120min后,异噁草酮去除率达到94％,此时TOC去除率为57．9％,能耗为25kWh／m2,且废水的可生化性能显著提高。     

Ni2 +对活性污泥活性及群落多样性的影响简

通过检测活性污泥的电子传递体系活性以及生物多样性,研究Ni²⁺对活性污泥微生物活性及群落多样性的影响。结果表明：与对照系统相比,5 mg/L的Ni²⁺对2,3,5-triphenylteltrazolium chloride（TTC-ETS）活性未产生显著的影响;但当Ni²⁺的浓度进一步增大到10、20和40 mg/L后,其对序批式反应器内活性污泥TTC-ETS活性的抑制率分别达到（36.79±11.14）%、（55.88±13.90）%和（70.97±6.78）%。低浓度Ni²⁺能增强活性污泥微生物对碳源的利用,但高于10 mg/L的Ni²⁺则显著抑制了活性污泥微生物对碳源的利用。各个SBR系统中微生物群落最常见的物种相近,物种丰富度和均一性则均有所不同,其中群落物种丰富度随着Ni²⁺浓度的增加而逐渐减小。TTC-ETS活性、平均每孔颜色变化率、Shannon指数和Simpson指数,与Ni²⁺的胁迫浓度之间的显著相关性表明,它们均可有效地表征Ni²⁺胁迫对活性污泥微生物活性及群落多样性的影响程度。     

Effect of temperature and particle size on the thermal desorption of PCBs from contaminated soil

Thermal desorption is widely used for remediation of soil contaminated with volatiles, such as solvents and distillates. In this study, a soil contaminated with semivolatile polychlorinated biphenyls (PCBs) was sampled at an interim storage point for waste PCB transformers and heated to temperatures from 300 to 600 °C in a flow of nitrogen to investigate the effect of temperature and particle size on thermal desorption. Two size fractions were tested: coarse soil of 420–841 μm and fine soil with particles <250 μm. A PCB removal efficiency of 98.0 % was attained after 1 h of thermal treatment at 600 °C. The residual amount of PCBs in this soil decreased with rising thermal treatment temperature while the amount transferred to the gas phase increased up to 550 °C; at 600 °C, destruction of PCBs became more obvious. At low temperature, the thermally treated soil still had a similar PCB homologue distribution as raw soil, indicating thermal desorption as a main mechanism in removal. Dechlorination and decomposition increasingly occurred at high temperature, since shifts in average chlorination level were observed, from 3.34 in the raw soil to 2.75 in soil treated at 600 °C. Fine soil particles showed higher removal efficiency and destruction efficiency than coarse particles, suggesting that desorption from coarse particles is influenced by mass transfer.     

Probing the distribution and contamination levels of 10 trace metal/metalloids in soils near a Pb/Zn smelter in Middle China

The horizontal and vertical distribution patterns and contamination status of ten trace metal/metalloids (Ag, Bi, Co, Cr, Ge, In, Ni, Sb, Sn, Tl) in soils around one of the largest Chinese Pb–Zn smelter in Zhuzhou City, Central China, were revealed. Different soil samples were collected from 11 areas, including ten agricultural areas and one city park area, with a total of 83 surface soil samples and six soil cores obtained. Trace metal/metalloids were determined by inductively coupled plasma–mass spectrometry after digestion by an acid mixture of HF and HNO₃. The results showed that Ag, Bi, In, Sb, Sn, and Tl contents decreased both with the distance to the Pb–Zn smelter as well as the soil depth, hinting that these elements were mainly originated from the Pb–Zn smelting operations and were introduced into soils through atmospheric deposition. Soil Ge was influenced by the smelter at a less extent, while the distributions of Co, Cr, and Ni were roughly even among most sampling sites and soil depths, suggesting that they were primarily derived from natural sources. The contamination status, as revealed by the geo-accumulation index (I _geo), indicated that In and Ag were the most enriched elements, followed by Sb, Bi, and Sn. In general, Cr, Tl, Co, Ni, and Ge were of an uncontaminated status.     

水泥窑共处置过程中水泥生料对砷的吸附/冷凝特性

针对水泥生料开展了氮吸附与SEM测试分析,研究了水泥生料的比表面积,孔径结构和微观表面积。同时,利用管式回转炉和控温立式炉联用装置研究了砷元素在水泥生料上的吸附冷凝特性。结果表明,水泥生料的比表面积很小,微观表面结构致密无孔,砷元素主要是冷凝在生料表面上。进入吸附冷凝炉的重金属可以分为3部分,第1部分冷凝在管壁上,占80%左右;第2部分吸附/冷凝在生料上,占10%左右;第3部分随烟气释放到空气中,不到10%。水泥生料对砷的吸附冷凝量随时间的增加而增加,随温度的升高而降低。水泥生料对砷的吸附冷凝特性可用双常数速率方程拟合,拟合效果较好,计算得表观活化能在6~7 kJ/mol之间。此外,砷的初始浓度对水泥生料的吸附冷凝特性影响很小。