铁炭微电解法降解TAIC废水

TAIC（三烯丙基异氰脲酸酯）作为过氧化物交联或自由基反应交联的助交联剂被广泛应用。由于TAIC性质稳定难于生物降解,采用铁炭微电解法处理TAIC生产废水,并考察了铁炭比、进水pH值、反应时间对处理效果的影响,以及TAIC降解机理和反应动力学过程。结果表明,影响微电解工艺的因素主次关系为：pH>Fe/C质量比>反应时间;在最佳条件进水pH值为5,铁炭质量比为2：1,反应时间为135 min时,COD的去除率达到46%以上,TAIC的去除率达到48%以上。TAIC去除机理研究表明,微电解对TAIC废水的作用主要通过·H的还原和铁离子的絮凝作用,其中·H的还原作用是TAIC降解的主要原因。反应动力学分析表明,铁炭微电解法处理TAIC的降解过程基本符合二级反应动力学规律,通过建立模型并拟合出了TAIC降解的二级反应动力学方程。     

水泥窑协同处置过程中Pb、Cd的挥发特性

对铅、镉2种重金属的氧化物开展了热重实验、熟料煅烧以及熟料消解实验,以重金属的挥发率为主要指标,研究了水泥窑协同处置过程中铅、镉在等温条件下随时间的挥发特性。结果表明,2种重金属的挥发率均是随温度的升高,时间的增加而增大。Pb的挥发率为96%,Cd的挥发率达到98%,根据等温动力学及阿累尼乌斯方程,对Pb,Cd的挥发率随时间变化的规律进行动力学模拟,得到较好的线性拟合效果,其中,Pb挥发反应的表观活化能E为88.73 kJ/mol,Cd挥发反应可以分2个部分：1 200℃以下的表观活化能E为61 kJ/mol;1 250℃以上的表观活化能E为184.6 kJ/mol。     

Presence of bacteria in aqueous solution influences virus adsorption on nanoparticles

Virus contamination in wastewater is usually accompanied by the existence of various bacteria. Nanoparticles (NPs) have been shown to efficiently remove virus. In this study, bacterial cells, supernatants, and cultures were harvested separately from three strains at the culture ages of 6 and 24 h, corresponding to the log and stationary phases, respectively. The aim is to investigate how their presence affects virus adsorption on the three Fe and Al oxide NPs (α-Fe₂O₃, γ-Fe₂O₃-B, and Al₂O₃) and how these effects change with bacterial growth phase. Bacteriophage phiX174 was used as a virus model. Results showed that bacterial cells, supernatants, and cultures harvested at 6 h generally reduced virus adsorption by an average of 0.75?±?0.84, 7.7?±?9.0, and 10.3?±?8.6 %, respectively, while those harvested at 24 h reduced virus adsorption by an average of 2.1?±?0.93, 21.5?±?6.6, and 24.6?±?6.9 %, respectively. Among the NPs, α-Fe₂O₃ showed more sensitivity to bacteria than the other two, probably because of its relatively higher value of point of zero charge. It was found that cell-induced and supernatant-induced reductions were combined to achieve added results, in which the supernatants contributed much more than the cells, implying that the bacterial exudates might be more crucial in the reduced virus adsorption than the bacterial cells. These results strongly demonstrated that the bacteria-induced reduction in virus adsorption became more significant with culture age. It is suggested that studies conducted in the absence of bacteria may not accurately evaluate the potential of virus removal efficiency of the NPs in bacteria-containing environments.     

A/O+MBR工艺处理玉米深加工废水的中试研究

实验基于企业污水站的改造工程,研究了MBR对玉米深加工废水的处理效果并对工艺运行参数优化提出建议.结果表明,该工艺对COD的去除率可以达到90％以上,出水稳定在26 mg/L左右;出水NH4-N达到1 mg/L以下;TN去除率达到70％以上,出水TN达到10 mg/L以下,出水完全达到排放标准.通过4种工况的比较,说明在污泥浓度8 g/L左右,曝气池内DO在3 mg/L左右,MBR内DO＞4 mg/L,好氧段停留时间13.5 h,并保证3h以上的缺氧段水力停留段时间的条件下,A/O+ MBR工艺可以有效去除玉米深加工废水中的污染物.     

冲击负荷对厌氧序批式反应器的影响及其恢复重建过程

研究了在厌氧条件下以葡萄糖为基质的厌氧序批式反应器(ASBR)中冲击负荷对基质吸收和储存的影响及其恢复重建过程.结果表明,正常状态下,反应器在进水COD为5 000.0 mg/L,出水COD为188.6 mg/L,当进水负荷提高至正常状态2倍后,反应器中COD大量累积,其中51.13％为挥发性有机酸(VFA),48.87％则被转化为糖原储存在细胞体内,出水COD最高为2 368.9 mg/L,污泥糖原储存量最高为273.55 mg/g(以挥发性固体计),是正常状态的4.2倍.在冲击负荷条件下,反应器的产甲烷能力恢复较快,胞内糖原储存恢复较慢,出水COD和胞内糖原分别经过20、41 d后恢复冲击负荷前水平.     

诱导结晶工艺中诱品载体的选择与改性

以含铜废水为处理对象,重点考察了诱晶载体的表面性质及表面负荷对诱导结晶过程的影响。结果表明,在工艺启动初期,白云石以及碱式碳酸铜为诱晶载体时,铜的去除率在90％以上,石英砂对铜的去除率较低,但石英砂经表面改性后对铜的去除效率亦可达90％以上。在运行稳定后,几类诱导载体对铜的去除率皆能稳定在95％,说明诱晶载体的表面性质对诱导结晶工艺的影响主要在于反应启动初期,选择与目标结晶产物结构、成分相同或相似的诱晶载体有利于诱导结晶过程的进行。此外,研究结果还表明,诱晶载体表面负荷对结晶过程影响较大,诱导结晶除铜工艺中载体表面负荷不宜高于0．054gCu／（m2·d）。     

Quantitative evaluation of environmental risks of flotation tailings from hydrothermal sulfidation–flotation process

Floatation tailings (FT) are the main by-products of the hydrothermal sulfidation–flotation process. FT (FT₁ and FT₂) were obtained by treating two different neutralization sludges (NS) (NS₁ and NS₂). This paper quantitatively evaluated the environmental risks of heavy metals (Zn, Cd, Cu, Pb, and As) in FT versus NS. The total concentration and leaching rates (R ₂) of heavy metals in FT were much lower than those in NS, demonstrating that the hydrothermal sulfidation–flotation process was able to effectively suppress the mobility and leachability of heavy metals. The BCR-three sequence leaching procedure of FT confirmed that all metals were transformed into more stable forms (residue and oxidizable forms) than were found that in NS. The potential ecological risk index indicated that the overall risks caused by heavy metals decreased significantly from 6627.59 and 7229.67 (very serious risk) in NS₁ and NS₂, respectively, to 80.26 and 76.27 (low risk) in FT₁ and FT₂, respectively. According to the risk assessment code, none of the heavy metals in FT posed significant risk to the natural environment except Zn (with low risk). In general, the risk of heavy metals in FT had been well controlled.     

Arsenic stabilization by zero-valent iron,bauxite residue,and zeolite at a contaminated site planting Panax notoginseng

Panax notoginseng (Burk.) F.H. Chen, a rare traditional Chinese medicinal herb, is a widely used phytomedicine used all over the world. In recent years, the arsenic contamination of the herb and its relative products becomes a serious problem due to elevated soil As concentration. This study aimed to evaluate the effects of different types and dosages of amendments on As stabilization in soil and its uptake by P. notoginseng. Results showed that comparing to control treatment, the As concentrations of P. notoginseng declined by 49–63%, 43–61% and 52–66% in 0.25% zero-valent iron (Fe(0)), 0.5% bauxite residue, and 1% zeolite treatment, respectively; whereas the biomasses were elevated by 62–116%, 45–152% and 114–265%, respectively. The As(III) proportions of P. notoginseng increased by 8%, 9%, and 8%, and the transfer factors of As from root to shoot increased by 37%, 42% and 84% in the optimal treatments of Fe(0), bauxite residue, and zeolite. For soil As, all the three amendments could transform the non-specifically adsorbed As fraction to hydrous oxides Fe/Al fractions (by Fe(0) and red mud) or specifically adsorbed As fraction (by zeolite), therefore reduced the bioavailability of soil As. With a comprehensive consideration of stabilization efficiency, plant growth, environmental influence, and cost, Fe(0) appeared to be the best amendment, and zeolite could also be a good choice. In conclusion, this study was of significance in developing As contamination control in P. notoginseng planting areas, and even other areas for medicinal herb growing.     

活性炭纤维负载TiO2催化剂的制备及其电催化性能

采用溶胶-凝胶法制备了活性炭纤维负载TiO₂催化剂（TiO₂/ACF）,并通过SEM和XRD等手段对TiO₂/ACF进行了表征。以邻苯二甲酸二甲酯（DMP）为目标降解物,考察了催化材料的电催化活性。实验结果表明：在反应温度为25 ℃、初始DMP质量浓度为100.0 mg/L、电解质Na₂SO₄质量浓度为100 mg/L、电流密度为62.5 mA/cm²、电极板间距为4 cm的条件下,经过40 min的降解,DMP质量浓度为1.8 mg/L,DMP去除率为98.2%;TiO₂/ACF在反应过程中可以原位再生,经6次重复使用后仍保持很高的催化活性,对DMP的去除率仍达90%以上。