Air Pollution in Singapore: Its Multielemental Aspect as Measured by Nuclear Analytical Techniques

Aerosol samples were collected in 1994 in Singapore on two occasions: once in June during the normal meteorological conditions and later in October during a long haze period caused by the heavy forest fire in Indonesia. Filtration and impaction collection methods were used simultaneously so that detailed elemental analysis of bulk as well as of different size fractions could be performed. Accelerator based nuclear analytical techniques such as Particle Induced X-Ray Emission (PIXE), Rutherford Backscattering (RBS) and Nuclear Microscopy (NM) were used for analysis. These techniques are fast, truly multielemental and perfectly suited for routine analysis of a large number of aerosol samples. Typically all samples were analysed for the following 24 elements: Na, Mg, Al, Si, P, S, Cl, K, Ca, Ti, V, Mn, Cr, Fe, Co, Ni, Cu, Zn, Ga, As, Br, Rb, Sr and Pb. Detection limits for bulk analysis were generally below ng/m3 and for single particle analysis absolute detectable mass was approximately 10-17 g. Additionally, trace elements such as Cd, Sn, Sb and Ba whose characteristic X-ray lines were normally "obscured" by the lines of other more abundant elements, were detected when analysing by nuclear microscope in single particle mode.Judging by the average concentrations of lead and sulphur which are good indicators of industrial component of air pollution the situation in Singapore is satisfactory. Pb was typically found in concentrations of 5 to 50 ng/m3 and sulphur in concentrations of 1 to 2 µg/m3. These concentrations are well below limits set by the World Health Organisation (1500 ng/m3 and 40 µg/m3, respectively). On the other hand during the haze period the average concentrations of elements like S, K, Ti, V, Mn, Ni, As and Pb were found to be 3 to 6 times higher than usual. Results are presented and discussed.     

Recycling of petroleum-contaminated sand

The environmental impact of using petroleum-contaminated sand (PCS) as a substitute in asphalt paving mixtures was examined. An appreciable component of PCS is oily sludge, which is found as the dregs in oil storage tanks and is also produced as a result of oil spills on clean sand. The current method for the disposal of oily sludge is land farming. However, this method has not been successful as an oil content of < 1% w/w is required, and difficulty was encountered in reaching this target. The reuse of the sludge in asphalt paving mixtures was therefore considered as an alternative. Standard tests and environmental studies were conducted to establish the integrity of the materials containing the recycled sludge. These included physical and chemical characterization of the sludge itself, and an assessment of the mechanical properties of materials containing 0%, 5%, 22% and 50% oily sludge. The blended mixtures were subjected to special tests, such as Marshall testing and the determination of stability and flow properties. The experimental results indicated that mixtures containing up to 22% oily sludge could meet the necessary criteria for a specific asphalt concrete wearing course or bituminous base course. To maximize the assay from the recycled material, the environmental assessment was restricted to the 50% oily sludge mixture. Leachates associated with this particular mixture were assayed for total organic residue and certain hazardous metal contaminants. The results revealed that the organics were negligible, and the concentrations of the metals were not significant. Thus, no adverse environmental impact should be anticipated from the use of the recycled product. Our research showed that the disposal of oily sludge in asphalt paving mixtures could possibly yield considerable savings per tonne of asphalt concrete, and concurrently minimize any direct impact on the environment.     

Concentration and Distribution of Persistent Organic Pollutants (POPs) in Harbour Dredging Sediments: A Pilot Study Using a Statistical Approach for a More Efficient Characterisation and Management

The Italian guidelines concerning the dumping of dredgingmaterials implies chemical, physical and microbiologicalcharacterisation of dumping sediments collected through aspecific sampling strategy.POP's such as PCB's and organochlorine pesticides, areconsidered as priority pollutants in all the InternationalConventions for the protection of the marine environment, inconsequence of their persistence, toxicity and bioaccumulation capacity.In the present article the concentrations and distribution ofPCB's and organochlorine pesticides in dredging sediments ofPiombino harbour (northern Thyrrenian sea) were investigates.The results showed high POP's concentrations in all the studiedareas. The maximum values were: 3.94 mg kg^-1 dry weight for PCB's(IUPAC Nos. 28; 52; 101, 118; 137; 153; 180; 209); 2.04 mg kg^-1 d.w.for HCH's (-, -, - and -hexachlorocyclohexane isomers); 0.28 mg kg^-1 d.w. for DD's (DDT + DDE + DDD).Subsequently, the data related to each pollutant were treatedwith statistical tests, in order to verify how well the samplingstrategy is able to represent the distribution of contaminantsin the dredging area. Finally, management strategies werederived for the studied dredging sediments.     

Cumulative impact assessment in environmental planning: A coastal wetland watershed example

Several theoretical, analytical, and institutional difficulties have impeded the development and application of the assessment of cumulative environmental impacts. Watershed development on coastal wetlands offers an ideal context for evaluating the land disturbance target approach to cumulative impact assessment. A model land use planning system involving a time series approach was developed for Elkhorn Slough in California. The approach included four major components: evaluation of erosion susceptibility, measurement of land disturbance, establishment of a land disturbance target, and a comparison of existing and target land disturbance values. Further research is needed to test the transferability of the approach in a wide range of coastal watersheds and to verify the applicability of the methods to other cumulative impact problems.     

Scenario Analysis for the San Pedro River, Analyzing Hydrological Consequences of a Future Environment

Studies of future management and policy options based on different assumptions provide a mechanism to examine possible outcomes and especially their likely benefits and consequences. The San Pedro River in Arizona and Sonora, Mexico is an area that has undergone rapid changes in land use and cover, and subsequently is facing keen environmental crises related to water resources. It is the location of a number of studies that have dealt with change analysis, watershed condition, and most recently, alternative futures analysis. The previous work has dealt primarily with resources of habitat, visual quality, and groundwater related to urban development patterns and preferences. In the present study, previously defined future scenarios, in the form of land-use/land-cover grids, were examined relative to their impact on surface-water conditions (e.g., surface runoff and sediment yield). These hydrological outputs were estimated for the baseline year of 2000 and predicted twenty years in the future as a demonstration of how new geographic information system-based hydrologic modeling tools can be used to evaluate the spatial impacts of urban growth patterns on surface-water hydrology.     

Plant Phenology in Western Canada: Trends and Links to the View From Space

One feature of climate change is the trends to earlier spring onset in many north temperate areas of the world. The timing of spring flowering and leafing of perennial plants is largely controlled by temperature accumulation; both temperature and phenological records illustrate changes in recent decades. Phenology studies date back over a century, with extensive databases existing for western Canada. Earlier spring flowering has been noted for many woody plants, with larger trends seen for species that develop at spring's start. Implications for ecosystems of trends to earlier spring arrival include changes in plant species composition, changes in timing and distribution of pests and disease, and potentially disrupted ecological interactions. While Alberta has extensive phenology databases (for species, years, and geographic coverage) for recent decades, these data cannot provide continuous ground coverage. There is great potential for phenological data to provide ground validation for satellite imagery interpretation, especially as new remote sensors are becoming available. Phenological networks are experiencing a resurgence of interest in Canada (www.plantwatch.ca) and globally, and linking these ground-based observations with the view from space will greatly enhance our capacity to track the biotic response to climate changes.     

Mercury and trace elements in cloud water and precipitation collected on Mt. Mansfield,Vermont

The lack of high quality measurements of Hg and trace elements in cloud and fog water led to the design of a new collector for clean sequential sampling of cloud and fog water. Cloud water was collected during nine non-precipitating cloud events on Mt. Mansfield, VT in the northeastern USA between August 1 and October 31, 1998. Sequential samples were collected during six of these events. Mercury cloud water concentrations ranged from 7.5 to 71.8 ng l(-1), with a mean of 24.8 ng l(-1). Liquid water content explained about 60% of the variability in Hg cloud concentrations. Highest Hg cloud water concentrations were found to be associated with transport from the Mid-Atlantic and Ohio River Valley, and lowest concentrations with transport from the north of Mt. Mansfield out of Canada. Twenty-nine event precipitation samples were collected during the ten-week cloud sampling period near the base of Mt. Mansfield as part of a long-term deposition study. The Hg concentrations of cloud water were similar to, but higher on average (median of 12.5 ng l(-1)) than Hg precipitation concentrations (median of 10.5 ng l(-1)). Cloud and precipitation samples were analyzed for fifteen trace elements including Mg, Cu, Zn, As, Cd and Pb by ICP-MS. Mean concentrations were higher in cloud water than precipitation for elements with predominately anthropogenic, but not crustal origin in samples from the same source region. One possible explanation is greater in-cloud scavenging of crustal elements in precipitating than non-precipitating clouds, and greater below-cloud scavenging of crustal than anthropogenic aerosols.     

Suspended particulates and bioaerosols emitted from an agricultural non-point source

Suspended particulate and bioaerosol levels were measured at three sites downwind of an agricultural non-point source during the wheat harvesting season. Suspended particulates were detected at mean values ranging from 10000 to 2420 micrograms m-3 at distances of from 20 to 60 m downwind of the source, respectively. Airborne viable bacterial counts were recorded at mean values ranging between 10(4) and 10(6) colony forming units (cfu) m-3, whereas, Gram negative (Gram -ve) bacteria varied between 10(3) and 10(5) cfu m-3. Fungi levels were detected at mean values varying between 10(5) and 10(6) cfu m-3. However, streptomycetes were found at lower counts than those recorded for viable bacteria and fungi. Total viable bacteria, Gram -ve bacteria, fungi and streptomycetes associated hay fragments were determined at mean values of 1.5 x 10(6), 1.6 x 10(3), 2.2 x 10(4) and 6 x 10(3) cfu g-1 of hay, respectively. Cladosporium, white and red yeasts as well as Alternaria were the predominant airborne fungi, whereas, Alternaria was the dominant species associated with hay fragments. Pseudomonas, Acinetobacter and Enterobacteriaceae were the dominant Gram -ve bacteria. The most common fungal genera, such as Cladosporium and Fusarium (minor short axis), as well as Streptomyces species have an aerodynamic diameter (dae) of less than 5 microns, which can penetrate and deposit in the alveoli. Farmers and nearby residents are exposed to high levels of organic dust and bioaerosols during the wheat harvesting season. This may cause health problems in exposed persons based on toxic or allergic reactions.     

Optimal and suboptimal control of anaerobic digesters

Anaerobic digester failure due to entry of inhibitors or sudden changes in the feed substrate concentration may be encompassed beneficially by applying optimal control theory. An almost proportional relationship between the dilution rate and the methane production rate leads to a simple suboptimal control law with only minor loss in performance, after the occurrence of the above mentioned events.     

Control of rumen methanogenesis

During the last decades, considerable research on methane production in the rumen and its inhibition has been carried out. Initially, as methane production represents a significant loss of gross energy in the feed (2–15%), the ultimate goal of such intervention in rumen fermentation was an increase in feed efficiency. A second reason favouring research on methane inhibition is its role in the global warming phenomenon and in the destruction of the ozone layer. In this review, the authors describe briefly several interventions for reducing methane emission by ruminants. The objective can be reached by intervention at the dietary level by ration manipulation (composition, feeding level) or by the use of additives or supplements. Examples of additives are polyhalogenated compounds, ionophores and other antibiotics. Supplementation of the ration with lipids also lowered methanogenesis. More biotechnological interventions, e.g., defaunation, probiotics and introduction of reductive acetogenesis in the rumen, are also mentioned. It can be concluded that drastic inhibition of methane production is not unequivocally successful as a result of several factors, such as: instantaneous inhibition often followed by restoration of methanogenesis due to adaptation of the microbes or degradation of the additive, toxicity for the host animal, negative effects on overall digestion and productive performance. Therefore, methanogenesis and its inhibition cannot be considered as a separate part of rumen fermentation and its consequences on the animal should be taken into account.