亚氧化钛膜电极电化学特性及其处理印染工业废水的效能研究

电化学氧化法具有稳定高效、操作灵活、集成度高等特点,在处理难降解有机废水领域具有独特优势.电化学废水处理过程通常受限于传质速率,而膜电极有望解决这一瓶颈问题.亚氧化钛膜电极（TiSO-ME）的化学结构与电化学性质结果显示,经过高温还原法制备的TiSO-ME电极主要由Ti₄O₇和少量Ti₅O₉组成,大孔体积占总孔体积的92.7%,平均孔径为0.508 μm.电化学测试结果表明,TiSO-ME具有良好的导电性、高析氧电位和电化学稳定性.过滤试验结果表明,在0.82×10^-3~3.14×10^-3 mL·cm^-2·s^-1范围内膜通量与传质系数成正比.在电流密度为8 mA·cm^-2,膜通量为2.31×10^-3 mL·cm^-2·s^-1的条件下,电解1.5 h即可有效处理实际印染工业废水,sCOD去除率高达96.07%,电流效率可达24.22%,电能消耗较不存在膜通量时降低了32.99%.TiSO-ME能够实现废水在膜孔结构内部的穿流式操作,有效克服旁流式操作传质受限的问题,在小规模分散式工业废水处理中有着重要的研究价值和发展潜力.     

高锰酸钾强化PAC混凝处理温瑞塘河黑臭水体试验研究

以浙江省温州市温瑞塘河某河段黑臭地表水为研究对象,考察高锰酸钾强化PAC混凝工艺的除污效能,获得处理温瑞塘河黑臭水体的最佳工艺条件,为恢复河流水体生态自净功能提供基础。试验结果表明,高锰酸钾的最优投加方式为在混凝剂PAC前投加,最佳预氧化时间5 min,最佳投加量1.5 mg/L。将本实验得出的最优混凝处理条件应用于温瑞塘河实际黑臭水体的处理时发现,处理后水质明显改善,此表明高锰酸钾强化混凝应急处理温瑞塘河黑臭水体是切实可行的,可为实际的应急处理工艺提供了理论依据和技术指导。     

废旧电子电气设备的资源化与无害化技术

数量巨大的废旧电子电气设备已成为威胁我国环境的重要固体废弃物,同时也是丰富的再生资源,介绍了国内外回收处理废弃电子电气设备的现状,讨论了当前处理利用废弃电子电气设备方面存在的主要问题,并根据废旧电子电气设备的特点,就其拆卸、电子塑料的处理以及有毒有害物质的分离等技术提出了研究开发建议。     

Regulated emission characteristics of in-use LNG and diesel semi-trailer towing vehicles under real driving conditions using PEMS

On-road driving emissions of six liquefied natural gas(LNG) and diesel semi-trailer towing vehicles(STTVs) which met China Emission Standard IV and V were tested using Portable Emission Measurement System(PEMS) in northern China.Emission characteristics of these vehicles under real driving conditions were analyzed and proved that on-road emissions of heavy-duty vehicles(HDVs) were underestimated in the past.There were large differences among LNG and diesel vehicles, which also existed between China V vehicles and China IV vehicles.Emission factors showed the highest level under real driving conditions, which probably be caused by frequent acceleration, deceleration, and start-stop.NOx emission factors ranged from 2.855 to 20.939 g/km based on distance-traveled and 6.719–90.557 g/kg based on fuel consumption during whole tests, which were much higher than previous researches on chassis dynamometer.It was inferred from tests that the fuel consumption rate of the test vehicles had a strong correlation with NOx emission, and the exhaust temperature also affected the efficiency of Selected Catalytic Reduction(SCR) aftertreatment system, thus changing the NOx emission greatly.THC emission factors of LNG vehicles were 2.012–10.636 g/km, which were much higher than that of diesel vehicles(0.029–0.185 g/km).Unburned CH_4 may be an important reason for this phenomenon.Further on-road emission tests, especially CH_4 emission test should be carried out in subsequent research.In addition, the Particulate Number(PN) emission factors of diesel vehicles were at a very high level during whole tests, and Diesel Particulate Filter(DPF)should be installed to reduce PN emission.     

高含固污泥厌氧消化中蛋白质转化规律

采用剩余污泥在含固率(total solid,TS)为12%条件下进行中温(37℃)厌氧消化,通过分析厌氧消化前后污泥蛋白质组分的变化情况,研究了高含固污泥厌氧消化中蛋白质的转化规律,探讨了高含固条件下污泥蛋白质转化效率较低的原因.结果表明,经过45 d的厌氧消化处理,污泥蛋白质的转化率为34.26%.污泥蛋白质转化效率较低的原因主要表现在:(1)高含固条件下污泥的传质较差;同时,污泥蛋白质经水解过程形成大量的氨氮,反应结束后污泥总氨氮(total ammonia nitrogen,TAN)质量浓度达到1 201 mg·L~(-1),导致对厌氧消化过程,尤其对蛋白质的分解表现出一定的抑制作用;(2)三维荧光光谱(three-dimensional fluorescence spectroscopy,3D-EEM)分析表明,部分蛋白质向腐殖质类、富里酸类物质转化,从而更难分解;(3)通过二维电泳(two-dimensional electrophoresis,2-DE)-质谱(mass spectrometry,MS)分析发现,厌氧消化后污泥蛋白质的相对分子质量和等电点(isoelectric point,p I)降低;最终,污泥中残留的大部分蛋白质来源于微生物体内.由于微生物代谢能力随着厌氧消化过程的进行而减弱,难以继续利用这些蛋白质,或消化体系中不具备分解这些蛋白质的酶,从而限制了污泥中蛋白质的分解效率.     

长株潭地区秋冬季环境空气质量分析及与气象参数的关联性研究

以湖南省长株潭3市为研究区域,分析其在2013年第4季度的城市环境空气质量状况,并与上年同期进行对比,同时研究PM_2.5质量浓度和AQI值与气象参数的相关性。结果表明,PM₁₀和PM_2.5是长株潭3市的主要大气污染物;2013年第4季度中,长株潭3市在11月份的空气质量最好;总体上,3市中,湘潭市的空气质量最差,而3市2013年第4季度的环境空气质量较上年同期明显下降,复合污染特征越来越明显。PM_2.5质量浓度和AQI值与气象参数都有一定的相关性,尤其是与能见度显著负相关,与风速、湿度和气压微弱负相关,而与温度微弱正相关。与上年同期相比,长株潭3市在2013年第4季度的气温偏高,湿度较小,平均风速小,气象条件不利于大气污染物扩散。因此,尽管3市的污染治理力度大,减排成效明显,但城市环境空气质量反而较上年同期下降。在大气环境容量基本利用殆尽的情况下,不利气象条件随时可能直接诱发严重的大气污染问题。     

高温高含二氧化碳条件下五种含Cr钢适用性评价

目的 预测某高温高含二氧化碳油井中管柱的腐蚀情况,为该油井推荐安全经济的材质。方法 采用高温高压反应釜模拟现场工况进行腐蚀试验,通过失重法、扫描电子显微镜(SEM)和X射线能谱分析(EDS)对五种含Cr钢的适用性进行评价。结果 在40~160 ℃温度范围内,五种钢材随温度的升高,其均匀腐蚀速率先升高后降低,且均在80 ℃时达到最大值。3Cr钢的腐蚀速率最高,在整个温度范围内,均远高于0.076 mm/a。在温度为120 ℃时,9Cr钢开始出现局部腐蚀。在温度为160 ℃时,13Cr钢有一定的局部腐蚀倾向。S13Cr、22Cr钢在整个温度范围内的腐蚀速率都较低,试验后试样表面平整连续,耐蚀性能好。结论 建议在采出井井筒中上部40~80 ℃较低温度井段选用9Cr钢,中部80~120 ℃中高温井段选用13Cr钢,底部120~160 ℃高温井段选用S13Cr钢。     

接枝羧基壳聚糖的合成及其对重金属离子的吸附性能

以壳聚糖为基体,经环氧氯丙烷交联,制备了水不溶性交联壳聚糖,然后以Ｆｅ＾２＋－Ｈ２Ｏ２为引发剂,将丙烯腈单体接枝到ＣＣＴＳ分子骨架上,经皂化制得了水溶性接枝羧基壳聚糖聚合物。     

Factors influencing the contents of metals and As in soils around the watershed of Guanting Reservoir, China

Topsoil samples from 61 sites around the Guanting Reservoir,China,were measured for Cu,Zn,Cr,Ni,Cd,Pb and As concentrations.The mean concentrations of Cu,Zn,Cr,Ni,Cd,Pb and As were 16.8,59.4,37.8,18.3,0.32,20.1 and 8.67 mg/kg dry weight,respectively.Factors that influence the dynamics of these metals in soils around the watersheds of Beijing reservoirs were examined.The influence of atmospheric deposition,land use,soil texture,soil type and soil chemical parameters on metal contents in soils was investigated.Atmospheric deposition,land use and soil texture were the important factors affecting heavy metal residues.Soil type and soil chemical parameters were also involved in heavy metal retention in soils.The data provided in this study are considered crucial for reservoir remediation,especially since the Guanting Reservoir will serve as one of the main drinking water sources for Beijing in the foreseeable future.     

风蚀条件下人类活动对高寒草地水分保持功能影响的定量模拟

青藏高原是我国重要的生态屏障,具有重要的水源涵养功能。高寒草地生态系统退化将严重地影响高原的水源涵养功能。为了定量研究人类活动对青藏高原高寒草地水分保持功能的影响,采用大型风洞实验,模拟人类不同的干扰方式和干扰程度对高寒草地土壤水分保持功能的影响。实验样品采自青藏高原三个草地类型:高寒草甸、草原化草甸和高寒草原。干扰方式包括破坏草地地上部分和根系,干扰程度包括轻干扰、中度干扰、重度干扰和全部破坏。实验结果表明,地上部分破坏后,土壤含水率均有下降,降幅分别为:QZ1为6.9%～9.2%、QZ2为6.8%～10.1%、QZ3为9%～10%;当根系遭到破坏后土壤含水率的降幅则分别为:QZ1为16%～30%,QZ2为17.25～32.1%,QZ3为22%～50%,显然,根系破坏后土壤含水率降幅远大于地表植被破坏后的情形。因此,植被根系是高寒草地水分保持功能的关键。随着干扰程度的加剧,土壤含水率在迅速下降。从试验模拟结果看,三个草地类型中土壤水分保持功能分别是高寒草甸>草原化草甸>高寒草原。