The Effects of Some Air Pollutants and Meteorological Conditions on Airborne Algae and Protozoa

The purpose of this investigation was to determine the effects of meteorological conditions and specific air pollutants on the viability of airborne algae and protozoa. Such investigations will be of interest to medical researchers because these organisms are the source of many allergies. The three air pollutants that were continuously measured and recorded were sulfur, hydrocarbons, and particulate maiter. During the experiment, 25 different species of algae and 19 species of protozoa were collected from the atmosphere and cultured at the Westinghouse Environmental Station Laboratory in Raleigh, North Carolina. The algae and protozoa were collected over a one-year period (Jan-Dec 1971) by using a sequential sampler that moved air through a membrane filter at the rate of 15 ft³/hr. Every two hours a new filter was sequentially moved in to replace the old one. The results indicated a relationship between wind speed, wind direction, temperature, dew-point, particulate matter, barometric pressure, and rainfall to the percent frequency of positive culture tubes and number of cells/ft³ of air. Further studies are necessary to determine the interrelationships between the physical and chemical character of various air masses and their effect on the survival of algae and protozoa.     

The Effect of Fuel Composition on Atmospheric Aerosol Due to Auto Exhaust

Aerosols attributable to automobile exhaust can be classified as two types—primary aerosol (initially present in the exhaust) and secondary aerosol (generated photochemically from hydrocarbons and nitrogen oxides in the exhaust). In this study, investigation was made of possible effects of motor-fuel composition on the formation of these aerosols. Secondary aerosol, of principal interest in this work, was produced by irradiating auto exhaust in Battelle-Columbus’ 610 ft³ environmental chamber. A limited number of determinations of primary aerosol in diluted auto exhaust was made at the exit of a 36 ft dilution runnel. Determination of both primary and secondary aerosol was based on light-scattering measurements.

Exhaust was generated with seven full-boiling motor gasolines, both leaded and nonleaded, in a 1967 Chevrolet which was not equipped with exhaust-emission control devices. Changes in fuel composition produced a maximum factor of three difference in light scattering due to primary aerosol. Aerosol yields, for consecutive driving cycles on the same fuel, vary considerably; as a result, ranking the fuels on the basis of average primary aerosol yield was not very meaningful. In addition to fuel composition, the more important independent variables are initial SO₂ concentration, relative humidity and initial hydrocarbon concentration. Statistical analysis of the data indicates that the seven test fuels can be divided into two arbitrary groups with regard to secondary aerosol-forming potential. The fuels in the lower light-scattering group had aromatic contents of 15 and 21%, while those in the higher light-scattering group had aromatic contents of 25, 48, and 55%. Although the fuels can be grouped on the basis of a compositional factor, the grouping of fuels with aromatic content ranging from 25 to 55% indicates that this compositional factor cannot be equated simply with aromatic content. In an associated study of the aerosol-forming potential of individual hydrocarbons prominent in auto exhaust, it was observed that aromatics produce substantially more photochemical aerosol than olefins and paraffins. However, experiments with binar/hydrocarbon mixtures containing aromatjcs, as well as in these exhaust experiments, a strong dependence of aerosol yield on the aromatic components is is not observed. Thus, the data indicate that the dependence of secondary aerosol formation on fuel factors is a complex one and cannot be predicted solely on the basis of a sirigle hydrocarbon component reactivity scale.

The two types of automobile aerosol did not have the same dependence on fuel, composition. The variation in total light scattering attributable to primary plus secondary aerosol was less than that due to either component alone. It therefore was concluded that the light scattering due to automobile exhaust emissions in these experiments was not significantly affected by changing fuel composition.     

Surface Transportation Noise and Its Control

Surface transportation creates most of the noise pollution imposed on our communities today. Reduction of this noise impact requires effective preparation and enforcement of regulations to control noise sources, and methods and locations of operation. At the Federal level, such action has begun, within the limited authority available. Concurrently, research and development programs are demonstrating that means to satisfy noise control regulations are technically practical and economically reasonable. This paper provides a brief review of Federal regulatory areas and corresponding R&D activities pertinent to surface transportation noise abatement.     

Ethylene: An Urban Air Pollutant

Ethylene is an unusual air pollutant in that it is a plant hormone. Motor vehicle exhaust is a primary source. In the Washington, D. C, area, ethylene concentrations ranged from 700 ppb in the city center to 39 ppb in areas outside the circumferential beltway. Plants grown in these concentrations of ethylene, using controlled environment chambers, exhibited typical symptoms of ethylene toxicity: reduced growth, premature senescence, and reduced flowering and fruit production. When plants were grown in carbon-filtered ambient air, which was also filtered through KMnO₄ to remove ethylene by oxidation, growth, flowering, and fruit production increased. These observations demonstrate that ethylene air pollution is a continual source of stress for plant growth and development in an urban environment.     

Oxygenates in Exhaust from Simple Hydrocarbon Fuels

Photochemical air pollution is known to be caused largely by automotive emissions such as hydrocarbons and oxygenated hydrocarbon derivatives. Unlike the hydrocarbons, the contribution of the oxygenates has been virtually unexplored, mainly because of lack of appropriate analytical methods. The objective of this study was to identify and estimate the levels of oxygenated hydrocarbon derivatives in exhaust from simple hydrocarbon fuels. This information is expected to yield ultimately estimates of the relative levels of various classes of oxygenates in exhaust from full-boiling-range gasolines. Identification and measurement of oxygenates in exhaust from the simplified fuels were accomplished using gas chromatography in conjunction with time-of-flight mass spectrometry. The analytical procedure involved concentration of the exhaust organics, followed by a two-stage chromatographic separation of the resultant mixture of oxygenates and hydrocarbons. Identified oxygenates in exhaust from nine test fuels included saturated and unsaturated aldehydes, ketones, and alcohols, as well as ethers, esters, and nitroalkanes; analytical data on organic acids were inconclusive. Of the identified noncarbonyl oxygenates, phenols, cyclic ethers and nitromethane appear to be relatively the most abundant.     

The Survival of Airborne Serratia marcescens in Urban Concentrations of Sulfur Dioxide

Aerosols of Serratia marcescens ATCC 274 were suspended in a 709L rotating drum at 20 ± 1 °C and high to mid-range relative humidities. At specified times after bacterial aerosolization, sulfur dioxide was added to concentrations of 2.5, or 5 mg/m³. Viable cell decay rate constants, in control aerosols without added sulfur dioxide, increased rapidly from near 100% to 60% RH in the first hour (termed: young aerosol) of suspension, and from a minimum rate constant at 80% in the succeeding four hours (termed: old aerosol).Upon addition of sulfur dioxide to a cloud of S. marcescens, generally, viable cell decay rate constants increased further. One exception was at 80% relative humidity where maximum resistance to SO₂ accelerated death was observed for old aerosols. Cells in young aerosols were particularly sensitive to SO₂ addition at mid-range humidities, while in older aerosols the cells were insensitive to up to 5 mg SO₂/m³ introduced at high RH; but were up to 10 times more sensitive than cells in young aerosols to a given increase (from 2.5 to 5 mg/m³) in SO₂ concentration at mid-range humidities.     

Jet Aircraft Operations: Impact on the Air Environment

This paper is directed to those concerned with the air environment and its degradation by the burden of pollution from jet aircraft operations. A summary is presented of the results of a comprehensive air pollution study of jet aircraft operations at the Los Angeles International Airport (LAX). Included in the data obtained from this study are jet engine exhaust measurements for currently used turboprop, turbojet and turbofan engines; measurements of specific contaminants in the atmosphere inside and outside of passenger terminals and ticketing areas, and in aircraft cabins during ground operations including passenger loading and taxiing prior to takeoff; also presented are ambient air measurements in a two-mile radius of the airport. An evaluation is made of the emissions of contaminants from air transport operations and all related ground activities including motor vehicles, that contribute to the total atmospheric contaminant burden at the airport.