Degradation of 2,4,6-trinitrotoluene by selected helophytes

Four emergent plants (helophytes, synonyms emersion macrophytes, marsh plants, etc.) Phragmites australis, Juncus glaucus, Carex gracillis and Typha latifolia were successfully used for degradation of TNT (2,4,6-trinitrotoluene) under in vitro conditions. The plants took up and transformed more than 90% of TNT from the medium within ten days of cultivation. The most efficient species was Ph. australis which took up 98% of TNT within ten days. The first stable degradation products 4-amino-2,6-dinitrotoluene (4-ADNT) and 2-amino-4,6-dinitrotoluene (2-ADNT) were identified and analysed during the cultivation period. [14C] TNT was used for the detection of TNT degradation products and their compartmentalization in plant tissues after two weeks of cultivation. Forty one percent of 14C was detected as insoluble or bound in cell structures: 34% in roots and 8% in the aerial parts. These results open the perspective of using the above-mentioned plants for the remediation of TNT contaminated waters.     

Tylosin sorption to silty clay loam soils, swine manure, and sand

The objectives of this study were to assess sorption and desorption of tylosin, a macrolide antimicrobial chemical used in swine, cattle, and poultry production, in three silty clay loam soils of South Dakota and compare soil sorption to sand and manure sorption. The silty clay loam soils, from a toposequence in eastern South Dakota, standardized sand samples, and swine manure were used in 24-h batch sorption studies with tylosin concentrations ranging from 25 to 232 micro mole/L. Desorption from soil was conducted over a four-day period. Partition coefficients, based on the Freundlich isotherm (K(f)) or K(d) values, were calculated. K(f) values for the silty clay loams were similar, not influenced by landscape position, and averaged 1,350 with isotherm slopes ranging from 0.85 to 0.93. K(f) values for sand were dependent on solution/sand ratios and pH, ranging from 1.4 to 25.1. K(d) values of manure were dependent on the solution type and ranged from 840 L/kg with urine to about 175 L/kg when sorbed from water. Desorption of tylosin from each soil over the four-day period was < 0.2% of the amount added. The soils' high K(f) values and low desorption amounts suggest that once tylosin is in these soils, leaching to lower depths may not occur. However, this does not preclude runoff with soil eroded particles. If tylosin reaches a sand aquifer, through bypass flow or other mechanism(s), movement in the aquifer most likely would occur.     

Predictions by the Odor From Feedlots, Setback Estimation Tool (OFFSET) compared with observations by neighborhood monitors

A comparison between predicted and observed odor intensities at 20 neighborhood residences in the vicinity of seven various livestock farms in five different Minnesota counties was made to evaluate the Odor From Feedlots, Setback Estimation Tool (OFFSET) developed by the University of Minnesota. Observations by neighborhood monitors suggest that the OFFSET-predicted separation distances for annoyance-free frequencies of 99, 98, and 97% are large enough. The observations additionally indicate that predicted distances to obtain 94 and 91% annoyance-free frequencies may be large enough for some farms, but for other farms, greater distances may be needed. For two farms in the study, no significant difference between all of the observed and predicted intensities could be found. At four sites, a significant difference was found, and at three of these the difference was considerable. Odor emission rates used in the OFFSET model seem to describe the average emission fairly well for many odor sources, but improvement may be needed for some types of sources. Possible reasons for observations of annoying odor when not predicted include fluctuations in the odor emissions, wind speed fluctuations, topographic variation between sites, sensitivity differences by neighborhood monitors, and background emissions from other sources.     

Inter- and intra-species variation in acute zinc tolerance of field-collected cladoceran populations

Acute zinc toxicity was assessed for 10 freshwater cladoceran species collected in six different ecosystems across Europe and for two standard laboratory-reared species (Daphnia magna and Ceriodaphnia dubia). The collected organisms belonged to five different genera: Daphnia (subgenus Daphnia and Ctenodaphnia), Ceriodaphnia, Simocephalus, Acroperus and Chydorus. The 48-h EC50 of the field-collected organisms tested in standard laboratory water ranged from 375+/-141 to 4314+/-1513 microg Znl(-1). The laboratory clone of D. magna was less sensitive than the majority of the field-collected species, while our laboratory Ceriodaphnia dubia was the second most sensitive. Considerable inter-species variation was found within the genus of Ceriodaphnia (factor 6) and within the genus Daphnia (factor 8). Among the different (sub)genera tested, Chydorus and Ctenodaphnia were significantly more tolerant than the others (up to a factor 3 difference). A significant positive relationship (r2=0.67, p<0.05) between the mean cladoceran 48-h EC50 and the ambient zinc concentration of the different aquatic systems was demonstrated, suggesting a role of acclimation and/or adaptation. No significant correlation between the acute zinc tolerance and the length of the organisms was found.     

Monitoring of the booster biocide dichlofluanid in water and marine sediment of Greek marinas

Dichlofluanid (N-dichlorofluoromethylthio-N'-dimethyl-N-phenylsulphamide) is used as booster biocide in antifouling paints. The occurrence of dichlofluanid and its metabolite DMSA (N'-dimethyl-N-phenyl-sulphamide) was monitored in seawater and marine sediment from three Greek marinas. Seawater and sediment samples were collected at three representative positions and one suspected hotspot in each marina and shipped to the laboratory for chemical analysis. As part of the project, an analytical method had been developed and validated. Furthermore, some additional experiments were carried out to investigate the potential contribution of paint particle bound dichlofluanid on the total concentration in the sediment. As expected, given its known high hydrolytic degradation rate, no detectable concentrations of dichlofluanid were measured in any of the seawater samples. DMSA was detected in seawater samples at very low concentrations varying from <3 ng l(-1) (LOD) to 36 ng l(-1). During method validation, it had already been demonstrated that dichlofluanid is unstable in sediment and can therefore only be determined as its metabolite DMSA. In a separate experiment, in which marine sediment was spiked with artificial paint particles containing dichlofluanid and then analysed according to the validated method, it was demonstrated that if there is any dichlofluanid originating from paint particles, this would be determined as DMSA. No DMSA was detected in any of the sediment samples. It could therefore be concluded that there were no significant concentrations of dichlofluanid in the sediment samples.     

湿式烟气脱硫喷淋塔内部流场数值模拟研究

以300MW机组湿法烟气脱硫喷淋塔为研究对象,利用计算流体力学通用软件对其内部两相流场进行模拟。气相湍流由标准k 模型描述,喷淋液滴由拉格朗日颗粒轨道模型描述。预测了无喷淋和有喷淋2种条件下的气相湍流流场分布、沿塔高方向不同截面上的气速分布以及喷淋液滴的轨迹。模拟结果表明,引入喷淋液后,出口截面气速分布明显均匀化,其最大值由无喷淋时的12m/s降至6m/s。该最大值出现在靠近塔壁处,是由塔壁附近喷淋密度较低造成的,可通过改进周边喷嘴的布置方式及喷嘴型式进行优化。     

Pencycuron application to soils: degradation and effect on microbiological parameters

Clay loam soil from agricultural fields of alluvial (AL) soil (typic udifluvent) and coastal saline (CS) soil (typic endoaquept) were investigated for the degradation and effect of pencycuron application at field rate (FR), 2-times FR (2FR) and 10-times FR (10FR) with and without decomposed cow manure (DCM) on soil microbial variables under laboratory conditions. Pencycuron degraded faster in CS soil and in soil amended with DCM. Pencycuron spiking at FR and 2FR resulted in a short-lived (in case of 10FR slightly longer) and transitory toxic effect on soil microbial biomass-C (MBC), ergosterol content and fluorescein diacetate hydrolyzing activity (FDHA). Amendment of DCM did not seem to have any counteractive effect of the toxicity of pencycuron on the microbial variables. The ecophysiological status of the soil microbial communities as expressed by microbial metabolic quotient (qCO2) and microbial respiration quotient (Q(R)) changed, but for a short period, indicating pencycuron induced disturbance. The duration of this disturbance was slightly longer at 10FR. Pencycuron was more toxic to the metabolically activated soil microbial populations, specifically the fungi. It is concluded that side effects of pencycuron at 10FR on the microbial variables studied were only short-lived and probably of little ecological significance.     

A lysimeter experiment to investigate the leaching of veterinary antibiotics through a clay soil and comparison with field data

Pharmaceuticals used in livestock production may be present in manure and slurry as the parent compound and/or metabolites. The environment may therefore be exposed to these substances due to the application of organic fertilisers to agricultural land or deposition by grazing livestock. For other groups of substances that are applied to land (e.g. pesticides), preferential flow in clay soils has been identified as an extremely important mechanism by which surface water pollution can occur. This lysimeter study was therefore performed to investigate the fate of three antibiotics from the sulphonamide, tetracycline and macrolide groups in a clay soil. Only sulphachloropyridazine was detected in leachate and soil analysis at the end of the experiment showed that almost no antibiotic residues remained. These data were analysed alongside field data for the same compounds to show that soil tillage which breaks the connectivity of macropores formed over the summer months, prior to slurry application, significantly reduces chemical mobility.     

Laboratory simulation of biodegradation of chemicals in surface waters: closed bottle and respirometric test

Microbial degradation is the most dominant elimination mechanism of organics from the environment. For evaluation of biodegradability of pure chemicals many standardized tests are available, but no standardized procedure for assessment of biodegradability of chemicals in surface water is agreed upon. Rates of in-situ biodegradation are usually estimated in laboratory simulation where environmental factors are reproduced to some extent. The aim of our study was to compare standardised ready biodegradability assessment, test (Closed bottle test) and its modifications employing the basic agreements on test conditions to simulate biodegradation in surface water. Standard test was modified using various natural river waters to simulate the natural environment in a simplified way. The impact of different types and amounts of nutrients and microorganisms on biodegradation was confirmed. The conditions in the recipient should be examined to extrapolate the results from ready biodegradability tests to real surface water.     

Methane emission from lakes

A physico-chemical model to describe methane and carbon dioxide emission from lakes was developed. The model describes the emission by diffusion, bubbles and plants. The intensity of the fluxes can be calculated either for total or particular emission in dependence on gas bubbles composition. It was found, that diffusional (Q) and bubble (J) fluxes depend on the methane molar ratio (X) in bubbles as follows: [formula: see text]. The model allows to estimate the role of the methane oxidation by atmospheric oxygen in the total methane flux. It was shown, that the methane oxidation does not influence much methane fluxes to the atmosphere for most of the experimentally observed situations.