Broadening of appropriate demulsifier dosage range for latex-containing wastewater by sulfate addition

Investigation of demulsification of polybutadiene latex (PBL) wastewater by polyaluminum chloride (PAC) indicated that there was an appropriate dosage range for latex removal. The demulsification mechanism of PAC was adsorption-charge neutralization and its appropriate dosage range was controlled by zeta potential. When the zeta potential of the mixture was between -15 and 15 mV after adding PAC, the demulsification effect was good. Decreasing the latex concentration in chemical oxygen demand (COD) from 8.0 g/L to 0.2 g/L made the appropriate PAC dosage range narrower and caused the maximum latex removal efficiency to decrease from 95% to 37%. Therefore, more accurate PAC dosage control is required. Moreover, adding 50 mg/L sulfate broadened the appropriate PAC dosage range, resulting in an increase in maximum latex removal efficiency from 37% to 91% for wastewater of 0.2 g COD/L. The addition of sulfate will favor more flexible PAC dosage control in demulsification of PBL wastewater.

Open image in new window

     

Pyrolysis behaviors of oil sludge based on TG/FTIR and PY-GC/MS

Pyrolysis is an alternative technology for oil sludge treatment. Thermogravimetric Analysis-Fourier Transform Infrared Spectroscopy and Pyrolysis-Gas Chromatography/Mass Spectrometry were employed to investigate the pyrolysis process and products of oil sludge. The pyrolysis process was divided into five stages: drying and gas desorption, oil volatilization, main pyrolysis, semi-coke charring, and mineral decomposition. The main reaction temperatures ranged from 497.6 K to 753.2 K. The products were mainly composed of pairs of alkane and alkene (carbon number ranges from 1 to 27). The mechanisms consisted of random chain scission followed by end chain scission at high temperatures with volatilization occurring during the whole process. This study is useful not only for the proper design of a pyrolysis system, but also for improving the utilization of liquid oil products.     

厌氧折流内循环反应器(ABIC)处理木薯淀粉废水试验

对自主研发的厌氧折流内循环反应器(anaerobic baffled internal circulation,ABIC)处理木薯淀粉废水的运行特性进行研究,结果表明:ABIC在水力停留时间为20~24 h、进水ρ(COD)为3 000~15 000 mg/L、有机负荷为3.0~20.0kg/(m3·d)时COD去除率均高于80.0%,最高可达91.2%。ABIC对进水负荷的冲击具有良好耐受能力,最大可承受的容积负荷VLR为26.0 kg/(m3·d),运行稳定。反应器重新启动耗时较短,对处理木薯淀粉季节性生产废水有利。     

沉管隧道对接端深基坑止水墙水下爆破对周围环境的影响研究

基于爆破动态效应的现场监测数据,研究了襄阳汉江鱼梁州沉管隧道对接端深基坑止水墙水下爆破对邻近建(构)筑物和周围水域的不利影响.结果 表明:爆源附近方圆50 rn范围内属于爆破振动近场区、方圆50～150 m范围内属于爆破振动过渡区、方圆150 m范围外属于爆破振动远场区;爆破振动近场区内薄壁支护结构爆破振动速度呈现高峰...     

耐低温混菌降解苯系物的特性及菌种鉴定研究

以吉化双苯厂被硝基苯、苯系物（BTEX）污染的土壤为菌源,经过筛选驯化得到一组在低温条件（10℃）下可降解苯系物（BTEX）的混菌。室内研究表明,在10℃,pH=6.8,苯系物（BTEX）总质量浓度200mg·L^-1的条件下,84h后该菌对苯、甲苯、乙苯、二甲苯的降解率依次为93.2%、95.6%、91%、88.4%、对6种质量浓度的苯系物（BTEX）污染物中最难降解的苯进行降解动力学曲线模拟,当苯质量浓度小于17.48mg·L-1时,降解符合一级降解动力学,当苯的质量浓度为17.48～195.30mg·L^-1时,降解符合零级降解动力学、该混菌降解效果稳定、适应环境能力强,经80次传代后仍能保持良好的降解效果,且在6个不同地区含有不同背景组成的地下水中降解效果稳定、应用Biolog细菌自动鉴定系统和16SrDNA序列分析方法对降解率较高的3株菌B2、B4、B6作菌种鉴定,B2为嗜麦芽糖寡养单胞菌（Stenotrophomonas maltophilia）,B4为斑生假单胞菌（Pseudomonas maculicola）,B6为多刺假单胞菌（Pseudomonas spinosa）。     

用废铅蓄电池制备黄丹和红丹

以废铅蓄电池为原料,采用湿法、火法联合冶炼技术制备黄丹和红丹。该技术可靠、设备投资少、操作简单、无二次污染、铅尘处理效果好,且环境效益和经济效益显著。用该法制备的红丹产品,Pb3O4质量分数达到97．44％。     

碱水残渣等工业“三废”调剖可行性研究

从加大中原油田调剖措施工作力度的必要性、紧迫性出发。通过利用室内实验前后岩心渗透率、铸体图象、压汞参数、扫描电镜孔隙变化等实验分析结果,研究了利用碱水残渣、废纸浆、锯木灰等工业“三废”调剖的可行性,及其在中原油田水井调剖中的适用性。结合目前注水冲刷地层孔隙结构变化的特点,还提出配套改进办法和扩大推广应用规模的建议。     

烟花爆竹燃放对四川盆地边缘城市环境空气的影响及其污染传输特征研究

为了解四川盆地边缘城市环境空气质量受烟花爆竹燃放影响的特征,选取位于成都平原西南部的乐山市进行研究。研究发现,春节期间乐山市受烟花爆竹燃放影响的环境空气中的颗粒物及其组分的浓度变化趋势一致。相关性分析结果显示：在除夕夜烟花爆竹燃放影响时间段内,乐山市环境空气中的颗粒物(PM₁₀、PM_2.5)浓度与SO₄^2-、F^-、Al、K、Mn、Cu、Zn等组分浓度呈显著正相关,Pearson相关系数达到了0.48～0.73;Al、Si、K、Mn、Cu、Zn等组分浓度之间也表现出显著正相关,Pearson相关系数高达0.78～0.98。其中,K⁺浓度占比从0%上升到7.32%,SO₄^2-浓度占比从18.94%上升到24.73%,Cl^-浓度占比从0.46%上升到4.29%,Cu元素浓度占比从0.05%上升到0.30%,Al元素浓度占比从5.87%上升到7.46%。除夕夜烟花爆竹燃放影响期间,乐山市中部和北部区...     

氢氧化镁处理含镍废水的研究

考察了氢氧化镁用量、搅拌时间、温度及pH对处理效果的影响 ,初步探讨了吸附作用机理。结果表明 :氢氧化镁对镍离子具有较强的吸附性能 ,去除率可达 99%以上。吸附等温线符合Langmuir模式 ,饱和吸附量 17.5 7mg/g。含Cd2 +、Ni2 +和Pb2 +的电镀废水经氢氧化镁吸附后 ,出水达到国家排放标准。     

一株红假单胞菌对偶氮染料的脱色研究

一株球形红假单胞菌(Rhodobacter sphaeroides YB)缺氧情况下对数种偶氮染料的24 h脱色率达到90％以上。结构相对简单的偶氮染料较容易脱色。研究了外加碳源、温度和pH值等环境因素对该菌生长以及脱色活性的影响,得出最优脱色条件为:光照缺氧、蛋白胨作碳源、温度35～40℃、pH=7-8。