Hot Steam Transfer Through Heat Protective Clothing Layers

The aim of this study was to analyse the transfer of steam through different types of textile layers as a function of sample parameters such as thickness and permeability. In order to simulate the human body, a cylinder releasing defined amounts of moisture was also used. The influence of sweating on heat and mass transfer was assessed.

The results show that in general impermeable materials offer better protection against hot steam than semi-permeable ones. The transfer of steam depended on the water vapour permeability of the samples, but also on their thermal insulation and their thickness. Increasing the thickness of the samples with a spacer gave a larger increase in protection with the impermeable samples compared to semi-permeable materials. Measurements with pre-wetted samples showed a reduction in steam protection in any case. On the other hand, the measurements with a sweating cylinder showed a beneficial effect of sweating.     

Performance of Firefighters’ Protective Clothing After Heat Exposure

Heat and mechanical protection properties of 6 fabric combinations commonly used in firefighters’ protective clothing were assessed before and after different heat treatment. It was shown that after heat exposure, the values obtained were generally lower than in the original state. The mechanical properties of the materials were more affected by heat than by heat protective properties. In 2 cases, degradation started before a visible change in the material could be observed, which might be potentially dangerous for the end user who will not realize the alteration of the material.     

Assessing the impacts of mountain biking and hiking on subalpine grassland in Australia using an experimental protocol

Mountain biking is an increasingly popular, but sometimes controversial, activity in protected areas. Limited research on its impacts, including studies comparing biking with hiking, contributes to the challenges for mangers in assessing its appropriateness. The impacts of mountain bike riding off trail were compared to those of hiking on subalpine grassland in Australia using a modification of a common trampling experimental methodology. Vegetation and soil parameters were measured immediately and two weeks after different intensities of mountain biking (none, 25, 75, 200 and 500 passes across slope, 200 pass up and down slope) and hiking (200 and 500 passes across slope). There were reductions in vegetation height, cover and species richness, as well as changes in species composition and increases in litter and soil compaction with riding. Riding up and down a moderate slope had a greater impact than riding across the slope. Hiking also affected vegetation height, cover and composition. Mountain biking caused more damage than hiking but only at high use (500 passes). Further research including other ecosystems, topography, styles of riding, and weather conditions are required, but under the conditions tested here, hiking and mountain biking appear to be similar in their environmental impacts.     

Size and spatial structure in deep versus shallow populations of the Mediterranean gorgonian <Emphasis Type="Italic">Eunicella singularis</Emphasis> (Cap de Creus,northwestern Mediterranean Sea)

In the Western Mediterranean Sea, the gorgonian Eunicella singularis (Esper, 1794) is found at high densities on sublittoral bottoms at depths from 10 to 70 m. Shallow colonies have symbiotic zooxanthellae that deeper colonies lack. While knowledge of the ecology of the shallow populations has increased during the last decades, there is almost no information on the ecology of the deep sublittoral populations. In October and November 2004 at Cap de Creus (42°19′12″ N; 03°19′34″ E), an analysis of video transects made by a remotely operated vehicle showed that shallow populations (10–25 m depth) were dominated by small, non-reproductive colonies, while deep sublittoral populations (50–67 m depth) were dominated by medium-sized colonies. Average and maximum colony heights were greater in the deeper populations, with these deeper populations also forming larger patch sizes and more extensive regions of continuous substrate coverage. These results suggest that shallow habitats are suitable for E. singularis, as shown by the high recruitment rate, but perturbations may limit or delay the development of these populations into a mature stage. This contrasts with the deep sublittoral habitats where higher environmental stability may allow the development of mature populations dominated by larger, sexually mature colonies.     

Heavy metal bioaccumulation by the bryophyte Scleropodium purum at three French sites under various influences: rural conditions, traffic, and industry

An active biomonitoring of the heavy metals pollution experiment was undertaken by means of the bryophyte species Scleropodium purum transplanted at three different sites exposed to rural, traffic, or industrial influences. Concentrations of about 40 elements in S. purum were determined by instrumental neutron activation analysis and inductively coupled plasma mass spectrometry. Accumulation rates of heavy metals were determined in the three sites. These accumulation rates in polluted sites were matched together and also to those recorded at the rural site. The changes of the accumulation rate of heavy metals in S. purum versus their concentrations in PM₁₀ particles simultaneously collected above show some different accumulation properties of S. purum according to elements and sites. S. purum has a weak efficiency in the three sites to accumulate elements like V, Cr, Cu, Zn, As, Se, Sb, and Pb originating from atmospheric hot sources generally enriched in particulates matter (PM₁₀), whereas it is particularly high for Br, Th, and Rb. For other elements, Co, La, Ce, and Hf, and rare earth elements, Fe, Sr, Nb, Ti, Al, and Sc, the collection efficiency by S. purum is intermediate. In the industrial site Dunkerque, a magnification of the collection efficiency by S. purum for elements originating from steel and aluminum productions and petroleum refinement suggests that these metals could be enriched in coarse particles with a better accumulation by the bryophyte with respect to PM10.     

Regional-scale meteorological characteristics of the Vento Norte phenomenon observed in Southern Brazil

Environmental Fluid Mechanics - The sudden increase in air temperature associated with strong gusty winds of northerly direction is a phenomenon occasionally observed during the cold season in the...     

The role of silicon in the supply of terrestrial ecosystem services

Environmental Chemistry Letters - Silicon (Si) is the most abundant element on the earth’s surface after oxygen. Si &nbsp;can be found in minerals,&nbsp;electronic chips, cosmetic...     

History of titanium dioxide regulation as a food additive: a review

Environmental Chemistry Letters - Since its discovery in the late eighteenth century and mass production in the early twentieth century, titanium dioxide has been used in a wide range of...     

Pesticide and agro-ecological transition: assessing the environmental and human impacts of pesticides and limiting their use

Environmental Science and Pollution Research -     

Aerobic Biodegradation of Polymers in Solid-State Conditions: A Review of Environmental and Physicochemical Parameter Settings in Laboratory Simulations

During the last few years, biodegradable polymers have been developed to replace petrochemical polymers. Until now, research devoted to these polymers essentially focused on their biodegradability. There is now a need to bear out their nontoxicity. To verify this, the biodegradation must be carried out in accelerated laboratory tests which allow the metabolites and residues to be recovered. To reproduce the natural conditions (compost, field) as closely as possible, degradation experiments must be run on solid-state substrates. We review studies of aerobic degradation in solid-state substrates. This article focuses in particular on the environmental, physical, and chemical parameters (such as substrate nature, moisture, temperature, C/N ratio, and pH) that influence biodegradation kinetics. This study also aims at finding the solid substrate most adapted to residues and metabolite recovery. The most significant parameters would appear to be the substrate type, moisture content, and temperature. Inert substrates such as vermiculite are well suited to residue extraction. This review also opens the field to new research aimed at optimizing conditions for aerobic solid-state biodegradation and at recovering the metabolites and residues of this degradation process.