MIXING INDUCED BY AN INTERNAL HYDRAULIC JUMP1

ABSTRACT The efficiency of an inverted internal hydraulic jump as a mixing and dispersion mechanism in an aquatic environment was examined. The flow considered was a two-dimensional buoyant flow from a shallow channel over a sloping bottom into a deep reservoir. It could be seen that a rapidly varied flow associated with violent turbulent mixing occurred near the point of discharge if specific discharge conditions and downstream controls were met. Downstream from the mixing zone the flow was stably stratified. The main object of the study was to find the conditions under which a turbulent mixing zone occurred and the rate of turbulent entrainment. Energy loss and length of the mixing zone were also investigated. The independent variables were the outlet densimetric Froude number, the density differential between outfall water and receiving water, the relative depths of the upper and lower layers in the stratified flow portion, the total depth, and the slope of the transition. Theoretical calculations had to be confined to a step increase in depth, but experiments in a laboratory flume showed that results obtained with slopes of 23° and 90° were quite similar. Both theory and experiments showed, for example, that dilution (entrainment rates) up to 2:1 (2 parts heated water to one part cold water) can be achieved at very little energy expense and with downstream depths approximately 8 times the outlet depth. Theoretically, any amount of dilution can be obtained, but large depths may be required. Experimental results also indicate that the length of the mixing zone was frequently ten times the value of the outlet densimetric Froude number.     

Importance of public relations in recycling strategies: principles and case studies

The separate collection of waste, and especially of recyclables with specific collection systems, would not be possible without the involvement of the users. Apart from the physical installations such as collection containers, collection points, etc., the motivation of the users is an essential component. Motivation can be reinforced through public relations work. In addition to the underlying technical considerations, this paper describes the difference between communication in general and public relations and specifically examines public involvement in recycling. Through the use of examples, we look at the targeted users and typical media employed. Furthermore, we analyzes the development of public involvement. The examples show that public relations for recycling strategies relies to a great extent on attitudes, habits, and access to the target group. Thus, standardized procedures cannot be developed. For these reasons, public relation activities must be planned carefully and professionally and include an analysis of the target group, choice of media, and verification of success.     

Monitoring ammonia in urban, inner alpine and pre-alpine ambient air

Passive samplers were used to monitor ammonia concentrations at rural inner alpine and pre-alpine, as well as urban, sites in Austria and Bavaria. Elevated concentrations were measured both at farms (up to 36 microg NH3 m(-3)) and at urban locations (up to 28 microg NH3 m(-3)). At urban locations a linear relationship between the traffic density and the NH3 concentration was found, but there was no marked seasonal trend. The highest ammonia concentrations were measured in a traffic tunnel (up to 78 microg NH3 m(-3)). The presence of livestock breeding or small scale alpine pastures resulted in elevated concentrations at the rural sites (8.1-12 and 2.5-4.6 microg NH3 m(-3), respectively), compared to the surrounding areas (3.1 and 0.9 microg NH3 m(-3)). Agriculture related sources are usually limited either spatially or seasonally. As the emissions were moderate in our case, a rapid removal and dilution of ammonia was possible and therefore the NH3 burden was only local. Sources related to traffic are more evenly distributed both geographically and seasonally. The WHO guideline, annual average concentration of 8 microg m(-3) for the protection of vegetation, was only exceeded at farms, at the urban station with the heaviest traffic and in the Tauerntunnel.     

The European Water Framework Directive: Water Quality Classification and Implications to Engineering Planning

The European Water framework directive (WFD) is probably the most important environmental management directive that has been enacted over the last decade in the European Union. The directive aims at achieving an overall good ecological status in all European water bodies. In this article, we discuss the implementation steps of the WFD and their implications for environmental engineering practice while focusing on rivers as the main receiving waters. Arising challenges for engineers and scientists are seen in the quantitative assessment of water quality, where standardized systems are needed to estimate the biological status. This is equally of concern in engineering planning, where the prediction of ecological impacts is required. Studies dealing with both classification and prediction of the ecological water quality are reviewed. Further, the combined emission–water quality approach is discussed. Common understanding of this combined approach is to apply the most stringent of either water quality or emission standard to a certain case. In contrast, for example, the Austrian water act enables the application of only the water quality based approach - at least on a temporary basis.     

The effect of light and iron(II)/iron(III) on the distribution of Tl(I)/Tl(III) in fresh water systems

The distribution of aqueous Tl(I)/Tl(III) as a function of light exposure and solution properties was studied by quantifying the oxidation states after separation with ion chromatography and on-line detection with ICP-MS. Ultraviolet irradiation of aqueous solutions containing 1 microg l(-1) Tl(III) and in equilibrium with the atmosphere increases the reduction rate. In systems with photoreduction of Fe(III)(aq) a quantitative oxidation of Tl(I)(aq) was observed, notably at low pH. The process is reversible, as indicated by formation of Tl(I) when the irradiated systems were kept in the dark. In systems with colloidal silica-stabilised ferrihydrite, UV irradiation also leads to oxidation of Tl(I)(aq), but not quantitatively. It is suggested that adsorption of thallium to the ferrihydrite determines the rate of oxidation. Detectable, but not quantitative, oxidation of Tl(I)(aq) took place when natural water samples with 1 microg l(-1) Tl(I)(aq) were exposed to either sunlight or UV-light. For these samples, the reduction was not quantitative when they were kept in the dark for 24 h. The results suggest that the light dependent iron cycle in fresh water systems strongly influences the redox state of thallium.     

Transport and distribution of artificial gamma-emitting radionuclides in the River Yenisei and its sediment

Discharges from the Krasnoyarsk Mining and Chemical Industrial Complex (KMCIC) near Krasnoyarsk resulted in radioactive contamination of sediments of the River Yenisei. Between 1999 and 2006, 16 sediment cores were collected at different positions 15-1500 km downstream from the discharge point. The concentration of artificial gamma-emitting radionuclides (¹³⁷Cs, ⁶⁰Co, ¹⁵²Eu, and ²⁴¹Am) was determined with the objective to analyze the migration processes leading to the transport of these radionuclides along the river and to their vertical distribution within the sediment. In cores taken in the vicinity of the reactors, the average activity concentration of ¹³⁷Cs, ¹⁵²Eu, and ⁶⁰Co was about 1000 Bq kg⁻¹, and the activity concentration of ²⁴¹Am was about 20 Bq kg⁻¹. Contamination levels of artificial radionuclides were decreasing with increasing distance downstream the KMCIC: The fastest decrease of average activity by a factor of 10 over a distance of 300 km was observed for ²⁴¹Am, whereas for ¹³⁷Cs this decrease occurred over a distance of 1100 km. Sequential extraction experiments revealed that in all depths and at all distances the studied radionuclides were tightly bound to the sediment.To investigate the mechanisms of transport of the ¹³⁷Cs and ⁶⁰Co contamination, mathematical models have been used to describe the contamination in the river water and within the sediments.     

Principal component analysis of indicator PCB profiles in breast milk from Poland

Principal component analysis (PCA) was applied to a data set containing the levels of indicator polychlorinated biphenyls (PCBs) in human milk of mothers living in the Wielkopolska region, Poland, in order to investigate the information captured in the PCB patterns and to elucidate the relationship between PCB concentrations in milk and donor characteristics. According to the obtained PCA results milk fat content was the most influential factor affecting the PCB levels in milk of the Wielkopolska cohort. The lifestyle data collected from the questionnaire completed by the donors appeared to have no influence on PCB concentrations in breast milk. The score plots revealed the PCB contents of milk were quite low and uniform with a few outliers, without discrimination observed either between the primipareous and secundipareous females or between donors from the urban and rural areas. Comparison of the PCB levels and profiles of human milk from the Wielkopolska region and from various European and Asian locations made by PCA reflected a generally low background exposure and indicated the possible reasons for the outlying of some samples. In order to enhance the chances of observing the relationship between donor habits and PCB levels in breast milk it was suggested that the questionnaire be redesigned to gather information about vegetable product consumption and indoor air exposure.     

Multilingual education of students on a global scale and perspective—international networking on the example of bioindication and biomonitoring (B&B technologies)

Living or formerly living organisms are being used to obtain information on the quality of the general health status of our environment by bioindication and biomonitoring methods for many decades. Thus, different roads toward this common scientific goal were developed by a lot of different international research groups. Global cooperation in between various scientific teams throughout the world has produced common ideas, scientific definitions, and highly innovative results of this extremely attractive working field. The transdisciplinary approach of different and multifaceted scientific areas—starting from biology, analytical chemistry, via health physics, up to social and economic issues—have surpassed mental barriers of individual scientists, so that “production” of straightforward common results related to the influence of material and immaterial environmental factors to the well-being of organisms and human life has now reached the forefront of international thinking. For the further sustainable development of our common scientific “hobby” of bioindication and biomonitoring, highest personal energy has to be given by us, being teachers to our students and to convince strategically decision makers as politicians to invest (financially) into the development of education and research of this innovative technique. Young people have to be intensively convinced on the “meaning” of our scientific doing, e.g., by extended forms of education. One example of multilingual education of students on a global scale and perspective is given here, which we started about 3 years ago.