Comparative study on indoor air quality in Japan and China: Characteristics of residential indoor and outdoor VOCs

We conducted a comparative study on the indoor air quality for Japan and China to investigate aromatic volatile organic compounds (VOCs) in indoor microenvironments (living room, bedroom, and kitchen) and outdoors in summer and winter during 2006–2007. Samples were taken from Shizuoka in Japan and Hangzhou in China, which are urban cities with similar latitudes. Throughout the samplings, the indoor and outdoor concentrations of many of the targeted VOCs (benzene, toluene, ethylbenzene, xylenes, and trimethylbenzenes) in China were significantly higher than those in Japan. The indoor concentrations of VOCs in Japan were somewhat consistent with those outdoors, whereas those in China tended to be higher than those outdoors. Here, we investigated the differences in VOC concentrations between Japan and China. Compositional analysis of indoor and outdoor VOCs showed bilateral differences; the contribution of benzene in China was remarkably higher than that in Japan. Significant correlations (p < 0.05) for benzene were observed among the concentrations in indoor microenvironments and between the outdoors and living rooms or kitchens in Japan. In China, however, significant correlations were observed only between living rooms and bedrooms. These findings suggest differences in strengths of indoor VOC emissions between Japan and China. The source characterizations were also investigated using principal component analysis/absolute principal component scores. It was found that outdoor sources including vehicle emission and industrial sources, and human activity could be significant sources of indoor VOC pollution in Japan and China respectively. In addition, the lifetime cancer risks estimated from unit risks and geometric mean indoor concentrations of carcinogenic VOCs were 2.3 × 10^?5 in Japan and 21 × 10^?5 in China, indicating that the exposure risks in China were approximately 10 times higher than those in Japan.     

An international comparative study of end-of-life vehicle (ELV) recycling systems

End-of-life vehicles (ELV) have become a global concern as automobiles have become popular worldwide. An international workshop was held to gather data and to discuss 3R policies and ELV recycling systems, their background and present situation, outcomes of related policies and programs, the framework of recycling and waste management, and case studies on related topics in several countries and regions, as well as the essential points of the comparison. Legislative ELV recycling systems are established in the EU, Japan, Korea, and China, while in the US, ELV recycling is managed under existing laws on environmental protection. Since automobile shredding residue (ASR) has a high calorific value and ash content, and includes heavy metals as well as a mass of unclassified fine particles, recycling ASR is considered highly difficult. Countries with a legislative ELV system commonly set a target for recovery rates, with many aiming for more than 95 % recovery. In order to reach this target, higher efficiency in ASR recovery is needed, in addition to material recycling of collectable components and metals. Environmentally friendly design was considered necessary at the planning and manufacturing stages, and the development of recycling systems and techniques in line with these changes are required for sound ELV management.     

Trace elements and butyltins in a Dall's porpoise (Phocoenoides dalli) from the Sanriku coast of Japan

Concentrations and body burdens of 14 trace elements (Hg, Cr, Mn, Co, Cu, Zn, Sr, Ag, Cd, V, Se, Pb, Mo, and Fe) and butyltins (BTs) (tributyltin TBT, dibutyltin DBT, and monobutyltin MBT) were determined in various tissues of a mature male Dall's porpoise (Phocoenoides dalli) collected off the Sanriku coast of Japan. Selective accumulation in this porpoise was observed for Hg, Mn, Cu, Ag, Mo, Fe, and total BTs (TBT, DBT, and MBT) in the liver, Cd in the kidney, Zn, Sr, V, Pb, and Co in the bone, and Se in the skin. In contrast, Cr concentrations in all tissues were similar. This distribution pattern in this mature porpoise was in general agreement with the accumulation characteristics of trace elements and butyltins reported for other marine mammals. The whole body of the porpoise contained approximately 62 g Fe, 8.8 g Zn, 4.0 g Sr, 0.6g Se, 0.41 g Cu, 0.19 g Hg, 0.17 g Cd, 0.16 g Mn, 0.05 g Cr, 0.009 g Ag, 0.008 g Mo, 0.005 g Pb, 0.004 g Co, and 0.7 mg of BTs (0.4 mg TBT, 0.2 mg DBT, and 0.1 mg MBT). Metabolism of TBT to its breakdown products of this porpoise seems to be limited, since TBT still accounted for about half of the total burden of BTs. As in the cases of Hg, Mn, Cu, Se, and Fe, the muscle was the most important reservoir (43%) for the whole body burden of total BTs, 80% of which was TBT, and thus muscle played a crucial role in the higher body composition of TBT in this Dall's porpoise.     

Ecosystem changes following the 2016 Kumamoto earthquakes in Japan: Future perspectives

Major earthquakes cause widespread environmental and socioeconomic disruptions that persist for decades. Extensive ground disturbances that occurred during the shallow-focus Kumamoto earthquakes will affect future sustainability of ecosystem services west of Aso volcano. Numbers of earthquake-initiated landslides per unit area were higher in grasslands than forests, likely owing to greater root reinforcement of trees, and mostly initiated on ridgelines and/or convex/planar hillslopes. Most landslides traveled short distances and did not initially evolve into debris flows; resultant sediments and wood accumulating in headwater channels can be mobilized into debris flows during future storms. Fissures along ridgelines may promote water ingress and induce future landslides and debris flows that affect residents downstream. Native grasses are at risk because of habitat fragmentation caused by ground disturbances, extensive damage to rural roads, and abandonment of traditional pasture management practices. Sustainable management of affected areas needs to consider future risk of cascading hazards and long-term socioeconomic impacts.     

Chlorination of bisphenol A in aqueous media: formation of chlorinated bisphenol A congeners and degradation to chlorinated phenolic compounds

The chlorination of bisphenol A (BPA) in aqueous media was investigated in order to describe the degradation profile of this compound and the formation of chlorinated products. Aqueous solutions of BPA (approx. 1 mg/l) were chlorinated by sodium hypochlorite solution at room temperature and under weakly alkaline conditions. Chlorinated compounds were extracted with dichloromethane and determined by gas chromatography/mass spectrometry (GC/MS). BPA was consumed completely within 5 min of chlorination, when the initial chlorine concentration was 10.24 mg/l (molar ratio to BPA, 58.7). On the other hand, when the initial chlorine concentration was 1.03 mg/l (molar ratio, 6.56), 9.3% of BPA still remained after 60 min chlorination. Five chlorinated BPA congeners, 2-chlorobisphenol A (MCBPA), 2,6-dichlorobisphenol A (2,6-D2CBPA), 2,2'-dichlorobisphenol A (2,2'-D2CBPA), 2,2',6-trichlorobisphenol A (T3CBPA) and 2,2', 6,6'-tetrachlorobisphenol A (T4CBPA) were formed in the earlier stages of chlorination. Several chlorinated phenolic compounds, 2,4,6-trichlorophenol (T3CP), 2,6-dichloro-1,4-benzoquinone (D2CBQ), 2,6-dichloro-1,4-hydroquinone (D2CHQ), C9H10Cl2O2, C9H8Cl2O and C10H12Cl2O2, were also formed by further chlorination.     

Removal of Pb(II) from water using keratin colloidal solution obtained from wool

The aim of this study is to investigate the use of keratin colloidal solution, which was obtained from wool, for the removal of Pb(II) from water. The addition of keratin colloidal solution (15 g L^?1, 0.30 mL) to a Pb(II) solution (1.0 mM, 0.90 mL, pH 5.0) resulted in the formation and precipitation of a Pb–keratin aggregate. Measurement of the Pb(II) and protein concentrations in the supernatant solution revealed that 88 and 99 % of the Pb(II) and keratin protein were removed from the solution, respectively. The maximum Pb(II) uptake capacity of keratin in the colloidal solution was 43.3 mg g^?1. In addition, the Pb–keratin aggregate was easily decomposed via the addition of nitric acid, which enabled the recovery of Pb(II). However, aggregation did not occur in solutions with Pb(II) concentrations below 0.10 mM. Therefore, we used a keratin colloidal solution encapsulated in a dialysis cellulose tube to remove Pb(II) from 0.10 mM solutions, which enabled the removal of 95 % of the Pb(II). From these results, we conclude that keratin colloidal solution is useful for the treatment of water polluted with Pb(II).     

Mercury contamination in human hair and fish from Cambodia: levels, specific accumulation and risk assessment

Mercury (Hg) concentrations in human hair and fish samples from Phnom Penh, Kien Svay, Tomnup Rolork and Batrong, Cambodia, collected in November 1999 and December 2000 were determined to understand the status of contamination, and age- and sex-dependent accumulation in humans and to assess the intake of mercury via fish consumption. Mercury concentrations in human hair ranged from 0.54 to 190mug/g dry wt. About 3% of the samples contained Hg levels exceeding the no observed adverse effects level (NOAEL) of WHO (50mug/g) and the levels in some hair samples of women also exceeded the NOAEL (10mug/g) associated with fetus neurotoxicity. A weak but significant positive correlation was observed between age and Hg levels in hair of residents. Mercury concentrations in muscle of marine and freshwater fish from Cambodia ranged from <0.01 to 0.96mug/g wet wt. Mercury intake rates were estimated on the basis of the Hg content in fish and daily fish consumption. Three samples of marine fish including sharp-tooth snapper and obtuse barracuda, and one sample of sharp-tooth snapper exceeded the guidelines by US EPA and by Joint FAO/WHO Expert Committee on Food Additives (JECFA), respectively, which indicates that some fish specimens examined (9% and 3% for US EPA and JECFA guidelines, respectively) were hazardous for consumption at the ingestion rate of Cambodian people (32.6g/day). It is suggested that fish is probably the main source of Hg for Cambodian people. However, extremely high Hg concentrations were observed in some individuals and could not be explained by Hg intake from fish consumption, indicating some other contamination sources of Hg in Cambodia.     

Evaluation of thermally treated asbestos based on fiber number concentration determined by transmission electron microscopy

Appropriate treatment of asbestos waste is a significant problem. In Japan, inertization of asbestos-containing waste by novel techniques approved by the Ministry of the Environment is now promoted. A quantitative method of testing with high sensitivity to the asbestos levels present in the inertization products is required for the approval process, but many testing methods are only qualitative. Thus, we have developed an evaluation method for asbestos in inertized products, consisting of the extraction of fibers from inertized products and determination of fiber number concentration by transmission electron microscopy. We adopted this testing method to evaluate thermally treated asbestos. It was found that fiber number concentrations of thermally treated asbestos decreased with increased treatment temperature, and were below the environmental level (10² Mf/g) at more than 1000 °C for chrysotile and crocidolite and more than 1400 °C for amosite and other amphibole forms of asbestos.     

Distribution of copper,silver and gold during thermal treatment with brominated flame retardants

The growing consumption of electric and electronic equipment results in creating an increasing amount of electronic waste. The most economically and environmentally advantageous methods for the treatment and recycling of waste electric and electronic equipment (WEEE) are the thermal techniques such as direct combustion, co-combustion with plastic wastes, pyrolysis and gasification. Nowadays, this kind of waste is mainly thermally treated in incinerators (e.g. rotary kilns) to decompose the plastics present, and to concentrate metals in bottom ash. The concentrated metals (e.g. copper, precious metals) can be supplied as a secondary raw material to metal smelters, while the pyrolysis of plastics allows the recovery of fuel gases, volatilising agents and, eventually, energy. Indeed, WEEE, such as a printed circuit boards (PCBs) usually contains brominated flame retardants (BFRs). From these materials, hydrobromic acid (HBr) is formed as a product of their thermal decomposition.In the present work, the bromination was studied of copper, silver and gold by HBr, originating from BFRs, such as Tetrabromobisphenol A (TBBPA) and Tetrabromobisphenol A-Tetrabromobisophenol A diglycidyl ether (TTDE) polymer; possible volatilization of the bromides formed was monitored using a thermo-gravimetric analyzer (TGA) and a laboratory-scale furnace for treating samples of metals and BFRs under an inert atmosphere and at a wide range of temperatures. The results obtained indicate that up to about 50% of copper and silver can evolve from sample residues in the form of volatile CuBr and AgBr above 600 and 1000 °C, respectively. The reactions occur in the molten resin phase simultaneously with the decomposition of the brominated resin. Gold is resistant to HBr and remains unchanged in the residue.     

Morphological plasticity of submerged macrophyte Potamogeton wrightii Morong under different photoperiods and nutrient conditions

The morphological plasticity of the submerged macrophyte Potamogeton wrightii under different nutrient conditions and photoperiods was measured in a laboratory controlled experiment for 70 days in Japan. Six treatments were used in this experiment (3 × 2 factorial design with three replications) which consisted of three photoperiods and two nutrient conditions. Both photoperiod and nutrient condition had a pronounced effect on shoot and leaf morphology in P. wrightii. New shoot recruitment, and the length of main and new shoots gradually decreased with shortening photoperiod under both nutrient treatments. Plants under an 8 h photoperiod and high nutrient levels generated significantly more dead leaves (7.42 leaf·shoot^?1) and decomposed shoots (1.3 shoots·pot^?1) than plants under other treatments. Under short photoperiods (12 and 8 h) plants failed to produce flowering spikes in both nutrient conditions. In high nutrient conditions, P. wrightii produced shorter shoots, fewer leaves with shorter and narrower laminas, and smaller petioles compared with plants in the low nutrient condition. This may be adaptive under high nutrient conditions because it lowers foliar uptake and, thus, nutrient toxicity.