某省高危含砷爆炸物污染农田评价及分布研究

利用不同的评价标准和方法评价了吉林省某地含砷高危爆炸物造成的砷污染,同时借助GIS软件绘制了砷污染指数分布图。结果表明:以土壤环境背景值的上限值为评价标准,平均污染累积指数为2.61,最大为65.38,约57.38%的土壤受到人为外源砷的干扰;以(GB 15618-2008)中砷的二级标准作为评价标准,平均污染指数为1.01,最大污染指数达15.27,超标率为23.87%,表明该区存在严重的砷污染;地累积指数污染评价结果也表明该地存在明显的外源砷污染,受到污染的比例达41.57%;3种评价方法结果基本一致。污染指数分布表明,该地重污染区集中在中部区域,并形成了一个西北-东南方向分布的污染带。     

码头港作机械大气污染物排放清单研究

目前,国内对于港口港作机械的大气污染物排放计算方法尚未开展深入研究。在国内外文献综合分析的基础上,结合上海港各类港作机械现状调研结果,对港作机械污染物排放计算方法进行了上海本地化校正,建立了2010年上海港码头港作机械大气污染物排放清单,并提出相应的排放减排措施和进一步完善排放计算方法的思路。     

On-board measurement of particle numbers and their size distribution from a light-duty diesel vehicle: Influences of VSP and altitude

In this study, the particle size-resolved distribution from a China-3 certificated light-duty diesel vehicle was measured by using a portable emission measurement system (PEMS). In order to examine the influences of vehicle specific power (VSP) and high-altitude operation, measurements were conducted at 8 constant speeds, which ranged from 10 to 80 km/hr at 10 km/hr intervals, and two different high altitudes, namely 2200 and 3200 m. The results demonstrated that the numbers of particles in all size ranges decreased significantly as VSP increased when the test vehicle was running at lower speeds (< 20 km/hr), while at a moderate speed (between 30 and 60 km/hr), the particle number was statistically insensitive to increase VSP. Under high-speed cruising conditions, the numbers of ultrafine particles and PM_2.5 were insensitive to changes in VSP, but the numbers of nanoparticles and PM₁₀ surged considerably. An increase in the operational altitude of the test vehicle resulted in increased particle number emissions at low and high driving speeds; however, particle numbers obtained at moderate speeds decreased as altitude rose. When the test vehicle was running at moderate speeds, particle numbers measured at the two altitudes were very close, except for comparatively higher number concentrations of nanoparticles measured at 2200 m.     

Constructed wetlands for wastewater treatment in cold climate — A review

Constructed wetlands (CWs) have been successfully used for treating various wastewaters for decades and have been identified as a sustainable wastewater management option worldwide. However, the application of CW for wastewater treatment in frigid climate presents special challenges. Wetland treatment of wastewater relies largely on biological processes, and reliable treatment is often a function of climate conditions. To date, the rate of adoption of wetland technology for wastewater treatment in cold regions has been slow and there are relatively few published reports on CW applications in cold climate. This paper therefore highlights the practice and applications of treatment wetlands in cold climate. A comprehensive review of the effectiveness of contaminant removal in different wetland systems including: (1) free water surface (FWS) CWs; (2) subsurface flow (SSF) CWs;and (3) hybrid wetland systems, is presented. The emphasis of this review is also placed on the influence of cold weather conditions on the removal efficacies of different contami-nants. The strategies of wetland design and operation for performance intensification, such as the presence of plant, operational mode, effluent recirculation, artificial aeration and in-series design, which are crucial to achieve the sustainable treatment performance in cold climate, are also discussed. This study is conducive to further research for the understanding of CW design and treatment performance in cold climate.     

Modeling the two-phase cloud evolution from instantaneous flashing release using CFD

Computational Fluid Dynamics (CFD) approach has been successfully applied to simulate the small-scale instantaneous flashing release experiment by Pettitt. A model for dispersion of the release event is provided based on relevant theories and existing experimental data. An application of the CFD method to the dispersion simulation is illustrated. Furthermore, a new methodology based on discrete phase model for setting computational initial conditions is provided. An initial expansion and subsequent turbulence dispersion can be characteristically identified from both volume and temperature variation of the cloud obtained by the simulation. The possible mechanism for these phenomena has also been discussed and analyzed. The study deepens the understanding of the physical process of this event and provides one more reliable tool for relevant safety systems.     

大气中二次有机气溶胶估算方法研究进展

大气中二次有机气溶胶产生于光化学反应或挥发性及半挥发性有机物的气-粒转化,目前没有直接测定二次有机气溶胶的方法,一般采用间接方法估算二次有机气溶胶的贡献.通过分析对比各种二次有机气溶胶估算方法的优缺点及应用条件,认为EC示踪法操作简单,参数容易获得,但参数的不确定性高; 化学迁移模型法能详细反映二次有机气溶胶形成情况,但所需参数不易获得; 有机物受体模型示踪法,不需要模拟复杂的情况,但难于保证成分谱的准确性及可靠性.因此,在选择估算方法时应充分考虑到各种方法的局限性及适用范围,将试验观测与环境空气质量模型联合用于二次有机气溶胶估算应成为今后重要的发展方向.     

Comparison of phenylpropanoid volatiles in male rectal pheromone gland after methyl eugenol consumption, and molecular phylogenetic relationship of four global pest fruit fly species: Bactrocera invadens, B. dorsalis, B. correcta and B. zonata

Males of many tephritid fruit fly species of the genus Bactrocera show a very strong affinity to methyl eugenol (ME). An attracted male compulsively ingests ME, which is then biotransformed before its metabolites are accumulated into the rectal gland. The glandular organ is known to serve as a reservoir for sex pheromone in some species. Upon ME-feeding, males of the oriental fruit fly, Bactrocera dorsalis, selectively accumulated two metabolites, 2-allyl-4,5-dimethoxyphenol (DMP) and (E)-coniferyl alcohol (E-CF), in the rectal pheromone gland. We compared the profiles of phenylpropanoid metabolites accumulated by three other species of very high economic and quarantine importance—Bactrocera invadens, Bactrocera zonata and Bactrocera correcta, with that of B. dorsalis. Males of each species were fed artificially on ME and the metabolites stored in the rectal glands were examined by means of chromatography and spectroscopy. Similar to B. dorsalis, males of laboratory-raised B. invadens accumulated DMP and E-CF, in almost equal quantities, in the rectal sac. The sum of DMP and E-CF increased gradually with time after ME consumption and reached as high as 150 μg/male 2 days post ME-feeding. Wild males of B. invadens captured in Kenya also possessed both the compounds in varying quantities. In contrast, males of B. zonata accumulated DMP and (Z)-coniferyl alcohol (Z-CF) in an approximate ratio of 1:1; whereas B. correcta is known to convert ME to (Z)-3,4-dimethoxycinnamyl alcohol (Z-DMC) and Z-CF also in an approximately 1:1 ratio. Thus, there are three types of binary combinations of rectal phenylpropanoid volatiles (i.e. DMP + E-CF; DMP + Z-CF; Z-CF + Z-DMC) utilized among the four Bactrocera species. Such differences in phenylpropanoid ingredients may play a critical role in differentiating these species if encountered in the natural habitat. In this context, the two putative sibling species—B. invadens and B. dorsalis, possess the identical subset of rectal volatiles (DMP and E-CF) in a similar proportion. Furthermore, the phylogenetic analyses of the four Bactrocera species by comparing nucleotide sequences in the mitochondrial genes showed that B. invadens clearly belonged to the same clade as B. dorsalis species. Therefore, we consider the two as the same biological species, and certainly not distinct.     

A steam dried municipal solid waste gasification and melting process

Considering high-moisture municipal solid waste (MSW) of China, a steam dried MSW gasification and melting process was proposed, the feasibility was tested, and the mass and energy balance was analyzed. Preliminary experiments were conducted using a fixed-bed drying apparatus, a 200 kg per day fluidized-bed gasifier, and a swirl melting furnace. Moisture percentage was reduced from 50% to 20% roughly when MSW was dried by slightly superheated steam of 150°C?C350°C within 40 min. When the temperature was less than 250°C, no incondensable gas was produced during the drying process. The gasifier ran at 550°C?C700°Cwith an air equivalence ratio (ER) of 0.2?C0.4. The temperature of the swirl melting furnace reached about 1240°C when the gasification ER was 0.3 and the total ER was 1.1. At these conditions, the fly ash concentration in the flue gas was 1.7 g·(Nm³)^?1, which meant over 95% fly ash was trapped in the furnace and discharged as slag. 85% of Ni and Cr were bound in the slag, as well as 60% of Cu. The mass and energy balance analysis indicates that the boiler heat efficiency of an industrial MSW incineration plant reaches 86.97% when MSW is dried by steam of 200°C. The boiler heat efficiency is sensitive to three important parameters, including the temperature of preheated MSW, the moisture percentage of dried MS Wand the fly ash percentage in the total ash.     

Source apportionment of ambient PM10 in urban areas of Wuxi, China

A total of 168 PM₁₀ samples were collected during the year of 2005 at eight sites in the city of Wuxi in China. Fifteen chemical elements, three water-soluble ions, total carbon and organic carbon were analyzed. Six source categories were identified and their contributions to ambient PM₁₀ in Wuxi were estimated using a nested chemical mass balance method that reduces the effects of colinearity on the chemical mass balance model. In addition, the concentrations of secondary aerosols, such as secondary organic carbon, sulfate and nitrate, were quantified. The spatially averaged PM₁₀ was high in the spring and winter (123 ??g·m^?3 and low in the summer-fall (90 ??g·m^?3). According to the result of source apportionment, resuspended dust was the largest contributor to ambient PM₁₀, accounting for more than 50% of the PM₁₀ mass. Coal combustion (14.6%) and vehicle exhaust (9.4%) were also significant source categories of ambient PM₁₀. Construction and cement dust, sulfates, secondary organic carbon, and nitrates made contributions ranging between 4.1% and 4.9%. Other source categories such as steel manufacturing dust and soil dust made low contributions to ambient PM₁₀.