纳米TiO2光催化-超滤法处理模拟二级出水

采用纳米TiO2光催化-超滤对模拟二级出水进行处理。分别考察了纳米TiO2光催化剂的投加量、光催化反应时间、光催化过程曝气量、膜出水通量以及回流比对废水中污染物去除率的影响。结果表明:光催化反应最优处理工况,纳米TiO2投加量250 mg/L、反应时间150 min、曝气量为1.0 L/min、膜出水通量为115 L/(m2·h)、错流过滤的回流比200%;在此工况条件下,出水的UV254和TOC的去除率分别为96%和84%。     

Heavy metal pollution and forest health in the Ukrainian Carpathians

The Ukrainian Carpathians are characterized by high air pollution caused by emissions from numerous industries. We have been monitoring the state of forests in this region since 1989. The highest levels of tree defoliation (>30%) are found close to industrial emission sources and in the upper mountain forests of the Ivano-Frankivsk and Chernivtsi regions. This is caused by a combination of strong anthropogenic influences (pollution, illegal uses, recreation) as well as poor site and climatic conditions. In the Ivano-Frankivsk region, Cd and Mo accumulate in forest soils; Cr, Mo and Zn soil concentrations are higher than their limit levels; and Pb concentrations exceed toxic levels close to industrial areas (10% of the region territory). Local background levels of heavy metals are greatly exceeded in snow close to industrial regions. Analysis of correlation matrices shows that the chemical elements Ba, Cd, Co, Cr, Cu, Mo, Ni, Pb, V and Zn occur at pollution levels in natural ecosystems in the Ukrainian Carpathians. Maximum concentrations of toxic elements occur in the oak forest zone; the most industrially developed area of the region. Toxic heavy metals in the Ukrainian Carpathians forests enter with precipitation and dustfall, then become fixed in soil and accumulate in leaves, needles of vascular plants and mosses. Concentrations of these metals decrease with altitude: highest in the oak forests, less in beech, and lowest in the spruce forest zones. However, some chemical elements have the highest concentrations in spruce forests; V in needles, As in snow, and Ba and Al in soils.     

Prediction for biodegradability of chemicals by an empirical flowchart

A method for predicting aerobic biodegradability of chemicals was developed based on empirical knowledge. A flowchart was derived from rule of thumb relationships between the biodegradability and the number of the functional groups and substructures in a certain skeletal structure of chemicals. The flowchart classified chemicals into readily biodegradable, not readily biodegradable and not predictable. It was validated by using MITI data of 177 mono benzene derivatives and 168 acyclic compounds, resulting in correct prediction at 94% and 88% levels, respectively.     

Identification of the dimethylbenzyl mercapturic acid in urine of rats administered with 1,2,4-trimethylbenzene

A study was undertaken of the mercapturic acid metabolism of 1,2,4-trimethylbenzene in the rat. Of three regioisomeric dimethylbenzyl mercapturic acids, i.e. 2,4-, 2,5- and 3,4-dimethylbenzyl isomers, the third isomer was not found in the urinary mercapturic acid isolated by preparative HPLC, from the comparison of NMR spectrum of the isolate with those of authentic specimens. The urinary mercapturate was then assigned to 2,4- and/or 2,5-dimethylbenzyl isomers. The excretion rate of the mercapturic acid was 14-20% of dose as 2,4-dimethylbenzyl isomer.     

重庆城市餐厨垃圾管理对策的初步研究

餐厨垃圾对环境的污染和人们身心健康的危害日益显现,重庆市对餐厨垃圾的统一管理与处置基本还处于空白状态.本文介绍了国内外餐厨垃圾管理的政策和措施,剖析重庆城市餐厨垃圾污染的现状及原因,进而提出全市餐厨垃圾管理的总体思路,并着重从健全法律法规体系、转变政府管理职能、建立市场化机制及引导公众参与等方面提出了相应的对策建议.     

Microwave regeneration of activated carbon used for removal of solvents from vented air

A microwave regeneration of activated carbon used to remove organic solvents from vented air has been investigated. Methyl ethyl ketone (MEK), acetone, and tetrachloroethylene (TCE) vapors were removed from vented air through adsorption onto granular activated carbon. The saturated carbon was then regenerated in a microwave field, where the solvent was quickly desorbed and recovered from the inner pores of the carbon granules. The microwave-induced regeneration restored the original adsorption capacity and surface area of the activated carbon.     

Effects of EDTA and low molecular weight organic acids on soil solution properties of a heavy metal polluted soil

A pot experiment was conducted to study the effects of EDTA and low molecular weight organic acids (LMWOA) on the pH, total organic carbon (TOC) and heavy metals in the soil solution in the rhizosphere of Brassica juncea grown in a paddy soil contaminated with Cu, Zn, Pb and Cd. The results show that EDTA and LMWOA have no effect on the soil solution pH. EDTA addition significantly increased the TOC concentrations in the soil solution. The TOC concentrations in treatments with EDTA were significantly higher than those in treatments with LMWOA. Adding 3 mmol kg(-1) EDTA to the soil markedly increased the total concentrations of Cu, Zn, Pb and Cd in the soil solution. Compared to EDTA, LMWOA had a very small effect on the metal concentrations. Total concentrations in the soil solution followed the sequence: EDTA > citric acid (CA) approximately oxalic acid (OA) approximately malic acid (MA) for Cu and Pb; EDTA > MA > CA approximately OA for Zn; and EDTA > MA > CA > OA for Cd. The labile concentrations of Cu, Zn, Pb and Cd showed similar trends to the total concentrations.     

Physiological responses involved in cadmium tolerance in a high-cadmium-accumulating rice (Oryza sativa L.) line

Environmental Science and Pollution Research - The disparity of tolerance in plants in response to Cd stress is associated with multiple physiological processes. A pot experiment was conducted to...     

燃煤烟气低温SCR脱硝中试研究

低温选择性催化还原(SCR)脱硝是国内外脱硝技术研发的热点,但目前主要集中在实验室小试范围,无法完全反映催化剂在实际烟气中的运行状况。在30 t/h循环流化床燃煤锅炉脱硫除尘装置后建设了2 000~5 000 m3/h的SCR脱硝中试装置,经系统研究发现,中试使用的蜂窝式催化剂对SO2和NO具有很强的吸附能力,且反应温度、喷氨速率和气体空速均会影响催化脱硝效率。为期5 d的连续运行实验结果表明,催化剂的脱硝效率一直稳定在30%~50%,并未发现明显的失活,这证明设计除雾除尘器、较大的混合器、混合器与反应器间较长的管路均有利于缓解催化剂因SO2、H2O和飞灰中的碱性金属导致的失活。