The ability of biological and organic synthetic materials to accumulate atmospheric particulates containing copper, lead, nickel and strontium

This work was aimed at finding materials that could be used as alternatives to lichens as air quality monitors since the high natural variability and the large amount of lichen collected are two drawbacks of the use of these organisms. Lichen Flavoparmelia caperata(L.) Hale was exposed in three different forms (transplant, detached from the substratum and as a biomass-ground and homogeneized) and compared to the planetree bark (Platanus hybrida Brot.), exposed as a biomass, and two organic synthetic materials (Chelex(R) 100 resin and cellulose acetate). Materials were exposed for two months in the winter, spring and summer, at three Portuguese coastal cities. The results showed that the airborne accumulations of Cu, Ni, Pb and Sr were partially dependent on the meteorological conditions but mainly dependent on the nature of the exposed material. The standard deviations of the synthetic materials or homogenized biomass were the same or greater than lichen transplants or detached. The accumulation by biological materials, of the four studied elements, was comparable to the lichen transplant accumulation. The replacement of the traditional transplants by the biomass was not considered advantageous, since their preparation is time-consuming. Therefore lichens remain the most suitable in biomonitoring studies. The exposure of detached lichen allows the accurate measurement of the exposed area/volume so it can be useful to relate atmospheric deposition rates with the lichen metal content. The synthetic materials accumulated Cu and Ni and should only be used as an alternative to traditional transplants when these are the elements of interest.     

Recycling extruded polystyrene by dissolution with suitable solvents

The amount of extruded polystyrene (XPS) waste has increased in recent years due to the increase of its use in the thermal insulation of buildings, transport vehicles, and refrigerators, among others. Dissolution with suitable solvents to achieve a volume reduction of more than 100 times without degradation of polymer chains is one of the cheapest and most efficient methods of recycling XPS. Several environmentally friendly solvents have been tested as dissolution agents for XPS volume reduction; the action of these solvents does not produce any degradation of polymer chains. The solubility of the polymer in such solvents at different temperatures was investigated. The solvent can be easily recycled by distillation, obtaining a high-quality recycled polymer. Chemical Feedstock Recycling & Other Innovative Recycling Techniques 6     

Occupational embeddedness and job performance

While researchers have recently focused their attention on organizational embeddedness, occupational embeddedness has received little theoretical and empirical attention. Using multisource data on 162 employees in multiple jobs and organizations, we found that occupational embeddedness is positively related to both task performance and creativity and is negatively related to counterproductive work behavior, even after controlling for the effects of organizational embeddedness. In addition, we found that trait affect moderated the relationships of occupational embeddedness to job performance. Occupational embeddedness was more strongly related to counterproductive work behavior when trait negative affect was high, while occupational embeddedness was more strongly related to both citizenship behavior and creativity when trait positive affect was high. Results also indicated that the various components of occupational embeddedness had different effects on job outcomes. Fit had a strong positive effect on core task performance, links had a positive effect on creativity, and sacrifice had a small positive effect on citizenship behavior. The article concludes with a discussion of implications for future research and management practice. Copyright © 2009 John Wiley & Sons, Ltd.     

Plant uptake of radiocaesium from artificially contaminated soil monoliths covering major European soil types

Uptake of ¹³⁷Cs was measured in different agricultural plant species (beans, lettuce, barley and ryegrass) grown in 5 undisturbed soil monoliths covering major European soil types. The first cultivation was made three years after soil contamination and plants were grown during 3 successive years. The plant–soil ¹³⁷Cs transfer factors varied maximally 12-fold among soils and 35-fold among species when grown on the same soil. Single correlations between transfer factors and soil properties were found, but they varied widely with plant type and can hardly be used as a predictive tool because of the few soils used. The variation of ¹³⁷Cs concentrations in plants among soils was related to differences in soil solution ¹³⁷Cs and K concentrations, consistent with previous observations in hydroponics and pot trials. Absolute values of transfer factors could not be predicted based on a model validated for pot trials. The ¹³⁷Cs activity concentration in soil solution decreased significantly (11- to 250-fold) for most soils in the 1997–1999 period and is partly explained by decreasing K in soil solution. Transfer factors of lettuce showed both increasing and decreasing trends between 2 consecutive years depending on soil type. The trends could be explained by the variation in ¹³⁷Cs and K concentrations in soil solution. It is concluded that differences in ¹³⁷Cs transfer factors among soils and trends in transfer factors as a function of time can be explained from soil solution composition, as shown previously for pot trials, although absolute values of transfer factors could not be predicted.     

Satellite observations of Mexico City pollution outflow from the Tropospheric Emissions Spectrometer (TES)

Concurrent tropospheric O₃ and CO vertical profiles from the Tropospheric Emission Spectrometer (TES) during the MILAGRO/INTEX-B aircraft campaigns over the Mexico City Metropolitan Area (MCMA) and its surrounding regions were used to examine Mexico City pollution outflow on a regional scale. The pollution outflow from the MCMA occurred predominantly at 600–800 hPa as evident in O₃, CO, and NO_x enhancements in the in situ aircraft observations. TES O₃ and CO are sensitive to the MCMA pollution outflow due to their relatively high sensitivities at 600–800 hPa. We examined O₃, CO, and their correlation at 600–800 hPa from TES retrievals, aircraft measurements, and GEOS-Chem model results. TES captures much of the spatial and day-to-day variability of O₃ seen in the in situ data. TES CO, however, shows much less spatial and day-to-day variability compared with the in situ observations. The ΔO₃/ΔCO slope is significantly higher in the TES data (0.43) than the in situ data (0.28) due partly to the lack of variability in TES CO. Extraordinarily high ΔO₃/ΔCO slope (0.81) from TES observations at 618 hPa over the Eastern U.S. was previously reported by Zhang et al. [Zhang, L., Jacob, D.J., Bowman, K.W., et al., 2006. Ozone–CO correlations determined by the TES satellite instrument in continental outflow regions. Geophys. Res. Lett. 33, L18804. 10.1029/2006GL026399.]. Thus the application of TES CO–O₃ correlation to map continental pollution outflow needs further examination.     

Monitoring of polychlorinated biphenyl contamination and estrogenic activity in water, commercial feed and farmed seafood

We evaluated the concentration and congener distribution of seven "target" polychlorinated biphenyls (PCBs) present in water collected in different aquaculture farms of the Mediterranean area, commercial feeds, and farmed seafood. PCBs were present in feed and in tissues of all the analysed organisms at levels ranging from 1.96 ng g(-1) to 124.00 ng g(-1) wet weight, and in 10.5% of the water samples, at levels from under detection limit to 33.0 ng l(-1) with total PCB concentrations significantly higher in samples from the Tyrrhenian Sea than the Adriatic Sea. PCB congener distribution in tissues resembled that of feed, suggesting that commercial feed is an important source of PCBs. The estrogenicity of organic extracts of the samples was also evaluated by using an in vitro yeast reporter assay. Estrogenic activity higher than 10% of the activity induced by 10 nM 17 beta-estradiol was observed in 20.0% of seafood samples and 15.8% of water samples. Seafood and water samples from the Tyrrhenian Sea were more frequently estrogenic than the Adriatic ones (16.45 versus 4.08%). A significant correlation of total PCB concentrations on biological activity was observed for sea bass and mussels from the Adriatic Sea (p < 0.045 and p < 0.04, respectively), and for sea bass of the Tyrrhenian Sea (p = 0.05). These results indicate the need of an integral approach in the exposure assessment to potential toxic compounds for human via food.     

Long work hours: a social identity perspective on meta‐analysis data

The current study utilizes social identity theory to investigate employees' work hours. Specifically, we use meta‐analysis to examine the relationships between hours worked and indicators of organizational identity (e.g., organizational support and tenure), occupational identity (e.g., human capital investments and work centrality), and family identity (e.g., family responsibilities and family satisfaction). The meta‐analysis also allowed us to explore other important correlates of hours worked (e.g., situational demands, job performance, mental health, and physical health), moderating variables (e.g., age, gender, and job complexity), and curvilinear relationships of work hours to social identity indicators. Overall, we found that occupational factors and situational demands had the strongest relationships with hours worked, hours worked were negatively associated with measures of employee well‐being, gender had several significant moderating effects, and there were curvilinear relationships between hours worked and well‐being and work–family conflict variables. The article concludes with directions for future theoretical and empirical research. Copyright © 2008 John Wiley & Sons, Ltd.     

Kinetic of carbonaceous substrate in an upflow anaerobic sludge sludge blanket (UASB) reactor treating 2,4 dichlorophenol (2,4 DCP)

The performance of an upflow anaerobic sludge blanket (UASB) reactor treating 2,4 dichlorophenol (2,4 DCP) was evaluated at different hydraulic retention times (HRTs) using synthetic wastewater in order to obtain the growth substrate (glucose-COD) and 2,4 DCP removal kinetics. Treatment efficiencies of the UASB reactor were investigated at different hydraulic retention times (2-20 h) corresponding to a food to mass (F/M) ratio of 1.2-1.92 g-COD g(-1) VSS day(-1). A total of 65-83% COD removal efficiencies were obtained at HRTs of 2-20 h. In all, 83% and 99% 2,4 DCP removals were achieved at the same HRTs in the UASB reactor. Conventional Monod, Grau Second-order and Modified Stover-Kincannon models were applied to determine the substrate removal kinetics of the UASB reactor. The experimental data obtained from the kinetic models showed that the Monod kinetic model is more appropriate for correlating the substrate removals compared to the other models for the UASB reactor. The maximum specific substrate utilization rate (k) (mg-COD mg(-1) SS day(-1)), half-velocity concentration (K(s)) (mg COD l(-1)), growth yield coefficient (Y) (mg mg(-1)) and bacterial decay coefficient (b) (day(-1)) were 0.954 mg-COD mg(-1) SS day(-1), 560.29 mg-COD l(-1), 0.78 mg-SS g(-1)-COD, 0.093 day(-1) in the Conventional Monod kinetic model. The second-order kinetic coefficient (k(2)) was calculated as 0.26 day(-1) in the Grau reaction kinetic model. The maximum COD removal rate constant (U(max)) and saturation value (K(B)) were calculated as 7.502 mg CODl(-1)day(-1) and 34.56 mg l(-1)day(-1) in the Modified Stover-Kincannon Model. The (k)(mg-2,4 DCP mg(-1) SS day(-1)), (K(s)) (mg 2,4 DCPl(-1)), (Y) (mg SS mg(-1) 2,4 DCP) and (k(d)) (day(-1)) were 0.0041 mg-2,4 DCP mg(-1) SS day(-1), 2.06 mg-COD l(-1), 0.0017 mg-SS mg(-1) 2,4 DCP and 3.1 x 10(-5) day(-1) in the Conventional Monod kinetic model for 2,4 DCP degradation. The second-order kinetic coefficient (k(2)) was calculated as 0.30 day(-1) in the Grau reaction kinetic model. The maximum 2,4 DCP removal rate constant (U(max)) and saturation value (K(B)) were calculated as 0.01 mg COD l(-1) day(-1) and 9.8 x 10(-3) mg l(-1) day(-1) in the Modified Stover-Kincannon model.