In the present study, a land suitability assessment was conducted in the basin of four Uruguayan coastal lagoons (Southwestern Atlantic) to analyze the productive development while minimizing eutrophication, biodiversity loss and conflicts among different land uses. Suitable land for agriculture, forest, livestock ranching, tourism and conservation sectors were initially established based on a multi-attribute model developed using a geographic information system. Experts were consulted to determine the requirements for each land use sector and the incompatibilities among land use types. The current and potential conflicts among incompatible land use sectors were analyzed by overlapping land suitability maps. We subsequently applied a multi-objective model where land (pixels) with similar suitability was clustered into "land suitability groups", using a two-phase cluster analysis and the Akaike Information Criterion. Finally, a linear programming optimization procedure was applied to allocate land use sectors into land suitable groups, maximizing total suitability and minimizing interference among sectors. Results indicated that current land use overlapped by 4.7?% with suitable land of other incompatible sectors. However, the suitable land of incompatible sectors overlapped in 20.3?% of the study area, indicating a high potential for the occurrence of future conflict. The highest competition was between agriculture and conservation, followed by forest and agriculture. We explored scenarios where livestock ranching and tourism intensified, and found that interference with conservation and agriculture notably increased. This methodology allowed us to analyze current and potential land use conflicts and to contribute to the strategic planning of the study area. 相似文献
We use GEOS-Chem chemical transport model simulations of sulfate–ammonium aerosol data from the NASA ARCTAS and NOAA ARCPAC aircraft campaigns in the North American Arctic in April 2008, together with longer-term data from surface sites, to better understand aerosol sources in the Arctic in winter–spring and the implications for aerosol acidity. Arctic pollution is dominated by transport from mid-latitudes, and we test the relevant ammonia and sulfur dioxide emission inventories in the model by comparison with wet deposition flux data over the source continents. We find that a complicated mix of natural and anthropogenic sources with different vertical signatures is responsible for sulfate concentrations in the Arctic. East Asian pollution influence is weak in winter but becomes important in spring through transport in the free troposphere. European influence is important at all altitudes but never dominant. West Asia (non-Arctic Russia and Kazakhstan) is the largest contributor to Arctic sulfate in surface air in winter, reflecting a southward extension of the Arctic front over that region. Ammonium in Arctic spring mostly originates from anthropogenic sources in East Asia and Europe, with added contribution from boreal fires, resulting in a more neutralized aerosol in the free troposphere than at the surface. The ARCTAS and ARCPAC data indicate a median aerosol neutralization fraction [NH4+]/(2[SO42?] + [NO3?]) of 0.5 mol mol?1 below 2 km and 0.7 mol mol?1 above. We find that East Asian and European aerosol transported to the Arctic is mostly neutralized, whereas West Asian and North American aerosol is highly acidic. Growth of sulfur emissions in West Asia may be responsible for the observed increase in aerosol acidity at Barrow over the past decade. As global sulfur emissions decline over the next decades, increasing aerosol neutralization in the Arctic is expected, potentially accelerating Arctic warming through indirect radiative forcing and feedbacks. 相似文献
Chemical emissions from research and development (R&D) activities are difficult to estimate because of the large number of chemicals used and the potential for continual changes in processes. In this case study, stack measurements taken from R&D facilities at Pacific Northwest National Laboratory (PNNL) were examined, including extreme worst-case emissions estimates and alternate analyses using a Monte Carlo method that takes into account the full distribution of sampling results. The objective of this study was to develop techniques to estimate emissions from stack measurement data that take into account a high degree of variability in the actual emissions. The results from these analyses were then compared to emissions estimated from chemical inventories. Results showed that downwind ambient air concentrations calculated from the stack measurement data were below acceptable source impact levels (ASILs) for almost all compounds, even under extreme worst-case analyses. However, for compounds with averaging periods of a year, the unrealistic but simplifying extreme worst-case analysis often resulted in calculated emissions that were above the lower level regulatory criteria used to determine modeling requirements or to define trivial releases. Compounds with 24-hr averaging periods were nearly all several orders of magnitude below all, including the trivial release, criteria. The alternate analysis supplied a more realistic basis of comparison and an ability to explore effects under different operational modes.
Implications:
Air emissions from research operations are difficult to estimate because of the changing nature of research processes and the small quantity and wide variety of chemicals used. Stack measurements can be used to verify compliance with applicable regulatory criteria. This study shows that while extreme worst-case assumptions can be used for a relatively simple initial comparison, methods that take into account the full range of measurement data are needed to provide a more realistic estimate of emissions for comparison to regulatory criteria, particularly those criteria that define trivial levels of environmental concern.相似文献
Time series of polychlorinated dioxins and furans (PCDD/F) and polychlorinated biphenyls (PCB) in ambient air of a large conurbation in North-Western Germany are presented and analyzed. The trend of PCDD/F concentrations, starting from as early as 1988, shows a pronounced decrease by at least one order of magnitude, demonstrating that the emission reductions were effective. The PCDD/F depositions also have decreased by a factor of 5 since 1992. However, both trends have leveled out since 2005. Time series of PCB concentrations and depositions starting in 1994 show only slight decreases for the concentrations and almost no decrease for the depositions. From the decay rates following first order kinetics, half-lives in the order of 5-15 years for the PCDD/F and 15-31 years for the sum of the six indicator PCB could be calculated, which are much longer than the half-lives estimated from their reactivity towards the OH radical. Apparently, small fresh emissions (PCDD/F), considerable secondary emissions and evaporation from contaminated soils slow down their decay in the atmosphere of big conurbations. Analyzing the decay rates of individual PCB congeners shows that the lower chlorinated and more volatile ones are removed faster than the higher chlorinated congeners, probably via gas phase reactions with the OH radical. It can be concluded from the present study that the input of PCDD/F and PCB into the food chain via the air path will continue for another one or two decades in big conurbations. 相似文献
Concentrations of heavy metals were determined in the water column (including the sea-surface microlayer, subsurface, mid-depth
and bottom water) and sediments from Singapore’s coastal environment. The concentration ranges for As, Cd, Cr, Cu, Ni, Pb
and Zn in the seawater dissolved phase (DP) were 0.34–2.04, 0.013–0.109, 0.07–0.35, 0.23–1.16, 0.28–0.78, 0.009–0.062 and
0.97–3.66 μg L−1 respectively. The ranges for Cd, Cr, Cu, Ni, Pb and Zn in the suspended particulate matter (SPM) were 0.16–0.73, 6.72–53.93,
12.87–118.29, 4.34–60.71, 1.10–6.08 and 43.09–370.49 μg g−1, respectively. Heavy metal concentrations in sediments ranged between 0.054–0.217, 37.48–50.52, 6.30–21.01, 13.27–26.59,
24.14–37.28 and 48.20–62.36 μg g−1 for Cd, Cr, Cu, Ni, Pb and Zn, respectively. The lowest concentrations of metals in the DP and SPM were most frequently found
in the subsurface water while the highest concentrations were mostly observed in the SML and bottom water. Overall, heavy
metals in both the dissolved and particulate fractions have depth profiles that show a decreasing trend of concentrations
from the subsurface to the bottom water, indicating that the prevalence of metals is linked to the marine biological cycle.
In comparison to data from Greece, Malaysia and USA, the levels of metals in the DP are considered to be low in Singapore.
Higher concentrations of particulate metals were reported for the Northern Adriatic Sea and the Rhine/Meuse estuary in the
Netherlands compared to values reported in this study. The marine sediments in Singapore are not heavily contaminated when
compared to metal levels in marine sediments from other countries such as Thailand, Japan, Korea, Spain and China. 相似文献
Before waste-water-relevant organic materials are to be found in large quantities, their specific behavior in sewage treatment plants must be known. With the aid of the OECD simulation test #303 A, an estimation of their elimination in biological clarification stages can be made. In this work, an economical and continuous testing system is presented, which consists of a polyester flies bound to an activated biosludge with a high inoculum density, allowing one to measure no only the elimination of individual substances, but also the specific degree of mineralization. The toxicity of the activated biosludge and the nitrifying substances can also be examined. With the described testing procedure, it is possible to determine the rate of degradation within only a few hours. Finally, it can also be seen that it is possible to reliably and continuously determine the rate of anaerobic, biological degradability through the use of such a modified testing procedure. 相似文献
Female ornaments in species with conventional sex roles often indicate individual quality, but the evolutionary forces maintaining
them are less clear. Sexual competition for breeding opportunities may represent an important role for female signals, especially
in polygynous species, but there is little experimental evidence for this. The wing patch size (WPS) of female collared flycatchers
indicates age and body condition and predicts social mating patterns. We challenged nest-building females with decoy females
of varying WPS and found that the aggressive response of residents increased with decoy WPS, suggesting a role for this female
ornament in territorial competition. Our results explain why female WPS predicts territorial distances when mated to a polygynous
male and indicate that the role of WPS in female competitive interactions is similar to that in males of the same population. 相似文献