Anatomical localization and stereoisomeric composition of <Emphasis Type="Italic">Tribolium castaneum</Emphasis> aggregation pheromones

We report that the abdominal epidermis and associated tissues are the predominant sources of male-produced pheromones in the red flour beetle, Tribolium castaneum and, for the first time, describe the stereoisomeric composition of the natural blend of isomers of the aggregation pheromone 4,8-dimethyldecanal (DMD) in this important pest species. Quantitative analyses via gas chromatography–mass spectrometry showed that the average amount of DMD released daily by single feeding males of T. castaneum was 878 ± 72 ng (SE). Analysis of different body parts identified the abdominal epidermis as the major source of aggregation pheromone; the thorax was a minor source, while no DMD was detectable in the head. No internal organs or obvious male-specific glands were associated with pheromone deposition. Complete separation of all four stereoisomers of DMD was achieved following oxidation to the corresponding acid, derivatization with (1R, 2R)- and (1S, 2S)-2-(anthracene-2,3-dicarboximido)cyclohexanol to diastereomeric esters, and their separation on reversed-phase high-performance liquid chromatography at −54°C. Analysis of the hexane eluate from Porapak-Q-collected volatiles from feeding males revealed the presence of all four isomers (4R,8R)/(4R,8S)/(4S,8R)/(4S,8S) at a ratio of approximately 4:4:1:1. A walking orientation bioassay in a wind tunnel with various blends of the four synthetic isomers further indicated that the attractive potency of the reconstituted natural blend of 4:4:1:1 was equivalent to that of the natural pheromone and greater than that of the 1:1 blend of (4R,8R)/(4R,8S) used in commercial lures.     

Impact analysis of drought, water excess and salinity on grass production in The Netherlands using historical and future climate data

The coupled SWAP-WOFOST model was used to study the effects of increasing salinity of groundwater, drought and water excess on grass production in The Netherlands. WOFOST simulates crop growth and SWAP simulates transport of water, solutes and heat in the vadose zone. The model was tested using several datasets from field experiments. We applied the models at regional scale where we quantified the impact of various groundwater salinity levels on grass growth and production using historical weather data (1971-2000). The salt concentrations in the subsoil were derived from the National Hydrological Instrument. The results show that salinity effects on grass production are limited. In wet years the excess rainfall will infiltrate the soil and reduce salt water seepage. In a next step we used future weather data for the year 2050, derived from 3 Global Circulation Models. From each model we used data from two CO₂ emission scenarios. As expected higher temperatures increased drought stress, however, the production reduction as a result of salt water in the root zone is limited. Salt stress mainly occurred when irrigation was applied with saline water. The increased CO₂ concentration in combination with the limited drought stress resulted in increasing simulated actual and potential yields. Overall conclusion for grassland in The Netherlands: drought stress is stronger than stress caused by water excess which on its turn is stronger than salinity stress. Future water demand for irrigation may increase by 11-19% and result in water scarcity if water supply is insufficient.     

Sustainability issues in sheet metal forming processes: an overview

Environmental sustainability in manufacturing is nowadays an urgent and remarkable issue and the main concerns are related to more efficient use of materials and energy.In sheet metal forming processes there is still a lack of knowledge in this field mainly due to the need of a proper modelling of sustainability issues and factors to be taken into account. The aim of this paper is mainly to underline the state of the art from a forming point of view about the sustainability contributions offered in any phase of a product life cycle. Actually, a lack in terms of comprehensive contributions is present in the technical literature, thus, the authors try to give a sort of holistic vision aimed to provide basic guidelines in order to help in identifying the possible solutions with regard to all the phases of a forming product life cycle. The main attention was paid to sheet metal forming technologies. The paper gives an overview of the main topics concerning sheet metal forming problems related to energy and resource efficiency with the aim to stress the principal contributions which may derive from such processes to environmental performances of manufacturing.     

An environmental impact assessment of quantum dot photovoltaics (QDPV) from raw material acquisition through use

Some emerging technologies are expected to be pivotal for solving many of the environmental challenges faced today, especially those related to energy. However, many of these technologies may incur significant environmental impacts over their life cycle, while having environmental benefits during their use. This paper presents results of a Life Cycle Assessment (LCA) of a proposed type of nanophotovoltaic, quantum dot photovoltaic (QDPV) module. The LCA is confined to the stages of raw materials acquisition, manufacturing, and use. The impacts of QDPV are compared with other types of PV modules and energy sources - both renewable and nonrenewable. To provide a comprehensive comparative assessment, QDPV modules were compared with mature as well as emerging PV types for which data are available. Comparative assessment with other types of energy sources includes coal, oil, lignite, natural gas, diesel, nuclear, wind, and hydropower.QDPV modules may have the potential to overcome two current barriers of solar technology: low efficiencies and high manufacturing costs. If higher efficiencies are realized, QDPV modules could pave the way to large scale implementation of solar energy, helping nations move toward greater energy independence. On the other hand, candidate materials as quantum dots for solar cell applications are mostly compound semiconductors such as cadmium selenide, cadmium telluride, and lead sulfide which may be toxic and for which renewable options are limited. Toxic effects of these materials may be exacerbated by their nanoscale features.The LCA was carried out using the software SimaPro, and the Ecoinvent Life Cycle Inventory (LCI) database supplemented with available literature and patent information. Our results indicate that while QDPV modules have shorter Energy PayBack Time (EPBT), lower Global Warming Potential (GWP), SO_x and NO_x emissions than other types of PV modules, they have higher heavy metal emissions, underscoring the need for investigation of emerging technologies, especially nano-based ones, from a life cycle perspective. QDPV modules are better in all impact categories assessed than carbon-based energy sources but they have longer EPBT than wind and hydropower and higher GWP.     

Health implications of radon distribution in living rooms and bedrooms in U.K. dwellings--a case study in Northamptonshire

Environmental radon exposure of residents of domestic premises in the United Kingdom (UK) and elsewhere in Europe is estimated on the basis of the measured radon concentrations in, and the relative occupancies of, the principal living room and bedroom. While studies on radon concentration variability in the individual units in apartment blocks in various countries have been described, little data has been reported on variability in two-storey single-family dwellings, and the majority of extant studies consolidate living room and bedroom data early in the analysis. To investigate this further, detailed analysis was made of radon concentration data from a set of thirty-four homes situated in areas of Northamptonshire known to exhibit high radon levels. All homes were of typical UK construction of brick/block/stone walls under a pitched tile/slate roof. Approximately 50% of the sample were detached houses, the remainder being semi-detached (duplex) or terraced (row-house). Around 25% of the sample possessed cellars, while 12% were single-storey dwellings (bungalows), reflecting the typical incidence of this type of dwelling in England. In the two-storey homes, all monitored bedrooms were on the upper floor. Distribution of the ratios of bedroom/living room radon concentrations (BR/LR ratio) in individual properties was left-skewed (mean 0.67, median 0.73, range 0.05-1.05) with a tail extending to just above 1.0. The mean is consistent with the outcome of earlier extensive studies in England, while the variability depends principally on the characteristics of the property, and not on seasonal factors. In a small set of homes, the BR/LR ratio was anomalously low, (mean 0.3). BR/LR ratios in single-storey homes clustered around a value of 1.0, indicating that house design, rather than lifestyle, is the dominant factor in determining bedroom radon concentrations. Homes with higher mean annual radon concentrations showed lower BR/LR ratios, supporting our proposal that, in some homes, radon emanation from building materials may comprise a significant component of the overall radon level.     

Trends in the spatial and temporal distribution of 129I and 99Tc in coastal waters surrounding Ireland using Fucus vesiculosus as a bio-indicator

Spatial and temporal trends in (129)I and (99)Tc concentrations around the Irish coastline have been evaluated using Fucus vesiculosus as a bio-indicator. (129)I concentrations in a recent set of seawater samples have also been recorded and reveal an identical spatial pattern. Concentrations of (129)I in Fucus from the northeast coast of Ireland proved to be at least two orders of magnitude higher than concentrations in Fucus from the west coast. The (129)I content of Fucus increased significantly between 1985 and 2003, in line with increases in discharges of (129)I from the Sellafield nuclear reprocessing plant. Similar trends were observed in the case of (99)Tc. (129)I/(99)Tc ratios in Irish seawater were deduced from the Fucus data, and compared to ratios in discharges from Sellafield and from the French reprocessing plant at Cap de la Hague. Levels of (129)I and (99)Tc in Fucus from the west coast were found to be enhanced with respect to levels in seaweeds from other regions in the Northern Hemisphere unaffected by discharges from nuclear installations such as those referred to.     

Intra-cultivar variability of the soil-to-grain transfer of fallout 137Cs and 90Sr for winter wheat

Differences between the root uptake of fallout radionuclides by different cultivars ('inter-cultivar' variability) growing on the same field may be influenced not only by genetic differences of the cultivars, but also by the spatial variability of the soil-to-grain transfer within the cultivation area of each cultivar. This 'intra-cultivar' variability was investigated in 2001 and 2002 for 137Cs and 90Sr using three winter wheat cultivars with four replicates for each cultivar at three different sites in Bavaria, Germany. The intra-cultivar variability proved to be in the same range as the inter-cultivar variability which was determined earlier at the same sites for both radionuclides. An ANOVA of the 137Cs data set revealed that the variability of the 137Cs soil-to-grain transfer was caused by the soil and climate (year) at the field sites and the interaction of cultivar and field. A significant contribution of the factor 'cultivar' alone to the variability could not be detected. This may be due to the complex environmental conditions to which plants are exposed in field experiments. To find wheat cultivars with minimal uptake of fallout radionuclides it may be better to examine the molecular mechanisms of their root uptake in order to identify targets for breeding "safer" plants.     

A review of research on the environmental impact of e-business and ICT

This paper attempts to provide a review of the current state of the art of how e-business/ICT affects the environment. The work reviewed is in various forms including journal papers and thesis which have been peer-reviewed, as well as other resources such as projects and project reports, conference and symposia, and websites. It is claimed that the research examined has captured the most important work to date, either for a general knowledge of this new area or for background study by experts carrying out future research. The review has found that the currently dominant approach is either a micro-level case study approach or a macro-level statistical approach. It is concluded that a more predictive and empirical model, which can be applied within a sector of society, should be more beneficial in the long term. This approach should help simulate potential impacts resulting from changes of indicators, so that positive effects can be promoted and negative ones alleviated proactively, rather than knowing and accepting outcomes passively.     

Evaluation of the usefulness of bird feathers as a non-destructive biomonitoring tool for organic pollutants: a comparative and meta-analytical approach

In this study, we investigated whether bird feathers can be used as a non-destructive biomonitor for organic pollutants. We analysed the outermost tail feathers of 8 terrestrial and aquatic bird species from Belgium (8 species, n=108) for polychlorinated biphenyls (PCBs), polybrominated diphenyl ethers (PBDEs) and organochlorine pesticides (OCPs). Every compound class could be quantified in one single tail feather of the birds under study (sum PCBs ranging from 5.5 to 510 ng/g feather, sum PBDEs from 0.33 to 53 ng/g feather, sum DDTs from 1.5 to 730 ng/g feather), except for PBDEs in feathers of the common moorhen (Gallinula chloropus). Further, we calculated Pearson correlations between concentrations of organic pollutants in feathers and concentrations in corresponding muscle or liver tissue from the birds. Correlations were found significant in half of the cases of the terrestrial species, but were found not significant for the aquatic species, with the exception of a significant correlation of sum PCBs in the common moorhen. Only for the common buzzard (Buteo buteo) (n=43) all correlations were found significant (0.32相似文献   

Perfluorinated chemicals in blood of residents in Catalonia (Spain) in relation to age and gender: a pilot study

Fluorinated organic compounds (FOCs) are a group of chemicals widely used as surfactants, lubricants, polymers, and fire-fighting foams. Recent studies have shown the ubiquitous distribution of FOCs in the environment, wildlife, and humans. We here report the results of a pilot study conducted to provide preliminary data on the levels of 13 FOCs in the blood of 48 residents in Catalonia, Spain, in relation to gender and age (25+/-5 and 55+/-5 years). The highest mean concentration was obtained for perfluorooctane sulfonate (PFOS, 7.64 ng/ml), followed by perfluorohexane sulfonate (PFHxS, 3.56 ng/ml) and perfluorooctanoic acid (PFOA, 1.80 ng/ml). Four other FOCs showed mean levels between 0.30 and 0.44 ng/ml, whereas those of the remaining 6 compounds were below the detection limit. Regarding gender, the blood levels of PFHxS and PFOA were significantly higher (p<0.05) in men than in women, while differences according to age were only noted for PFHxS (p<0.05) and perfluorooctane sulfonamide (PFOSA) (p<0.001), for which the levels were higher in the younger (25+/-5 years) group of subjects. A significant correlation between PFOS levels and those of the remaining detected FOCs (except PFDA) was found. In general terms, the current FOC concentrations were lower than those found in recent studies concerning levels of these chemicals in human blood and serum of subjects from different countries.