Evaluation of a Watershed Model for Estimating Daily Flow Using Limited Flow Measurements1

Abstract: The Soil and Water Assessment Tool (SWAT) model was evaluated for estimation of continuous daily flow based on limited flow measurements in the Upper Oyster Creek (UOC) watershed. SWAT was calibrated against limited measured flow data and then validated. The Nash‐Sutcliffe model Efficiency (NSE) and mean relative error values of daily flow estimations were 0.66 and 15% for calibration, and 0.56 and 4% for validation, respectively. Also, further evaluation of the model’s estimation of flow at multiple locations was conducted with parametric paired t‐test and nonparametric sign test at a 95% confidence level. Among the five main stem stations, four stations were statistically shown to have good agreement between predicted and measured flows. SWAT underestimated the flow of the fifth main stem station possibly because of the existence of complex flood control measures near to the station. SWAT estimated the daily flow at one tributary station well, but with relatively large errors for the other two tributaries. The spatial pattern of predicted flows matched the measured ones well. Overall, it was concluded from the graphical comparisons and statistical analyses of the model results that SWAT was capable of reproducing continuous daily flows based on limited flow data as is the case in the UOC watershed.     

Choosing a Food Future: Differentiating Among Alternative Food Options

This article examines the diversity of food networks that fit within the alternative food system of the United States. While farmers’ markets, community supported agriculture schemes, and corporate organic food markets all fit within the alternative food system, they differ greatly in the conventions and beliefs that they represent. The alternative food system has divided into two movements: corporate, weak alternative food networks; and local, strong alternative food networks. The weak corporate version focuses on protecting the environment; however, it neglects issues concerning labor standards, animal welfare, rural communities, small-scale farmers, and human health. Local, strong alternative food networks not only assure environmental protection, but they also address the issues that weak alternatives neglect. Using three case studies from the Washington, D.C. metro area, the author explains that strong alternative food networks are better suited to create social and political change because they challenge the foundations of the conventional food system: standardized and generic products, price-based competition, consolidated power, and global scale. To affect true social and political change in the United States, the author recommends supporting strong alternative food networks by creating the requisite cultural and political space for them to succeed.     

Convergence of Culture, Ecology, and Ethics: Management of Feral Swamp Buffalo in Northern Australia

This paper examines the identity of Asian swamp buffalo (Bubalus bubalis) from different value orientations. Buffalo were introduced into Northern (Top End) Australia in the early nineteenth century. A team of transdisciplinary researchers, including an ethicist, has been engaged in field research on feral buffalo in Arnhem Land over the past three years. Using historical documents, literature review, field observations, interviews with key informants, and interaction with the Indigenous land owners, an understanding of the diverse views on the scientific, cultural, and economic significance of buffalo was obtained. While the diverse stakeholders in buffalo exploitation and management have historically delivered divergent value orientations on the nature of the human–buffalo relationship, we argue that over time there is the possibility of values and ethical convergence. Such convergence is possible via transdisciplinary and transcultural agreement on the value stances that constitute the construction of the being or identity of buffalo in the face of the overwhelming need to manage population density and gross numbers.     

Investigations on CO2 storage capacity in saline aquifers—Part 2: Estimation of storage capacity coefficients

Many studies on geological carbon dioxide (CO₂) storage capacity neglect the influence of complex coupled processes which occur during and after the injection of CO₂. Storage capacity is often overestimated since parts of the reservoirs cannot be reached by the CO₂ plume due to gravity segregation and are thus not accessible for storage. This work investigates the effect of reservoir parameters like depth, temperature, absolute and relative permeability, and capillary pressure on the processes during CO₂ injection and thus on estimates of effective storage capacity. The applied statistical characteristics of parameters are based on a large reservoir parameter database. Different measured relative permeability relations are considered. The methodology of estimating storage capacity is discussed. Using numerical 1D and 3D experiments, detailed time-dependent storage capacity estimates are derived. With respect to the concept developed in this work, it is possible to estimate effective CO₂ storage capacity in saline aquifers. It is shown that effective CO₂ mass stored in the reservoir varies by a factor of 20 for the reservoir setups considered. A high influence of the relative permeability relation on storage capacity is shown.     

Model-based prediction of long-term leaching of contaminants from secondary materials in road constructions and noise protection dams

In this study, contaminant leaching from three different secondary materials (demolition waste, municipal solid waste incineration ash, and blast furnace slag) to groundwater is assessed by numerical modeling. Reactive transport simulations for a noise protection dam and a road dam (a typical German autobahn), in which secondary materials are reused as base layers, were performed to predict the breakthrough of a conservative tracer (i.e., a salt) and sorbing contaminants (e.g., PAHs like naphthalene and phenanthrene or heavy metals) at the groundwater table. The dam constructions have a composite architecture with soil covers in inclined layers and distinct contrasts in the unsaturated hydraulic properties of the used materials. Capillary barrier effects result in strong spatial variabilities of flow and transport velocities. Contaminant breakthrough curves at the groundwater table show significant tailing due to slow sorption kinetics and a wide distribution of travel times. While conservative tracer breakthrough depends primarily on subsoil hydraulic properties, equilibrium distribution coefficients and sorption kinetics represent additional controlling factors for contaminant spreading. Hence, the three secondary materials show pronounced differences in the temporal development of leached contaminant concentrations with consequences for breakthrough times and peak concentrations at the groundwater table. Significant concentration reductions due to dispersion occur only if the source concentrations decrease significantly prior to the arrival of the contaminant at the groundwater table. Biodegradation causes significant reduction of breakthrough concentrations only if flow velocities are low.     

Geopolymerisation of silt generated from construction and demolition waste washing plants

Recycling plants that size, sort and wash construction and demolition waste can produce high quality aggregate. However, they also produce up to 80ton per hour of filter cake waste containing fine (<63mum) silt particles that is classified as inert waste and normally landfilled. This research investigated the potential to form geopolymers containing silt, which would allow this problematic waste to be beneficially reused as aggregate. This would significantly improve the economic viability of recycling plants that wash wastes. Silt filter cakes have been collected from a number of aggregate washing plants operating in the UK. These were found to contain similar aluminosilicate crystalline phases. Geopolymer samples were produced using silt and silt mixed with either metakaolin or pulverised fuel ash (PFA). Silt geopolymers cured at room temperature had average 7-day compressive strengths of 18.7MPa, while partial substitution of silt by metakaolin or PFA increased average compressive strengths to 30.5 and 21.9MPa, respectively. Curing specimens for 24h at 105 degrees C resulted in a compressive strength of 39.7MPa and microstructural analysis confirmed the formation of dense materials. These strengths are in excess of those required for materials to be used as aggregate, particularly in unbound applications. The implications of this research for the management of waste silt at construction and demolition waste washing plants are discussed.     

Municipal solid waste management in Rasht City, Iran

Pollution and health risks generated by improper solid waste management are important issues concerning environmental management in developing countries. In most cities, the use of open dumps is common for the disposal of wastes, resulting in soil and water resource contamination by leachate in addition to odors and fires. Solid waste management infrastructure and services in developing countries are far from achieving basic standards in terms of hygiene and efficient collection and disposal. This paper presents an overview of current municipal solid waste management in Rasht city, Gilan Province, Iran, and provides recommendations for system improvement. The collected data of different MSW functional elements were based on data from questionnaires, visual observations of the authors, available reports and several interviews and meetings with responsible persons. Due to an increase in population and changes in lifestyle, the quantity and quality of MSW in Rasht city has changed. Lack of resources, infrastructure, suitable planning, leadership, and public awareness are the main challenges of MSW management of Rasht city. However, the present situation of solid waste management in this city, which generates more than 400tons/d, has been improved since the establishment of an organization responsible only for solid waste management. Source separation of wastes and construction of a composting plant are the two main activities of the Rasht Municipality in recent years.     

The effect of changing the fuel of the LASTFIRE test

The LASTFIRE test is intended for the evaluation of foams used in extinguishing fires of flammable and combustible liquids in storage tanks in refinery and oil related facilities. The purpose of this study is to find, experimentally, an alternative fuel to be used in the LASTFIRE test, as a replacement for the heptane fuel, which is normally used in this test. Beside heptane, three other fuels are tested in the current study: diesel, jet A1 and kerosene. The study involved performing the LASTFIRE test, using each of the fuels and then comparing the results. The same foam is used as an extinguishing agent for all the tests and for each fuel, tests are conducted three times with separate foam discharging nozzles: semi-aspirated, aspirated and system. Using a commonly used scoring system, the results of the four fuels are evaluated. Any replaceable fuel should obtain the similar score as that is obtained by heptane. The study shows that none of the three alternatives has been judged to be suitable to replace heptane, in the LASTFIRE test.     

Pilot sample risk analysis for underground coal mine fires and explosions using MSHA citation data

After three decades of sustained continuous improvement of mine safety performances in the US, mine disasters in 2006 and 2007 compromised an excellent record and presented new challenges and vulnerabilities for the underground coal mining industry. In the aftermath of the incidents, formal investigations and new scrutiny of mine safety by the US Congress and expert study groups followed. The US Congress passed the Mine Improvement and New Emergency Response Act of 2006 (MINER Act), which mandated new laws to address the issues, including those related to mine fires and explosions from which miners must be protected. The National Mining Association-sponsored Mine Safety Technology and Training Commission report highlighted the role of risk analysis and management in identifying and controlling major hazards, such as fires and explosions. In this paper an approach is given for analyzing the risks for fires and explosions based on the Mine Safety and Health Administration citation database. Using 2006 citation data and focusing on subsystem failures, the methodology is applied to a database for a pilot sample of underground coal mines stratified by mine size and state.     

Low-dose irradiation by electron beam for the treatment of high-SOx flue gas on a semi-pilot scale—Consideration of by-product quality and approach to clean technology

Attention has been focused on the treatment of lignite-fired flue gas in order to use lignite in an environmentally friendly way – (i) low-CO₂ emission, (ii) production of a valuable by-product, (iii) no discharge of wastewater, (iv) direct removal of SO₃ (strong toxicity), and (v) treatment of high SO₂ concentration. Based on these criteria, electron beam irradiation with ammonia injection was tested on a semi-pilot scale: 800 Nm³ h^?1 flow rate, 5500 ppm SO₂, 70 ppm NO_x, 22% flue gas moisture, and 75–80 °C at the reactor outlet.As an energy-saving measure, a low dose (5 kGy) of irradiation was applied: the problem lay in the by-product quality. It is considered that (NH₄)₂SO₃ and NH₄HSO₃ produced by thermal reactions are oxidized to form (NH₄)₂SO₄ (fertilizer) by an electron beam. However, not all reactions were complete because the by-product contained small amounts of H₂SO₄ and NH₂SO₃NH₄ (herbicide), so a vegetable pot test was performed to study the by-product quality: no adverse effect was observed. It is inferred from the pot test that slightly acidic soil may protect vegetables from disease and a small amount of NH₂SO₃NH₄ probably affects woody species and not herbaceous species.It is concluded that the electron beam system is noted as a multi-component pollution control process (removal of NO_x, SO₃, SO₂ and dioxins) and this system will contribute to environmentally friendly use of lignite as well as agricultural productivity via fertilizer supply.