A comparison of X-ray fluorescence and wet chemical analysis of air filter samples from a scrap lead smelting operation

Personal and area air samples were taken at a scrap lead smelter operation in a bullet manufacturing facility. Samples were taken using the 37-mm styrene-acrylonitrile closed-face filter cassette (CFC, the current US standard device for lead sampling), the 37-mm GSP or "cone" sampler, the 25-mm Institute of Occupational Medicine (IOM) inhalable sampler, and the 25-mm Button sampler (developed at the University of Cincinnati). Polyvinylchloride filters were used for sampling. The filters were pre- and post-weighed, and analyzed for lead content using a field-portable X-ray fluorescence (XRF) analyzer. The filters were then extracted with dilute nitric acid in an ultrasonic extraction bath and the solutions were analyzed by inductively coupled plasma optical emission spectroscopy. The 25-mm filters were analyzed using a single XRF reading, while three readings on different parts of the filter were taken from the 37-mm filters. The single reading from the 25-mm filters was adjusted for the nominal area of the filter to obtain the mass loading, while the three readings from the 37-mm filters were inserted into two different algorithms for calculating the mass loadings, and the algorithms were compared. The IOM sampler was designed for material collected in the body of the sampler to be part of the collected sample as well as that on the filter. Therefore, the IOM sampler cassettes were rinsed separately to determine if wall-loss corrections were necessary. All four samplers gave very good correlations between the two analytical methods above the limit of detection of the XRF procedure. The limit of detection for the 25-mm filters (5 microg) was lower than for the 37-mm filters (10 microg). The percentage of XRF results that were within 25% of the corresponding ICP results was evaluated. In addition, the bias from linear regression was estimated. Linear regression for the Button sampler and the IOM sampler using single readings and the GSP using all tested techniques for total filter loading gave acceptable XRF readings at loadings equivalent to sampling at the OSHA 8-hour Action Level and Permissible Exposure Limit. However, the CFC only had acceptable results when the center reading corrected for filter area was used, which was surprising, and may be a result of a limited data set. In addition to linear regression, simple estimation of bias indicated reasonable agreements between XRF and ICP results for single XRF readings on the Button sampler filters, (82% of the individual results within criterion), and on the IOM sampler filters (77% or 61%--see text), and on the GSP sampler filters using the OSHA algorithm (78%). As a result of this pilot project, all three samplers were considered suitable for inclusion in further field research studies.     

A pilot project to detect and forecast harmful algal blooms in the northern Gulf of Mexico

More timely access to data and information on the initiation, evolution and effects of harmful algal blooms can reduce adverse impacts on valued natural resources and human health. To achieve this in the northern Gulf of Mexico, a pilot project was initiated to develop a user-driven, end-to-end (measurements to applications) observing system. A key strategy of the project is to coordinate existing state, federal and academic programs at an unprecedented level of collaboration and partnership. Resource managers charged with protection of public health and aquatic resources require immediate notice of algal events and a forecast of when, where and what adverse effects will likely occur. Further, managers require integrated analyses and interpretations, rather than raw data, to make effective decisions. Consequently, a functional observing system must collect and transform diverse measurements into usable forecasts. Data needed to support development of forecasts will include such properties as sea surface temperature, winds, currents and waves; precipitation and freshwater flows with related discharges of sediment and nutrients; salinity, dissolved oxygen, and chlorophyll concentrations (in vivo fluorescence); and remotely-sensed spatial images of sea surface chlorophyll concentrations. These data will be provided via a mixture of discrete and autonomous in situ sensing with near real-time data telemetry, and remote sensing from space (SeaWiFS), aircraft (hyperspectral imagery) or land (high-frequency radar). With calibration across these platforms, the project will ultimately provide a 4-dimensional visualization of harmful algae events in a time frame suitable to resource managers.     

Concentrations and profiles of polychlorinated biphenyls, -dibenzo-p-dioxins and -dibenzofurans in livers of mink from South Carolina and Louisiana,U.S.A

In South Carolina, U.S.A., mink have been reintroduced from two apparently healthy populations to areas where populations haveexisted in the past but have been extirpated. High mortality wasobserved during transport of mink from the source populations. Inorder to elucidate the potential effects of dioxin-like compoundson the survival and reproduction of mink, concentrations of totalpolychlorinated biphenyls (PCBs), p,p-DDE, dioxin-likePCBs, polychlorinated dibenzo-p-dioxins (PCDDs), anddibenzofurans (PCDFs) were measured in livers of mink collectedfrom the source populations in South Carolina and Louisiana. Concentrations of total 2,3,7,8-tetrachlorodibenzo-p-dioxinequivalents (TEQs) for the South Carolina and Louisiana mink were21 and 14 pg g^-1, wet wt., respectively. PCB and TEQ concentrations were close to the threshold values that can, under laboratory conditions, elicit toxic effects in ranchmink. Therefore, any additional exposures of these populations toTEQs might adversely affect their populations.     

Sharing the geo-Referenced Results of Climate Change Impact Research

The Prairie Adaptation Research Collaborative (PARC) has implemented an Internet Map Server (IMS) at the PARC web site (www.parc.ca) to 1) disseminate the geo-referenced results of PARC sponsored research on climate change impacts and adaptation, and 2) address data, information and knowledge management within the PARC network of researchers and partners. PARC facilitates interdisciplinary research on adaptation to the impacts of climate change in the Canadian Prairie Provinces. The web site is intended as a platform for sharing information and encouraging discussion of climate change impacts and adaptation. The IMS enables scientists and stakeholders to apply simple climate change scenarios to geo-referenced biophysical and social data, and dynamically create maps that display the geographic distribution of potential impacts of climate change. With a limited capacity for spatial analysis, most geo-processing and the climate impact modeling is done offline within a GIS environment. The IMS will serve the output from climate impact models, such that the model results can be customized by the web site user and be most readily applied to the planning and analysis of adaptation strategies.     

Metal Pollution Assessment of Sediment and Water in the River Hindon, India

The metal pollution in water and sediment of the River Hindon in western Uttar Pradesh (India) was assessed for Cd, Cr, Cu, Fe, Mn, Ni, Pb and Zn. The metal concentrations in water showed wide temporal variation compared with bed sediment because of variability in water discharge and variations in suspended solid loadings. Metal concentrations in bed sediments provided a better evaluation of the degree and the extent of contamination in the aquatic environment, Santagarh and Atali being the most polluted sites of the river. The ratio of heavy metals to conservative elements (Fe, Al, etc.) may reveal the geochemical imbalances due to the elevated metal concentrations normally attributed to anthropogenic sources. Metal/Al ratios for the bed sediments of the river Hindon were used to determine the relative mobility and general trend of relative mobility occurred Fe > Mn > Zn > Cr > Ni > Pb > Cu > Cd.     

Linking Land Cover and Water Quality in New York City’S Water Supply Watersheds

The Catskill/Delaware reservoirs supply 90% of New York City’s drinking water. The City has implemented a series of watershed protection measures, including land acquisition, aimed at preserving water quality in the Catskill/Delaware watersheds. The objective of this study was to examine how relationships between landscape and surface water measurements change between years. Thirty-two drainage areas delineated from surface water sample points (total nitrogen, total phosphorus, and fecal coliform bacteria concentrations) were used in step-wise regression analyses to test landscape and surface-water quality relationships. Two measurements of land use, percent agriculture and percent urban development, were positively related to water quality and consistently present in all regression models. Together these two land uses explained 25 to 75% of the regression model variation. However, the contribution of agriculture to water quality condition showed a decreasing trend with time as overall agricultural land cover decreased. Results from this study demonstrate that relationships between land cover and surface water concentrations of total nitrogen, total phosphorus, and fecal coliform bacteria counts over a large area can be evaluated using a relatively simple geographic information system method. Land managers may find this method useful for targeting resources in relation to a particular water quality concern, focusing best management efforts, and maximizing benefits to water quality with minimal costs.The United States Environmental Protection Agency through its Office of Research and Development funded and managed the research described here. It has been subjected to Agency’s administrative review and approved for publication as an EPA document.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

Using Wet-FGD systems for mercury removal

A plan to control mercury emissions to the atmosphere and to establish mercury emission limits has recently been elaborated by the European Commission, making it necessary to devise an efficient and cost effective mercury removal technology. Towards this end wet flue gas desulfurization units appear as a promising option for multi-pollutant control. However, more investigation on mercury removal and a greater mercury removal efficiency are required to achieve this objective. In the present work scrubber chemistry and the application of various solid additives to enhance mercury removal in wet scrubbers is evaluated. The results obtained show a significant correlation between mercury removal efficiency and the pH of the scrubber slurry and SO2 concentration. A weaker correlation was observed between oxygen or slurry concentration and removal efficiency. Finally several solid oxides were found to be effective additives for enhancing mercury capture in wet scrubbers.     

A ten year summary of concurrent ambient water column and sediment toxicity tests in the Chesapeake Bay watershed: 1990-1999

The goal of this study was to identify the relative toxicity ofambient areas in the Chesapeake Bay watershed by using a suiteof concurrent water column and sediment toxicity tests at seventy-five ambient stations in 20 Chesapeake Bay rivers from1990 through 1999. Spatial and temporal variability was examinedat selected locations throughout the 10 yr study. Inorganicand organic contaminants were evaluated in ambient water andsediment concurrently with water column and sediment tests toassess possible causes of toxicity although absolute causalitycan not be established. Multivariate statistical analysis wasused to develop a multiple endpoint toxicity index (TOX-INDEX) at each station for both water column and sediment toxicity data. Water column tests from the 10 yr testing period showed that49% of the time, some degree of toxicity was reported. The mosttoxic sites based on water column results were located inurbanized areas such as the Anacostia River, Elizabeth River andthe Middle River. Water quality criteria for copper, lead,mercury, nickel and zinc were exceeded at one or more of thesesites. Water column toxicity was also reported in localizedareas of the South and Chester Rivers. Both spatial and temporalvariability was reported from the suite of water column toxicitytests. Some degree of sediment toxicity was reported from 62% of the tests conducted during the ten year period. The ElizabethRiver and Baltimore Harbor stations were reported as the most toxic areas based on sediment results.Sediment toxicity guidelines were exceeded for one or more of thefollowing metals at these two locations: arsenic, cadmium,chromium, copper, lead, nickel and zinc. At the Elizabeth Riverstations nine of sixteen semi-volatile organics and two of sevenpesticides measured exceeded the ER-M values in 1990. Ambientsediment toxicity tests in the Elizabeth River in 1996 showedreduced toxicity. Various semi-volatile organics exceeded the ER-M values at a number of Baltimore Harbor sites; pyrene anddibenzo(a,h)anthracene were particularly high at one of thestations (Northwest Harbor). Localized sediment toxicity was alsoreported in the Chester, James, Magothy, Rappahannock, andPotomac Rivers but the link with contaminants was not determined.Both spatial and temporal variability was less for sedimenttoxicity data when compared with water column toxicity data. Acomparison of water column and sediment toxicity data for thevarious stations over the 10 yr study showed that approximatelyhalf the time agreement occurred (either both suite of testsshowed toxicity or neither suite of tests showed toxicity).