Size mass distribution of water-soluble ionic species and gas conversion to sulfate and nitrate in particulate matter in southern Taiwan

A Micro-Orifice Uniform Deposition Impactor (MOUDI) and a Nano-MOUDI were employed to determine the size-segregated mass distributions of ambient particulate matter (PM) and water-soluble ionic species for particulate constituents. In addition, gas precursors, including HCl, HONO, HNO₃, SO₂, and NH₃ gases, were analyzed by an annular denuder system. PM size mass distribution, mass concentration, and ionic species concentration were measured during the day and at night during episode and non-episode periods in winter and summer. Average total suspended particle (TSP) concentrations during episode days in winter were as high as 153?±?33 μg/m³, and PM mass concentrations in summer were as low as one-third of that in winter. Generally, PM concentration at night was higher than that in the daytime in southern Taiwan during the sampling periods. In winter during the episode periods, the size-segregated mass distribution of PM mass concentration was mostly in the 0.32–3.2-μm range, and the PM concentration increased significantly in the range of 0.32–3.2 μm at night. Ammonium, nitrate, and sulfate were the dominant water-soluble ionic species in PM, contributing 34–48 % of TSP mass. High concentrations of ammonia (12.9–49 μg/m³) and SO₂ (2.6–27 μg/m³) were observed in the gas precursors. The conversion ratio was high in the PM size range of 0.18–3.2 μm both during the day and at night in winter, and the conversion ratio of episode days was 20 % higher than that of non-episode days. The conversion factor was high for both nitrogen and sulfur species at nighttime, especially on episode days.     

Product Guide/1982

Abstract

An efficient venturi scrubber system making use of heterogeneous nucleation and condensational growth of particles was designed and tested to remove fine particles from the exhaust of a local scrubber where residual SiH₄ gas was abated and lots of fine SiO₂ particles were generated. In front of the venturi scrubber, normal-temperature fine-water mist mixes with high-temperature exhaust gas to cool it to the saturation temperature, allowing submicron particles to grow into micron sizes. The grown particles are then scrubbed efficiently in the venturi scrubber. Test results show that the present venturi scrubber system is effective for removing submicron particles. For SiO₂ particles greater than 0.1 μm, the removal efficiency is greater than 80–90%, depending on particle concentration. The corresponding pressure drop is relatively low. For example, the pressure drop of the venturi scrubber is ～15.4 ± 2.4 cm H₂O when the liquid-to-gas ratio is 1.50 L/m³. A theoretical calculation has been conducted to simulate particle growth process and the removal efficiency of the venturi scrubber. The theoretical results agree with the experimental data reasonably well when SiO₂ particle diameter is greater than 0.1 μm.     

Integrated model of simulated occupant injury risk and real medical costs

Introduction

The purpose of this study was to develop an integrated methodology that links occupant injury risk functions, estimated in the laboratory, with real world medical treatment costs by using the abbreviated injury score (AIS). Using our model, the expected medical treatment costs for crash injuries to various body regions and of different severities can be investigated.

Methods

First, the simulation results are compared with NHTSA crash data. We used a modified kinematics simulation model that incorporates an F = E^b function as a supplement to the previous Steffan's model to obtain a more accurate acceleration history a(t). Second, head injury criteria HIC₃₆ can be calculated from a(t), and we use the injury probability P as a function of HIC_36, as proposed by Kuppa, to obtain the injury risk function for various AIS values. Third, medical treatment cost models for various AIS values can be calculated by using a regression cost model with real world data. Finally, the injury risk function and medical treatment cost models are linked through AIS values. We establish an integrated methodology and predict medical costs and car safety data using real world police reports, medical treatment costs, and laboratory simulation results.

Results

Using head injuries in frontal crashes as an example, we focus on simulation parameters for different vehicle models, with and without airbags. We specifically examine impact closing speed, Delta-V, and impact directions.

Conclusion

Simulation results can be used to supplement insufficient real crash data, in particular ΔV, and injury risk results from police crash reports.

Impact on industry

The proposed integrated methodology may provide the vehicle industry with a new safety assessment method. Real crash data coupling provides consumers with more realistic and applicable information.     

A study of ground-level ozone pollution, ozone precursors and subtropical meteorological conditions in central Taiwan

Hourly concentrations of ozone (O(3)), 55 volatile organic compounds (VOCs, ozone precursors) and nitrogen oxides (NOx) were measured at an upwind urban site, a downwind suburban site, and a rural site in central Taiwan, from January 2003 to December 2006. VOC and NOx mean concentrations showed a gradient from high to low across the urban (56 ppb and 34 ppb), suburban (38 ppb and 27 ppb) and rural sites (25 ppb and 21 ppb) but a reverse gradient in ozone across these sites (24, 27, and 29 ppb, respectively). Although there was about twice the difference in VOC concentrations between the urban and rural sites, nearly 65% ozone formation potential was contributed to by the same 9 VOCs. Seasonal patterns showed peak ozone levels in autumn and minima in summer at the urban site, but minima in winter at the downwind suburban and rural sites. Ozone precursor levels, on the other hand, were lowest in summer and highest in winter. The diurnal pattern showed that ozone levels peaked one hour later at the rural site than at the urban site. The ethylbenzene to m,p-xylene ratio, an indicator of the age of the air mass, increased from 0.4 at the urban site to 0.6 at the suburban site and 0.8 at the rural site during daily peak ozone times. This finding suggests the transport of ozone and precursors from upwind to downwind producing elevated ozone levels in the suburban and rural areas. Ozone episodes occurred mostly in days with a mean midday UV index of 6.5 (1 UV index=100 J m(-2)) and wind speed at 1.3 m s(-1) at all three sites.     

Joint Impact of Scaling and Hysteresis on NAPL Flow Simulation

The hysteresis of capillary pressure versus saturation (P–S) relation is an important constitutive relation in multiphase flow, since the P–S relation is widely used to predict P–S relations in the simulation of the non-aqueous phase liquids (NAPLs). This work examined the performance of the scaling rule on predicting the P–S relationship and then studied the joint impact of the scaling and hysteresis on the multiphase NAPL flow simulation. Various experimental P–S values of distinct fluid pairs were compared with the scaled P–S curves using the scaling rule. The comparison indicated that the prediction of P–S is more accurate when the water–air P–S curve is used to scale other P–S curves. The joint impact of the scaling and hysteresis on the NAPLs flow simulation was then investigated by numerical simulation studies. The NAPL simulator was used to simulate the outcome of several scenarios based on a system with water–NAPL–air in a hypothetical sand tank. For both gasoline and trichloroethylene, the difference of the injected NAPL volume between no hysteretic and hysteretic simulations over a given time period was the smallest when the water–air P–S curve was used to scale other P–S curves. Simulation results of this study are valuable references for predicting the distribution of NAPLs.     

Estimation of waste generation from floods

A framework of correlation for estimating the amount of waste generation from floods is developed. Flood waste data were collected from four recent typhoons in Taiwan. Parameters affecting the flood waste are analyzed. Population density, flooded area and amount of total rainfall are chosen as the correlating parameters for the model development, and regression diagnostics are performed to check the validity of the collected data. The simple linear model is shown to be incapable of correlating the flood waste data. An exponential model is proposed and shown to give acceptable correlation with the flood waste data spanning five orders of magnitude. The model can be useful in the planning of waste cleanup after floods.     

Influences of metals on kinetics of methyl tert-butyl ether biodegradation by Ochrobactrum cytisi

The influence of zinc, manganese, and nickel on the degradation of MTBE (methyl tert-butyl ether), by an aerobic MTBE-degrading strain, Ochrobactrum cytisi, were investigated. The result showed that unlike previous findings, O. cytisi was able to degrade MTBE through direct metabolism when MTBE was present as the only carbon source. The degradation rate of MTBE was rapid, completed within 80 h. MTBE biodegradation by this strain was stimulated at low concentrations of Zn(2+) (1-5 mg l(-1)) and Mn(2+) (1-5 mg l(-1)) but inhibited at high concentrations of Zn(2+) (20 mg l(-1)) and Mn(2+) (20 mg l(-1)), and at low concentration of Ni(2+) (1-4 mg l(-1)). Kinetic parameters for MTBE degradation in the presence or absence of metals were obtained through nonlinear regression and a least-square minimization procedure. In all cases, a good agreement was achieved between kinetic simulations and experimental results.     

Fate of anilide and aniline herbicides in plant-materials-amended soils

The fate of herbicides trifluralin, pendimethalin, alachlor and metolachlor in paddy field soils amended with plant materials was investigated. The plant materials were purple sesbania, vegetable soybean and rice straw. The investigation was performed at two temperatures (25 and 40 degrees C) and two soil water moistures (60 and 90% water-holding capacity). The results showed linear and Freudlich equations described the adsorption of amide compound to soil. Adsorption coefficient (K(d)) fit to linear equation were in general greater in plant material-amended soils than in non-amended soil, especially in soil amending with rice straw. Increasing temperature and soil water moisture content shortened the half-lives of compounds in various treated soils. The movement of compounds in the soil columns showed the maximum distribution of aniline type compound, trifluralin and pendimethalin, appeared at the upper top of 0 to 5 and 0 to 10 cm of soil column, respectively, and of anilide type, alachlor and metolachlor, were distributed at 0 to 25 cm of the soil column. The mobility of chemicals in the different treated soils was simulated by the behavior assessment model (BAM). There was no significant difference among different plant material incubated soils on dissipation and mobility of compounds in soils.     

OPTIMUM STORAGE VOLUME OF ROOFTOP RAIN WATER HARVESTING SYSTEMS FOR DOMESTIC USE1

ABSTRACT: Major parameters and optimum storage volumes of rooftop rain water harvesting systems (RRWHSs) have not been investigated in detail in Taiwan. Accordingly, the four major parameters of RRWHSs were herein identified and elucidated using a simulation method. Because the performance of the RRWHSs is sensitive to the runoff coefficient, a field experiment was conducted to determine the runoff coefficient more precisely for various types of roofs. A simulation model including production theory was developed and employed to estimate the most cost effective combination of the roof area and the storage capacity that best supplies a specific volume of water. Consequently, the expansion path of optimum solutions for different volumetric reliability of water supply can be determined. Additionally, the method based on the marginal rate of substitution can be used for determining the rational volumetric reliability. The procedures developed herein constitute an effective tool for preliminarily estimating the most satisfactory storage capacity of any specific roof area and for determining the rational reliability of a corresponding water supply.