Determination of protective effect of carob (Ceratonia siliqua L.) extract against cobalt(II) nitrate-induced toxicity

Environmental Science and Pollution Research - Cobalt (Co) is widely used in many industrial fields such as batteries and paints. Cobalt, a dangerous heavy metal, can be found in high...     

流动注射催化光度法测定环境水样中的痕量亚硝酸根

基于在pH为2.7的一氯乙酸缓冲溶液中亚硝酸根对溴酸钾氧化亮绿具有催化作用,建立了测定环境水样中痕量亚硝酸根的流动注射催化光度法。在室温下,当溴酸钾浓度为0.15mol/L、亮绿溶液浓度为1.12×10-3mol/L时,该方法的线性范围为0.04～0.36mg/L,检出限为7.44×10-4mg/L,测定频率为60次/h,相对标准偏差为1.1%(n=11)。     

化学氧化絮凝技术在强化处理受污染河水中的应用

采用化学氧化絮凝技术(COF)对东莞市某河流的受污染河水进行处理,通过烧杯搅拌试验,考察了COF技术除污效能,在此基础上进行现场试验.结果表明,COD、BOD5、TP和NH3-N的去除率分别可达到71.2%、77.4%、91.1%和68.7%,出水指标达到了国家一级排放要求,为工程设计提供了依据.     

Composition and source apportionment of PAHs in sediments at river mouths and channel in Kaohsiung Harbor, Taiwan

Fifty-eight sediment samples were collected in 2009 from the bottom of river mouths near Kaohsiung Harbor (Taiwan) and the harbor channel for the analyses of polycyclic aromatic hydrocarbons (PAHs) using gas chromatography-mass spectrometry (GC-MS). Concentrations of total PAHs varied from 39 to 30,521 ng g(-1) (dry weight); samples collected from the mouths of Love River, Canon River, Jen-Gen River, and Salt River showed the highest PAHs concentrations. This indicates that the major sources of sediment PAHs come from those polluted urban rivers and the harbor channel. In samples collected from the Salt River mouth, approximately 43% of the PAHs are identified as PAHs with 2 or 3 rings. However, samples collected from other locations contain predominantly PAHs with 4 rings (32 to 42%) or 5 and 6 rings (36 to 44%). Emissions from traffic-related sources and waste incineration contribute to the majority of PAHs found in most channel and river mouth sediments. However, coal/oil combustion is the main cause of high concentrations of PAHs observed in the Salt River mouth sediments. Principal component analyses with multivariate linear regression (PCA/MLR) have been used to further quantify the source contributions, and the results show that the contributions of coal/oil combustion, traffic-related and waste incineration are 37%, 33% and 30%, respectively.     

Heavy metal concentration and speciation of seven representative municipal sludges from wastewater treatment plants in Northeast China

The analysis of heavy metals is very important for assessing the feasibility of the agricultural utilization for the municipal sludge. In this paper, a four-step sequential extraction method was applied to extract heavy metals (Cu, Zn, Mn, Cr, and Ni) in municipal sludges from seven individual wastewater treatment plants located in Jilin and Heilongjiang Province, China, for estimating the mobility and bioavailability of the metal ions in the agricultural application. The total concentrations of heavy metals and their chemical fractions after the sequential extraction were determined. Principal component analysis (PCA) was applied to analyze the relations of heavy metals fractions in the municipal sludges. Experimental results indicated that the total concentrations of Cu, Zn, Cr, and Ni in all sludge samples were below the threshold values set out by the Chinese legislation (GB18918-2002). Specially, Zn had a high bioavailability and mobility, Cu and Cr had potential bioavailability, while Mn mainly existed in the residual fraction of municipal sludge. On the other hand, Ni had different mobility in different municipal sludge. PCA results were confirmed by the environmental behavior of heavy metals.     

Development of an efficient and sensitive analytical method for the determination of copper at trace levels by slotted quartz tube atomic absorption spectrometry after vortex-assisted dispersive liquid-liquid microextraction in biota and water samples using a novel ligand

This study describes the determination of trace levels of copper by slotted quartz tube atomic absorption spectrometry after dispersive liquid-liquid microextraction. A ligand synthesized from the reaction of salicylaldehyde and 1-naphthylamine was used to form coordinate copper complex prior to extraction. All parameters that influence the output of complex formation, extraction, and instrumental measurement were optimized to enhance the absorbance signal of copper. Under the optimum conditions, about 104-fold enhancement in sensitivity was recorded over the conventional flame atomic absorption spectrometer, corresponding to a 0.51 ng/mL detection limit. The percent relative standard deviation calculated for the lowest concentration (4.8%) indicated high precision for the experimental procedure. Accuracy and applicability of the optimum method were determined by performing spiked recovery tests on urine, lake water, and mineral water samples. Satisfactory recovery results were obtained between 82.2 and 106.3% at four different concentrations. Matrix matching method was also performed to increase the accuracy of quantification, and the percent recovery calculated for 175 ng/mL was 105.14%.     

Advantages and risks of using steel slag in preparing composts from raw organic waste

It had been reported that iron and manganese oxides in steel slag enhanced the production of humic acid (HA) from low-molecular-weight compounds, such as phenolic acids, amino acids, and saccharides. In the present study, this function of steel slag was applied to the composting of raw organic wastes (ROWs). The degree of humification of HAs is an important factor in evaluating compost quality. Thus, HAs were extracted from the prepared composts and the humification parameters were determined, in terms of elemental compositions, acidic functional group contents, molecular weights, spectroscopic parameters from UV–vis absorption and ¹³C NMR spectra. The timing for adding steel slag affected the degree of humification of HAs in the composts. The weight average molecular weight of a HA when slag was added initially (29 kDa) was significantly higher than when slag was added after elevating the temperature of the compost pile (17–18 kDa). These results show that ROWs are decomposed to low-molecular-weight compounds after the pile temperature is elevated and the presence of slag enhances the polycondensation of these compounds to produce HAs with a higher degree of humification. Because the slag used in the present study contained several-tens ng g^?1 to several μg g^?1 of toxic elements (B, Cu, Cr, and Zn), leaching tests for these elements from the prepared composts were carried out. Levels for leaching boron from composts prepared by adding slag (0.2–0.4 mg L^?1) were obviously higher than the corresponding levels without slag (0.05 mg L^?1).     

Arsenic and other trace elements in groundwater and human urine in Ha Nam province,the Northern Vietnam: contamination characteristics and risk assessment

The contamination characteristics of arsenic and other trace elements in groundwater and the potential risks of arsenic from the groundwater were investigated. Elevated contamination of arsenic, barium and manganese was observed in tube-well water of two villages (Chuyen Ngoai and Chau Giang) in Ha Nam province in the Northern Vietnam. Concentrations of As in the groundwater ranged from 12.8 to 884 µg/L with mean values in Chuyen Ngoai and Chau Giang were 614.7 and 160.1 µg/L, respectively. About 83 % of these samples contained As concentrations exceeding WHO drinking water guideline of 10 μg/L. The mean values of Mn and Ba in groundwater from Chuyen Ngoai and Chau Giang were 300 and 657 μg/L and 650 and 468 μg/L, respectively. The mean value of Ba concentration in groundwater in both Chuyen Ngoai and Chau Giang was about 22 % of the samples exceeded the WHO guideline (700 µg/L). Arsenic concentrations in human urine of residents from Chuyen Ngoai and Chau Giang were the range from 8.6 to 458 µg/L. The mean values of Mn and Ba in human urine of local people from Chuyen Ngoai were 46.9 and 62.8 μg/L, respectively, while those in people from Chau Giang were 25.9 and 45.9 μg/L, respectively. The average daily dose from ingesting arsenic for consuming both untreated and treated groundwater is from 0.02 to 11.5 and 0.003 to 1.6 μg/kg day, respectively. Approximately, 57 % of the families using treated groundwater and 64 % of the families using untreated groundwater could be affected by elevated arsenic exposure.     

Persistence of diflubenzuron and bay sir 8514 in natural and sterile sandy loam and organic soils

Abstract

Disappearance rates of 10 ppm technical diflubenzuron (N(((4‐chloro‐phenyl)amino)carbonyl)‐2,6‐diflurobenzamide, Dimilin^®) and BAY SIR 8514 (2‐chloro‐N(((4‐trifluoromethoxyphenyl)amino)carbonyl)benzamide) applied on quartz sand to natural sandy loam and muck soils were significantly greater than for the corresponding sterilized soils, e.g. 47–51% vs. 68–87% BAY SIR 8514 and 2–12% vs. 80–87% diflubenzuron remaining at 12 wk, indicating that soil microorganisms play a major role in their degradation. Kinetic analysis of the data based on a first order dependence on the insecticide concentration showed that the rate constants for these disappearance reactions decreased with time.     

应用表面活性剂-生物柴油微乳液去除污染土壤中多环芳烃

针对修复焦化厂高浓度多环芳烃污染土壤高成本的现实,采用以非食用性植物油、生物柴油、表面活性剂及其乳化合成的微乳液为淋洗剂,比较不同淋洗剂的淋洗效果。结果表明乳化合成的微乳液对焦化厂土壤中多环芳烃的总去除率高于单独使用表面活性剂为淋洗剂对土壤中多环芳烃的总去除率,说明生物柴油及植物油与表面活性剂乳化形成的微乳液对原污染土壤中的多环芳烃具有显著的增溶作用。1%TW-80和2.5%TW-80对土壤中多环芳烃总去除率分别为11%和14%;以2.5%TW-80为原料乳化合成的微乳液的淋洗去除率较以1%TW-80为原料乳化合成的微乳液高,总去除率分别为15%～30%和11%～18%;以生物柴油为原料乳化合成的微乳液的淋洗去除率较以植物油为原料乳化合成的微乳液高,分别为17%～30%和15%～23%,且对多环芳烃的去除率与其辛醇水分配系数(logKow)呈线性相关关系。