Derivation of correlations to evaluate the impact of retrofitted post-combustion CO2 capture processes on steam power plant performance

When integrating a post-combustion CO₂ capture process and CO₂ compression into a steam power plant, the three interface quantities heat, electricity and cooling duty must be satisfied by the power plant, leading to a loss in net efficiency. The heat duty shows to be the largest contributor to the overall net efficiency penalty of the power plant. Additional energy penalty results from the cooling and electric power duty of the capture and compression units.In this work, the dependency of the energy penalty on the quantity and quality of the heat duty is analyzed and quantified for a state-of-the-art hard coal fired power plant. Furthermore, the energy penalty attributed to the additional cooling and power duty is quantified. As a result correlations are provided which enable to predict the impact of the heat, cooling and electricity duty of post-combustion CO₂ capture processes on the net output of a steam power plant in a holistic approach.     

A workflow to investigate the impacts of weathered multi-walled carbon nanotubes to the mud snail Lymnaea stagnalis

Environmental Science and Pollution Research - Although the development and application of nanomaterials is a growing industry, little data is available on the ecotoxicological effects on aquatic...     

Erprobung und Erfolgskontrolle eines Phytoremediationsverfahrens zur Sanierung Sprengstoff-kontaminierter Böden

On the area of a former ordnance plant (‘Werk Tanne’, Clausthal-Zellerfeld, Germany), a field experiment for phytoremediation of TNT-contaminated soils has been carried out since May 1999. The concept is based on a stepwise degradation of TNT by white-rot fungi and mycorrhiza within the rhizosphere of site-specific seedlings. An appropiate site with contaminants in the surface-soil was prepared with a large-scale soil grader and subsequently divided into different experimental plots, including an uncontaminated control as well as a contaminated plot without treatment. Planting of the selected trees and shrubs (infected with mycorrhiza during nursery) and inoculation with wood chips (inoculated with white-rot fungi) is followed by a detailed monitoring of the experimental plots (chemical analyses, biotest-battery, ecological field indicators). For the evaluation of the results, multivariate methods are applied.     

Rapid assessment of different oxygenic phototrophs and single-cell photosynthesis with multicolour variable chlorophyll fluorescence imaging

We present a new system for microscopic multicolour variable chlorophyll fluorescence imaging of aquatic phototrophs. The system is compact and portable and enables microscopic imaging of photosynthetic performance of individual cells and chloroplasts using different combinations of blue, green, red or white light. Automated sequential exposure of microscopic samples to the three excitation colours enables subsequent deconvolution of the resulting fluorescence signals and colour marking of cells with different photopigmentation, i.e., cyanobacteria, green algae, red algae and diatoms. The photosynthetic activity in complex mixtures of phototrophs and natural samples can thus be assigned to different types of phototrophs, which can be quantified simultaneously. Here, we describe the composition and performance of the new imaging system and present applications with both natural phytoplankton and microalgal culture samples.     

Volatile nanoparticle formation and growth within a diluting diesel car exhaust

A major source of particle number emissions is road traffic. However, scientific knowledge concerning secondary particle formation and growth of ultrafine particles within vehicle exhaust plumes is still very limited. Volatile nanoparticle formation and subsequent growth conditions were analyzed here to gain a better understanding of "real-world" dilution conditions. Coupled computational fluid dynamics and aerosol microphysics models together with measured size distributions within the exhaust plume of a diesel car were used. The impact of soot particles on nucleation, acting as a condensational sink, and the possible role of low-volatile organic components in growth were assessed. A prescribed reduction of soot particle emissions by 2 orders of magnitude (to capture the effect of a diesel particle filter) resulted in concentrations of nucleation-mode particles within the exhaust plume that were approximately 1 order of magnitude larger. Simulations for simplified sulfuric acid-water vapor gas-oil containing nucleation-mode particles show that the largest particle growth is located in a recirculation zone in the wake of the car. Growth of particles within the vehicle exhaust plume up to detectable size depends crucially on the relationship between the mass rate of gaseous precursor emissions and rapid dilution. Chassis dynamometer measurements indicate that emissions of possible hydrocarbon precursors are significantly enhanced under high engine load conditions and high engine speed. On the basis of results obtained for a diesel passenger car, the contributions from light diesel vehicles to the observed abundance of measured nucleation-mode particles near busy roads might be attributable to the impact of two different time scales: (1) a short one within the plume, marked by sufficient precursor emissions and rapid dilution; and (2) a second and comparatively long time scale resulting from the mix of different precursor sources and the impact of atmospheric chemistry.     

Biosensors for detection of mercury in contaminated soils

Biosensors based on whole bacterial cells and on bacterial heavy metal binding protein were used to determine the mercury concentration in soil. The soil samples were collected in a vegetable garden accidentally contaminated with elemental mercury 25 years earlier. Bioavailable mercury was measured using different sensors: a protein-based biosensor, a whole bacterial cell based biosensor, and a plant sensor, i.e. morphological and biochemical responses in primary leaves and roots of bean seedlings grown in the mercury-contaminated soil. For comparison the total mercury concentration of the soil samples was determined by AAS. Whole bacterial cell and protein-based biosensors gave accurate responses proportional to the total amount of mercury in the soil samples. On the contrary, plant sensors were found to be less useful indicators of soil mercury contamination, as determined by plant biomass, mercury content of primary leaves and enzyme activities.     

Oily substances from gastral intersegmental glands of the antPachycondyla tridenta (Ponerinae): Lack of pheromone function in tandem running and antibiotic effects but further evidence for lubricative function

Summary Gas chromatographic analyses of volatizable material from gaster intersegmental complex glands ofP. tridentata revealed the presence of linoleic acid, palmitic acid, methyl oleate, and several long-chain hydrocarbons as major constituents, which form an oily fluid mixture. The nest relocation communication ofP. tridentata is tandem running. Tandem following is mediated by pheromones as demonstrated by dummy experiments with isolated gasters and thoraces and with glass balls. The secretions of all gaster complex glands, as well as hind gut contents and metapleural gland secretions, were unable to evoke tandem following. Morphology and position of the glands, lack of pheromonal function, oily properties, low volatility, and lack of antibiotic effects of these secretions strongly suggest a function as lubricants for the ants' gastral segments.     

Das Komplementsystem: Ein Funktionsträger für Infektabwehr und Immunregulation

Complement is a physiological constituent of bloodplasma. In its activated state complement is able to stimulate various cells for special performance, e.g., monocytes, macrophages, granulocytes, platelets, but also T- and B-lymphocytes. The biological functions of the complement system cover the following areas: induction of inflammation, defence against microbial infections, handling of immune complexes, and modulation of the immune response.