CUMULATIVE IMPACTS OF LANDUSE ON WATER QUALITY IN A SOUTHERN APPALACHIAN WATERSHED1

ABSTRACT: Water quality variables were sampled over 109 weeks along Coweeta Creek, a fifth-order stream located in the Appalachian mountains of western North Carolina. The purpose of this study was to observe any changes in water quality, over a range of flow conditions, with concomitant downstream changes in the mix of landuses. Variables sampled include pH, HCO₃^2?, conductivity, NO₃^?_?-N, NH₄⁺-N, PO₄^3?-P, C1^?-, Na, K, Ca²⁺, Mg²⁺, SO₄^2?, 5iO₂, turbidity, temperature, dissolved oxygen, total and fecal coliform, and focal streptococcus. Landcover/landuse was interpreted from 1:20,000 aerial photographs and entered in a GIS, along with information on total and paved road length, building location and density, catchment boundaries, hydrography, and slope. Linear regressions were performed to relate basin and near-stream landscape variables to water quality. Consistent, cumulative, downstream changes in water quality variables were observed along Coweeta Creek, concomitant with downstream, human-caused changes in landuse. Furthermore, larger downstream changes in water quality variables were observed during stormflow when compared to baseflow, suggesting cumulative impacts due to landscape alteration under study conditions were much greater during storm events. Although most water quality regulations, legislation, and sampling are promulgated for baseflow conditions, this work indicates they should also consider the cumulative impacts of physical, chemical, and biological water quality during stormflow.     

Starch- polyvinyl alcohol crosslinked film— performance and biodegradation

Starch-PVOH cast films were prepared with and without crosslinking agent (hexamethoxymethylmelamine) in the absence of plasticizer. Moisture absorption in films without crosslinking agent at a low relative humidity was similar to that of PVOH and increased as the relative humidity increased. Films with crosslinking agent showed moisture absorption linearly proportional to the relative humidity. Significant improvement in resistance to water disintegration for crosslinked starch-PVOH films was observed. While the tensile strength decreased with increased relative humidity, crosslinking significantly improved the tensile strength. Increased PVOH content improved elongation of films even when the relative humidity was 80% or higher. Biodegradation studies revealed that the degradation rate was negatively correlated with the PVOH content in films and crosslinking generated more converged degradation curves. Names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by USDA implies no approval of the product to the exclusion of others that may also be suitable.     

Design parameters for fixed bed reactors of activated carbon developed from fertilizer waste for the removal of some heavy metal ions

Activated carbon, developed from fertilizer waste, has been used for the removal of Hg²⁺, Cr⁶⁺, Pb²⁺, and Cu²⁺. Mass transfer kinetic approach has been successfully applied for the determination of various parameters necessary for designing a fixed-bed absorber. Parameters selected are the length of the (PAZ) primary adsorption zone (δ), total time involved for the establishment of primary adsorption zone (t_x), mass rate of flow to the absorber (F_m), time for primary adsorption zone to move down its length (t_δ), amount of adsorbate adsorbed in PAZ from breakpoint to exhaustion (M_s), fractional capacity (f), time of initial formation of PAZ (t_f) and per cent saturation of column at break point. Chemical regeneration has been achieved with 1 M HNO₃.     

Study of Pollution of the Plitvice Lakes by Water and Sediment Analyses

The process of eutrophication in form of intense plant growth has been observed in some lakes and water streams at the Plitvice Lakes National Park in central Croatia. Here we investigate whether this phenomenon is a consequence of anthropogenic pollution or due to naturally produced organic matter in the lakes. We applied chemical analysis of water at two springs and four lakes (nutrients, dissolved organic carbon (DOC), trace elements) and measurements of surface lake sediments (mineral and organic fraction analyses, trace elements) in four different lakes/five sites. The chemical composition of water does not indicate recent anthropogenic pollution of water because the concentrations of most trace elements are below detection limits. The concentrations of DOC and nutrients are slightly higher in the area of increased eutrophication-plant growth. Also the content of organic matter in the sediment is at the highest level in areas with highest C/N ratio indicating that the organic fraction of this sediment is mainly of terrestrial origin. There is no significant difference among the trace element concentration in the upper segment of all cores, deposited approximately during last 50 years when higher anthropogenic influence is expected due to development and touristic activity, and the lower part of the cores, corresponding to the period approximately 100–200 years before present. The content of trace elements and organic matter in sediments decreases from the uppermost lake downstream. According to our results there is no indication of recent anthropogenic pollution in water and sediment. Higher concentrations of DOC in water as well as phosphorus and some other elements in the lake sediment can be a consequence of input of natural organic matter to the lake water.     

Assessing the Performance Level of a Water System

Water, Air, &; Soil Pollution: Focus - What should System Managers prefer? Systems that never fail or systems that remain safe during a failure? The present paper tries to give an answer to this...     

Review of in situ remediation technologies for lead,zinc, and cadmium in soil

This article presents a review of in situ technologies for the remediation of soils contaminated with lead, zinc, and/or cadmium. The objective of this review is to assess the developmental status of the available in situ technologies and provide a general summary of typical applications and limitations of these technologies. The literature review identified seven in situ remediation technologies—solidification/stabilization, vitrification, electrokinetic remediation, soil flushing, phytoextraction, phytostabilization, and chemical stabilization. These technologies were considered for their ability to meet a specific set of remediation objectives under a range of conditions. Each of these technologies has both strengths and weaknesses for addressing particular remedial situations discussed in the article for each of the technologies. A general summary of which technologies are most applicable to common remedial scenarios is also provided. © 2004 Wiley Periodicals, Inc.     

Electroremediation: A study of the influence of buffering behavior in contaminated soils

This article presents the results of an experimental study conducted to evaluate the behavior of two types of andisol soils found in Tenerife, Canary Islands, Spain. The soils were evaluated in relation to their buffering capacity when confronted with acid and alkaline fronts generated during electroremediation treatment. The study was conducted using a cell, which established a continuous flow of distilled water through electrode chambers to remove H⁺ and OH^? generated during electrolysis. The results indicate that the soils had sufficient buffer capacity to support variations in pH independent of the maintenance of flow of solution in the electrode chambers. Although the mechanism of migration was not affected, the flow of water favored the movement of ions by diffusion monitoring of the electrolytic current allowed for a real‐time parameter to act as an indicator of the quantity of ions available in regions near the electrodes. © 2004 Wiley Periodicals, Inc.     

Steady-state analyses for reactive distillation control: An MTBE case study

An approach, based purely on steady-state analyses, for synthesizing effective control structures for reactive distillation (RD) columns is presented. The main idea is to analyze the steady-state relationships between the manipulated (input) variables and the potential controlled (output) variables to identify input–output (IO) pairings that are sensitive and avoid steady-state multiplicities providing a large range of nearly linear operating region around the base case design. Traditional SISO control loops are then implemented using these IO pairings to obtain control structures that maintain the column near the design product purity and conversion for the anticipated primary disturbances. The Niederlinski Index is used to eliminate dynamically unstable pairings in control structures with multiple loops. The approach is demonstrated on an example MTBE RD column. The impact of steady-state multiplicities on control structure design is highlighted.     

Nitrogen removal in laboratory model leachfields with organic-rich layers

Septic system leachfields can release dissolved nitrogen in the form of nitrate into ground water, presenting a significant source of pollution. Low cost, passive modifications, which increase N removal in traditional leachfields, could substantially reduce the overall impact on ground water resources. Bench-scale laboratory models were constructed to evaluate the effect of placing an organic layer below the leachfield on total N removal. The organic layer provides a carbon source for denitrification. Column units representing septic leachfields were constructed with sawdust-native soil organic layers placed 0.45 m below the influent line and with thicknesses of 0.0, 0.3, 0.6, and 0.9 m. Using a synthetic septic tank effluent, NO(3)-N concentrations at 3.8 m below the influent line were consistently below 1 mg L(-1) during 10 months of operation compared with a NO(3)-N concentration of nearly 12 mg L(-1) in the control column. The average total N removal increased from 31% without the organic layer to 67% with the organic layer. Total N removal appeared limited by the extent of organic N oxidation and nitrification in the 0.45-m aerobic zone. Design modifications targeted at improving nitrification above the organic layer may further increase total N removal. Increased organic layer thicknesses from 0.3 m to 0.9 m did not significantly improve average total N removal, but caused a shift in residual nitrogen from organic N to ammonia N. Results indicate that addition of a layer of carbon source material at least 0.3 m thick below a standard leachfield substantially improves total N removal.     

BIOECONOMIC ANALYSIS OF SELECTED CONSERVATION PRACTICES ON SOIL EROSION AND FRESHWATER FISHERIES1

ABSTRACT: Farmers can generate environmental benefits (improved water quality and fisheries and wildlife habitat), but they may not be able to quantify them. Furthermore, farmers may reduce their incomes from managing lands to produce these positive externalities but receive little monetary compensation in return. This study simulated the relationship between agricultural practices, water quality, fish responses to suspended sediment and farm income within two small watersheds, one of a cool water stream and one of a warm water stream. Using the Agricultural Drainage and Pesticide Transport (ADAPT) model, this study related best management practices (BMPs) to calculated instream suspended sediment concentrations by estimating sediment delivery, runoff, base flow, and streambank erosion to quantify the effects of suspended sediment exposure on fish communities. By implementing selected BMPs in each watershed, annual net farm income declined $18,000 to $28,000 (1 to 3 percent) from previous levels. “Lethal” fish events from suspended sediments in the cool water watershed decreased by 60 percent as conservation tillage and riparian buffers increased. Despite reducing suspended sediments by 25 percent, BMPs in the warm water watershed did not reduce the negative response of the fisheries. Differences in responses (physical and biological) between watersheds highlight potential gains in economic efficiency by targeting BMPs or by offering performance based “green payments.”