Micronucleus frequency in sheep lymphocytes after in vitro exposure to fungicide tolylfluanid

The fungicide tolylfluanid (N - dichlorofluoromethylthio-N′, N - dimethyl - N - p - tolylsulfamide), was investigated by cytokinesis-block micronucleus assay. Tolylfluanid at the lowest concentration (1 × 10^{? 6}mol L^{? 1})did not influence significantly the frequency of micronuclei in sheep lymphocyte cultures in comparison with control (32.33 ± 3.51/1000 binucleated cells versus 30.33 ± 2.82/1000 binucleated cells in dimethylsulfoxide (DMSO) control, P = 0.44). Higher tolylfluanid concentrations (1 × 10^{? 4} and, 1 × 10^{? 5} mol L^{? 1}) resulted in a significant dose-dependent increase in the number of micronuclei in comparison with control (74.00 ± 13.00/1000 binucleated cells and 52.67 ± 10.12/1000 binucleated cells versus 30.33 ± 2. 82/1000 binucleated cells in DMSO control, P = 0.005 and 0.02, respectively, ANOVA followed by Tukey test P < 0.05). Many of the treated cells also possessed multiple micronuclei. Tolylfluanid did not affect the nuclear division index at all treatment concentrations. Our in vitro results thus demonstrate that tolylfluanid had a significant genotoxic effect at only the highest concentration tested.     

Microwave enhanced advanced oxidation process for treating dairy manure at low pH

This study investigated the treatment of dairy manure using the microwave enhanced advanced oxidation process (MW-AOP) at pH 2. An experimental design was developed based on a statistical program using response surface methodology to explore the effects of temperature, hydrogen peroxide dosage and heating time on sugar production, nutrient release and solids destruction. Temperature, hydrogen peroxide dosage and acid concentration were key factors affecting reducing sugar production. The highest reducing sugar yield of 7.4% was obtained at 160°C, 0 mL, 15 min heating time, and no H₂O₂ addition. Temperature was a dominant factor for an increase of soluble chemical oxygen demand (SCOD) in the treated dairy manure. The important factors for volatile fatty acids (VFA) production were microwave temperature and hydrogen peroxide dosage. Temperature was the most important parameter, and heating time, to a lesser extent affecting orthophosphate release. Heating time, hydrogen peroxide dosage and temperature were significant factors for ammonia release. There was a maximum of 96% and 196% increase in orthophosphate and ammonia concentration, respectively at 160°C, 0.5 mL H₂O₂ and 15 min heating time. The MW-AOP is an effective method in dairy manure treatment for sugar production, nutrient solubilisation, and solids disintegration.     

Effects of combinations of malathion and cypermethrin on survivability and time of metamorphosis of tadpoles of Indian cricket frog (Fejervarya limnocharis)

This study was undertaken to determine the effect of environmentally realistic concentrations of two commonly used pesticides viz., malathion and cypermethrin, using a fully 3 × 3 factorial experiments on the survivability and time of metamorphosis in a common rice paddy field frog (cricket frog) Fejervarya limnocharis under laboratory conditions. The results suggest that cypermethrin is more toxic than malathion and combinations of higher concentrations of cypermethrin (50 μg/L) with malathion (250 and 500 μg/L) are more deleterious to the survivability of tadpoles. With increasing cypermethrin concentration, the survivability of tadpole decreased (r = ?0.986, P = 0.108). But cypermethrin alone induced early metamorphosis among the surviving tadpoles. However, there was a delay in the time required for metamorphosis induced by malathion and its combination with cypermethrin. The delay in metamorphosis may indicate the altered physiological fitness of the individual. The emergent froglets will be subjected to environmental stressors like high temperature and less humidity of post-monsoon tropical climate that could enhance negative influence triggered by pesticides.     

Comparative effect of thymol or its glucose conjugate,thymol-β-d-glucopyranoside,on Campylobacter in avian gut contents

Campylobacter jejuni is an important human food-borne pathogen that can contaminate meat and poultry during processing. Consequently, strategies are sought to reduce the carriage of C. jejuni in food animals before they arrive at the abattoir. Thymol is a natural product that reduces survivability of Campylobacter in vitro, but its rapid absorption from the proximal alimentary tract limits its bactericidal efficacy in vivo. Thymol-β-d-glucopyranoside is more resistant to absorption than free thymol, but its administration to chickens has not been reported. In the present studies, 1 mM thymol-β-d-glucopyranoside was shown to exhibit near equal anti-Campylobacter activity as 1 mM thymol when incubated anaerobically in avian crop or cecal contents in vitro, resulting in reductions of 1.10–2.32 log₁₀ colony forming units mL^?1 in C. jejuni concentrations after 24 h incubation. In a follow-up live animal study, oral administration of thymol-β-d-glucopyranoside, but not free thymol, significantly lowered (>10-fold) recovery of Campylobacter from the crop of market-aged broilers when compared to placebo-treated controls (n = 6 broilers/treatment). Neither thymol-β-d-glucopyranoside nor thymol affected recovery of Campylobacter from cecal contents of the treated broilers. These results indicate that rapid absorption or passage of free thymol from the crop precluded its anti-Campylobacter activity at this site and throughout the entire gastrointestinal tract. Conversely, lower recovery of Campylobacter from the crop of birds treated with thymol-β-d-glucopyranoside indicates this conjugate was retained and able to be hydrolyzed to biologically active free thymol at this site as intended, yet was not sufficiently protected to allow passage of efficacious amounts of the intact glycoside to the lower gut. Nevertheless, these results warrant further research to see if higher doses or encapsulation of thymol-β-d-glucopyranoside or similar glycosides may yield an efficacious additive to reduce carriage of Campylobacter as well as other pathogens throughout the avian gut.     

Indoor Ozone Exposures

Indoor and outdoor ozone concentrations were measured from late May through October at three office buildings with very different ventilation rates. The indoor values closely tracked the outdoor values, and, depending on the ventilation rate, were 20 to 80 percent of those outdoors. The Indoor/outdoor data are adequately described with a mass balance model. The model can also be coupled with reported air exchange rates to estimate indoor/outdoor ratios for other structures. The results from this and previous studies indicate that Indoor concentrations are frequently a significant fraction of outdoor values. These observations, and the fact that most people spend greater than 90 percent of their time indoors, indicate that indoor ozone exposure (concentration × time) is greater than outdoor exposure for many people. Relatively Inexpensive strategies exist to reduce indoor ozone levels, and these could be implemented to reduce the public’s total ozone exposure.     

Polymers as Solid Waste in Municipal Landfills

Abstract

Synthetic polymers reach municipal landfills as components of products such as waste household paints, packaging films, storage containers, carpet fibers, and absorbent sanitary products. Some polymers in consumer products that reach landfills are designed to photodegrade or biodegrade. This article examines the significance of degradable polymers in management of solid waste in municipal landfills. Most landfills are not designed to photodegrade or biodegrade solid waste. Landfill disposal of stable polymers such as polyacrylics and polyethylenes is not associated with significant polymer degradation or mobility. Stability to photodegradation and biodegradation is an advantage when municipal landfills are used for disposal of polymer products as solid waste. Use of landfill disposal can be a responsible means to manage polymer waste and can be part of an overall waste management plan which includes source reduction, recycling, reuse, composting, and waste-to-energy incineration.     

Rotary Kiln Incineration of Dichloromethane and Xylene: A Comparison of Incinerability Characteristics Under Various Operating Conditions

Comparisons are made, for the first time, between the combustion characteristics of dichloromethane and xylene in an industrial rotary kiln incinerator. The comparisons are made under different operating conditions, including variable kiln rotation rate and operation both with and without turbulence air. Continuous gas composition and temperature measurements and batch gas composition measurements were obtained from two vertical locations hear the exit region of the rotary kiln. The measurements show that there is significant vertical stratification at the exit of the kiln. Addition of turbulence air enhanced combustion conditions throughout the kiln during xylene processing. During dichloromethane processing, however, the addition of turbulence air had minimal effect and only promoted greater bulk mixing; chlorinated compounds transported from the lower kiln during operation with turbulence air were not efficiently processed in the upper kiln. Evolution of test liquids from the bed was not constant but rather was characterized by intermittent peaks. The field-scale data of this work suggest that the evolution rate of the test liquid was increased as kiln rotation rate increased. Many of the differences between xylene and dichloromethane processing during these experiments are explained by a simple stoichiometric analysis.     

Exposure of Chronic Obstructive Pulmonary Disease Patients to Particulate Matter: Relationships between Personal and Ambient Air Concentrations

ABSTRACT

Most time-series studies of particulate air pollution and acute health outcomes assess exposure of the study population using fixed-site outdoor measurements. To address the issue of exposure misclassification, we evaluate the relationship between ambient particle concentrations and personal exposures of a population expected to be at risk of particle health effects.

Sampling was conducted within the Vancouver metropolitan area during April-September 1998. Sixteen subjects (non-smoking, ages 54-86) with physician-diagnosed chronic obstructive pulmonary disease (COPD) wore personal PM_{2 5} monitors for seven 24-hr periods, randomly spaced approximately 1.5 weeks apart. Time-activity logs and dwelling characteristics data were also obtained for each subject. Daily 24-hr ambient PM₁₀ and PM_2.5 concentrations were measured at five fixed sites spaced throughout the study region. SO₄ ^2-, which is found almost exclusively in the fine particle fraction and which does not have major indoor sources, was measured in all PM_{2 5} samples as an indicator of accumulation mode particu-late matter of ambient origin.     

The 1999 Fresno Particulate Matter Exposure Studies: Comparison of Community,Outdoor, and Residential PM Mass Measurements

ABSTRACT

Two collaborative studies have been conducted by the U.S. Environmental Protection Agency (EPA) National Exposure Research Laboratory (NERL) and National Health and Environmental Effects Research Laboratory to determine personal exposures and physiological responses to par-ticulate matter (PM) of elderly persons living in a retirement facility in Fresno, CA. Measurements of PM and other criteria air pollutants were made inside selected individual residences within the retirement facility and at a central outdoor site on the premises. In addition, personal PM exposure monitoring was conducted for a subset of the participants, and ambient PM monitoring data were available for comparison from the NERL PM research monitoring platform in central Fresno. Both a winter (February 1-28, 1999) and a spring (April 19-May 16, 1999) study were completed so that seasonal effects could be