Wastewater disinfection by peracetic acid: assessment of models for tracking residual measurements and inactivation.

With its potential for low (if any) disinfection byproduct formation and easy retrofit for chlorine contactors, peracetic acid (PAA) or use of PAA in combination with other disinfectant technologies may be an attractive alternative to chlorine-based disinfection. Examples of systems that might benefit from use of PAA are water reuse schemes or plants discharging to sensitive receiving water bodies. Though PAA is in use in numerous wastewater treatment plants in Europe, its chemical kinetics, microbial inactivation rates, and mode of action against microorganisms are not thoroughly understood. This paper presents results from experimental studies of PAA demand, PAA decay, and microbial inactivation, with a complementary modeling analysis. Model results are used to evaluate techniques for measurement of PAA concentration and to develop hypotheses regarding the mode of action of PAA in bacterial inactivation. Kinetic and microbial inactivation rate data were collected for typical wastewaters and may be useful for engineers in evaluating whether to convert from chlorine to PAA disinfection.     

Variation in CO2 assimilation rate induced by simulated dew waters with different sources of hydroxyl radical (*OH) on the needle surfaces of Japanese red pine (Pinus densifora Sieb. et Zucc.)

The hydroxyl radical (*OH) is generated in polluted dew on the needle surfaces of Japanese red pine (Pinus densiflora Sieb. et Zucc.). This free radical, which is a potent oxidant, is assumed to be a cause of ecophysiological disorders of declining trees on the urban-facing side of Mt. Gokurakuji, western Japan. Mists of *OH-generating N(III) (HNO2 and NO2-) and HOOH + Fe + oxalate solutions (50 and 100 microM, pH 5.1-5.4) simulating the dew water were applied to the foliage of pine seedlings grown in open-top chambers in the early morning. Needles treated with 100 microM N(III) tended to have a greater maximum CO2 assimilation rate (Amax), a greater stomatal conductance (g(s)) and a greater needle nitrogen content (Nneedle), suggesting that N(III) mist acts as a fertilizer rather than as a phytotoxin. On the other hand, needles treated with 100 microM HOOH + Fe + oxalate solution showed the smallest Amax, g(s), and Nneedle, suggesting that the combination of HOOH + Fe + oxalate caused a decrease in needle productivity. The effects of HOOH + Fe + oxalate mist on pine needles were very similar to the symptoms of declining trees at Mt. Gokurakuji.     

Characterization of silver release from commercially available functional (nano)textiles

Silver, both in the nano as well as in other forms, is used in many applications including antimicrobial textiles. Washing of such textiles has already been identified as an important process that results in the release of silver into wastewater. This study thus investigated the release of silver from eight different commercially available silver-textiles during a washing and rinsing cycle. The silver released was size-fractionated and characterized using electron microscopy. In addition, the antimicrobial functionality of the textiles was tested before and after washing. Three of the textiles contained nanosized silver (labeled or confirmed by manufacturers’ information), another used a metallic silver wire and four contained silver in undeclared form. The initial silver content of the textiles was between 1.5 and 2925 mg Ag/kg. Only four of the investigated textiles leached detectable amounts of silver, of which 34-80% was in the form of particles larger than 450 nm. Microscopic analysis of the particles released in the washing solutions identified Ti/Si-AgCl nanocomposites, AgCl nanoparticles, large AgCl particles, nanosilver sulfide and metallic nano-Ag, respectively. The nanoparticles were mainly found in highly agglomerated form. The identified nanotextiles showed the highest antimicrobial activity, whereas some of the other textiles, e.g. the one with a silver wire and the one with the lowest silver content, did not reduce the growth of bacteria at all. The results show that different silver textiles release different forms of silver during washing and that among the textiles investigated AgCl was the most frequently observed chemical form in the washwater.     

Nitrogen in aquatic ecosystems

Aquatic ecosystems respond variably to nutrient enrichment and altered nutrient ratios, along a continuum from fresh water through estuarine, coastal, and marine systems. Although phosphorus is considered the limiting nutrient for phytoplankton production in freshwater systems, the effects of atmospheric nitrogen and its contribution to acidification of fresh waters can be detrimental. Within the estuarine to coastal continuum, multiple nutrient limitations occur among nitrogen, phosphorus, and silicon along the salinity gradient and by season, but nitrogen is generally considered the primary limiting nutrient for phytoplankton biomass accumulation. There are well-established, but nonlinear, positive relationships among nitrogen and phosphorus flux, phytoplankton primary production, and fisheries yield. There are thresholds, however, where the load of nutrients to estuarine, coastal and marine systems exceeds the capacity for assimilation of nutrient-enhanced production, and water-quality degradation occurs. Impacts can include noxious and toxic algal blooms, increased turbidity with a subsequent loss of submerged aquatic vegetation, oxygen deficiency, disruption of ecosystem functioning, loss of habitat, loss of biodiversity, shifts in food webs, and loss of harvestable fisheries.     

Removal of dinitrotoluenes from water via reduction with iron and peroxidase-catalyzed oxidative polymerization: a comparison between Arthromyces ramosus peroxidase and soybean peroxidase

A two-step process for the removal of dinitrotoluene from water is presented: zero-valent iron reduction is coupled with peroxidase-catalyzed polymerization of the resulting diaminotoluenes (DAT). The effect of pH was examined in the reduction step: at pH 6 the reaction occurred much more rapidly than at pH 8. In the second step, optimal pH and substrate ratio, minimal enzyme concentration and effect of polyethylene glycol (PEG) as an additive for greater than 95% conversion of DAT, over a 3h reaction period were determined using high performance liquid chromatography. Two enzymes were investigated and compared: Arthromyces ramosus peroxidase (ARP) and soybean peroxidase (SBP). The optimal pH values were 5.4 and 5.2 for ARP and SBP, respectively, but SBP was more resistant to mild acid whereas ARP was more stable in neutral solutions. SBP was found to have a greater hydrogen peroxide demand (optimal peroxide/DAT molar ratio for SBP: 2.0 and 3.0 for 2,4-diaminotoluene (2,4-DAT) and 2,6-diaminotoluene (2,6-DAT), respectively; for ARP: 1.5 and 2.75 for 2,4-DAT and 2,6-DAT, respectively) but required significantly less enzyme (0.01 and 0.1 U ml(-1) for 2,4-DAT and 2,6-DAT, respectively) to convert the DAT than ARP (0.4 and 1.5 U ml(-1) for 2,4-DAT and 2,6-DAT, respectively). PEG was shown to have no effect upon the degree of substrate conversion for either enzyme.     

A field trial for an ex-situ bioremediation of a drilling mud-polluted site

The remediation of drilling mud-polluted sites in the Southeast of Mexico is a top priority for Mexican oil industry. The objective of this work was to find a technology to remediate these sites. A field trial was performed by composting in biopiles, where four 1ton soil-biopiles were established, one treatment in triplicate and one unamended biopile. Amended biopiles were added with nutrients to get a C/N/P ratio of 100/3/0.5 plus a bulking agent (straw) at a soil/straw ratio of 97/3. Moisture content was maintained around 30-35%. Results showed that, after 180 d, total petroleum hydrocarbon (TPH) concentrations decreased from 99300+/-23000mgTPHkg(-1) soil to 5500+/-770mgTPHkg(-1) for amended biopiles and to 22900+/-7800mgTPHkg(-1) for unamended biopile. An undisturbed soil control showed no change in TPH concentrations. Gas chromatographic analysis showed residual alkyl dibenzothiophene type compounds. Highest bacterial counts were observed during the first 30 d which correlated with highest TPH removal, whereas fungal count increased at the end of the experimentation period. Results suggested an important role of the straw, nutrient addition and water content in stimulating aerobic microbial activity and thus hydrocarbon removal. This finding opens an opportunity to remediate old polluted sites with recalcitrant and high TPH concentration.     

Potential antitermite compounds from Juniperus procera extracts

Thin layer chromatography (TLC) analysis revealed that destructive distillation of Juniperus procera tree gave ten major components, whereas Croton megalocarpus tree yielded five components. This was confirmed by gas chromatography (GC). The components were isolated by column chromatography and analysed using infrared, ultra-violet, visible and mass spectroscopy (MS) techniques. The whole extract was about 30.3% of the starting material (sawdust) and consisted of 77.5% water and 22.5% oily reddish-brown layer. The extracts had alcoholic and phenolic compounds together with acids. Cedrol, a tertiary tricyclic alcohol, was found to be in the greatest proportion in the oily layer. IR spectra with a peak beyond 3000 cm(-1), UV-VIS absorption maxima at 230 nm and mass spectra with m/e 204 suggested the presence of cedrene in the extract.     

Relation between extracellular polymers' composition and its ability to complex Cd,Cu and Pb

Activated sludges originated from wastewater treatment plants (WWTPs) play an important role in heavy metal removal from effluents. Extracellular polymers (ECP) form a major part of the activated sludge and are heavily involved in biosorption of heavy metals. The complexation of three heavy metals (Cd, Cu and Pb) with ECP extracted from six activated sludges, originated from different WWTPs, was investigated at pH 7.

ECP in the study were shown to be mainly composed of proteins, humic acids, uronic acids and polysaccharides along with smaller amounts of lipids and nucleic acids. IR spectra confirmed the presence of the functional groups usually found in the ECP and the content in each fraction was determined using colorimetric methods. The determination of surface charge was carried out on each ECP sample and allowed two pK_a values characteristic of two distinctive functional groups to be determined. At the pH used in the study, the value of these constants indicates that only one functional group is under protonated form.

A polarographic method was used to determine the complexation parameters (number of binding sites and complexation constant) of ECP solutions towards metals. The following orders were established for the number of binding sites: Cu > Pb  Cd and for the stability of the ECP–metal complex: Cd > Pb  Cu.

A matrix of correlation between the composition of the polymers and the complexation parameters showed that the number of binding sites and the complexation constant were strongly linked to proteins, polysaccharides and humic substances content.