Nitrogen and metals in two regions in Central Europe: Significant differences in accumulation in mosses due to land use?

The study was conducted to test the hypothesis that the regional variability of nitrogen (N) and metal accumulations in terrestrial ecosystems are due to historical and recent ways of landuse. To this end, two regions of Central Europe were selected for investigation: the Weser-Ems Region (WER) and the Euro Region Nissa (ERN). They were assumed to have land use-specific accumulation profiles. Thus, the metal and N accumulations in both regions were examined by means of geostatistically based comparative moss analysis. The sampling and chemical analysis of mosses were conducted in accordance with the convenient guidelines and methods, respectively. The spatial representativity of the sampling sites was computed by means of a land classification which was calculated for Europe by means of classification trees and GIS-techniques. The differences of deposition loads were tested for statistical significance with regard to time and space. The measurement values corroborated the decline of metal accumulation observed since the beginning of the European Metals in Mosses Surveys in 1990. The metal loads of the mosses in the ERN exceeded those in the WER significantly. The opposite holds true for the N concentrations: those in the WER were significantly higher than those in the ERN. The reduction of emissions from power plants, factories and houses was strongly correlated with the decline of deposition and bioaccumulation of metals. As proved by the European Metals in Mosses Surveys, this tendency is due to successful environmental policies. But no such success could be verified by monitoring the accumulation of N in mosses.     

Trends analysis of ambient 8 hour ozone and precursor monitoring data in the south central U.S

For the south central U.S., lower tropospheric ozone pollution has been a persistent and challenging problem. This paper provides long-term trends analyses of the ozone and precursor monitoring data collected over the past 20 years in four south central U.S. cities. The results of these analyses should be useful to air quality scientists, managers, planners, and modelers in assessing the effectiveness of ozone pollution control strategies being implemented or being planned for the future. Results of the data analyses show that all areas have monitored significant decreases in ozone and precursor concentrations over the past 20 years, especially in El Paso, Texas. Continuing challenges include the reduction of the percentage of time that monitors record 8 hour ozone concentrations over the U.S. 8 hour ozone standard, and the future control of highly reactive volatile organic compounds.     

Pyrolysis of mixtures of sewage sludge and manure: a comparison of the results obtained in the laboratory (semi-pilot) and in a pilot plant

A pilot-scale pyrolysis process was carried out for the treatment of a mixture of two types of waste, sewage sludge and cattle manure, comparing the results with others obtained under laboratory conditions (semi-pilot scale). The aim of this study was to obtain the energetic valorization of the products. Owing to the specific characteristics of the plant, two products were obtained from the process: gas and carbonized solid. As no liquid fraction was obtained, the gas fraction is a greater percentage made up of both condensable and non-condensable compounds, which were obtained separately at the laboratory scale. The pilot plant was designed so that the gases produced by thermolysis were burnt continuously in a combustion chamber, while the carbonized fraction was fed in batches for co-combustion. To determine composition and combustion ability, the gas and solid products from the pilot process were characterized by chromatographic analysis of the gaseous fraction and chemical analysis and programmed-temperature combustion of the carbonized solid. The composition of the combustion gases, rich in light hydrocarbons, and the carbon present in the carbonized fraction enable the energetic valorization of these products. The combustion gases were subjected to a cleaning process and their composition analysed twice: before and after the gas cleaning treatment. The study led to a positive assessment of the possible use of the process products as fuel, provided that the combustion gases are treated. As most of the sulphur and chlorine from the original waste are mainly concentrated in the solid fraction, the use of char as a fuel will depend on the effectiveness of clean-up techniques for combustion gases. During gas cleansing, neutralizing with sodium bicarbonate proved effective, especially for the acidic compounds HCl, HF and SO(2).     

Simulation of the flue gas cleaning system of an RDF incineration power plant

Because of the stringent pollutant emission standards introduced with the European Union guidelines for waste incineration, it is very important to optimize the flue gas cleaning systems which are able to result in a low environmental impact according to the emission limits. In this paper a thermochemical model has been proposed for the simulation of the flue gas cleaning system of an RDF incineration plant. The model simulates the operation of the flue-gas treatment section and the combustion section by using a simplified approach. The combustion includes the grate incinerator and the post-combustion chamber, while the cleaning section includes the NO(x) reduction process (urea injection) and the scrubbing of SO(2) and HCl (Ca(OH)(2) as sorbent). The modelling has been conducted by means of ASPEN PLUS code. The simulation results have been validated with the operating data. The model proposed by the authors can be a useful tool in both evaluating the efficiency of the gas cleaning system by verifying the environmental pollution of an incinerator power plant in nominal operating conditions and in forecasting the efficiency of the cleaning system in off-design operating conditions.     

Investigations on mechanical biological treatment of waste in South America: towards more sustainable MSW management strategies

This work presents an analysis on the suitability of mechanical biological treatment of municipal solid waste in South America, based on two previous experimental investigations carried out in two different countries. The first experiment was performed for determining the mass and volume reduction of MSW in the province of Concepción (Chile). The implemented bench-scale process consisted of a manual classification and separation stage, followed by an in-vessel biological degradation process. The second experiment consisted of a full-scale experiment performed in the city of Estrela (Brazil), where the existing municipal waste management facility was adapted to enhance the materials sorting and separation. Expressed in wet weight composition, 85.5% of the material input in the first experiment was separated for biological degradation. After 27 days of processing, 60% of the initial mass was reduced through degradation and water evaporation. The final fraction destined for landfilling equals 59% of the total input mass, corresponding to about 50% of the initial volume. In the second experiment, the fraction destined to landfill reaches 46.6% of the total input waste mass, whilst also significantly reducing the total volume to be disposed. These results, and the possible recovery of material streams suitable for recycling or for preparing solid recovered fuels, are the main advantages of the studied process.     

Performance results from the Tucumán solid waste bioreactor

Performance results obtained from a 6200 ton demonstration-scale anaerobic bioreactor, constructed on the Pacara Pintada Landfill in Tucumán, Argentina, are described. The operational aspects over a 30-month period for the Tucumán bioreactor demonstrate the ability to maintain the bioreactor in the mesophilic range, with the result that the generation and collection of the biogas has been maintained at accelerated rates with a rate constant of approximately 0.5 year(-1). Field measurements of metal concentrations in leachate indicated significant attenuation over time. Refuse subsidence, measured over a 28-month period, ranged from 4% to 19%, with an average of 11% subsidence across the Tucumán cell.     

Life cycle assessment of a national policy proposal - the case of a Swedish waste incineration tax

At the core of EU and Swedish waste policy is the so-called waste hierarchy, according to which waste should first be prevented, but should otherwise be treated in the following order of prioritisation: reuse, recycling when environmentally motivated, energy recovery, and last landfilling. Some recent policy decisions in Sweden aim to influence waste management in the direction of the waste hierarchy. In 2001 a governmental commission assessed the economic and environmental impacts of introducing a weight-based tax on waste incineration, the purpose of which would be to encourage waste reduction and increase materials recycling and biological treatment. This paper presents the results of a life cycle assessment (LCA) of the waste incineration tax proposal. It was done in the context of a larger research project concerning the development and testing of a framework for Strategic Environmental Assessment (SEA). The aim of this paper is to assess the life cycle environmental impacts of the waste incineration tax proposal, and to investigate whether there are any possibilities of more optimal design of such a tax. The proposed design of the waste incineration tax results in increased recycling, but only in small environmental improvements. A more elaborate tax design is suggested, in which the tax level would partly be related to the fossil carbon content of the waste.     

Waste polyvinylchloride derived pitch as a precursor to develop carbon fibers and activated carbon fibers

Polyvinylchloride (PVC) was successfully recycled through the solvent extraction from waste pipe with an extraction yield of ca. 86%. The extracted PVC was pyrolyzed by a two-stage process (260 and 410 degrees C) to obtain free-chlorine PVC based pitch through an effective removal of chlorine from PVC during the heat-treatment. As-prepared pitch (softening point: 220 degrees C) was spun, stabilized, carbonized into carbon fibers (CFs), and further activated into activated carbon fibers (ACFs) in a flow of CO2. As-prepared CFs show comparable mechanical properties to commercial CFs, whose maximum tensile strength and modulus are 862 MPa and 62 GPa, respectively. The resultant ACFs exhibit a high surface area of 1200 m2/g, narrow pore size distribution and a low oxygen content of 3%. The study provides an effective insight to recycle PVC from waste PVC and develop a carbon precursor for high performance carbon materials such as CFs and ACFs.     

Landfill leachate treatment using a rotating biological contactor and an upward-flow anaerobic sludge bed reactor

This paper describes the feasibility of an aerobic system (rotating biological contactor, RBC) and a biological anaerobic system (upward-flow anaerobic sludge bed reactor) at small scale for the treatment of a landfill leachate. In the first phase of the aerobic system study, a cyclic-batch RBC system was used to select perforated acetate discs among three different acetate disc configurations. These discs were chosen on the basis of high COD removal (65%) and biological stability. In the second phase, the RBC system (using four stages) was operated continuously at different hydraulic retention times (HRT), at different rotational speeds, and with varying organic concentrations of the influent leachate (2500-9000mgL(-1)). Forty percent of the total surface area of each perforated disc was submerged in the leachate. A COD removal of about 52% was obtained at an HRT of 24h and a rotational speed of 6rpm. For the anaerobic system, the reactor was evaluated with a volumetric organic load of 3273g-COD m(-3) day(-1) at an HRT of 54, 44, 39, 24 and 17h. At these conditions, the system reached COD removal efficiencies of 62%, 61%, 59%, 44% and 24%, respectively.     

Hospital waste management and toxicity evaluation: a case study

Hospital waste management is an imperative environmental and public safety issue, due to the waste's infectious and hazardous character. This paper examines the existing waste strategy of a typical hospital in Greece with a bed capacity of 400-600. The segregation, collection, packaging, storage, transportation and disposal of waste were monitored and the observed problematic areas documented. The concentrations of BOD, COD and heavy metals were measured in the wastewater the hospital generated. The wastewater's toxicity was also investigated. During the study, omissions and negligence were observed at every stage of the waste management system, particularly with regard to the treatment of infectious waste. Inappropriate collection and transportation procedures for infectious waste, which jeopardized the safety of staff and patients, were recorded. However, inappropriate segregation practices were the dominant problem, which led to increased quantities of generated infectious waste and hence higher costs for their disposal. Infectious waste production was estimated using two different methods: one by weighing the incinerated waste (880 kg day(-1)) and the other by estimating the number of waste bags produced each day (650 kg day(-1)). Furthermore, measurements of the EC(50) parameter in wastewater samples revealed an increased toxicity in all samples. In addition, hazardous organic compounds were detected in wastewater samples using a gas chromatograph/mass spectrograph. Proposals recommending the application of a comprehensive hospital waste management system are presented that will ensure that any potential risks hospital wastes pose to public health and to the environment are minimized.