The Removal of Particulate Matter from Fluid Bed Catalytic Cracking Unit Stack Gases

The application of a high-efficiency centrifugal type of separator to fluid bed catalytic cracking units is described in which most of the catalyst particles often lost to the atmosphere are concentrated into a small part of the stack gas (2%). A further separation can then be made on this small stream by an auxiliary separator which further concentrates the catalyst particle into 0.1% of the initia stream. Performance of the main and auxiliary separators are such as to reduce the loss of catalyst particles in the stack gas from 800 ppm to less than 60 ppm in a typical unit. Large amounts of power can be recovered by application of expander turbines to catalytic cracking plants employing this system of separation.     

The Effect of Fuel Composition on Atmospheric Aerosol Due to Auto Exhaust

Aerosols attributable to automobile exhaust can be classified as two types—primary aerosol (initially present in the exhaust) and secondary aerosol (generated photochemically from hydrocarbons and nitrogen oxides in the exhaust). In this study, investigation was made of possible effects of motor-fuel composition on the formation of these aerosols. Secondary aerosol, of principal interest in this work, was produced by irradiating auto exhaust in Battelle-Columbus’ 610 ft³ environmental chamber. A limited number of determinations of primary aerosol in diluted auto exhaust was made at the exit of a 36 ft dilution runnel. Determination of both primary and secondary aerosol was based on light-scattering measurements.

Exhaust was generated with seven full-boiling motor gasolines, both leaded and nonleaded, in a 1967 Chevrolet which was not equipped with exhaust-emission control devices. Changes in fuel composition produced a maximum factor of three difference in light scattering due to primary aerosol. Aerosol yields, for consecutive driving cycles on the same fuel, vary considerably; as a result, ranking the fuels on the basis of average primary aerosol yield was not very meaningful. In addition to fuel composition, the more important independent variables are initial SO₂ concentration, relative humidity and initial hydrocarbon concentration. Statistical analysis of the data indicates that the seven test fuels can be divided into two arbitrary groups with regard to secondary aerosol-forming potential. The fuels in the lower light-scattering group had aromatic contents of 15 and 21%, while those in the higher light-scattering group had aromatic contents of 25, 48, and 55%. Although the fuels can be grouped on the basis of a compositional factor, the grouping of fuels with aromatic content ranging from 25 to 55% indicates that this compositional factor cannot be equated simply with aromatic content. In an associated study of the aerosol-forming potential of individual hydrocarbons prominent in auto exhaust, it was observed that aromatics produce substantially more photochemical aerosol than olefins and paraffins. However, experiments with binar/hydrocarbon mixtures containing aromatjcs, as well as in these exhaust experiments, a strong dependence of aerosol yield on the aromatic components is is not observed. Thus, the data indicate that the dependence of secondary aerosol formation on fuel factors is a complex one and cannot be predicted solely on the basis of a sirigle hydrocarbon component reactivity scale.

The two types of automobile aerosol did not have the same dependence on fuel, composition. The variation in total light scattering attributable to primary plus secondary aerosol was less than that due to either component alone. It therefore was concluded that the light scattering due to automobile exhaust emissions in these experiments was not significantly affected by changing fuel composition.     

A Portable,Battery-Operated,Immediate-Readout Dust-Particle Analyzer

A portable, battery-operated, electro-optical dust analyzer operating on the principle of light scattering from individual dust particles in air drawn through a high-intensity light field has been developed for monitoring dust levels where external power may be unavailable. The instrument counts and size-discriminates airborne particles over two size ranges upwards of 0.3 microns with immediate readout. A dilution mechanism permits analysis of particulate concentrations as high as 2400 particles/cm³ on each channel. The self-contained Ni-Cd batteries are rechargeable. Total weight, including batteries and all components, is approximately 14 Ib. Total power used, mainly for pumping a filtered air sheath at 300 cm/sec and for the light source, is less than 34 watts. Another unique feature is the flow system designed for turbulence suppression.

Electronic calibration in terms of number of particles/cm³ for each size range is accomplished in the laboratory by means of a pulse generator with respect to which the readout indicator is calibrated for count. The input voltages to the pulse-height discriminators are appropriately attenuated for various pulse amplitudes simulating the output of the light-sensitive pickup, a photomultiplier tube.Pulse height as a function of particle size was measured for polystyrene latex beads ranging from 0.3 to 2 microns in diameter. Good correlation is obtained with results from commercial analyzers.

Field surveys have been undertaken with the CAES prototype analyzer at various sites in central Pennsylvania and at numerous sampling points within the cities of Pittsburgh and Philadelphia. Particulate concentrations as high as 1400 particles/ cm³ have been measured at a coal cleaning plant.     

Determination of Oxides of Nitrogen in Combustion Effluents with a Nitrate Ion Selective Electrode

The nitrate ion selective electrode was investigated as an alternative approach to the present colorimetric determination of nitrate resulting from oxidative absorption of nitrogen oxides from combustion effluents. The electrode offers advantages of speed and relatively simple experimental procedure. Replicate measurements of 10^?4–10^?2M nitric acid solutions using bracketing standards show that the electrode approach is capable of good precision (coefficient of variation = ±4%). Comparison of a method utilizing the nitrate electrode with the more laborious phenol disulfonic acid method for the measurement of nitrogen oxides in both oil and gas fired combustion effluents showed agreement within 4% of the mean even in the presence of high levels of SO₂. The correlation coefficient found for PDS vs nitrate electrode is 0.987.     

Automotive Exhaust Emission Levels by Geographic Area and Vehicle Make A Nationwide Survey

Gross average automotive exhaust emissions data collected by the Atlantic Richfield Clean Air Caravan during the summer of 1970 showed only slight geographical variations when the specific makes were ignored. When considering specific makes, significant differences were found on an average emissions basis. Vehicle population—emission distributions showed wide variations in the 50% population levels and in the percent of vehicles with emissions greater than specified values. Hydrocarbon (HC) and carbon monoxide (CO) data are given on a gross basis for the 1970, 1968-69, 1966-67, and pre-1966 model year group vehicles. Average HC and CO emissions and vehicle population-Idle emissions distribution curves are included for specific make vehicles in selected areas.     

On the Relation Between the Indoor and Outdoor Concentrations of Nitrogen Oxides

Simultaneous measurements were made of the concentrations of NO, NO₂, and CO inside and outside of a building. The building is located in the Los Angeles area, which is heavily polluted by photochemical smog, and the experiments were conducted at a time of the year when the pollutants in question tend to be high. The results shows that there is a direct relationship between the inside and outside concentrations, and that the phase lag between the concentrations depends principally on the ratio of the building volume to the ventilation rate. Although the outside concentrations of the pollutants in question did not follow the same pattern every day, peak concentrations seemed to be related to “rush-hour” traffic. By reducing ventilation rates during these periods, it may be possible to reduce the concentration peaks inside of the building. The building involved in the current study was not located in the immediate vicinity of heavy traffic, and the indoor concentrations of NO, NO₂, and CO did not appear to be very severe when compared to those defined by present air quality standards. Finally, the results support the belief that NO and O₃ do not co-exist indoors except in very small quantities.     

A Policy of Options

As many of you know, I previously served as Deputy Administrator of the Environmental Protection Agency at a time when the problem of air pollution control was reaching a peak of public awareness. The work of the Air Pollution Control Association in investigating facts and accelerating the development of solutions earned my high respect then and my continued admiration now.     

Stack Dust Sampling: in-Stack Filter or E.P.A. Train

The Environmental Protection Agency has recommended or specified methods for the measurement of participate concentrations in flue gases. The EPA Train for this measurement originally comprised two segments: the front half and the impinger train downstream from the filter proper. This review examines the controversial areas implicit in the use of this EPA Train or the revised EPA train which eliminates the impinger train.