聚乙烯醇/超细羽绒粒子共混膜的制备及其染料吸附动力学

为了改善并更好地研究聚乙烯醇的染料吸附性能,制备了不同超细羽绒粒子含量的聚乙烯醇/超细羽绒粒子共混膜,并将其用于对活性艳红X-3B染料的吸附。结果表明,随着超细羽绒粒子含量的增加,聚乙烯醇/超细羽绒粒子共混膜表面粗糙程度增大。当超细羽绒粒子的质量分数为27.8%时,K/S值最大,染料吸附性能最好,其吸附效果比纯聚乙烯醇膜提升约54.5%。动力学研究结果表明,伪二级动力学模型能更好地描述聚乙烯醇/超细羽绒粒子共混膜对染料的吸附。     

CAS工艺与AOE工艺曝气池水质信息场的测量与分析

为了研究曝气池空间内水质的分布及变化规律,采用了YSI6600 V2多参数水质检测仪对成都市三瓦窑污水处理厂的一期工程传统污泥法(CAS)、二期工程缺氧、好氧和内源呼吸(AOE)工艺中的曝气池分别进行了包括DO、NH3-N、NO3--N、pH、氯化物和温度等水质指标的场的检测,通过分析这些数据,揭示了曝气池内部水质变化的规律,并比较了CAS工艺与AOE工艺内水质处理效果的差别。结果表明,(1)溶解氧沿池深方向呈现出一定的分布规律,CAS工艺中随池深增加,溶解氧增加,AOE工艺中随着池深的增加,溶解氧降低;(2)AOE工艺对氨氮在O区的去除率可达97.64%,明显高于CAS工艺的41.76%;(3)沿曝气池长度测量溶解氧空间分布规律,参照理论曲线及依据水质处理要求,调整曝气量的方法具有长期运行经济、水质处理效果好的特点。     

固定化解脂耶氏酵母处理油脂废水研究

利用海藻酸钙包埋固定的解脂耶氏酵母(Yarrowia lipolytica)分别降解以色拉油为惟一碳源和以葡萄糖为惟一碳源的污水,结果表明,在最佳处理条件下,固定化细胞在50 h内,能较好地降解废水中浓度为2 000 mg/L的色拉油和浓度为2 000 mg/L 的COD,降解率都在80%以上;固定化细胞对色拉油、COD降解效率随着时间的延长而增加、随着底物浓度的增加而下降;与未固定菌株相比,固定化细胞有着更好的储存稳定性和可重复使用性,结果进一步提示固定化解脂耶氏酵母适于含油废水以及高COD含量的生活污水处理。     

德国行业管理中工伤保险的作用及启示

介绍了德国同业公会在职业安全卫生工作和工伤保险中的作用，对我国职业安全卫生的行业管理提出了看法。     

铁氧体沉淀法处理含锰废水的研究

对铁氧体与锰共沉淀进行了中和法、氧化法2种方法的试验研究，并探讨了主要技术参数。结果表明，模拟废水中Mn^2＋含量在110～310mg／L时，在常温，Fe^3＋／Fe^2＋（质量比）=2．投料比Fe^2＋／Mn^2＋（质量比）=4，pH-10的条件下（氧化法中曝气时间=6min），Mn^2＋的去除率可达99％以上，出水水质达到国家工业废水的排放标准。     

Environmental sensitivity and risk assessment in the Saharan Tunisian oasis agro-systems using the deepest water table source for irrigation: water quality and land management impacts

Environment, Development and Sustainability - In dry-hot areas, such as southern Tunisia, the availability of good water is very limited by the low scanty rainfall, the long dry periods and the...     

广州轨道交通三号线高速行驶条件下对安全限界的影响研究

给出了轨道交通车辆横向偏移量的计算方法 ,并应用列车 -线路动力耦合模型 ,分析了广州地铁三号线的安全限界变化问题。确定了当前按 80km/h行车速度设计的建筑限界能满足 13 0km/h行车速度的要求 ,限界尺寸不需改动可保证列车运行安全平稳     

Characteristics of the stabilized/solidified municipal solid wastes incineration fly ash and the leaching behavior of Cr and Pb

Fly ash is a hazardous byproduct of municipal solid wastes incineration (MSWI). An alkali activated blast furnace slag-based cementitious material was used to stabilize/solidify the fly ash at experimental level. The characteristics of the stabilized/solidified fly ash, including metal leachability, mineralogical characteristics and the distributions of metals in matrices, were tested by toxic characteristic leaching procedure (TCLP), X-ray diffraction (XRD) and scanning electron microscopy-energy dispersive spectrometer (SEM-EDS) respectively. Continuous acid extraction was utilized to extract metal ions and characterize their leaching behavior. The stabilization/solidification procedure for MSWI fly ash demonstrates a strong fixing capacity for the metals by the formation of C-S-H phase, hydrated calcium aluminosilicate and ettringite. The stabilized/solidified fly ash shows a dense and homogeneous microstructure. Cr is mainly solidified in hydrated calcium aluminosilicate, C-S-H and ettringite phase through physical encapsulation, precipitation, adsorption or substitution mechanisms, and Pb is mainly solidified in C-S-H phase and absorbed in the Si-O structure.     

Ethoxylated Soybean Polyols for Polyurethanes

Soybean polyols prepared by ring opening reactions of epoxidized soybean oil with hydrogen active compounds (water, alcohols, organic or inorganic acids, thiols, hydrogen etc.) have a low reactivity in the reaction with isocyanates because the hydroxyl groups are secondary. This paper presents a simple and convenient method to increase the reactivity of soybean polyols with secondary hydroxyl groups by ethoxylation reactions with the preservation of triglyceride ester bonds. The method uses mild reaction conditions: low alkoxylation temperature of 35–45 °C, low pressure of 0.1–0.2 MPa (15–30 p.s.i.) and a superacid as catalyst (HBF₄). The new soybean polyols have a higher reactivity toward isocyanates in polyurethane formation due to the high percentage of primary hydroxyl groups. The primary hydroxyl content was determined by the second order kinetics of polyol reaction with phenyl isocyanate.     

Adsorption mechanism of Zn2+, Ni2+, Cd2+, and Cu2+ ions by carbon-based adsorbents: interpretation of the adsorption isotherms via physical modelling

Environmental Science and Pollution Research - A theoretical physicochemical and thermodynamic investigation of the adsorption of heavy metals Zn2+, Cd2+, Ni2+, and Cu2+on carbon-based adsorbents...