Occurrence and congeners specific of poiychlorinated biphenyls in agricultural soils from Southern Jiangsu, China

A total of 198 agricultural soil samples were collected from Zhangjiagang and Changshu in Southern Jiangsu for analysis of 13 polychlorinated biphenyls (PCBs) in order to assess the levels of pollution, sources, area distribution, and potential risk for the environment. All methods were rigorously tested and an adequate quality control was ensured. Only one site had no PCBs residues, and the highest total PCBs concentration in the surface soils was 32.83 ng/g. The average concentration in all the soil samples was 4.13 ng/g, signaling low-level pollution. Tetra-, penta-, and hexa-chlorinated biphenyls were dominant species in soil samples, accounting for more than 75% ofΣPCBs in the soil samples. PCB118 was the most abundant congener in all the samples. The PCB118 was about 20% ofΣPCBs. The soil organic matter content showed only a weak correlation with the levels of all PCB congeners, in which a better correlation was noted for the more volatile lighter PCB congeners than for the heavier homologues. To a certain extent, the sources and land use seemed to influence the levels of PCBs.     

花岗岩类岩体与金矿床成因关系的探讨

花岗岩类岩体与金矿床存在着密切的空间联系，其成因关系一直是矿床学界争论的焦点，目前传统的岩浆热液成因观点仍居统治地位。随着地质资料的积累，高温高压实验技术，尤其是金矿床同位素定年技术的进展，传统观点受到了严峻挑战。成岩成矿的时代与时差、成矿流体的来源和成矿物质的来源等确定金矿床成因类型关键因素的综合研究表明，有密切空间关系的金矿床与花岗岩类岩体之间，在多数情况下两者并无直接的成因联系，金矿床不是岩浆热液成因，而是与大气降水或建造水有关的改造成矿作用的产物。     

楔横轧模具的铣削加工及其机床设计

根据楔横轧模具孔型及其加工成形的特点,对楔横轧模具大面积大螺距楔形提出了一种简单高效的铣削加工方法,并设计制造了楔横轧轧辊模具孔型加工专用机床——SDM机床。新设计的SDM机床投资小,可以加工直径为φ620 mm～φ1000mm的轧辊模具,加工导程最大可达469 mm,加工周期短,成本低,且大大降低了工人劳动强度。     

土壤环境容量数学模型——Ⅰ.土壤污染动力学模型

应用物质平衡原理,导出模拟土壤污染过程的动力学方程.可用于估算土壤环境容量、分析土壤污染动态和预测土壤超容年限.以测定残留率为基础的一类模型是本文提出的模型的一个特例.     

区域环境质量综合评价的一种方法——Fuzzy概率法

本文应用Fuzzy概率原理,在对区域环境内各单项污染指标进行分级评价的基础上,考虑各单项污染指标在总体中的权重,并综合各单项污染指标的作用,给出区域环境内环境“总”质量的综合评价。     

金属对催化还原DDT的降解产物及其反应机制的研究

本报告介绍DDT经金属对处理后降解产物的分析鉴定和有关反应机制的初步研究。 降解产物主要是用气相色谱—质谱联用分析鉴定的。水溶液中的DDT用Cu-Zn金属对还原其降解产物经鉴定是DDD、DDMS、DDE_t,它们是DDT分子脱去烷基碳原子上不同数目的氯原子的产物。而在Cu-Fe金属对作用下,水溶液中的DDT的还原则是同时得到四种不同类型的产物。它们是DDT脱去烷基碳原子上的1个和3个氯原子的DDD和DDE_t;DDT脱氯、氧化产物DBP和DBH;DDT脱去HCI生成的DDE;两个DDT分子二聚脱氯的产物TTTB和TTDB。 实验证明金属对对DDT的作用是催化还原反应,金属对起着催化剂和还原剂双重作用。通过实验结果对DDT在金属对作用下的反应机制进行了初步探讨。     

Promotive effect of pyridine on indole degradation by activated sludge under anoxic conditions

Batch experiments were carried out to investigate the promotive effect of pyridine on indole degradation under denitrifying conditions. The seed sludge was obtained from a local coal-coking wastewater treatment facility and was acclimated in the laboratory. Indole and pyridine were supplemented to the synthetic wastewater at different ratios. The optimum ratio of chemical oxygen demand (COD) to nitrate (C/N) was 8.4–8.9 for both denitrification and indole and pyridine degradation. At a temperature of 28°C and pH of 7.0–7.5, the nitrate reductase activity (NRA) was in the best state. The addition of pyridine could promote NRA and the degradation of indole. When the initial concentration of indole was 150 mg/L, the concentration ratio of indole to pyridine was in the range of 1–10. Under optimum C/N conditions, the degradation of indole could be described with pseudo-zero-order kinetics. There was no accumulation of nitrite during the reaction. When the concentration ratio of pyridine to indole was less than 0.25 with an increase in the pyridine proportion, there were more significant augment rates for NRA and the degradation of indole than the situation when the concentration ratio was more than 0.25. __________ Translated from Environmental Science, 2006, 27(2): 300–304 [译自: 环境科学]     

水霉科真菌在北京地区不同污染水体中的分布和数量变化

对北京地区水霉科真菌在不同污染水体中分布和数量变化的调查研究表明,水霉科游动孢子在水体中的数量随水体污染程度的变化而不同:一般在净水中较少,在轻度污染至中度污染的水体中明显增多,污染加重时逐渐下降,在重污染区明显减少,在近于毒污染的水体中则几乎绝迹.可见水霉科真菌在不同污染水体中的分布和数量变化具有一定的规律性,将其用作对水体进行综合评价的一项生物指标的可行性值得进一步研究.     

高浓度印染废水处理工程工艺条件与实例分析

研究以三相生物流化床作为工程化反应器处理印染废水的工程工艺条件及操作特性，分别测定流化床内的气相含率，兴体循环速度及体积氧传质系数。     

建设项目审批数据管理系统的设计与实现

本系统根据葫芦岛市环境保护的需要,整合各种环境保护建设项目审批数据,建立Oracle数据仓库,利用PowerBuilder技术完成对环境保护建设项目数据的管理、统计与发布。