厌氧／缺氧SBR反硝化除磷效能的研究

采用厌氧 缺氧SBR反应器对以硝酸盐作为电子受体的反硝化除磷过程进行了研究。结果表明 ,反硝化聚磷菌完全可以在厌氧 缺氧交替运行条件下得到富集。稳定运行的厌氧 缺氧SBR反应器的反硝化除磷效率 >90 % ,出水磷浓度 <1mg L。进水COD浓度对反硝化除磷的效率影响很大 ,在COD浓度 <180mg L时 ,进水COD浓度越高 ,除磷效率也就越高。较高浓度的进水COD浓度将导致有剩余的COD进入缺氧段 ,对反硝化吸磷构成不利影响。污泥龄为 16d时 ,厌氧 缺氧SBR反应器取得稳定和理想的反硝化除磷效果。污泥龄减少到 8d ,由于反硝化聚磷菌的流失导致反硝化除磷效率的下降。当污泥龄恢复到 16d时 ,经过一段时间的运行 ,反硝化聚磷菌重新得到富集 ,除磷效率恢复到 90 %以上。     

土壤中水动力弥散系数的研究进展

从溶质运移的基本方程出发 ,系统论述了国内外对土壤中水动力弥散系数测定方法的研究进展 ,并指出了上述各种方法的适用条件及存在的问题     

A/O脱氮工艺的控制策略和应用性研究

根据A/O脱氮工艺的运行状况和影响因素 ,提出了应用在线传感器连续测定曝气池中DO浓度、氨氮浓度和硝酸氮浓度 ,并据此调节供氧强度、内循环回流量、有机碳源的投加以及硝化区和反硝化区的大小 ,这是保证A/O脱氮工艺良好处理效果的重要控制策略和思想。同时对近年来国外A/O脱氮工艺自动控制的应用及研究进行了简单的回顾。     

L-半胱氨酸改性甲壳素处理含铅、镉工业废水

研究了L 半胱氨酸改性甲壳素作为吸附剂对Pb2 + 、Cd2 + 的动态吸附性能 ,同时考察了流速、溶液中离子的含量、吸附剂的相对用量等因素对吸附效果的影响 ,以及洗脱液的种类和酸度、洗脱速度、洗脱液体积等因素对解吸率的影响。结果表明 ,用该吸附剂填装的吸附柱对含Pb2 + 、Cd2 + 工业废水直接进行处理 ,处理后的水达到了排放标准。     

Persistent organic pollutants in water and surface sediments of Taihu Lake,China and risk assessment

Organic pollutants, especially persistent organic pollutants were examined in the water and surface sediments of Taihu Lake, China. Both 12 water and 12 sediment samples were collected over the lake. C-18 solid-phase extraction technique was applied to extract organic pollutants in collected water samples. Soxhlet extraction procedure was used to extract organic pollutants in sediment samples. The analysis was performed by GC-MS controlled by a Hewlett Packard chemstation. Two hundred and seventy-three kinds of organic chemicals in water were examined, 200 more than that detected in 1985; 188 kinds of chemicals in sediments were detected as well. Among them 21 kinds of chemicals belong to priority pollutants as well as 17 kinds to be the endocrine disruptors. The concentrations of the pollutants were more than 2 times higher than that in 1985. The possible source and relation to anthropogenic activity were discussed.     

Multivariate statistical study of heavy metal enrichment in sediments of the Pearl River Estuary

The concentrations and chemical partitioning of heavy metals in the sediment cores of the Pearl River Estuary were studied. Based on Pearson correlation coefficients and principal component analysis results, Al was selected as the concentration normalizer for Pb, while Fe was used as the normalizing element for Co, Cu, Ni and Zn. In each profile, sections with metal concentrations exceeding the upper 95% prediction interval of the linear regression model were regarded as metal enrichment layers. The heavy metal accumulation mainly occurred at sites in the western shallow water areas and east channel, which reflected the hydraulic conditions and influence from riparian anthropogenic activities. Heavy metals in the enrichment sections were evaluated by a sequential extraction method for possible chemical forms in sediments. Since the residual, Fe/Mn oxides and organic/sulfide fractions were dominant geochemical phases in the enriched sections, the bioavailability of heavy metals in sediments was generally low. The 206Pb/207Pb ratios in the metal-enriched sediment sections also revealed the influence of anthropogenic sources. The spatial distribution of cumulative heavy metals in the sediments suggested that the Zn and Cu mainly originated from point sources, while the Pb probably came from non-point sources in the estuary.     

Quantification of joint effect for hydrogen bond and development of QSARs for predicting mixture toxicity

A QSAR model is successfully proposed to predict the toxicity effect on Photobacterium phosphoreum by nonpolar-narcotic-chemical mixtures and/or polar-narcotic-chemical mixtures. For nonpolar-narcotic-chemical mixtures and polar-narcotic-chemical mixtures, their corresponding hydrophobicity-based QSAR models are derived from regression analysis. Comparison of these two QSAR models make us believe that it is the joint effect of hydrogen bond in polar-narcotic-chemical mixture that leads to the difference between these two models. Such joint effect of hydrogen bond can be quantified as AMH and BMH by using the different partition coefficients of mixtures in various organic phase/water systems. And the regression analysis results convinced us that the introduction of AMH does improve the quality of the QSAR model with r2=0.948, S.E.=0.166 and F=745.201 at P=0.000 for total 84 mixtures.     

汽车尾气净化催化剂涂层改性研究

汽车尾气净化催化剂的净化转化效果及其耐久性，与催化剂涂层的涂覆量以及涂层和载体的结合强度密切相关。本文研究了几种不同类型表面活性剂对浆料固体含量、涂层涂覆量以及涂层结合强度的影响。研究结果表明，不使用表面活性剂时，30％为最佳的固体含量；在使用表面活性剂的情况下，浆料的固体含量可以提高至35％。非离子型表面活性剂有助于提高催化剂涂层涂覆量，而使用离子型表面活性剂的浆料球磨过程中产生大量泡沫，无法涂覆。使用非离子型表面活性剂的催化剂涂层的结合强度最好。     

同步硝化反硝化生物脱氮技术研究

讨论了影响同步硝化反硝化反应的各参数，并进行了单因素实验与正交实验，获得了同步硝化反硝化生物脱氮工艺运行的最佳条件：DO浓度控制在0．5～2mg／L，COD浓度为600～800mg／L，混合液悬浮固体（MLSS）为5000mg/L，pH值在8．0左右，反应时间为6h。在此条件下，氨氮及COD的去除率都较高，分别达85％和95％，总氮去除率为68．5％。     

MnO2负载树脂的制备及对As（V）的去除效果

制备了大孔和DH302 2种MnO2的负载树脂。并用SEM、EDS手段表征了负载树脂，实验了负载MnO2后树脂对As（V）的去除效果。结果表明：负载树脂对As（V）的去除效果比原树脂有很大提高；吸附As（V）后的2种负载树脂，均能较好地解吸并可重新用于对As（V）的吸附实验。