双循环多级水幕脱硫塔的设计和性能测试

双循环多级水幕脱硫塔是在常规两段式湿法脱硫塔基础上加以改进而成的新型脱硫塔,其双循环浆液采用不同pH控制,低pH促进CaCO2溶解,高pH提高SO2吸收效果;同时,多级水幕强化气液流态,增加气液接触面积和传质动力,促进对SO2的吸收.实验利用SPSSV13.0软件进行正交实验设计,通过数据分析得出两个不同的优化运行方案,再利用多指标分析法中的综合平衡法进行单因素实验,得出最优运行方案.在最优运行方案条件下,即烟气流量为100 m3/h,上循环浆液pH为6.0,下循环浆液pH为4.8,上、下循环液气比均为20 L/m3,人口 SO2质量浓度为1 000mg/m3时,脱硫效率达97.8%,CaCO3利用率为95.2%,钙硫质量比约为1.03.双循环多级水幕脱硫塔具有良好的应用前景,实验结果对现场脱硫系统的调试和运行有很好的参考价值.     

Effects of open burning of rice straw on concentrations of atmospheric polycyclic aromatic hydrocarbons in central Taiwan

The sizes and concentrations of 21 atmospheric polycyclic aromatic hydrocarbons (PAHs) were measured at Jhu-Shan (a rural site) and Sin-Gang (a town site) in central Taiwan in October and December 2005. Air samples were collected using semi-volatile sampling trains (PS-1 sampler) over 16 days for rice-straw burning and nonburning periods. These samples were then analyzed using a gas chromatograph with a flame-ionization detector (GC/FID). Particle-size distributions in the particulate phase show a bimode, peaking at 0.32-0.56 microm and 3.2-5.6 microm at the two sites during the nonburning period. During the burning period, peaks also appeared at 0.32-0.56 microm and 3.2-5.6 microm at Jhu-Shan, with the accumulation mode (particle size between 0.1 and 3.2 microm) accounting for approximately 74.1% of total particle mass. The peaks at 0.18-0.32 microm and 1.8-3.2 microm at Shin-Gang had an accumulation mode accounting for approximately 70.1% of total particle mass. The mass median diameter (MMD) of 3.99-4.35 microm in the particulate phase suggested that rice-straw burning generated increased numbers of coarse particles. The concentrations of total PAHs (sum of 21 gases + particles) at the Jhu-Shan site (Sin-Gang site) were 522.9 +/- 111.4 ng/ml (572.0 +/- 91.0 ng/ml) and 330.1 +/- 17.0 ng/ml (or 427.5 +/- 108.0 ng/ml) during burning and nonburning periods, respectively, accounting for a roughly 58% (or 34%) increase in the concentrations of total PAHs due to rice-straw burning. On average, low-weight PAHs (about 87.0%) represent the largest proportion of total PAHs, followed by medium-weight PAHs (7.1%), and high-weight PAHs (5.9%). Combustion-related PAHs during burning periods were 1.54-2.57 times higher than those during nonburning periods. The results of principal component analysis (PCA)/absolute principal component scores (APCS) suggest that the primary pollution sources at the two sites are similar and include vehicle exhaust, coal/wood combustion, incense burning, and incineration emissions. Open burning of rice straw was estimated to contribute approximately 5.0-33.5% to the total atmospheric PAHs at the two sites.     

The longitudinal dependence of black carbon concentration on traffic volume in an urban environment

The purpose of this study was to evaluate the effect of traffic volume on ambient black carbon (BC) concentration in an inner-city neighborhood "hot spot" while accounting for modifying effects of weather and time. Continuous monitoring was conducted for 12 months at the Baltimore Traffic Study site surrounded by major urban streets that together carry over 150,000 vehicles per day. Outdoor BC concentration was measured with an Aethalometer; vehicles were counted pneumatically on two nearby streets. Meteorological data were also obtained. Missing data were imputed and all data were normalized to a 5-min observational interval (n = 105,120). Time-series modeling accounted for autoregressively (AR) correlated errors. This study found that outdoor BC was positively correlated at a statistically significant level with neighborhood-level vehicle counts, which contributed at a rate of 66 +/- 10 (SE) ng/m3 per 100 vehicles every 5 min. Winds from the SW-S-SE quarter were associated with the greatest increases in BC (376-612 ng/m3). These winds would have entrained BC from Baltimore's densely trafficked central business district, as well as a nearby interstate highway. The strong influence of wind direction implicates atmospheric transport processes in determining BC exposure. Dew point, mixing height, wind speed, season, and workday were also statistically significant predictors. Background exposure to BC was estimated to be 905 ng/m3. The optimal, statistically significant representation of BC's autocorrelation was AR([1:6]) x 288 x 2016, where the short-term AR factor (lags 1-6) indicated that BC concentrations are correlated for up to 30 min, and the AR factors for lags 288 and 2016 indicate longer-term autocorrelations at diurnal and weekly cycles, respectively. It was concluded that local exposure to BC from mobile sources is substantially modified by meteorological and temporal conditions, including atmospheric transport processes. BC concentration also demonstrates statistically significant autocorrelation at several time scales.     

耐热乳杆菌的分离及在食物垃圾乳酸发酵中的应用

食物垃圾在我国城市生活垃圾中占有较大比重.发酵食物垃圾生产乳酸是实现其资源化的有效方法.从厌氧发酵的食物垃圾中分离到一株耐热乳酸菌TY50,根据形态、生理生化特征和16S rDNA序列,确定该菌株属于乳杆菌属的干酪乳杆菌组群(Lactobacillus casei group),其最高生长温度为52℃.TY50发酵食物垃圾生产乳酸的最佳同液比为1:12,最适温度为45 ℃.在pH 5.5～6.0条件下,发酵食物垃圾产生36.29 g/L的乳酸,乳酸体积产牢和转化率(乳峻/垃圾干重)分别达到1.01 g/(L·h)和0.44.     

由粉煤灰合成单一的沸石及其对Cr(Ⅵ)的吸附研究

以粉煤厌为原料采用两步法合成了2种单一沸石矿物种的NaA和NaX型沸石,并对产物的结构和性能进行了详细表征.2种沸石产物的吸附性能比较结果表明,NaA型沸石优于NaX型沸石.在静态吸附条件下,研究了NaA型沸石吸附水溶液中Cr(Ⅵ)的相关参数(溶液pH值、吸附温度和吸附时间),并用Langmuir和Freundlich等温吸附线对吸附结果进行拟和.结果表明:Cr(Ⅵ)的吸附行为符合Langmuir方程;饱和吸附量为47.78 mg/g.NaA型沸石对Cr(Ⅵ)的吸附是物理和化学吸附两种行为共同作用的结果.     

改性粉煤灰在酸雾治理方面的研究

为去除化工生产等过程中产生的酸雾废气,首先用水作用法、微波法和传统湿法对粉煤灰进行改性试验,结果显示:传统湿法中的碱法效果最佳,改性后粉煤灰的BET比表面积是改性前的8.23倍.再用改性后的粉煤灰与廉价易得的天然矿物沸石和熟石灰作为活性组分,制得一种新型的复合吸附剂.常温常压下,动态吸附盐酸雾,实验结果表明:由改性粉煤灰制作的吸附剂G对盐酸雾的吸附性能比未经改性的吸附剂W有所提高,在文中所述条件下,饱和吸附量由改性前的331.4 mg/g提高到改性后的445.2 mg/g.     

废食用油活性炭脱色工艺的研究

脱色处理是提高废食用油油品质量、利用其生产生物柴油的关键环节之一.研究餐饮废食用油活性炭吸附脱色工艺,考察典型木质活性炭和煤基活性炭对脱色效果的影响,并将活性炭结构、性能指标与其脱色能力进行关联.结果表明,以弱粘性煤和褐煤为原料制备的活性炭对废食用油脱色效果较好;活性炭的总孔容积、总比表面积、微孔比表面积、微孔容积、碘值和亚甲基蓝值等性能指标与脱色效果关联度不大,而活性炭的孔径和中孔容积是决定活性炭脱色效果的主要指标.优化后废食用油活性炭脱色工艺的主要参数是:活性炭用量7%,炭粒度100～300目,脱色温度90～120℃,吸附时间为30 min,搅拌速度为10 r/min,废食用油的脱色率在50%～65%.     

碱熔融法合成NaA和NaX型粉煤灰沸石的品质表征

以粉煤灰为原料采用碱熔融法合成了2种单一沸石矿物种的NaA和NaX型沸石,并对产物的结构、性能和应用指标进行了详细表征.经x射线衍射和IR光谱分析,表明合成产物是无杂晶生成的NaA和NaX型沸石相;在扫描电镜观察下,产物分别具有NaA和NaX型沸石的立方体和八面体晶体骨架结构.DTA分析表明了合成产物中沸石水的存在,且产物热稳定性较好.通过对比,粉煤灰合成的NaA和NaX型沸石的比表面积达到了相应商品沸石的66.9%和83.6%;孔容为41.1%和70.2%;阳离子交换容量(CEC,cation exchange capacity)为82.93%和84.31%.通过比较化学组成表明,大规模应用合成产物不会对环境造成危害.     

典型铬渣简易掩埋场铬渣及土壤铬污染特征和处置分析

通过钻孔采样分析,研究了典型铬渣简易掩埋场地下铬渣及土壤铬中Cr6 、总Cr的分布特征和污染状况,结果表明,铬渣简易掩埋场铬污染程度严重,引起了周边和地下深部较大面积的土壤污染,深度达到了地下的基岩.铬含量在土壤层剖面中分布呈现规律性变化,即随土壤深度增加,Cr6 、总Cr含量逐渐下降,但绝大多数超过了危险废物毒性鉴别标准.从铬污染程度上看,总体上存在铬渣>土壤>人工填土.在此基础上,提出了铬渣及污染土壤的处置方式,为铬渣污染治理和资源化利用提供科学依据.     

QUAL2K模型在西苕溪干流梅溪段水质模拟中的应用

QUAL2K是一维稳态水质模型,由美国环保局开发并在QUAL2E模型的基础上发展起来的.采用QUAL2K模型对西苕溪干流梅溪段的水质进行了模拟和预测.针对西苕溪的具体情况,选用COD、氨氮和总磷作为模拟预测指标,用模型率定法并参考相关文献确定了COD降解系数Kc、氨氮降解系数Kn和总磷平衡系数Kp等水质参数,并对模拟结果进行了验证,结果表明预测值和实测值的相关性较好.