THE TWO‐DIMENSIONAL UPLAND EROSION MODEL CASC2D‐SED1

ABSTRACT: The two‐dimensional soil erosion model CASC2D‐SED simulates the dynamics of upland erosion during single rainstorms. The model is based on the raster‐based surface runoff calculations from CASC2D. Rainfall precipitation is distributed in time and space. Infiltration is calculated from the Green‐Ampt equations. Surface runoff is calculated from the diffusive wave approximation to the Saint‐Venant equations in two‐dimensions. Watershed data bases in raster Geographical Information System (GIS) provide information on the soil type, size fractions, soil erodibility, cropping management, and conservation practice factors for soil erosion calculations. Upland sediment transport is calculated for the size fractions (sand, silt, and clay), and the model displays the sediment flux, the amount of suspended sediment, and the net erosion and deposition using color graphics. The model has been tested on Goodwin Creek, Mississippi. The peak discharge and time to peak are within ± 20 percent and sediment transport rates within ?50 percent to 200 percent.     

Physicochemical and mineralogical characterization of soil-saprolite cores from a field research site, Tennessee

Site characterization is an essential initial step in determining the feasibility of remedial alternatives at hazardous waste sites. Physicochemical and mineralogical characterization of U-contaminated soils in deeply weathered saprolite at Area 2 of the DOE Field Research Center (FRC) site, Oak Ridge, TN, was accomplished to examine the feasibility of bioremediation. Concentrations of U in soil-saprolite (up to 291 mg kg(-1) in oxalate-extractable U(o)) were closely related to low pH (ca. 4-5), high effective cation exchange capacity without Ca (64.7-83.2 cmol(c) kg(-1)), amorphous Mn content (up to 9910 mg kg(-1)), and the decreased presence of relative clay mineral contents in the bulk samples (i.e., illite 2.5-12 wt. %, average 32 wt. %). The pH of the fill material ranged from 7.0 to 10.5, whereas the pH of the saprolite ranged from 4.5 to 8. Uranium concentration was highest (about 300 mg kg(-1)) at around 6 m below land surface near the saprolite-fill interface. The pH of ground water at Area 2 tended to be between 6 and 7 with U concentrations of about 0.9 to 1.7 mg L(-1). These site specific characteristics of Area 2, which has lower U and nitrate contamination levels and more neutral ground water pH compared with FRC Areas 1 and 3 (ca. 5.5 and <4, respectively), indicate that with appropriate addition of electron donors and nutrients bioremediation of U by metal reducing microorganisms may be possible.     

Size-differentiated chemical characteristics of Asian paleo dust: records from aeolian deposition on Chinese Loess Plateau

The Chinese Loess Plateau (CLP) receives and potentially contributes to Asian dust storms that affect particulate matter (PM) concentrations, visibility, and climate. Loess on the CLP has experienced little weathering effect and is regarded as an ideal record to represent geochemical characteristics of Asian paleo dust. Samples were taken from 2-, 9-, and 15-m depths (representing deposition periods from approximately 12,000 to approximately 200,000 yr ago) in the Xi Feng loess profile on the CLP. The samples were resuspended and then sampled through total suspended particulates (TSP), PM10, PM2.5, and PM1 (PM with aerodynamic diameters < approximately 30, 10, 2.5, and 1 microm, respectively) inlets onto filters for mass, elemental, ionic, and carbon analyses using a Desert Research Institute resuspension chamber. The elements Si, Ca, Al, Fe, K, Mg, water-soluble Ca (Ca2+), organic carbon, and carbonate carbon are the major constituents (> 1%) in loess among the four PM fractions (i.e., TSP, PM10, PM2.5, and PM1). Much of Ca is water soluble and corresponds with measures of carbonate, indicating that most of the calcium is in the form of calcium carbonate rather than other calcium minerals. Most of the K is insoluble, indicating that loess can be separated from biomass burning contributions when K+ is measured. The loess has elemental abundances similar to those of the upper continental crust (UCC) for Mg, Fe, Ti, Mn, V, Cr, and Ni, but substantially different ratios for other elements such as Ca, Co, Cu, As, and Pb. These suggest that the use of UCC as a reference to represent pure or paleo Asian dust needs to be further evaluated. The aerosol samples from the source regions have similar ratios to loess for crustal elements, but substantially different ratios for species from anthropogenic sources (e.g., K, P, V, Cr, Cu, Zn, Ni, and Pb), indicating that the aerosol samples from the geological-source-dominated environment are not a "pure" soil product as compared with loess.     

Winter and summer characteristics of airborne particles inside emperor Qin's Terra-Cotta Museum, China: a study by scanning electron microscopy-energy dispersive X-ray spectrometry

Day- and nighttime total suspended particulate matter was collected inside and outside Emperor Qin's Terra-Cotta Museum in winter and summer 2008. The purpose was to characterize the winter and summer differences of indoor airborne particles in two display halls with different architectural and ventilation conditions, namely the Exhibition Hall and Pit No. 1. The morphology and elemental composition of two season samples were investigated using scanning electron microscopy and energy dispersive X-ray spectrometry. It is found that the particle size, particle mass concentration, and particle type were associated with the visitor numbers in the Exhibition Hall and with the natural ventilation in Pit No. 1 in both winter and summer. Evident winter and summer changes in the composition and physicochemical properties of the indoor suspended particulate matters were related to the source emission and the meteorological conditions. Particle mass concentrations in both halls were higher in winter than in summer. In winter, the size of the most abundant particles at the three sites were all between 0.5 and 1.0 microm, whereas in summer the peaks were all located at less than 0.5 microm. The fraction of sulfur-containing particles was 2-7 times higher in winter than in summer. In addition to the potential soiling hazard, the formation and deposition of sulfur-containing particles in winter may lead to the chemical and physical weathering of the surfaces of the terra-cotta statues.     

Regional source identification using Lagrangian stochastic particle dispersion and HYSPLIT backward-trajectory models

The main objective of this study was to investigate the capabilities of the receptor-oriented inverse mode Lagrangian Stochastic Particle Dispersion Model (LSPDM) with the 12-km resolution Mesoscale Model 5 (MM5) wind field input for the assessment of source identification from seven regions impacting two receptors located in the eastern United States. The LSPDM analysis was compared with a standard version of the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) single-particle backward-trajectory analysis using inputs from MM5 and the Eta Data Assimilation System (EDAS) with horizontal grid resolutions of 12 and 80 km, respectively. The analysis included four 7-day summertime events in 2002; residence times in the modeling domain were computed from the inverse LSPDM runs and HYPSLIT-simulated backward trajectories started from receptor-source heights of 100, 500, 1000, 1500, and 3000 m. Statistics were derived using normalized values of LSPDM- and HYSPLIT-predicted residence times versus Community Multiscale Air Quality model-predicted sulfate concentrations used as baseline information. From 40 cases considered, the LSPDM identified first- and second-ranked emission region influences in 37 cases, whereas HYSPLIT-MM5 (HYSPLIT-EDAS) identified the sources in 21 (16) cases. The LSPDM produced a higher overall correlation coefficient (0.89) compared with HYSPLIT (0.55-0.62). The improvement of using the LSPDM is also seen in the overall normalized root mean square error values of 0.17 for LSPDM compared with 0.30-0.32 for HYSPLIT. The HYSPLIT backward trajectories generally tend to underestimate near-receptor sources because of a lack of stochastic dispersion of the backward trajectories and to overestimate distant sources because of a lack of treatment of dispersion. Additionally, the HYSPLIT backward trajectories showed a lack of consistency in the results obtained from different single vertical levels for starting the backward trajectories. To alleviate problems due to selection of a backward-trajectory starting level within a large complex set of 3-dimensional winds, turbulence, and dispersion, results were averaged from all heights, which yielded uniform improvement against all individual cases.     

A Common Representative Intermediates (CRI) mechanism for VOC degradation. Part 3: Development of a secondary organic aerosol module

A Photochemical Trajectory Model (PTM), containing the Master Chemical Mechanism version 3.1 (MCM v3.1) coupled with an optimised representation of gas–aerosol absorptive partitioning of 365 oxygenated product species, has been used to simulate mass concentrations of secondary organic aerosol (SOA) for the conditions of the TORCH-2003 campaign in the south-east UK in late July and August 2003. A comprehensive reference dataset of 50 case study arrival events (and 4750 associated hourly air mass history events) has been compiled, which considers the base case conditions and scenarios in which emissions of anthropogenic pollution have been reduced by factors of up to 100. The relative contributions of SOA derived from anthropogenic and biogenic precursors are presented for the range of conditions, and the composition of these simulated components is discussed in terms of average molecular formulae, atomic ratios (H/C, O/C and N/C) and organic aerosol mass to organic carbon mass ratios (OM/OC), which are compared to reported measurements. The MCM v3.1 dataset has been used as a reference benchmark for development and optimisation of a reduced (14 species) SOA module for use with version 2 the Common Representative Intermediates mechanism (CRI v2), described in the first of two preceding companion papers [Jenkin, M.E., Watson, L.A., Utembe, S.R., Shallcross, D.E., 2008a. A Common Representative Intermediates (CRI) mechanism for VOC degradation. Part 1: gas phase mechanism development. Atmospheric Environment, 42, pp. 7185–7195. doi:10.1016/j.atmosenv.2008.07.028.]. The resultant version of the PTM containing CRI v2 and the reduced SOA module has been used to simulate the entire TORCH-2003 campaign at hourly resolution, and the contributions of SOA derived from anthropogenic and biogenic precursors are presented and discussed. The reduced SOA module is also shown to be compatible with the most reduced CRI variant (CRI v2-R5), described in the second of two preceding companion papers [Watson, L.A., Shallcross, D.E., Utembe, S.R., Jenkin, M.E., 2008. A Common Representative Intermediates (CRI) mechanism for VOC degradation. Part 2: gas phase mechanism reduction. Atmospheric Environment, 42, pp. 7196–7204. doi:10.1016/j.atmosenv.2008.07.034.], which is considered appropriate as a traceable reference mechanism in global simulations.