全文获取类型
收费全文 | 1875篇 |
免费 | 107篇 |
国内免费 | 577篇 |
专业分类
安全科学 | 136篇 |
废物处理 | 116篇 |
环保管理 | 140篇 |
综合类 | 1078篇 |
基础理论 | 309篇 |
污染及防治 | 555篇 |
评价与监测 | 98篇 |
社会与环境 | 64篇 |
灾害及防治 | 63篇 |
出版年
2024年 | 6篇 |
2023年 | 48篇 |
2022年 | 132篇 |
2021年 | 102篇 |
2020年 | 77篇 |
2019年 | 81篇 |
2018年 | 76篇 |
2017年 | 86篇 |
2016年 | 103篇 |
2015年 | 104篇 |
2014年 | 126篇 |
2013年 | 182篇 |
2012年 | 149篇 |
2011年 | 161篇 |
2010年 | 120篇 |
2009年 | 112篇 |
2008年 | 108篇 |
2007年 | 113篇 |
2006年 | 75篇 |
2005年 | 60篇 |
2004年 | 39篇 |
2003年 | 56篇 |
2002年 | 63篇 |
2001年 | 44篇 |
2000年 | 48篇 |
1999年 | 46篇 |
1998年 | 39篇 |
1997年 | 37篇 |
1996年 | 42篇 |
1995年 | 25篇 |
1994年 | 12篇 |
1993年 | 25篇 |
1992年 | 14篇 |
1991年 | 9篇 |
1990年 | 10篇 |
1989年 | 3篇 |
1988年 | 10篇 |
1987年 | 3篇 |
1986年 | 3篇 |
1984年 | 3篇 |
1982年 | 2篇 |
1981年 | 2篇 |
1958年 | 1篇 |
1956年 | 2篇 |
排序方式: 共有2559条查询结果,搜索用时 984 毫秒
871.
Density functional theory (DFT) and ab initio method are employed to elucidate the mechanisms for O(3)-initiated oxidation of n-butyl vinyl ether (n-BVE) and its isomers (i-BVE and t-BVE). For each BVE, the reactions proceed via O(3) cycloaddition resulting in the formation of primary ozonides (POZs) and then two self-decomposition pathways of POZs are followed. Major products are identified to be formaldehyde and butyl formates (CH(3)CH(2)CH(2)CH(2)OCHO for n-BVE, (CH(3))(2)CHCH(2)OCHO for i-BVE and (CH(3))(3)COCHO for t-BVE). The total and individual rate constants for main product channels have been calculated using the modified multichannel Rice-Ramsperger-Kassel-Marcus (RRKM) approach. At 298 K and 101 kPa, the calculated total rate constants are 2.50×10(-16), 3.41×10(-16) and 4.17×10(-16) cm(3) molecule(-1) s(-1) for n-BVE+O(3), i-BVE+O(3) and t-BVE+O(3), respectively, which are in perfect agreement with experimental results. The total rate coefficients are almost pressure independent in the range of 0.001-101 kPa but obviously positive temperature dependent over the whole study temperature range (200-400 K). Also, the favorable reaction pathways have been determined through the estimation of branching ratios. Moreover, the influence of alkoxy group structure on the reactivity of vinyl ethers was examined. 相似文献
872.
序批式生物膜反应器处理农村生活污水的填料对比研究 总被引:1,自引:0,他引:1
选用4种填料进行序批式生物膜反应器(SBBR)处理农村生活污水的研究,通过出水COD、NH4+-N等指标的测定以及生物膜的扫描电镜观察,考察了运用不同填料时SBBR的污染物去除情况和生物膜的长势,以期筛选出适用于农村生活污水处理的填料。结果表明,3#、4#SBBR(分别选用组合填料和碳素纤维填料)的DO、pH波动幅度均相对较小,比1#、2#SBBR(分别选用立体网状填料及海绵填料)更加稳定;4#SBBR的COD去除效果最好,水力停留时间仅需5h,3#SBBR的COD去除效果其次,所需水力停留时间为6h,而1#、2#SBBR在运行8h时也无法将COD完全消化;3#、4#SBBR出水的NH4+-N、TN去除效果均高于1#、2#SBBR;采用4种填料的SBBR的生物膜长势优劣情况为碳素纤维填料>组合填料>海绵填料>立体网状填料;碳素纤维填料及组合填料在受到进水负荷冲击后,能相对较快适应环境,且填料上的微生物活性较高,较适合运用于中国农村生活污水的处理。 相似文献
873.
874.
通过批实验和柱实验研究了三氯乙烯(TCE)初始浓度、四氯乙烯(PCE)等对零价铁去除三氯乙烯的影响,并建立了三氯乙烯降解的反应动力学方程。结果表明:(1)零价铁对TCE具有较好的降解效果,反应符合准一级反应动力学方程,表观反应速率常数随TCE浓度的增加而减小;(2)在铁粉充足的条件下,TCE初始浓度对降解效果影响不显著,且TCE去除率皆可达到90%以上;(3)PCE的存在抑制了TCE的脱氯反应。PCE和TCE共存时,TCE的最大去除率仅为64.2%;TCE脱氯反应的表观反应速率明显降低,反应半衰期由TCE单独存在时的6.8~9.7 h增大到66 h~346.5 h。 相似文献
875.
根据空气质量日报的实际需要,引入了Excel软件神经网络技术建立空气质量日报污染指数计算模型,采用LM算法提高了计算精度,并将模型应用于北海市空气日报。结果表明:此法较之实际公式计算法更加快捷方便,并且计算结果相当吻合。 相似文献
876.
韩静 《中国环境管理干部学院学报》2012,22(2):52-54
垃圾填埋场渗滤液属于高浓度氨氮废水,其水量、水质特性变化大,成分复杂,因此较难处理。反渗透分离技术能有效截留垃圾渗滤液中溶解态的有机和无机污染物。采用三级反渗透处理垃圾渗滤液工艺处理后的出水水质,能够满足《生活垃圾填埋污染控制标准》(DB16889-2008)要求,并把渗滤液浓缩液回灌于填埋场。 相似文献
877.
研究了pH、初始浓度、时间及温度对甲基红在壳聚糖上吸附富集的影响。结果表明,pH是影响甲基红吸附富集的重要因素,最佳pH3.4。其动力学行为更好地符合Lagergren准二级反应动力学模型,随着温度增加,平衡吸附量减少。吸附过程的表观活化能(Ea)为7.518kJ/mol。壳聚糖对甲基红的吸附过程较好地符合Freundlich吸附等温方程。计算得到吸附过程的热力学参数△G0、△H0。和△S0分别为-24.88kJ/mol(303K)、-22.15kJ/mol和8.783J/(mol·K),表明壳聚糖对甲基红的吸附是一个自发的放热过程。红外光谱分析得到,壳聚糖吸附甲基红的过程中,壳聚糖分子中存在的大量羟基和氨基发挥了主要作用。 相似文献
878.
879.
排导槽是泥石流治理常用的工程措施,泥石流若在槽内淤积,将极大影响排导槽防治效果。目前国内现行规范中没有关于排导槽淤积情况计算的相关条款,导致排导槽被泥石流淤埋的工程事故时有发生。鉴于此,分析了排导槽淤堵的常见原因,对现有的一些排导槽淤积验算公式进行了分析和整理,提出了一套基于槽宽验算、槽内泥深及流速验算等公式的排导槽防淤设计验算方法。该方法在雅(安)泸(沽)高速公路沿线某泥石流沟V型排导槽淤埋事故的处理中进行了应用,重建的排导槽经受了2011年6月17日特大暴雨形成的泥石流的考验,说明该方法实施效果良好,可供相关研究与设计参考。 相似文献
880.
Guo B Gong L Duan E Liu R Ren A Han J Zhao W 《Journal of the Air & Waste Management Association (1995)》2012,62(4):485-488
IMPLICATIONS: During the production of penicillin, a mass of waste bacterial residue is generated. In the past, the bacterial residues have been used for food additives. Unfortunately, doubts of their suitability as a feedstock have been raised because of the small amount of antibiotics and the degradation products remaining in the bacterial residues. So, penicillin bacterial residue is one of the hazardous wastes. Therefore, penicillin bacterial residue should be managed in accordance with the hazardous waste. To get a right method, the penicillin bacterial residue was characterized. 相似文献