油气田工程职业病危害控制效果评价常见问题与对策

根据建设项目职业病危害控制效果评价技术导则要求,通过对油气田地面工程职业病危害控制效果评价及职业病防护设施竣工验收的实践经验,归纳评价过程中现场调查及检测常见的实际问题及难点,总结经验,探讨解决对策,使油气田建设项目职业病危害控制效果评价更加科学、公正、客观、真实。     

Fe(III)–EDDS complex in Fenton and photo-Fenton processes: from the radical formation to the degradation of a target compound

The present work compares the efficiency of homogenous Fenton and photo-Fenton processes in the presence of Fe(III)–EDDS complex under different experimental conditions. 4-tert-Butylphenol (4-t-BP), which is one of the endocrine disrupting chemicals, was used as a model pollutant to investigate the Fenton and photo-Fenton application. The efficiency of homogenous photo-Fenton process was significantly much higher than homogenous Fenton process, which is due to the rapid formation of Fe²⁺ under UV irradiation of the iron complex and the photochemical formation of HO^? from the photolysis of the complex Fe(III)–EDDS. Through the degradation of 4-t-BP, the effect of Fe(III)–EDDS concentration, H₂O₂ concentration, pH, and oxygen was investigated in both processes. Such trend was also correlated with pH calculating the polychromatic Fe²⁺ quantum yield formation at pH 4.0, 6.0, and 8.6. The results showed that at high Fe(III)–EDDS and H₂O₂ concentrations, a negative effect was found. By the way, the Fenton process was found to be enhanced at basic pH. These results can be very useful for the use and optimization of such iron complex in water treatment process as function of different physico-chemical conditions.     

宁波市大气可吸入颗粒物PM1o和PM2.5的源解析研究

在宁波市布设4个代表性点位,于2010年春季、夏季和冬季进行大气PM10和PM2.s的采样,同时采集了多种颗粒物源样品,建立了PM10、PM2.5和源样品的化学成分谱.采用化学质量平衡模型(CMB)对宁波市PM10、PM2.5进行源解析.结果表明,城市扬尘、煤烟尘、机动车尾气尘是宁波市PM10、PM2.5的3大污染源,...     

高硬度富锶地下水的软化沉淀-超滤膜联用工艺

针对一种高硬度富锶地下水,分别采用石灰和石灰-碳酸钠两种方法,利用药剂软化/超滤膜工艺对其进行软化处理,同时考察了药剂投量对出水锶含量的影响。结果表明,采用石灰软化/超滤膜法,Ca(OH)2最佳投加量为270 mg/L时,出水总硬度(以CaCO3计)由287.12 mg/L降低到96.44 mg/L,硬度去除率为66.41%,出水锶含量也由原水中的0.37 mg/L下降为0.21 mg/L;而采用石灰-碳酸钠软化/超滤膜法,Ca(OH)2和Na2CO3最佳投加量分别为270 mg/L、160mg/L时,出水总硬度降低到60.34 mg/L,硬度去除率达78.98%,锶含量仅为0.02 mg/L。2种处理方法出水总硬度均达到预期目标,石灰软化/超滤膜法可使出水锶含量满足富锶水的要求,而石灰-碳酸钠软化/超滤膜法则造成了对人体有益微量元素锶的大量损失。     

Degradation of bisphenol A in aqueous solution by persulfate activated with ferrous ion

Degradation of bisphenol A (BPA) in aqueous solution was studied with high-efficiency sulfate radical (SO₄ ^?·), which was generated by the activation of persulfate (S₂O₈ ^2?) with ferrous ion (Fe²⁺). S₂O₈ ^2? was activated by Fe²⁺ to produce SO₄ ^?·, and iron powder (Fe⁰) was used as a slow-releasing source of dissolved Fe²⁺. The major oxidation products of BPA were determined by liquid chromatography-mass spectrometer. The mineralization efficiency of BPA was monitored by total organic carbon (TOC) analyzer. BPA removal efficiency was improved by the increase of initial S₂O₈ ^2? or Fe²⁺ concentrations and then decreased with excess Fe²⁺ concentration. The adding mode of Fe²⁺ had significant impact on BPA degradation and mineralization. BPA removal rates increased from 49 to 97 % with sequential addition of Fe²⁺, while complete degradation was observed with continuous diffusion of Fe²⁺, and the latter achieved higher TOC removal rate. When Fe⁰ was employed as a slow-releasing source of dissolved Fe²⁺, 100 % of BPA degradation efficiency was achieved, and the highest removal rate of TOC (85 %) was obtained within 2 h. In the Fe⁰–S₂O₈ ^2? system, Fe⁰ as the activator of S₂O₈ ^2? could offer sustainable oxidation for BPA, and higher TOC removal rate was achieved. It was proved that Fe⁰–S₂O₈ ^2? system has perspective for future works.     

Different reaction mechanisms of diphenylether and 4-bromodiphenylether with nitrous acid in the 355 nm laser flash photolysis of mixed aqueous solution

The microscopic reaction mechanisms of diphenylether (DPE) and 4-bromodiphenylether (4-BrDPE) with nitrous acid (HNO(2)) in the absence of O(2) have been explored by the 355nm laser flash photolysis. It was proposed that OH radical, from the photolysis of HNO(2), added to DPE forms the C(12)H(10)O-OH adduct while added to 4-BrDPE forms the 4-BrDPE-OH and 4-BrOH-DPE adducts. The first-order decay rate constants of the C(12)H(10)O-OH adduct, 4-BrDPE-OH adduct and 4-BrOH-DPE adduct were measured to be (1.86+/-0.14)x10(5)s(-1), (2.19+/-0.04)x10(5)s(-1) and (1.56+/-0.03)x10(5)s(-1), respectively. The final photolysis products of DPE and HNO(2) identified by GC/MS analysis were phenol, o-hydroxydiphenylether, p-hydroxydiphenylether and p-nitrodiphenylether, while the final photolysis product of 4-BrDPE and HNO(2) identified by LC/MS analysis was mainly the dimer.     

植物及土壤碳同位素组成对环境变化响应研究进展

植物和土壤的δ13C（碳同位素组成）能可靠记录环境信息,综合反映植物的生理生态特征以及碳循环过程中的生物化学过程,为人们理解生态系统碳循环提供有用信息.因此,研究植物和土壤的δ13C与环境因子的关系可以揭示生态系统碳循环的格局及其控制因子,进而有效预测全球变化及其对生态系统的影响.对植物和土壤的δ13C以及二者的差值（Δδ13C）与气候因子（如温度、降水量、大气压强等）、土壤因子（如C/N、土壤质地、土壤pH等）的关系进行了综述.现有研究表明:C₃植物的δ13C与降水量、大气压强均呈负相关,与温度的关系非常复杂,而针对C₄植物和在群落水平上开展的研究还较少;土壤δ13C与降水量、土壤C/N、土壤w（粉粒）及w（黏粒）均呈负相关,与温度、土壤pH、土壤w（砂粒）均呈正相关,然而环境因素间的耦合作用使得情况复杂化,多种环境因素的匹配关系究竟如何影响土壤δ13C的机制问题仍有待深入研究;Δδ13C能够更加全面准确地反映土壤碳循环信息,但对其与环境因子关系的研究较少,并且影响Δδ13C的驱动因子及机制也不明确.因此,在土壤-植物体系内,同时在物种和群落水平上,进行植物和土壤δ13C特别是Δδ13C与环境因子关系的研究,能够更加准确地预测和揭示环境变化对生态系统碳循环的影响,这也将是今后该领域的研究重点.      

中国石化安全信息管理平台的设计与开发

阐述了中国石化安全信息管理平台的设计思想和主要功能,通过实施中国石化内部网运行的安全信息管理系统,为中国石化安全管理信息化提供了应用平台.     

Fe2+和零价铁活化过一硫酸盐降解酸性橙7

采用环境友好的Fe~(2+)和零价铁(ZVI)作活化剂,活化过一硫酸盐(PMS)来降解水中酸性橙7(AO7).结果表明,在Fe~(2+)-PMS体系中,AO7的降解效果不佳,但通过添加适量的络合剂,AO7的去除率会大幅提高.ZVI在PMS存在下被腐蚀,并能够缓慢、持续不断地释放Fe~(2+).ZVI-PMS体系可以在比较宽泛的pH范围(3～9)有效、快速地降解AO7,并且在酸性条件下降解速率较快.淬灭实验结果显示,硫酸根自由基(SO_4~(·-))对AO7的降解起主要作用.除了Cl~-和高浓度(50 mmol·L~(-1))的NO_3~-能够促进AO7的降解外,其他水中共存的阴离子对AO7在ZVI-PMS体系中的降解具有抑制作用,而腐殖酸(HA)则无明显影响.AO7在超纯水中的去除率高于其他实际水体,但反应90 min后,污水厂出水过滤水和胶体浓缩液中的AO7去除率也可高达98.6%和87.6%,说明ZVI-PMS可能可以有效地去除含有较高DOC含量的污水中的AO7.利用GC-MS检测到辐照后溶液中有3种中间产物,推测主要是通过AO7偶氮键断键后的中间产物进一步氧化形成.此外,TOC在一定程度上降低,说明部分AO7被矿化.     

不同模式对珠三角地区细颗粒物污染模拟效果对比评估

运用CAMxv5.4、CMAQv4.7.1、CMAQv5.0.2(AEOR5)和CMAQv5.02(AEOR6)模拟2013年12月珠三角地区空气质量,并对比评估不同模式、不同模式版本、不同气溶胶机制在PM_(2.5)模拟上的表现.各模式在PM_(2.5)的模拟上均表现良好,呈现出合理且相似的时空特征,在市区和非超标时段CAMx模式表现最优,而在郊区和超标时段则不存在表现最优的模式.CMAQ系列模式在市区和郊区、超标时段和非超标时段均表现相似,CMAQ4模式表现均优于CMAQ5系列模式,而CMAQ5AE6模式在反映PM_(2.5)的浓度水平的能力上强于CMAQ5AE5模式,但在重现PM_(2.5)小时浓度变化趋势的能力上却劣于CMAQ5AE5模式.边界条件是不同模式PM_(2.5)模拟差异的主要来源之一,且在超标时段边界条件对PM_(2.5)模拟效果的影响大于非超标时段.此外,CAMx模式与CMAQ5AE5模式之间硫酸盐、硝酸盐和有机颗粒的差异导致了其PM_(2.5)模拟表现上差异,CMAQ4模式与CMAQ5AE5模式之间硫酸盐、硝酸盐和铵盐等无机盐组分的差异是导致其PM_(2.5)模拟差异的主要原因,硝酸盐和铵盐的差异是CMAQ5AE5模式与CMAQ5AE6模式之间PM_(2.5)模拟差异的主要因素.