Spatial sampling and the environment: some issues and directions

In this paper we summarize research issues for spatial environmental sampling stemming from a NISS/USEPA workshop held on 21-22 September 1994 at Chapel Hill, NC.     

Inhibition of attachment of larval barnacles,Balanus amphitrite,by bacterial surface films

Films of bacteria on solid substrata can positively or negatively influence the attachment of marine invertebrate larvae. Effects of marine bacteria on the attachment of cypris larvae of the barnacle Balanus amphitrite Darwin were examined in the laboratory. Bacteria, grown to mid-exponential phase and allowed to adsorb irreversibly to polystyrene petri dishes, attached in densities of 10⁷ cells cm^-2. Assays (22h) were used to compare the effects of adsorbed cells of 18 different bacterial species on larval barnacle attachment. Most of the adsorbed bacteria either inhibited or had no effect on larval attachment compared to clean surfaces. Experiments testing the effect of larval age on barnacle attachment were conducted with six species of bacteria and showed that older larvae attached in higher percentages to clean surfaces and that bacterial films generally inhibited larval attaschment. Both the species of bacteria and the in situ age of the adsorbed bacteria affected barnacle attachment response: older films of Deleya (Pseudomonas) marina were more inhibitory. Bacterial extracellular materials may be involved in the inhibitory process.     

北京春季城区与远郊区不同大气粒径颗粒物中水溶性离子的分布特征

为比较北京城区与远郊区大气颗粒物中水溶性无机离子的组成特征,2012年4月,利用Andersen分级撞击式采样器同时在2个采样点进行大气颗粒物分级采样,样品采用离子色谱分析.结果表明,城区和上甸子大气颗粒物中水溶性无机离子总浓度分别为(83.7±48.9)μg·m-3和(75.5±52.9)μg·m-3,NO-3、SO2-4和NH+4是最主要的水溶性无机离子,分别占总离子浓度的81.2%和84.2%.粒径分布显示,Mg2+和Ca2+在5.8～9.0μm的粒径范围出现峰值,Na+、NH+4、Cl-在0.43～1.1μm和4.7～9.0μm的粒径范围出现双峰,K+、NO-3和SO2-4在0.65～2.1μm的粒径范围出现峰值.后向轨迹簇分析表明,气团来自南方时,城区和上甸子二次离子浓度分别为(92.4±40.0)μg·m-3和(95.0±35.4)μg·m-3,来自其他方向时,分别为(24.0±10.8)μg·m-3和(13.3±10.6)μg·m-3.     

Evidence for the "grasshopper" effect and fractionation during long-range atmospheric transport of organic contaminants

Although there is indisputable evidence that long-range atmospheric transport (LRAT) of organic contaminants occurs on a global scale, uncertainties remain about the detailed mechanism and extent of this phenomenon as well as the physical-chemical properties which facilitate LRAT. In this study, we discuss how mass balance models and monitoring data can contribute to a fuller understanding of the mechanism and extent of LRAT. Specifically we address the issues of "grasshopping" or "hopping" (the extent to which molecules are subject to multiple hops as distinct from a single emission-deposition event) and "global fractionation" (the differing behavior of chemicals as they are transported). It is shown that simple mass balance models can be used to assist the interpretation of monitoring data while also providing an instrument that can be used to assess the LRAT potential and the extent of hopping that organic substances may experience. The available evidence supports the notion that many persistent organic pollutants experience varying degrees of "hopping" during their environmental journey and as a consequence become fractionated with distance from source.     

An Automated Technique for Delineating and Characterizing Valley-Bottom Settings

Accurate delineation and characterization of valley-bottom settings is crucial to the assessment of the biological and geomorphological components of riverine systems; yet, to date, most valley-bottom mapping endeavors have been done manually. To improve this situation, we developed automated techniques in a Geographic Information System (GIS) for delineating and characterizing valley-bottom settings in river basins ranging in size from approximately 1,000–10,000 km². All procedures were developed with ARC/INFO GIS software and fully automated in Arc Macro Language (AML). The GRID module is required for valley-bottom delineation and slope calculations; whereas characterization (i.e., measuring the width of the valley-bottom zone) requires Coordinate Geometry (COGO) in the ARCEDIT module. The process requires three inputs: a polygon coverage of the analysis area; an arc coverage of its hydrography, and a grid representing its digital elevation. The AML is designed to operate within a wide range of computer memory/disk space options, and it allows users to customize several procedures to match the scale and complexity of a given analysis area with available computer hardware.     

The solid-phase controls on the mobility of heavy metals at the Copper Cliff tailings area, Sudbury, Ontario, Canada

The Copper Cliff Tailings Disposal Area, located near Sudbury, Ontario, covers an area of approximately 2200 ha and constitutes more than 10% of the total area of all mine tailings in Canada. The area has been utilized since 1936, receiving sulphide-containing tailings from the Inco Sudbury operations. Field measurements of pore-gas oxygen and carbon dioxide in the vadose zone indicate that sulphide oxidation has progressed to depths of 1.6 m to 1.7 m within the tailings. The oxidation of sulphide minerals within the vadose zone, and the accompanying dissolution of carbonate and aluminosilicate minerals within these tailings releases SO₄, Fe(II) and other metals to the pore water. In the vadose and saturated zones, concentrations of Fe and Ni exceed 10100 mg/l and 2210 mg/l, respectively. These high concentrations of dissolved metals are attenuated by a series of precipitation, coprecipitation and adsorption reactions. The precipitation of secondary sulphate and hydroxide phases also create hardpan layers at or near the oxidation front. Geochemical modelling of the pore-water chemistry suggests that pH-buffering reactions are occurring within the shallow oxidized zones, and that secondary-phase precipitation is occurring at or near the underlying hardpan and transition zones. Mineralogical study of the tailings confirmed the presence of jarosite, gypsum and goethite within the shallow tailings, suggesting that these phases are controlling the dissolved concentrations of Fe, SO₄ and Ca. Extraction experiments conducted on the tailings solids indicate that the constituents contained in the water-soluble fraction of the shallow, weathered tailings are derived from the original pore water and the dissolution of highly soluble phases such as gypsum. The acid-leachable fraction of the weathered tailings accounts for up to 25% of the heavy metals, and the reducible fraction may contain up to 100% of the heavy metals within the shallow, weathered tailings. Based on the pore water profiles and the geochemistry of the tailings solids, a relative mobility scale of Fe=Mn=Ni=Co>Cd Zn>Cr=Pb>Cu can be determined.     

Antimony distribution and environmental mobility at an historic antimony smelter site, New Zealand

A historic antimony smelter site at Endeavour Inlet, New Zealand has smelter residues with up to 17 wt.% antimony. Residues include coarse tailings (cm scale particles, poorly sorted), sand tailings (well sorted) and smelter slag (blocks up to 30 cm across). All of this material has oxidised to some degree over the ca. 100 years since the site was abandoned. Oxidation has resulted in acidification of the residues down to pH 2-5. Smelter slag contains pyrrhotite (FeS) and metallic antimony, and oxidation is restricted to surfaces only. The coarse tailings are the most oxidised, and few sulfide grains persist. Unoxidised sand tailings contain 10-20 vol.% stibnite (Sb2S3) containing up to 5% As, with subordinate arsenopyrite (FeAsS), and minor pyrite (FeS2). The sand tailings are variably oxidised on a scale of 2-10 cm, but original depositional layering is preserved during oxidation and formation of senarmontite (Sb2O3). Oxidation of sand tailings has resulted in localised mobility of both Sb and As on the cm scale, resulting in redistribution of these metalloids with iron oxyhydroxide around sand grain boundaries. Experiments demonstrate that Sb mobility decreases with time on a scale of days. Attenuation of both As and Sb occurs due to adsorption on to iron oxyhydroxides which are formed during oxidation of the smelter residues. There is no detectable loss of Sb or As from the smelter site into the adjacent river, <50 m away, which has elevated Sb (ca. 20 microg/l) and As (ca. 7 microg/l) from mineralised rocks upstream. Despite the high concentrations of Sb and As in the smelter residues, these metalloids are not being released into the environment.     

The effects of crude oil and the effectiveness of cleaner application following oiling on US Gulf of Mexico coastal marsh plants

Field studies were conducted in two different marsh habitats in Louisiana coastal wetlands to evaluate the effects of oiling (using South Louisiana Crude oil, SLC) and the effectiveness of a shoreline cleaner (COREXIT 9580) in removing oil from plant canopies. The study sites represented two major marsh habitats; the brackish marsh site was covered by Spartina patens and the freshwater marsh was covered by Sagittaria lancifolia. Field studies were conducted in each habitat using replicated 5.8 m2 plots that were subjected to three treatments; oiled only, oiled + cleaner (cleaner was used 2 days after oiling), and a control. Plant gas exchange responses, survival, growth, and biomass accumulation were measured. Results indicated that oiling led to rapid reductions in leaf gas exchange rates in both species. However, both species in 'oiled + cleaned' plots displayed improved leaf conductance and CO2 fixation rates. Twelve weeks after treatment initiation, photosynthetic carbon fixation in both species had recovered to normal levels. Over the short-term, S. patens showed more sensitivity to oiling with SLC than S. lancifolia as was evident from the data of the number of live shoots and above-ground biomass. Above-ground biomass remained significantly lower than control in S. patens under 'oiled' and 'oiled + cleaned' treatments while it was comparable to controls in S. lancifolia. These studies indicated that the cleaner removed oil from marsh grasses and alleviated the short-term impact of oil on gas exchange function of the study plants. However, use of cleaner had no detectable effects on above-ground biomass production or regeneration at the end of the first growing season in S. patens. Similarly, no beneficial effects of cleaner on carbon fixation and number of live shoots were apparent beyond 12 weeks in S. lancifolia.     

Long-term increases in surface water dissolved organic carbon: observations, possible causes and environmental impacts

Dissolved organic carbon (DOC) concentrations in 22 UK upland waters have increased by an average of 91% during the last 15 years. Increases have also occurred elsewhere in the UK, northern Europe and North America. A range of potential drivers of these trends are considered, including temperature, rainfall, acid deposition, land-use, nitrogen and CO2 enrichment. From examination of recent environmental changes, spatial patterns in observed trends, and analysis of time series, it is suggested that DOC may be increasing in response to a combination of declining acid deposition and rising temperatures; however it is difficult to isolate mechanisms based on monitoring data alone. Long-term DOC increases may have wide-ranging impacts on freshwater biota, drinking water quality, coastal marine ecosystems and upland carbon balances. Full understanding of the significance of these increases requires further knowledge of the extent of natural long-term variability, and of the natural "reference" state of these systems.