Further studies using X-ray fluorescence to sample lead contaminated carpeted surfaces

The sampling of carpeted surfaces to test for lead contamination primarily focuses upon vacuum techniques. Vacuum sampling techniques, however, require time-consuming, expensive laboratory analysis of the dusts obtained and are unable to determine total lead load on the carpet. X-ray fluorescence (XRF) analysis is an on-site, inexpensive, non-destructive, quick technique for predicting metals levels in a variety of media, such as water, soil, filter paper and painted surfaces. A 1992 study of the feasibility of XRF to analyze for lead and soil loadings on carpeted surfaces indicated that XRF can detect lead at a low enough level to warrant further study. This paper expands this earlier study and developes lead and soil loading calibration curves for three different carpet types based upon XRF lead L-beta peak areas and XRF iron and barium K-alpha peak and background areas. Results indicate that variation in the data can be reduced through modifications of the XRF analysis technique, thus reducing the statistically determined detection level, and that carpet type does affect the calibration. Detection levels of approximately 70 mg/m² for lead and 5 g/m² for soil were obtained. Overall, good agreement was found between results of this study and the earlier one. XRF shows excellent potential for quantitative analysis of lead on carpeted surfaces.     

Ambient air concentrations of PCDDs,PCDFs, coplanar PCBs,and PAHs at the Mississippi Sandhill Crane National Wildlife Refuge,Jackson County,Mississippi

Our objective was to determine the levels of selected airborne contaminants in ambient air at the Mississippi Sandhill Crane National Wildlife Refuge, Mississippi, that might be affecting the health of endangered cranes living there. Two high-volume air samplers were operated at separate locations on the Refuge during May–September 1991. The sampling media were micro-quartz filters in combination with polyurethane foam plugs. Composite bimonthly samples from each station were analyzed for polychlorinated dibenzo-p-dioxins (PCDDs), dibenzofurans (PCDFs), coplanar polychlorinated biphenyls (PCBs), and polycyclic aromatic hydrocarbons (PAHs). Overall, residue concentrations were low. The toxic PCDD isomer 2,3,7,8-tetra-CDD was not detected, nor was penta-CDD. There was no difference (P>0.05) in residue concentrations between stations or over time and meteorological parameters were not correlated with residue concentrations. Because contaminant levels and patterns may differ seasonally, we recommend that air samples collected during winter months also be analyzed for these same chemical groups.     

Heavy metals in the SPM of air in the environment surrounding a ferro-alloy industrial plant in India

Prices for ferro-alloys have hardened due to the closure of plants in developed countries on account of increasingly stringent pollution control legislation, resulting in a higher cost of production. A ferro-alloy industry with a capacity of 80000 MT per annum was selected to study the nature of pollution. Because of the objectionable nature of polluting air in and around the plant it was located in a rural area where there was no other industry. The area was agriculturally active and there was no effective control system for this plant.The quality of ambient air around the plant site is discussed in this paper along with the meteorological conditions. The maximum concentration of suspended particulate matter (SPM) was 768 µg/NM³ downwind of the plant, minimum 184 µg/NM³, and the average was more than 446 µg/NM³. The presence of heavy metals, viz. Fe, Mn, Cr and Pb, was also assessed. The concentration of Fe was 50 µg/NM³ downwind and 10 µg/NM³ upwind. The concentration of other metals followed a similar trend.     

Trend evaluation of water quality parameters in the Niagara and St. Lawrence Rivers

Physical and chemical (nutrients and major ions) indicators of water quality monitored by Environment Canada between 1977 and 1987 in the Niagara River at Niagara-on-the-Lake and in the St. Lawrence River at Wolfe Island are analyzed for seasonal and annual variations. Parametric methods such as moving averages and linear regression and nonparametric methods (Spearman's rank coefficient) are used to test for the existence of trends in these data. The results indicate that specific conductivity, sodium and chloride have decreased significantly over the period of study. During the same period there is no significant trend for either discharge and nutrients.     

Emissions of gaseous and particulate pollutants in a port and harbour region in India

Ports can generate large quantity of pollutants in the atmosphere due to various activities like loading and unloading,transportation, and construction operations. Determination of the character and quantity of emissions from individual sources is an essential step in any project to control and minimize the emissions.In this study a detailed emission inventory of total suspendedparticulate matter (TSP), particulate matter less than 10 m(PM₁₀), sulfur dioxide (SO₂) and nitrogen oxides (NO_x) for a port and harbour project near Mumbai is compiled. Results show that the total annual average contributions of TSP and PM₁₀ from all the port activitieswere 872 and 221 t yr^-1, respectively. Annual average emissions of gaseous pollutants SO₂ and NO_xwere 56 and 397 t yr^-1, respectively, calculatedby using emission factors for different port activities. The maximum TSP emission (419 t yr ^-1) was from paved roads, while the least (0.4 t yr^-1) was from bulk handling activity. The maximum PM₁₀ emission (123 t yr^-1) was from unpaved roads and minimum (0.2 t yr^-1) from bulk handling operations. Similarly the ratio of TSP and PM₁₀ emission was highest (5.18) from paved roads and least (2.17) from bulk handling operations. Regression relation was derivedfrom existing emission data of TSP and PM₁₀ from variousport activities. Good correlation was observed between TSP andPM₁₀ having regression coefficient >0.8.     

Fate and movement of atrazine, cyanazine, metolachlor and selected degradation products in water resources of the deep Loess Hills of Southwestern Iowa, USA

The environmental fate and movement of herbicides widely used for weed control in corn are assessed for a deep loess soil in southwestern Iowa. Beginning in the early 1980s, the herbicide-based weed control program emphasized the application of atrazine (ATR) or cyanazine (CYN) and metolachlor (MET) for both broadleaf and grass control. Between 1992 and 1995, concentrations of ATR, desethylatrazine (DEA), desisopropylatrazine (DIA), CYN and MET were measured in rainwater, both shallow and deep vadose zone water, and well water. Results show that the frequency of herbicide detections and the range and distribution of occurrences are dependent upon both landscape position and temporal inputs of recharge water from rainfall. Generally, DIA was observed more frequently and in higher mean concentration in well water than DEA, while DEA was observed more frequently than DIA in vadose zone groundwater. A chromatographic analogy is suggested to explain the occurrence patterns observed for both parent herbicide and degradation products within the unsaturated zone water. Analysis of rainwater samples collected during this time also revealed low concentrations of ATR, CYN and MET, with the timing of the detections indicative of non-local transport. Results show that the deep loess soil conducts both water and agricultural chemicals relatively rapidly and as such represents a production system which is vulnerable to contamination of shallow groundwater by herbicide-derived chemicals. Results also illustrate the importance of including major herbicide degradation products in water resource impact assessment studies.     

A study of the distribution of lead, cadmium and copper between water and kaolin, bentonite and a river sediment

Experiments were carried out to monitor the equilibrium distribution of lead, cadmium and copper between an aqueous phase modelling natural water and a solid phase modelling natural sediment, under varying conditions. The aqueous phase was analysed using ETAAS and differential pulse anodic stripping voltammetry (DPASV), whereas XRD and FTIR were used to study the solid phase. Sorption isotherms at constant pH were measured. Conditional distribution constants were calculated as functions of the pH, the time of equilibration and the amount of solid material. The results obtained stress the need for standardization of the approaches to the study of water-sediment interactions in order to be able to evaluate and compare the extensive data from field measurements and to predict these interactions.     

Insecticide Contamination of Jamaican Environment. V. Island-Wide Rapid Survey of Residues in Surface and Ground Water

Residues of organochlorines and organophosphates were determined by gas chromatography in water and sediment from 26 locations in 17 major rivers, 7 natural springs and 13 wells across Jamaica. Samples were collected on only one occasion between May and July, 1994. Residues of endosulfan were detected in all but three rivers; -endosulfan in 15 samples of sediment (0.9–108.1, mean = 28.93, S.E. = 7.198 g kg-1) and 13 of water (0.01–0.35, mean = 0.11, S.E. = 0.035 g L-1), -endosulfan in 5 sediment (15.29–49.35, mean = 30.56, S.E. = 7.132 g kg-1) and 12 water (0.05–0.31, mean = 0.14, S.E. = 0.031 g L-1) samples, and endosulfan sulphate in waters of three rivers (0.003–0.244 g L-1). Chlorpyrifos was present in 9 sediment (0.423-135.2, mean = 18.38, S.E. = 10.699 g kg-1) and two water (0.001–0.022 g L-1) samples, diazinon and ethoprophos in the sediment of one river each. Mean levels (g L-1) of and isomers and sulphate of endosulfan were 0.16 (S.E. = 0.057), 0.12 (S.E. = 0.036) and 0.15 (S.E. = 0.089), respectively, in four of the seven springs and 0.23 (S.E. = 0.052), 0.11 (S.E. = 0.029) and 0.26 (S.E. = 0.088), respectively, in seven of the thirteen wells monitored.     

A catalogue of urban hydrocarbons for the city of Leeds: atmospheric monitoring of volatile organic compounds by thermal desorption-gas chromatography

A method has been developed for the speciation and quantitative determination of hydrocarbons in urban air in the city of Leeds. Hydrocarbons were pre-concentrated by adsorbent tube air sampling and analyzed using thermal desorption and gas chromatography with flame ionization detection and structural confirmation by mass spectrometric detection. While automated volatile organic compound (VOC) analyzers produced data for a maximum of about 30 compounds simultaneously, with the method described here, a total of 68 C6-C12 hydrocarbons were measured simultaneously in one analysis at parts per billion (ppb) levels. Several monitoring surveys were performed, one during the winter of 1993 and the other in the summer of 1994, at a number of sites to investigate the levels of VOCs identified in the urban air of Leeds.