Synthesis,Characterization and Nanocomposite Formation of Poly(glycerol succinate-co-maleate) with Nanocrystalline Cellulose

A novel biodegradable polymer based on glycerol, succinic anhydride and maleic anhydride, poly(glycerol succinate-co-maleate), poly(GlySAMA), was synthesized by melt polycondensation and tested as a matrix for composites with nanocrystalline cellulose. This glycerol-based polymer is thermally stable as a consequence of its targeted cross-linked structure. To broaden its range of properties, it was specifically formulated with nanocrystalline cellulose (NCC) at concentrations of 1, 2 and 4 wt%, and showed improved mechanical properties with NCC. Specifically, the effect of reinforcement on mechanical properties, thermal stability, structure, and biodegradability was evaluated, respectively, by tensile tests and thermogravimetric analyses, X-ray diffraction and respirometry. The neat poly(GlySAMA) polymer proved flexible, exhibiting an elongation-to-break of 8.8 % while the addition of nanowhiskers (at 4 wt%) caused tensile strength and Young’s modulus to increase, 20 and 40 %, respectively. Stiffness improved without significantly decreasing thermal stability as measured by thermogravimetric analysis. Biodegradation tests indicated that all samples were degradable but NCC reduced the rate of biodegradation.     

Challenges in assessing biological recovery from acidification in Swedish lakes

Since the 1980s, Swedish lakes have in general become less acidified. Assessment of biological recovery is, however, hampered by poor pre-acidification data, confounding effects of climate change, and few lakes with annual sampling of fish and other organisms. Only three critically acidified, but non-limed, lakes had two decades of fish monitoring. The lakes had not yet recovered to pre-industrial chemical targets. Fish had low species richness compared to other organism groups. Roach (Rutilus rutilus) and/or European perch (Perca fluviatilis) were the dominant fish species, and the acid-sensitive roach had been lost from one of the lakes. Calcium decreased, possibly approaching pre-acidification concentrations, but exceeded minimum levels needed to sustain some Daphnia species. High or increasing levels of total organic carbon, likely due to reduced acidification and climate change, might influence the biological communities in unexpected ways, for example, facilitating more frequent occurrence of the invasive algae Gonyostomum semen.     

Spatio-temporal trends of PCBs in the Swedish freshwater environment 1981–2012

Polychlorinated biphenyls (PCBs) have been monitored in perch (Perca fluviatilis), pike (Esox lucius), and Arctic char (Salvelinus alpinus) in reference lakes since the late 1960s. Temporal trends and spatial patterns are currently monitored in nine and 32 lakes, respectively. Overall, PCB concentrations are decreasing. However, this is not consistent for all congeners across all lakes and species. Perch has comparatively low PCB concentrations relative to suggested target levels, but individual congener concentrations in some lakes are concerningly high. No temporal trend is seen for CB-118 and CB-153 in perch, but significant decreasing trends exist for Arctic char and pike, for which monitoring started earlier than for perch. The lower/higher chlorinated congener ratio decreased over time in most lakes, indicating fewer new emissions. CB-118 and CB-153 concentrations in perch show spatial gradients across Sweden, with higher concentrations found near urban/industrial areas.     

Long-term effects on nitrogen and benthic fauna of extreme weather events: Examples from two Swedish headwater streams

Climate change is expected to cause an increased frequency of extreme events such as heavy floods and major storms. Such stochastic events have an immediate impact on surface water quality, but the long-term effects are largely unknown. In this study, we assess long-term monitoring data from two Swedish headwater catchments affected by extreme weather events. At one site, where nitrogen effects in soil water, groundwater, and stream water were studied after storm-felling and subsequent forest dieback from bark beetle attack, long-term (>5 years) but relatively modest (generally <1 mg L^?1) increases in ammonium (NH₄-N) and nitrate (NO₃-N) concentrations were observed in the various aqueous media. At the other site, where effects on benthic fauna were studied in a stream impacted by extreme geophysical disturbances caused by rainstorm-induced flashflood, only short-term (1 year) effects were revealed both regarding diversity and composition of species.     

Assessing and managing freshwater ecosystems vulnerable to environmental change

Freshwater ecosystems are important for global biodiversity and provide essential ecosystem services. There is consensus in the scientific literature that freshwater ecosystems are vulnerable to the impacts of environmental change, which may trigger irreversible regime shifts upon which biodiversity and ecosystem services may be lost. There are profound uncertainties regarding the management and assessment of the vulnerability of freshwater ecosystems to environmental change. Quantitative approaches are needed to reduce this uncertainty. We describe available statistical and modeling approaches along with case studies that demonstrate how resilience theory can be applied to aid decision-making in natural resources management. We highlight especially how long-term monitoring efforts combined with ecological theory can provide a novel nexus between ecological impact assessment and management, and the quantification of systemic vulnerability and thus the resilience of ecosystems to environmental change.     

Anthropogenic oligotrophication via liming: Long-term phosphorus trends in acidified,limed, and neutral reference lakes in Sweden

Restoration of acidified lakes by liming does not, in many cases, improve productivity to a pre-acidified state. We hypothesize that the poor recovery detected in many of these lakes is due to constrained in-lake phosphorous (P) cycling caused by enhanced precipitation of metals in higher pH, limed waters. Long-term (1990–2012) data for 65 limed, circum-neutral (pH 6–8), and acidified lakes in Sweden were analyzed to determine trends for P and potential drivers of these trends. Limed lakes not only had lower mean values and stronger decreasing trends for total P than non-limed lakes, but they also had the highest percentage of decreasing trends (85 %). A P release factor (Hypolimnetic P/Epilimnetic P) was developed to elucidate differences in internal P cycling between lake groups. Consistently, lower P release factors in limed lakes show limitation of internal P cycling during summer months that may be a factor limiting P bioavailability and thus productivity of these systems.     

Valorization of solid waste products from olive oil industry as potential adsorbents for water pollution control—a review

The global olive oil production for 2010 is estimated to be 2,881,500 metric tons. The European Union countries produce 78.5 % of the total olive oil, which stands for an average production of 2,136,000 tons. The worldwide consumption of olive oil increased of 78 % between 1990 and 2010. The increase in olive oil production implies a proportional increase in olive mill wastes. As a consequence of such increasing trend, olive mills are facing severe environmental problems due to lack of feasible and/or cost-effective solutions to olive-mill waste management. Therefore, immediate attention is required to find a proper way of management to deal with olive mill waste materials in order to minimize environmental pollution and associated health risks. One of the interesting uses of solid wastes generated from olive mills is to convert them as inexpensive adsorbents for water pollution control. In this review paper, an extensive list of adsorbents (prepared by utilizing different types of olive mill solid waste materials) from vast literature has been compiled, and their adsorption capacities for various aquatic pollutants removal are presented. Different physicochemical methods that have been used to convert olive mill solid wastes into efficient adsorbents have also been discussed. Characterization of olive-based adsorbents and adsorption mechanisms of various aquatic pollutants on these developed olive-based adsorbents have also been discussed in detail. Conclusions have been drawn from the literature reviewed, and suggestions for future research are proposed.     

Composting of waste algae: A review

Although composting has been successfully used at pilot scale to manage waste algae removed from eutrophied water environments and the compost product applied as a fertiliser, clear guidelines are not available for full scale algae composting. The review reports on the application of composting to stabilize waste algae, which to date has mainly been macro-algae, and identifies the peculiarities of algae as a composting feedstock, these being: relatively low carbon to nitrogen (C/N) ratio, which can result in nitrogen loss as NH₃ and even N₂O; high moisture content and low porosity, which together make aeration challenging; potentially high salinity, which can have adverse consequence for composting; and potentially have high metals and toxin content, which can affect application of the product as a fertiliser. To overcome the challenges that these peculiarities impose co-compost materials can be employed.     

Sorption–desorption of imidacloprid onto a lacustrine Egyptian soil and its clay and humic acid fractions

Sorption–desorption of the insecticide imidacloprid 1-[(6-chloro-3-pyridinyl)-methyl]-N-nitro-2-imidazolidinimine onto a lacustrine sandy clay loam Egyptian soil and its clay and humic acid (HA) fractions was investigated in 24-h batch equilibrium experiments. Imidacloprid (IMDA) sorption–desorption isotherms onto the three sorbents were found to belong to a non-linear L-type and were best described by the Freundlich model. The value of the IMDA adsorption distribution coefficient, Kd_ads, varied according to its initial concentration and was ranged 40–84 for HA, 14–58 for clay and 1.85–4.15 for bulk soil. Freundlich sorption coefficient, Kf_ads, values were 63.0, 39.7 and 4.0 for HA, clay and bulk soil, respectively. The normalized soil Koc value for imidacloprid sorption was ～800 indicating its slight mobility in soils. Nonlinear sorption isotherms were indicated by 1/n_ads values <1 for all sorbents. Values of the hysteresis index (H) were <1, indicating the irreversibility of imidacloprid sorption process with all tested sorbents. Gibbs free energy (ΔG) values indicated a spontaneous and physicosorption process for IMDA and a more favorable sorption to HA than clay and soil. In conclusion, although the humic acid fraction showed the highest capacity and affinity for imidacloprid sorption, the clay fraction contributed to approximately 95% of soil-sorbed insecticide. Clay and humic acid fractions were found to be the major two factors controlling IMDA sorption in soils. The slight mobility of IMDA in soils and the hysteresis phenomenon associated with the irreversibility of its sorption onto, mainly, clay and organic matter of soils make its leachability unlikely to occur.     

Technical Session Preliminary Schedule Announced for 1988 APCA Annual Meeting

ABSTRACT

Stable heterogeneous catalysts for the oxidative removal of CO from air at ambient temperatures have been developed. An alumina support impregnated with PdCl₂, CuCl₂, and CuSO₄ is described. Optimal activity was obtained with Pd 0.020 mol/kg, Cu 0.50 mol/kg, CuCl₂ 20-30% of total Cu, a 2- to 24-hr soak, filtration of surplus raffinate, and a 2- to 4-hr firing in air at 200-350 °C. The catalysts are effective at 20-26 °C and relative humidities in the 15-90% range. They are reversibly deactivated by completely dry or water-saturated air streams. These catalysts have been tested at space velocities up to 30,000 hr^-1. In contact with <100 ppm CO, they are highly efficient, removing ~99% of the CO with contact times of ~120 msec (pseudo-first order k' > 25 sec^-1). At much higher CO concentrations, the maximum CO loading rate—limited by the Cu(I) reoxidation rate—is approximately 17 m mol CO per Limol Pd per hour.