The Southeastern Aerosol Research and Characterization Study: Part II. Filter-based measurements of fine and coarse particulate matter mass and composition

The Southeastern Aerosol Research and Characterization Study (SEARCH) was implemented in 1998-1999 to provide data and analyses for the investigation of the sources, chemical speciation, and long-term trends of fine particulate matter (PM2.5) and coarse particulate matter (PM10-2.5) in the Southeastern United States. This work is an initial analysis of 5 years (1999-2003) of filter-based PM2.5 and PM10-2.5 data from SEARCH. We find that annual PM2.5 design values were consistently above the National Ambient Air Quality Standards (NAAQS) 15 microg/m3 annual standard only at monitoring sites in the two largest urban areas (Atlanta, GA, and North Birmingham, AL). Other sites in the network had annual design values below the standard, and no site had daily design values above the NAAQS 65 microg/m3 daily standard. Using a particle composition monitor designed specifically for SEARCH, we found that volatilization losses of nitrate, ammonium, and organic carbon must be accounted for to accurately characterize atmospheric particulate matter. In particular, the federal reference method for PM2.5 underestimates mass by 3-7% as a result of these volatilization losses. Organic matter (OM) and sulfate account for approximately 60% of PM2.5 mass at SEARCH sites, whereas major metal oxides (MMO) and unidentified components ("other") account for > or = 80% of PM10-2.5 mass. Limited data suggest that much of the unidentified mass in PM10-2.5 may be OM. For paired comparisons of urban-rural sites, differences in PM2.5 mass are explained, in large part, by higher OM and black carbon at the urban site. For PM10, higher urban concentrations are explained by higher MMO and "other." Annual means for PM2.5 and PM10-2.5 mass and major components demonstrate substantial declines at all of the SEARCH sites over the 1999-2003 period (10-20% in the case of PM2.5, dominated by 14-20% declines in sulfate and 11-26% declines in OM, and 14-25% in the case of PM10-2.5, dominated by 17-30% declines in MMO and 14-31% declines in "other"). Although declining national emissions of sulfur dioxide and anthropogenic carbon may account for a portion of the observed declines, additional investigation will be necessary to establish a quantitative assessment, especially regarding trends in local and regional emissions, primary carbon emissions, and meteorology.     

Utilization of magnetic and electrostatic separation in the recycling of printed circuit boards scrap

The progress of the technology is directly related to the growth of production and consumption of electrical/electronics equipment, especially of personal computers. This type of equipment has a relatively short average lifetime, 2-3 years. The amount of defective or obsolete equipment has been increasing substantially; consequently its disposition and/or recycling should be studied. In this work, printed circuit boards, which are used in personal computers, were studied in order to recover the metals in the circuit boards through mechanical processing, such as crushing, screening, as well as magnetic and electrostatic separation. The results obtained demonstrate the feasibility of using these processes to separate metal fractions from polymers and ceramics, and that it is possible to obtain a fraction concentrated in metals containing more than 50% on average of copper, 24% of tin and 8% of lead.     

Physical modelling of the composting environment: a review. Part 1: Reactor systems

In this paper, laboratory- and pilot-scale reactors used for investigation of the composting process are described and their characteristics and application reviewed. Reactor types were categorised by the present authors as fixed-temperature, self-heating, controlled temperature difference and controlled heat flux, depending upon the means of management of heat flux through vessel walls. The review indicated that fixed-temperature reactors have significant applications in studying reaction rates and other phenomena, but may self-heat to higher temperatures during the process. Self-heating laboratory-scale reactors, although inexpensive and uncomplicated, were shown to typically suffer from disproportionately large losses through the walls, even with substantial insulation present. At pilot scale, however, even moderately insulated self-heating reactors are able to reproduce wall losses similar to those reported for full-scale systems, and a simple technique for estimation of insulation requirements for self-heating reactors is presented. In contrast, controlled temperature difference and controlled heat flux laboratory reactors can provide spatial temperature differentials similar to those in full-scale systems, and can simulate full-scale wall losses. Surface area to volume ratios, a significant factor in terms of heat loss through vessel walls, were estimated by the present authors at 5.0-88.0m(2)/m(3) for experimental composting reactors and 0.4-3.8m(2)/m(3) for full-scale systems. Non-thermodynamic factors such as compression, sidewall airflow effects, channelling and mixing may affect simulation performance and are discussed. Further work to investigate wall effects in composting reactors, to obtain more data on horizontal temperature profiles and rates of biological heat production, to incorporate compressive effects into experimental reactors and to investigate experimental systems employing natural ventilation is suggested.     

Effects of commercial diazinon and imidacloprid on microbial urease activity in soil and sod

Diazinon [O,O-diethyl O-2-isopropyl-6-methyl(pyrimidine-4-yl) phosphorothioate] and imidacloprid [1-(1-[6-chloro-3-pyridinyl]methyl)-N-nitro-2-imidazolidinimine] are applied to lawns for insect control simultaneously with nitrogenous fertilizers such as urea, but their potential effect on urease activity and nitrogen availability in turfgrass management has not been evaluated. Urease activity in enzyme assays, washed cell assays, and soil slurries was examined as a function of insecticide concentration. Intact cores from field sites were used to assess the effect of insecticide application on urease activity in creeping bentgrass (Agrostis palustris Huds.) and bluegrass (Poa pratensis L.) sod. Bacterial urease from Bacillus pasteurii and plant urease from jack bean [Canavalia ensiformis (L.) DC.] were unaffected by the insecticides. Both insecticides inhibited the growth of Proteus vulgaris, a urease-producing bacterium, but only diazinon significantly reduced urease activity in washed cells; neither insecticide inhibited urease activity in sonicated cells. Neither diazinon nor imidacloprid inhibited urease activity in Woolper soil (fine, mixed, mesic Typic Argiudoll) slurries, but diazinon slightly inhibited urease activity in Maury soil (fine, mixed, semiactive, mesic Typic Paleudalf) slurries. Imidacloprid had no effect on urease activity in creeping bentgrass or bluegrass sod at up to 10 times the commercial application rate. Diazinon briefly, but significantly, reduced urease activity in bluegrass sod. Co-application of imidacloprid and urea appears to be benign with respect to urease activity in soil and sod. Diazinon, in contrast, appears to have a significant, short-term, inhibitory effect on the microbial urease-producing community, but that effect depends on soil type.     

Dairy farm effluent effects on urine patch nitrous oxide and carbon dioxide emissions

Dairy farm effluent (DFE) comprises animal feces, urine, and wash-down water collected at the milking shed. This is collected daily during the milking season and sprayed onto grazed dairy pastures. Urine patches in grazed pastures make a significant contribution to anthropogenic N(2)O emissions. The DFE could potentially mitigate N(2)O emissions by influencing the N(2)O to dinitrogen (N(2)) ratio, since it contains water-soluble carbon (WSC). Alternatively, DFE may enhance N(2)O emissions from urine patches. The application of DFE may also provide a substrate for the production of CO(2) in pasture soils. The effects of DFE on the CO(2) and N(2)O emissions from urine patches are unknown. Thus a laboratory experiment was performed where repeated DFE applications were made to repacked soil cores. Dairy farm effluent was applied at 0, 7, or 14 d after urine deposition. The urine was applied once on Day 0. Urine contained (15)N-enriched urea. Measurements of N(2)O, N(2), and carbon dioxide (CO(2)) fluxes, soil pH, and soil inorganic N concentrations were made. After 43 d the DFE had not mitigated N(2)O fluxes from urine patches. A small increase in the N(2)O flux occurred from the urine-treated soils where DFE was applied 1 wk after urine deposition. The amount of WSC applied in the DFE proved to be insignificant compared with the amount of soil C released as CO(2) following urine application. The priming of soil C in urine patches has implications for the understanding of soil C processes in grazed pasture ecosystems and the budgeting of C within these ecosystems.     

Application of Cellulose Microfibrils in Polymer Nanocomposites

Cellulose microfibrils obtained by the acid hydrolysis of cellulose fibers were added at low concentrations (2–10% w/w) to polymer gels and films as reinforcing agents. Significant changes in mechanical properties, especially maximum load and tensile strength, were obtained for fibrils derived from several cellulosic sources, including cotton, softwood, and bacterial cellulose. For extruded starch plastics, the addition of cotton-derived microfibrils at 10.3% (w/w) concentration increased Young’s modulus by 5-fold relative to a control sample with no cellulose reinforcement. Preliminary data suggests that shear alignment significantly improves tensile strength. Addition of microfibrils does not always change mechanical properties in a predictable direction. Whereas tensile strength and modulus were shown to increase during addition of microfibrils to an extruded starch thermoplastic and a cast latex film, these parameters decreased when microfibrils were added to a starch–pectin blend, implying that complex interactions are involved in the application of these reinforcing agents.     

Sustainable land application: an overview

Man has land-applied societal nonhazardous wastes for centuries as a means of disposal and to improve the soil via the recycling of nutrients and the addition of organic matter. Nonhazardous wastes include a vast array of materials, including manures, biosolids, composts, wastewater effluents, food-processing wastes, industrial by-products; these are collectively referred to herein as residuals. Because of economic restraints and environmental concerns about land-filling and incineration, interest in land application continues to grow. A major lesson that has been learned, however, is that the traditional definition of land application that emphasizes applying residuals to land in a manner that protects human and animal health, safeguards soil and water resources, and maintains long-term ecosystem quality is incomplete unless the earning of public trust in the practices is included. This overview provides an introduction to a subset of papers and posters presented at the conference, "Sustainable Land Application," held in Orlando, FL, in January 2004. The USEPA, USDA, and multiple national and state organizations with interest in, and/or responsibilities for, ensuring the sustainability of the practice sponsored the conference. The overriding conference objectives were to highlight significant developments in land treatment theory and practice, and to identify future research needs to address critical gaps in the knowledge base that must be addressed to ensure sustainable land application of residuals.     

Adsorption of eosin dye on activated carbon and its surfactant based desorption

The performance of activated carbon has been investigated for the adsorption of eosin dye dissolved in water. Eosin is anionic in nature and highly toxic. The effects of initial dye concentration, contact time, pH and temperature on adsorption of eosin by a fixed amount of activated carbon (1.0 g/L) have been studied in batch and column mode. The equilibrium data are successfully fitted to the Freundlich adsorption isotherm. The adsorption rate data are successfully explained by a pseudo second-order kinetic model. Breakthrough curves for column adsorption have also been studied. The regeneration of spent carbon by desorbing the dye has been experimentally investigated applying a surfactant enhanced carbon regeneration (SECR) technique using both cationic and anionic surfactants. An empirical kinetic model for dye desorption from the commercial activated carbon (CAC) using different surfactant and desorption techniques, viz. change in pH, has been proposed. The comparison between the model and the experimental results is found to be satisfactory.     

Colonization of surfaces by phenolic compounds utilizing microorganisms

The aim of the present study is to determine optimal adhesive interaction of phenolic compounds utilizing Candida maltosa and Rhodococcus erythropolis when adhering to kaolin, silicone, synthetic foil (Steriking R40) and fluorinated silicones, comparing cell and support surface hydrophobicity. In parallel, the interfering effect of detergents was investigated. Data obtained show that the less hydrophobic supports display high initial cell adhesion when contacted with the cell type with a lower surface hydrophobicity (yeast cell) but most stable yeast biofilms are those formed on highly hydrophobic fluorinated silicones. On the other hand, support hydrophobicity has no effect on bacterial cell detachment; however, bacterial biofilms are denser when growing on more hydrophobic supports. Both detergents interfere (independently on the cell type) with the early and late phases of biofilm development.