Application of a permethrin immunosorbent assay method to residential soil and dust samples

A low-cost, high throughput bioanalytical screening method was developed for monitoring cis/trans-permethrin in dust and soil samples. The method consisted of a simple sample preparation procedure [sonication with dichloromethane followed by a solvent exchange into methanol:water (1:1)] with bioanalytical detection using a magnetic particle enzyme-linked immunosorbent assay (ELISA). Quantitative recoveries (83–126 %) of cis/trans-permethrin were obtained for spiked soil and dust samples. The percent difference of duplicate ELISA analyses was within ± 20 % for standards and ± 35 % for samples. Similar sample preparation procedures were used for the conventional gas chromatography/mass spectrometry (GC/MS) analysis except that additional cleanup steps were required. Recoveries of cis/trans-permethrin ranged from 81 to 108 % for spiked soil and dust samples by GC/MS. The ELISA-derived permethrin concentrations were highly correlated with the GC/MS-derived sum of cis/trans-permethrin concentrations with a correlation coefficient (r) of 0.986. The ELISA method provided a rapid qualitative screen for cis/trans-permethrin in soil and dust while providing a higher sample throughput with a lower cost as compared to the GC/MS method. The ELISA can be applied as a complementary, low-cost screening tool to prioritize and rank samples prior to instrumental analysis for exposure studies.     

Removal of Volatile Aliphatic Hydrocarbons in a Soil Bioreactor

Soil removal of propane, isobutane and n-butane from a waste air stream was evaluated in the laboratory and in a prototype soil bioreactor. Laboratory investigations indicated first-order kinetics and the potential to degrade light aliphatic hydrocarbons and trichlorethylene, a compound ordinarily resistant to aerobic biological treatment. The predicted behavior of the bioreactor, based on laboratory studies, agreed closely with the actual behavior of the Reid system. The prototype bioreactor reduced the hydrocarbon concentrations in the air by at least 90percent with a residence time of 15 minutes and a pressure drop of 85 cm of water. The bioreactor functioned well through a range of temperatures, 12°C to 24°C.     

Jellyfish aggregations and leatherback turtle foraging patterns in a temperate coastal environment

Leatherback turtles (Dermochelys coriacea) are obligate predators of gelatinous zooplankton. However, the spatial relationship between predator and prey remains poorly understood beyond sporadic and localized reports. To examine how jellyfish (Phylum Cnidaria: Orders Semaeostomeae and Rhizostomeae) might drive the broad-scale distribution of this wide ranging species, we employed aerial surveys to map jellyfish throughout a temperate coastal shelf area bordering the northeast Atlantic. Previously unknown, consistent aggregations of Rhizostoma octopus extending over tens of square kilometers were identified in distinct coastal "hotspots" during consecutive years (2003-2005). Examination of retrospective sightings data (>50 yr) suggested that 22.5% of leatherback distribution could be explained by these hotspots, with the inference that these coastal features may be sufficiently consistent in space and time to drive long-term foraging associations.     

Air Pollution and Health

The use of multistage, dry, fluidized beds of continuously recycled, coal-based activated carbon appears technically and economically attractive for both adsorption of stack gas So₂ and sequential conversion to elemental sulfur. Conceptual design details and economic factors are discussed for the treatment of power plant or oil refinery SO₂ effluents with by-product sulfur recovery.     

The Removal of Particulate Matter from Fluid Bed Catalytic Cracking Unit Stack Gases

The application of a high-efficiency centrifugal type of separator to fluid bed catalytic cracking units is described in which most of the catalyst particles often lost to the atmosphere are concentrated into a small part of the stack gas (2%). A further separation can then be made on this small stream by an auxiliary separator which further concentrates the catalyst particle into 0.1% of the initia stream. Performance of the main and auxiliary separators are such as to reduce the loss of catalyst particles in the stack gas from 800 ppm to less than 60 ppm in a typical unit. Large amounts of power can be recovered by application of expander turbines to catalytic cracking plants employing this system of separation.     

Photochemical Reactivities of Paraffinic Hydrocarbon-Nitrogen Oxide Mixtures Upon Addition of Propylene or Toluene

Effects associated with photochemical air pollution were measured during irradiation of n-butane-nitrogen oxide or n-butane-ethane-nitrogen oxide mixtures, with small amounts of propylene or toluene added. The effects measured including nitrogen dioxide and oxidant dosages, yields of formaldehyde and peroxy-acetyl nitrate, and eye irritation response. The results obtained clearly show that beneficial effects result from selective changes in hydrocarbon composition as well as from reduction of total hydrocarbon concenfration. Exclusion of olefins and alkylbenzenes was highly effective in reducing oxidant dosage, formaldehyde and peroxyacetyl nitrate concentrations, and eye irritation response. The only penalty was a modest increase in nitrogen dioxide dosage. A large reduction in nitrogen oxide concentration reduced nitrogen dioxide dosage and eye irritation response, but with the penalty of a large increase in oxidant dosage. The desirability of preferentially reducing olefins and alkylbenzenes rather than paraffinic hydrocarbons, acetylene, and benzene is strongly supported by this study. Research and development efforts should be directed toward preferential hydrocarbon control by mechanical or catalytic control     

The Effect of Fuel Composition on Atmospheric Aerosol Due to Auto Exhaust

Aerosols attributable to automobile exhaust can be classified as two types—primary aerosol (initially present in the exhaust) and secondary aerosol (generated photochemically from hydrocarbons and nitrogen oxides in the exhaust). In this study, investigation was made of possible effects of motor-fuel composition on the formation of these aerosols. Secondary aerosol, of principal interest in this work, was produced by irradiating auto exhaust in Battelle-Columbus’ 610 ft³ environmental chamber. A limited number of determinations of primary aerosol in diluted auto exhaust was made at the exit of a 36 ft dilution runnel. Determination of both primary and secondary aerosol was based on light-scattering measurements.

Exhaust was generated with seven full-boiling motor gasolines, both leaded and nonleaded, in a 1967 Chevrolet which was not equipped with exhaust-emission control devices. Changes in fuel composition produced a maximum factor of three difference in light scattering due to primary aerosol. Aerosol yields, for consecutive driving cycles on the same fuel, vary considerably; as a result, ranking the fuels on the basis of average primary aerosol yield was not very meaningful. In addition to fuel composition, the more important independent variables are initial SO₂ concentration, relative humidity and initial hydrocarbon concentration. Statistical analysis of the data indicates that the seven test fuels can be divided into two arbitrary groups with regard to secondary aerosol-forming potential. The fuels in the lower light-scattering group had aromatic contents of 15 and 21%, while those in the higher light-scattering group had aromatic contents of 25, 48, and 55%. Although the fuels can be grouped on the basis of a compositional factor, the grouping of fuels with aromatic content ranging from 25 to 55% indicates that this compositional factor cannot be equated simply with aromatic content. In an associated study of the aerosol-forming potential of individual hydrocarbons prominent in auto exhaust, it was observed that aromatics produce substantially more photochemical aerosol than olefins and paraffins. However, experiments with binar/hydrocarbon mixtures containing aromatjcs, as well as in these exhaust experiments, a strong dependence of aerosol yield on the aromatic components is is not observed. Thus, the data indicate that the dependence of secondary aerosol formation on fuel factors is a complex one and cannot be predicted solely on the basis of a sirigle hydrocarbon component reactivity scale.

The two types of automobile aerosol did not have the same dependence on fuel, composition. The variation in total light scattering attributable to primary plus secondary aerosol was less than that due to either component alone. It therefore was concluded that the light scattering due to automobile exhaust emissions in these experiments was not significantly affected by changing fuel composition.     

Inorganic nitrogen transformations in the treatment of landfill leachate with a high ammonium load: A case study

The inorganic nitrogen transformations occurring at a municipal waste leachate treatment facility were investigated. The treatment facility consisted of a collection well and an artificial wetland between two aeration ponds. The first aeration pond showed a decrease in ammonium (from 3480 (± 120) to 630(± 90) mg ⋅ L⁻¹), a reduction in inorganic nitrogen load (3480 to 1680 mg N ⋅ L⁻¹), and an accumulation of nitrite (< 1.3 mg-N ⋅ L⁻¹ in the collection well, to 1030 mg-N ⋅ L⁻¹). Incomplete ammonium oxidation was presumably the result of the low concentration of carbonate alkalinity (∼2 mg ⋅ L⁻¹), which may cause a limitation in the ammonium oxidation rate of nitrifiers. Low carbonate alkalinity levels may have been the result of stripping of CO₂ from the first aeration pond at the high aeration rates and low pH. Various chemodenitrification mechanisms are discussed as the reason for the reduction in the inorganic nitrogen load, including; the reduction of nitrite by iron (II) (producing various forms of gaseous nitrogen); and reactions involving nitrous acid. It is suggested that the accumulation of nitrite may be the result of inhibition of nitrite oxidizers by nitrous acid and low temperatures. Relative to the first aeration pond, the speciation and concentration of inorganic nitrogen was stable in the wetlands and 2nd aeration pond. The limited denitrification in the wetlands most probably occurred due to low concentrations of organic carbon, and short retention times.     

Comparative evaluation of a bioluminescent bacterial assay in terrestrial ecotoxicity testing

Despite the widespread and successful use of luminescence-based bioassays in water testing, their applications to soils and sediments is less proven. In part this is because such bioassays have mainly been carried out in an aqueous-based medium and, as such, favour contaminants that are readily water-soluble. In this study, aqueous solutions and soils contaminated with heavy metals (HM), polar organic contaminants and hydrophobic organic contaminants (HOCs) were tested using a range of luminescence-based bioassays (Vibrio fischeri, Escherichia coli HB101 pUCD607 and Pseudomonas fluorescens 10586r pUCD607). For the first two chemical groups, the assays were highly reproducible when optimised extraction procedures were employed but for HOCs the bioassay response was poor. Quantitative structure-activity relationships (QSARs) obtained from aqueous solutions had a linear response although correlation for the chemicals tested using bacterial bioassays was significantly less sensitive than that of sublethal tests for Tetrahymena pyriformis. Bacterial and Dendrobaena veneta bioassay responses to extracts from HM amended soils showed that a clear relationship between trophic levels could be obtained. There is no doubt that the wide range of bioluminescent-based bioassays offers complementary applications to traditional testing techniques but there is a significant need to justify and optimise the extraction protocol prior to application.     

Mathematical Modeling of Column and Field Dense Nonaqueous Phase Liquid Tracer Tests

Mathematical models for the simulation of dense nonaqueous phase liquid tracer tests (DTTs) in laboratory columns and in the field are developed and examined. The DTT technique is a means of estimating the quantity of dense nonaqueous phase liquid (DNAPL) in a domain of interest in an aquifer. The two-dimensional field DTT model uses the Method of Principal Directions and an asymmetrical upwind algorithm for describing advective transport. Both models include diffusion transport of tracer into and from low-permeability porous structures such as clay lenses, as well as the mass transport kinetics of partitioning tracer to and from the DNAPL droplets. The dependence of the effluent tracer concentration curves on the parameters of the models is explored, and conclusions are drawn regarding the applicability of, and several possible problems with, the DTT technique. Model results indicate that the DTT performs well at locating distributed droplets of DNAPL, but is unlikely to be useful in the assessment of pooled DNAPL.