核电安全

<正>2010年6月16日国家核安全局有关负责人向媒体通报,大亚湾核电站二号机组反应堆中的一根燃料棒包壳出现微小裂纹,其影响仅限于封闭的核反应堆一回路系统中,放射性物质未进入环境,未对环境造成影响和损害。该负责人指出,大亚湾核电站二号机组核反应堆一回路冷却     

废纸苯酚液化物合成热固型酚醛树脂

为了提高废纸的附加值,利用废纸苯酚液化物与甲醛在碱性环境中反应,进行热固型酚醛树脂合成实验。通过正交实验确定最优化的树脂化合成工艺为:n(甲醛)∶n(废纸液化物)=2.1,n(氢氧化钠)∶n(废纸液化物)=0.5,合成温度74℃,合成时间3.0h。在此工艺条件下制备的酚醛树脂压制的胶合板达到GB/T9846—2004《人造板及饰面人造板理化性能试验方法》中Ⅰ类胶合板的强度要求。     

磁絮凝处理废水工艺条件的响应曲面法优化研究

以聚硅硫酸铁(PFSS)为絮凝剂、磁流体为磁种,采用磁絮凝法处理模拟废水。在正交实验基础上,利用Matlab软件进行响应曲面分析,研究磁絮凝法处理模拟废水的各因素间具有的交互作用关系。回归拟合结果表明最佳工艺条件为:PFSS加入量36.8g/L,模拟废水pH7.4,磁种加入量14.7mg/L,搅拌转速266r/min。在最佳工艺条件下进行实验,TP去除率为97.70%。     

偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附

以腈纶纤维为原料络合Fe3+制得偕胺肟合铁(Ⅲ)纤维,用其处理α-萘酚溶液,研究了偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附工艺条件和吸附动力学参数。实验结果表明,偕胺肟合铁(Ⅲ)纤维对α-萘酚的最佳吸附工艺条件为pH=3.0、吸附温度313.15K和吸附时间45min。在最佳工艺条件下,偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附在所研究的α-萘酚浓度范围内符合Freundlich等温吸附方程。未达到饱和吸附前,偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附符合一级反应动力学特征。     

软质防弹材料的发展

近年来,软质防弹材料发展非常迅猛,本文系统地分析了软质防弹材料的防弹机理及其影响因素,提出了防弹装备设计的关注点。     

Investigation of low-molecular weight organic acids and their spatiotemporal variation characteristics in Hongfeng Lake, China

The identities and concentrations of low-molecular-weight organic acids (LMWOAs) were determined by ion chromatography throughout a 20-m water column in Hongfeng Lake, China. The spatiotemporal variations of LMWOAs and their contributions to dissolved organic matter (DOM) in a research period of 24 hr were also investigated. The results demonstrated that five LMWOAs (lactic, acetic, pyruvic, sorbic, oxalic acid) were detected, and their total concentration and proportion in DOC were 6.55 μmol/L and 7.47%. Their average levels were 2.50, 0.65, 2.35, 0.96 and 0.09 μmol/L, respectively. LMWOAs were higher during daytime (10:00-18:00 on Jun 13, 2008) than nighttime (21:00-6:00 the next morning), in particular 4.99 μmol/L high in the epilimnion ( 1 m water depth), reflecting the fact that direct import from terrigenous sources and photochemical production from humic materials were dominant during LMWOAs’ origin and accumulation. The same factors caused LMWOAs to be 0.63 μmol/L in the epilimnion higher than in the hypolimnion. The rapid decrease of total organic acid (TOA) up until 18:00 mainly resulted from bio-uptake and mineralization in the hypolimnion (>1 m water depth). Pyruvic acid increased with time in the epilimnion and decreased in the hypolimnion, largely related to the two contrary processes of continuous degradation and synthesis of macromolecular organic matter during life materials’ cycle mediated by organisms. Simultaneously, plankton behavior and thermal stratification played a pivotal role in LMWOAs’ behavior in the water column, causing decreasing and increasing profiles. The distribution of LMWOAs represents an interesting resource for biogeochemical research of DOM in aquatic ecosystems.     

镍基催化剂对污泥微波热解制生物气效能的影响

为实现污水污泥减量化、无害化及资源化的目标,在微波热解污水污泥基础上,进行了镍基催化剂对制取生物气效能影响的研究。采用元素分析对污泥元素进行检测,气/质联用分析(GC-MS)和气相色谱(GC)对热解生物气的组成和含量进行测定。实验结果表明,镍基催化剂的添加对微波热解污水污泥制取生物气有较大促进作用。5%添加量与800℃热解终温条件下具有最佳催化效果:生物气中H2、CO产量最大,H2产量由29 g/kg增加到35.8 g/kg,提升23.4%,CO产量由302.7 g/kg增加到383.3 g/kg,提升26.6%;同时催化剂还能提高热能利用效率,降低热解终温,即5%添加量在700℃热解终温时可达到空白800℃时的产气效果;镍基催化剂主要在500~600℃时发挥催化作用,加快了H2和CO的释放。微波热解污泥制取的生物气具有产量大、富含H2与CO等优点,可推动污水污泥的资源化进程。     

硼泥吸附水中酚的研究

经加热活化处理的硼泥,用于处理50mg/L的含酚废水,加入量为1％时,最佳吸附酚的pH为2～4,去除率为32％;加入量为5％时,去除率最好可达60％。吸附平衡浓度与吸附量关系符合Lanmuir吸附等温式,其20.0、25.0、30.0℃时的饱和吸附量分别为3.25、2.50、1.75mg/g,其吸附速度符合鲛岛吸附动力学方程。通过活性硼泥的红外光谱和Ｘ射线衍射图,探讨了吸附机理。     

介质阻挡放电联合催化臭氧化降解甲苯

采用介质阻挡放电区后结合MnOx/Al2O3/发泡镍去除甲苯,考察甲苯进气方式、臭氧产生方法及湿度对甲苯与O3同时去除的影响。结果表明,O3是等离子体区后催化降解甲苯的主要物种,介质阻挡放电联合催化臭氧化可实现甲苯及O3的同时高效去除。输入电压为9.0 kV时,甲苯的去除效率达92.8%,在80 min内O3的去除效率维持在99%以上。水蒸气对催化剂催化分解臭氧的活性没有直接的影响,O3浓度较高时湿度对甲苯降解效率的影响很小。GC-MS分析结果表明,甲苯降解的主要气相副产物有烷烃、酸、酮和含苯环有机物,提出了甲苯的降解途径。     

The role of doped-Mn on enhancing arsenic removal by MgAl-LDHs

To meet the challenges posed by global arsenic water contamination, the MgAlMn-LDHs with extraordinary efficiency of arsenate removal was developed. In order to clarify the enhancement effect of the doped-Mn on the arsenate removal performance of the LDHs, the cluster models of the MgAlMn-LDHs and MgAl-LDHs were established and calculated by using density functional theory (DFT). The results shown that the doped-Mn can significantly change the electronic structure of the LDHs and improve its chemical activity. Compared with the MgAl-LDHs that without the doped-Mn, the HOMO-LUMO gap was smaller after doping. In addition, the -OH and Al on the laminates were also activated to improve the adsorption property of the LDHs. Besides, the doped-Mn existed as a novel active site. On the other hand, the MgAlMn-LDHs with the doped-Mn, the increased of the binding energy, as well as the decreased of the ion exchange energy of interlayer Cl⁻, making the ability to arsenate removal had been considerably elevated than the MgAl-LDHs. Furthermore, there is an obvious coordination covalent bond between arsenate and the laminates of the MgAlMn-LDHs that with the doped-Mn.