干法煤粉磁选脱硫的试验研究

本工作首次在国内完成了干法煤粉磁选脱硫的试验,探讨了脱硫机理,简述了磁法脱硫的工艺及高梯度磁分离器(HGMS)装置。试验结果表明:最佳梯度磁场强度为0.65—0.75T,最佳煤粉颗粒度在100目—120目,脱硫率最高达70％左右,费用估计为7.5元/t煤左右。     

氧化铁脱除SO_2本征动力学研究

研究了温度、SO_2浓度、氧浓度及水蒸汽含量对α-Fe_2O_3脱除SO_2的影响规律.实验得到了幂函数型本征动力学模型中的各项参数值.结合流-固相反应理论,选择了流-固相反应模型,结果表明,在动力学控制区采用随机孔模型时,反应率-时间关系的实验数据与模型计算值能较好的吻合.     

土壤重金属污染的酶学诊断——紫色土中的镉、铜、铅、砷对水稻根系过氧化物酶的影响

通过四川酸性紫色土、中性紫色土,石灰性紫色土中不同浓度的Cd、Cu、Pb、As对水稻根系过氧化物酶的影响研究,揭示了过氧化物酶受抑制与产生抗性的过程.在低浓度时,上述元素对过氧化物酶的影响能反映土壤类型影响的差别.确定了三种紫色土中Cd、Cu、Pb、As的临界浓度.     

浙江拔茅银矿地质特征及成因

拔茅银矿是浙东中生代火山岩带中近几年新发出的金银矿田,矿床发育于破火山口机构内,矿体主要受NW及近SN向张性硅化破碎带控制。矿床的各种特征表明,其成因属浅成低温热液型。     

Effects of fluoride on growth and reproduction of the army worm, Mythimna separata (Walker)

This paper deals with effects of airborne fluorine on the army worm, Mythimna separata (Walker), by rearing the larvae on the wheat foliage exposed to HF or fumigating the larvae on the artificial diet with the pollutant. Larval relative growth rate (GR) and index of population trend of the insect reduced by 5% and 11%, respectively, when the larvae were reared on the foliage taken from the wheat plants exposed to 0.87 g·dm-2·day-1 of fluorine compared with those of the control. An extra instar appeared in a majority of the larvae treated. Survival rate and GR of the larvae on the wheat plant being exposure to the same concentration of fluorine in field open-top fumigation device were 40% and 15% lower than that of the control, respectively. Similar experiment with the insect on the artificial diet also showed that direct impact of the pollutant on the army worm was greater than its indirect effect via their host plant.     

Application and Evaluation of Two Air Quality Models for Particulate Matter for a Southeastern U.S. Episode

Abstract

The Models-3 Community Multiscale Air Quality (CMAQ) Modeling System and the Particulate Matter Comprehensive Air Quality Model with extensions (PMCAMx) were applied to simulate the period June 29–July 10, 1999, of the Southern Oxidants Study episode with two nested horizontal grid sizes: a coarse resolution of 32 km and a fine resolution of 8 km. The predicted spatial variations of ozone (O₃), particulate matter with an aerodynamic diameter less than or equal to 2.5 μm (PM_2.5), and particulate matter with an aerodynamic diameter less than or equal to 10 μm (PM₁₀) by both models are similar in rural areas but differ from one another significantly over some urban/suburban areas in the eastern and southern United States, where PMCAMx tends to predict higher values of O₃ and PM than CMAQ. Both models tend to predict O₃ values that are higher than those observed. For observed O₃ values above 60 ppb, O₃ performance meets the U.S. Environmental Protection Agency's criteria for CMAQ with both grids and for PMCAMx with the fine grid only. It becomes unsatisfactory for PMCAMx and marginally satisfactory for CMAQ for observed O₃ values above 40 ppb.

Both models predict similar amounts of sulfate (SO₄ ^2?) and organic matter, and both predict SO₄ ^2? to be the largest contributor to PM_2.5. PMCAMx generally predicts higher amounts of ammonium (NH₄ ⁺), nitrate (NO₃ ^?), and black carbon (BC) than does CMAQ. PM performance for CMAQ is generally consistent with that of other PM models, whereas PMCAMx predicts higher concentrations of NO₃ ^?,NH₄ ⁺, and BC than observed, which degrades its performance. For PM₁₀ and PM_2.5 predictions over the southeastern U.S. domain, the ranges of mean normalized gross errors (MNGEs) and mean normalized bias are 37–43% and –33–4% for CMAQ and 50–59% and 7–30% for PMCAMx. Both models predict the largest MNGEs for NO₃ ^? (98–104% for CMAQ, 138–338% for PMCAMx). The inaccurate NO₃ ^? predictions by both models may be caused by the inaccuracies in the ammonia emission inventory and the uncertainties in the gas/particle partitioning under some conditions. In addition to these uncertainties, the significant PM overpredictions by PMCAMx may be attributed to the lack of wet removal for PM and a likely underprediction in the vertical mixing during the daytime.     

The Adsorptive Capacity of Vapor-Phase Mercury Chloride onto Powdered Activated Carbon Derived from Waste Tires

Abstract

Injection of powdered activated carbon (PAC) upstream of particulate removal devices (such as electrostatic precipitator and baghouses) has been used effectively to remove hazardous air pollutants, particularly mercury-containing pollutants, emitted from combustors and incinerators. Compared with commercial PACs (CPACs), an alternative PAC derived from waste tires (WPAC) was prepared for this study. The equilibrium adsorptive capacity of mercury chloride (HgCl₂) vapor onto the WPAC was further evaluated with a self-designed bench-scale adsorption column system. The adsorption temperatures investigated in the adsorption column were controlled at 25 and 150 °C. The superficial velocity and residence time of the flow were 0.01 m/sec and 4 sec, respectively. The adsorption column tests were run under nitrogen gas flow. Experimental results showed that WPAC with higher Brunauer–Emmett–Teller (BET) surface area could adsorb more HgCl₂ at room temperature. The equilibrium adsorptive capacity of HgCl₂ for WPAC measured in this study was 1.49 × 10^?1 mg HgCl₂/g PAC at 25 °C with an initial HgCl₂ concentration of 25 μg/m³. With the increase of adsorption temperature ≤150 °C, the equilibrium adsorptive capacity of HgCl₂ for WPAC was decreased to 1.×34 10^?1 mg HgCl₂/g PA≤C. Furthermore,WPAC with higher sulfur contents could adsorb even more HgCl₂ because of the reactions between sulfur and Hg²⁺ at 150 °C. It was demonstrated that the mechanisms for adsorbing HgCl₂ onto WPAC were physical adsorption and chemisorption at 25 and 150 °C, respectively. Experimental results also indicated that the apparent overall driving force model appeared to have the good correlation with correlation coefficients (r) >0.998 for HgCl₂ adsorption at 25 and 150 °C. Moreover, the equilibrium adsorptive capacity of HgCl₂ for virgin WPAC was similar to that for CPAC at 25 °C, whereas it was slightly higher for sulfurized WPAC than for CPAC at 150 °C.     

Effect of chlorination and ultraviolet disinfection on tetA-mediated tetracycline resistance of Escherichia coli

Antibiotic-resistant bacteria are an emerging threat to public health during drinking water consumption and reclaimed water reuse. Several studies have shown that the proportions of antibiotic-resistant bacteria in waters may increase when exposed to low doses of UV light or chlorine. In this study, inactivation of tetracycline-resistant Escherichia coli and antibiotic-sensitive E. coli by UV disinfection and chlorination was compared to determine the tolerance of tetracycline-resistant E. coli to UV light and chlorine, and tetracycline resistance of a tetracycline-resistant E. coli population was studied under different doses of the disinfectants. Our results showed that relative to antibiotic-sensitive E. coli, tetracycline-resistant E. coli had the same tolerance to UV light and a potentially higher tolerance to chlorination. The mortality frequency distributions of tetracycline-resistant E. coli exposed to tetracycline were shifted by both chlorination and UV disinfection. When compared to the hemi-inhibitory concentrations (IC₅₀) of tetracycline-resistant E. coli with no exposure to UV or chlorination, the IC₅₀ of tetracycline-resistant E. coli treated with tetracycline was 40% lower when inactivation by UV light or chlorination reached 3-log but was 1.18 times greater when inactivation by chlorination reached 4.3-log. Chlorination applied to drinking water or reclaimed water treatment may increase the risk of selection for highly tetracycline-resistant E. coli.     

厌氧-局部循环供氧生物膜技术处理农村污水

通过模拟农村生活污水水质和间歇进水特点,利用“厌氧-局部循环供氧生物膜”技术,研究该工艺对有机物、氮、磷的去除效果.厌氧池和局部循环供氧池有效容积比为1∶1.6,曝气装置位于局部循环供氧池中间底部,环形导流板将局部循环供氧池分隔成中间好氧区和四周缺氧区,斜管沉淀池前置到厌氧池与局部循环供氧池之间,出水端设置循环水池.装置连续稳定运行12个月,平均进水量为140 L/d,生物反应区HRT为1.3d.监测结果表明,出水COD、BOD、NH3-N、TN和TP平均浓度分别在40.31、3.38、2.69、11.98和0.75 mg/L,达到了国家城镇污水处理厂污染物排放指标(GB-18918-2002)中的一级排放标准.研究表明,厌氧-局部循环供氧技术是一种适合农村分散污水处理的新工艺,可有效减轻农业面源污染.     

Occurrence and distribution of heavy metals and tetracyclines in agricultural soils after typical land use change in east China

Land use in east China tends to change from paddy rice to vegetables or other high-value cash crops, resulting in high input rates of organic manures and increased risk of contamination with both heavy metals (HMs) and antibiotics. This investigation was conducted to determine the accumulation, distribution and risks of HMs and tetracyclines (TCs) in surface soils and profiles receiving different amounts of farmyard manure. Soil samples collected from suburbs of Hangzhou city, Zhejiang province were introduced to represent three types of land use change from paddy rice to asparagus production, vineyards and field mustard cultivation, and divided into two portions, one of which was air-dried and sieved through 2-, 0.3- and 0.149-mm nylon mesh for determination of pH and heavy metals. The other portion was frozen at ?20 °C, freeze-dried and sieved through a 0.3-mm nylon mesh for tetracyline determination. HM and TC concentrations in surface soils of 14-year-old mustard fields were the highest with total Cu, Zn, Cd and ∑TCs of 50.5, 196, 1.03 mg?kg^?1 and 22.9 μg?kg^?1, respectively, on average. The total Cu sequence was field mustard?>?vineyards?>?asparagus when duration of land use change was considered; oxytetracycline (OTC) and doxycycline were dominant in soils used for asparagus production; OTC was dominant in vineyards and chlortetracycline (CTC) was dominant in mustard soils. There were positive pollution relationships among Cu, Zn and ∑TCs, especially between Cu and Zn or Cu and ∑TCs. Repeated and excessive application of manures from intensive farming systems may produce combined contamination with HMs and TCs which were found in the top 20 cm of the arable soil profiles and also extended to 20–40 cm depth. Increasing manure application rate and cultivation time led to continuing increases in residue concentrations and movement down the soil profile.