Indicator system to evaluate the effectiveness and efficiency of China clean power systems

Mitigation and Adaptation Strategies for Global Change - The mitigation of climate change demands a transition to low-carbon power generation systems. To identify effective transition strategies...     

Physico-chemical characterization and source tracking of black carbon at a suburban site in Beijing

Particles from ambient air and combustion sources including vehicle emission, coal combustion and biomass burning were collected and chemically pretreated with the purpose of obtaining isolated BC (black carbon) samples. TEM (transmission electron microscopy) results indicate that BC from combustion sources shows various patterns, and airborne BC appears spherical and about 50 nm in diameter with a homogeneous surface and turbostratic structure. The BET (Barrett–Emmett–Teller) results suggest that the surface areas of these BC particles fall in the range of 3–23 m²/g, with a total pore volume of 0.03–0.05 cm³/g and a mean pore diameter of 7–53 nm. The nitrogen adsorption–desorption isotherms are indicative of the accumulation mode and uniform pore size. O₂-TPO (temperature programmed oxidation) profiles suggest that the airborne BC oxidation could be classified as the oxidation of amorphous carbon, which falls in the range of 406–490°C with peaks at 418, 423 and 475°C, respectively. Generally, the BC characteristics and source analysis suggest that airborne BC most likely comes from diesel vehicle emission at this site.     

黄磷乳浊液脱硝及改性研究

采用黄磷乳浊液为吸收剂,考察了黄磷浓度、反应温度、搅拌速度、氧气浓度、烟气流量等影响因素对脱硝率的影响,并且通过添加碳酸钙进行改性,提高了体系的脱硝率。结果表明,脱硝率随黄磷浓度增大、反应温度升高、搅拌速度增大而升高;随烟气流量的增大而下降;加入碳酸钙改性可以明显提高体系脱硝效果;烟气流量400 m L/min,反应温度50℃,搅拌速度1 200 r/min,氧气浓度12%,黄磷浓度6 g/L,碳酸钙浓度2 g/L的条件下,处理NO浓度为0.06%的烟气,反应30 min体系脱硝率可达到84.76%。     

Phosphorus recovery from biogas fermentation liquid by Ca-Mg loaded biochar

Shortage in phosphorus (P) resources and P wastewater pollution is considered as a serious problem worldwide. The application of modified biochar for P recovery from wastewater and reuse of recovered P as agricultural fertilizer is a preferred process. This work aims to develop a calcium and magnesium loaded biochar (Ca-Mg/biochar) application for P recovery from biogas fermentation liquid. The physico-chemical characterization, adsorption efficiency, adsorption selectivity, and postsorption availability of Ca-Mg/biochar were investigated. The synthesized Ca-Mg/biochar was rich in organic functional groups and in CaO and MgO nanoparticles. With the increase in synthesis temperature, the yield decreased, C content increased, H content decreased, N content remained the same basically, and BET surface area increased. The P adsorption of Ca-Mg/biochar could be accelerated by nano-CaO and nano-MgO particles and reached equilibrium after 360 min. The process was endothermic, spontaneous, and showed an increase in the disorder of the solid-liquid interface. Moreover, it could be fitted by the Freundlich model. The maximum P adsorption amounts were 294.22, 315.33, and 326.63 mg/g. The P adsorption selectivity of Ca-Mg/biochar could not be significantly influenced by the typical pH level of biogas fermentation liquid. The nano-CaO and nano-MgO particles of Ca-Mg/biochar could reduce the negative interaction effects of coexisting ions. The P releasing amounts of postsorption Ca-Mg/biochar were in the order of Ca-Mg/B600 > Ca-Mg/B450 > Ca-Mg/B300. Results revealed that postsorption Ca-Mg/biochar can continually release P and is more suitable for an acid environment.     

Antimony(V) removal from water by hydrated ferric oxides supported by calcite sand and polymeric anion exchanger

We fabricated and characterized two hybrid adsorbents originated from hydrated ferric oxides(HFOs) using a polymeric anion exchanger D201 and calcite as host. The resultant adsorbents(denoted as HFO-201 and IOCCS) were employed for Sb(V) removal from water. Increasing solution pH from 3 to 9 apparently weakened Sb(V) removal by both composites, while increasing temperature from 293 to 313 K only improved Sb(V) uptake by IOCCS. HFO-201 exhibited much higher capacity for Sb(V) than for IOCCS in the absence of other anions in solution. Increasing ionic strength from 0.01 to 0.1 mol/L NaNO3would result in a significant drop of the capacity of HFO-201 in the studied pH ranges; however, negligible effect was observed for IOCCS under similar conditions. Similarly, the competing chloride and sulfate pose more negative effect on Sb(V) adsorption by HFO-201 than by IOCCS, and the presence of silicate greatly decreased their adsorption simultaneously, while calcium ions were found to promote the adsorption of both adsorbents. XPS analysis further demonstrated that preferable Sb(V) adsorption by both hybrids was attributed to the inner sphere complexation of Sb(V) and HFO, and Ca(II) induced adsorption enhancement possibly resulted from the formation of HFO-Ca-Sb complexes. Column adsorption runs proved that Sb(V) in the synthetic water could be effectively removed from 30 μg/L to below 5 μg/L(the drinking water standard regulated by China), and the effective treatable volume of IOCCS was around 6 times as that of HFO-201, implying that HFO coatings onto calcite might be a more effective approach than immobilization inside D201.     

防灾减灾系统工程的国际对比分析及建议

针对我国现存的灾害状况,本文通过国际对比的方法,对其他国家已有的减灾系统工程作了简单介绍,并结合我国实际,对未来建立减灾系统工程中应着重加强的薄弱环节作了分析,提出了加强立法工作,增加减灾投入,建立全国统一的减灾通讯系统的建议。     

曝气沉淀池的工艺改进及多点进水装置设计

针对吸气沉淀地处理炼油废水时存在的问题，采取了相应的改进措施，取得了满意的效果。对沿回流缝多点进水装置的工艺设计进行了详细论述。     

基于模式生物秀丽隐杆线虫的环境污染物生殖毒性研究进展

由于人类社会的发展,环境污染也越来越严重,研究环境污染物对生态及人类健康的影响极为重要。生殖系统是人和动物繁衍后代的重要系统,常见环境污染物对生殖系统的影响正引起研究人员的广泛关注。秀丽隐杆线虫具有身体透明、品系丰富和遗传背景清楚等优点,为生殖毒理学研究提供了一个便利的平台。以秀丽隐杆线虫为模型已对多种环境污染物的生殖毒性进行了评价。本文重点叙述了重金属、纳米材料、有机物等化学污染,辐射、磁场等物理污染,以及病毒等生物污染对秀丽线虫生殖系统的影响,并归纳讨论了环境污染物造成生殖功能障碍的几种主要机制,如氧化应激、DNA损伤、内质网应激以及神经损伤等,但不同类型污染物的毒性效应与其自身的物化性质紧密相关。环境污染物诱导的生殖毒性中不同响应机制之间的关联性、不同发育阶段的敏感性差异、污染物的传代效应以及有效的缓解方式的筛选等都有待进一步的开展。     

利用含油碳酸钙污泥制备橡胶填充剂

本文以中原油田含油碳酸钙污泥为研究对象,根据高分子理论化学和橡胶工程理论,论证了油田含油碳酸钙污泥开发含油橡胶填充剂的理论基础。经粉体加工,将含油碳酸钙污泥制备成实验用橡胶填充剂。通过橡胶工程实验及产品测试,结果表明,与正在使用的普通碳酸钙和纳米碳酸钙填充剂相比,含油碳酸钙污泥制备的填充剂对橡胶制品的性能没有明显的影响;在分散性、橡胶网状分子的交联性、磨耗、回弹性等方面,较普通碳酸钙和纳米碳酸钙的填充效果稍优。