自升式钻井平台就位安全性与覆盖能力要求分析*

为保证自升式钻井平台安全就位并覆盖海上生产平台井槽进行钻完井作业,研究自升式钻井平台就位及插桩作业过程中的风险及应对措施,提出考虑就位作业误差影响下的自升式钻井平台覆盖能力要求计算方法。结果表明:桩腿穿刺是自升式钻井平台就位安全的首要考虑因素;就位作业误差会明显提高对自升式钻井平台覆盖能力的要求;提出的方法可以准确计算出实际作业对自升式钻井平台横向和纵向覆盖能力的要求,对自升式钻井平台选型及安全作业具有一定的指导意义。     

特殊工况下船舶生活污水处理的试验研究

采用厌氧复合床反应器与接触氧化、接触沉淀相结合的工艺,针对实船条件下可能出现的重启动、倾斜、海水及淡水海水交替冲洗厕所和水力负荷增加等情况,进行了特殊工况下船舶生活污水处理的试验研究。结果表明,该组合工艺在设计条件下（HRT为5h）重启动速度较快,可用于海水冲厕所产生的高盐度污水处理,耐受淡水海水交替变化的盐度冲击负荷变化能力较强,具有一定的水力负荷增加潜力,并且不受倾斜影响。     

太湖流域经济增长与环境污染水平的关系研究

环境库兹涅茨曲线（KEC）是描述污染问题与经济发展之间关系的常用模型,一般情况下呈倒“U”形。通过对太湖流域1991-2005年的人均GDP与工业三废排放量之间的关系分析,研究发现,太湖流域的环境库兹涅茨曲线特征为增长的凹曲线,不同于传统的环境库兹涅茨曲线,同时分析了产生这一现象的原因,并从调整经济结构、转变增长方式、发展循环经济方面给出政策建议。     

不同品种茶叶中锗含量的测定与研究

在苏木色精－偏钒酸胺体系中，锗可产生一灵敏的极谱催化波，峰电位为－０．５７Ｖ（ｕｓ ＳＣＥ），检测下限为６．８８８×１０＾－１１ｍｏｌ／ｌ，线性范围为１．３７８×１０＾－１０—１．１０２×１０＾－５ｍｏｌ／ｌ。用催化极谱法测定茶叶中锗，兼具灵敏、准确、快速、简便、选择性好的优点，可用于茶叶样品中锗的定量测定。     

Separating method and dynamic processes of Nano-Al13

In order to investigate the characteristics of pure Nano-Al₁₃, Nano-Al₁₃ was separated and purified from a series of poly-aluminum chloride (PAC) solutions which had the same Al₁₃ percentage but different total Al concentrations, by using column chromatography, ethanol-acetone resolving and SO^2? ₄/Ba²⁺ displacement. The Al₁₃ species yield was characterized by Al-ferron timed complexation spectrophotometry and ²⁷Al-NMR (nuclear magnetic resonance). The coagulation efficiency of Nano-Al₁₃, PAC and AlCl₃ in synthetic water was also investigated by Jar tests. The dynamic process and aggregation state of kaolin suspensions coagulating with Nano-Al₁₃, PAC and AlCl₃ were similarly investigated using a photometric dispersion analyzer 2000 (PDA2000). The experimental results indicated that the ethanol-acetone resolving method was simple and could separate the PAC solution at different concentrations, while column chromatography could separate PAC solutions at low concentrations. The SO₄ ^2?/Ba²⁺ displacement method could separate PAC solutions at high concentrations. However, extra inorganic cation and anion could be added in the solution during separation. The coagulation efficiency and dynamic experimental results showed that Nano-Al₁₃ with high positive-charged species was effective in removing turbidity and color. The dynamic process results showed that Nano-Al₁₃ also had the best recovery capability after shearing compared with PAC and AlCl₃ because the Nano-Al₁₃ conformation is more effective in charge neutralization.     

Trophic modification of essential fatty acids by heterotrophic protists and its effects on the fatty acid composition of the copepod Acartia tonsa

To test whether heterotrophic protists modify precursors of long chain n−3 polyunsaturated fatty acids (LCn−3PUFAs) present in the algae they eat, two algae with different fatty acid contents (Rhodomonas salina and Dunaliella tertiolecta) were fed to the heterotrophic protists Oxyrrhis marina Dujardin and Gyrodinium dominans Hulbert. These experiments were conducted in August 2004. Both predators and prey were analyzed for fatty acid composition. To further test the effects of trophic upgrading, the calanoid copepod Acartia tonsa Dana was fed R. salina, D. tertiolecta, or O. marina that had been growing on D. tertiolecta (OM-DT) in March 2005. Our results show that trophic upgrading was species-specific. The presence of eicosapentaenoic acid (EPA) and docosahexaenoic acid (DHA) in the heterotrophic protists despite the lack of these fatty acids in the algal prey suggests that protists have the ability to elongate and desaturate 18:3 (n−3), a precursor of LCn−3PUFAs, to EPA and/or DHA. A lower content of these fatty acids was detected in protists that were fed good-quality algae. Feeding experiments with A. tonsa showed that copepods fed D. tertiolecta had a significantly lower content of EPA and DHA than those fed OM-DT. The concentration of EPA was low on both diets, while DHA content was highest in A. tonsa fed R. salina and OM-DT. These results suggest that O. marina was able to trophically upgrade the nutritional quality of the poor-quality alga, and efficiently supplied DHA to the next trophic level. The low amount of EPA in A. tonsa suggests EPA may be catabolized by the copepod.     

利用氧化铝-改性硅胶联柱分离测定水中多氯联苯

本文介绍一种多氯联苯(PCBs)与农药的分离和气相色谱分析PCBs新方法.富集浓缩后的样品首先经浓硫酸酸洗.排除大多数干扰PCBs测定的有机化合物,然后利用氧化铝-硅胶(Ag~+)联柱实现了PCBs和干扰其测定的农药的完全分离,应用毛细管气相色谱分析测试了水样中多氯联苯多种同系物、同分异构体的含量.其方法的回收率在79—88%之间.     

Analysis and structure prediction of chlorinated polycyclic aromatic hydrocarbons released from combustion of polyvinylchloride

Chlorinated polycyclic aromatic hydrocarbons (Cl-PAHs) released from combustion of polyvinylchloride (PVC) at different furnace temperatures were investigated. A laboratory-scale tube-type furnace with electric heating was utilized to control combustion conditions. Glass fabric filters and adsorbents were used to collect the combustion emissions. Following Soxhlet extraction, concentration and column chromatography purification, isomers separation, selective detection and identification of Cl-PAHs were performed on GC/MS system on the basis of retention data and mass spectra. Their quantification was accomplished by using external standard calibration technique. About 18 Cl-PAHs were determined, most of which were monochlorinated derivatives of naphthalene, biphenyl, fluorene, phenanthrene, anthracene, fluoranthene and pyrene. Only two dichlorophenanthrenes or anthracenes were identified. The possible positions of chlorine atoms attached to the aromatic rings are predicted by quantitative structure-property relationship. The levels of these compounds were in the range of 0.30-29.08 microg/g PVC. The relationship between the formation of Cl-PAHs and PAHs was discussed.     

Chlorination of dibenzofuran and dibenzo-p-dioxin vapor by copper (II) chloride

Dibenzofuran (DF) is formed from phenol and benzene in combustion gas exhaust streams prior to particle collection equipment. Subsequent chlorination at lower temperatures on particle surfaces is a potential source of chlorinated dibenzofuran (CDF). Gas streams containing 8% O₂ and approximately 0.1% DF vapor were passed through particle beds containing copper (II) chloride (0.5% Cu, mass) at temperatures ranging from 200 to 400 °C to investigate the potential for CDF formation during particle collection. Experiment duration was sufficient to provide an excess amount of DF (DF/Cu=3). The efficiency of DF chlorination by CuCl₂ and the distribution of CDF products were measured, with effects of temperature, gas velocity, and experiment duration assessed. Results of a more limited investigation of dibenzo-p-dioxin (DD) chlorination by CuCl₂ to form chlorinated DD (CDD) products are also presented.The efficiency of DF/DD chlorination by CuCl₂ was high, both in terms of CuCl₂ utilization and DF/DD conversion. Total yields of Cl on CDF/CDD products of up to 0.5 mole Cl per mole CuCl₂ were observed between 200 and 300 °C; this suggests that nearly 100% CuCl₂ was utilized, assuming a conversion of two moles of CuCl₂ to CuCl per mole Cl added to DD/DF. In a short duration experiment (DF/Cu=0.3), nearly 100% DF adsorption and conversion to CDF was achieved. The degree of CDF chlorination was strongly dependent on gas velocity. At high gas velocity, corresponding to a gas–particle contact time of 0.3 s, mono-CDF (MCDF) yield was largest, with yields decreasing with increasing CDF chlorination. At low gas velocity, corresponding to a gas–particle contact time of 5 s, octa-CDF yield was largest. DF/DD chlorination was strongly favored at lateral sites, with the predominant CDF/CDD isomers within each homologue group those containing Cl substituents at only the 2,3,7,8 positions. At the higher temperatures and lower gas velocities studied, however, broader isomer distributions, particularly of the less CDD/CDF products, were observed, likely due to preferential destruction of the 2,3,7,8 congeners.     

Magnetic resonance imaging of nonaqueous phase liquid during soil vapor extraction in heterogeneous porous media

Soil vapor extraction (SVE) is commonly used to remediate nonaqueous phase liquids (NAPLs) from the vadose zone. This paper aims to determine the effect of grain size heterogeneity on the removal of NAPL in porous media during SVE. Magnetic resonance imaging (MRI) was used to observe and quantify the amount and location of NAPL in flow-through columns filled with silica gel grains. MRI is unique because it is nondestructive, allowing three-dimensional images to be taken of the phases as a function of space and time. Columns were packed with silica gel in three ways: coarse grains (250-550 microm) only, fine grains (32-63 microm) only, and a core of fine grains surrounded by a shell of coarse grains. Columns saturated with water were drained under a constant suction head, contaminated with decane, and then drained to different decane saturations. Each column was then continuously purged with water-saturated nitrogen gas and images were taken intermittently. Results showed that at residual saturation, a sharp volatilization front moved through the columns filled with either coarse-grain or fine-grain silica gel. In the heterogeneous columns, the volatilization front in the core lagged just behind the shell because gas flow was greater through the shell and decane in the core diffused outward to the shell. When decane saturation in the core was above residual saturation, decane volatilization occurred near the inlet, the relative decane saturation throughout the core dropped uniformly, and decane in the core flowed in the liquid phase to the shell to replenish volatilized decane. These results indicate that NAPL trapped in low-permeability zones can flow to replenish areas where NAPL is lost due to SVE. However, when residual NAPL saturation is reached, NAPL flow no longer occurs and diffusion limits removal from low-permeability zones.