Formaldehyde Release from Simulated Wall Panels Insulated with Urea-Formaldehyde Foam Insulation

An important potential source of formaldehyde in the home is ureaformaldehyde foam insulation (UFFI). This study measures the long-term release of formaldehyde through the interior wall of test panels foamed with commercial urea-formaldehyde insulation. The measurements, made approximately 16 mo after initial foaming, were conducted under both static and dynamic air conditions with air flow selected to simulate a typical air exchange found in houses. Estimated room concentrations based on a simple model of uniform mixing within a room and measured emission rates are presented. Measurements of formaldehyde in the air from within the UFFI cavities are also reported.     

An Evaluation of the Semi-VOST Method for Determining Emissions from Hazardous Waste Incinerators

The Semi-Volatile Organic Sampling Train method was investigated to determine its reliability and to determine the bias and precision of the method when used to determine emissions from hazardous waste incinerators. Experiments showed that the matrix and sampling variables usually involved in sampling emissions from a hazardous waste incinerator had no significant effect on the recovery of 11 different organic compounds. Significant losses of the sampled compounds can occur during sample preparation. The degree of loss appears to be directly related to the compounds, vapor pressure. These losses can be corrected for by adding deuterated surrogates to the sample and analyzing the surrogates along with the native compounds.

The bias determination was based on dynamic spiking of the sampling train with five deuterated organic compounds selected from Appendix VIII of the Resource Conservation and Recovery Act regulations. The results show biases of from -1 ± 8 percent to -18 ± 27 percent for chlorinated and nonchlorinated compounds. Pyridine, a water-soluble compound, showed a larger bias of-29 ± 13 percent. Particular attention to the recovery of water soluble compounds is necessary to minimize bias in their determinations. Further work is needed to determine the reliability of laboratory-determined retention volumes that are used to determine sampling conditions.     

Use of Energy Scenarios in Addressing the CO2 Question

A reference scenario for CO₂ emissions was developed using a model of world energy supply and demand. In the reference scenario, world GNP and world energy demand increase at average rates of 2.1 percent per year and 1.5 percent per year, respectively during the period 1975-2100. The corresponding annual CO₂ emissions rise to a maximum of 16 gigatons of carbon around 2050 and then decline as a result of a transition to nonfossil fuel energy systems. A modified scenario for high CO₂ emissions was obtained by assuming an abundant supply of low cost coal, thus eliminating the transition. A low case was developed in which the low cost of alternative energy (i.e., solar, nuclear) induces an earlier shift away from fossil fuels.

Annual emissions of the three scenarios were used as input to a global carbon cycle model and the CO₂ buildup in the atmosphere during the period 1980-2100 was determined by the model. All three scenarios showed continuous rises in atmospheric CO₂ concentration. The reference scenario reached 775 ppm by 2100. The high CO₂ case resulted in concentrations of over 1040 ppm, and for the low case the 2100 concentration was just under 700 ppm. If the climate theory is correct, even 700 ppm is sufficient to give significant climate warming, but by experiencing the change gradually over a century, adaptation may not be painful. An early transition to nonfossil fuel supplies makes the problem less severe but does not eliminate it.     

A New Audit Technique for EPA Method 25

A simple, inexpensive, and accurate technique for evaluating or auditing the sampling, recovery, and analytical phases of EPA Source Reference Method 25 has been developed. The technique involves spiking a U-shaped stainless steel cartridge containing Tenax® with known quantities of selected organic compounds and thermally desorbing them at temperatures from 160°C to 180°C to generate organic vapors quantitatively. The major advantages of this technique are that no other measurement methods can be used to determine the generated organic concentrations in lieu of Method 25; and that the cartridge can easily be taken to the field for evaluation. The organic compounds generated in test runs are collected and analyzed using the Method 25 procedure. The generation of organics is quantitative and recoveries were found to be 100 ± 10%. The time required for desorption of the majority of organics is generally less than forty-five minutes at a flow rate of 100 mL/min; however, based on laboratory experience the recommended sampling time is sixty minutes. These spiked cartridges are stable at room temperature over a two-month period. Results of interlaboratory studies showed close agreement with the expected concentrations based on calculations from the mass loadings and sample volumes.     

Development of Federal Air Standards to Reduce Sulfur Dioxide Emissions from New Industrial Boilers

Federal new source performance standards to control air emissions of sulfur dioxide from new industrial boilers were proposed by EPA on June 19, 1986. These standards would require boiler owners to reduce SO₂ emissions by 90 percent and meet an emission limit of 1.2 lb/MM Btu of heat input for coal-fired boilers and 0.8 lb/MM Btu for oil-fired boilers. In developing these standards, several regulatory options were considered, from standards that could be met by firing low sulfur fuels to standards that would necessitate flue gas treatment. The environmental, economic, and cost impacts of each option were analyzed. National impacts were estimated by a computer model that projects the population of new boilers over the 5-year period following proposal, predicts the compliance strategy that will be used to comply with the particular option (always assuming that the lowest cost method of compliance will be selected), and estimates the resulting emission reductions and costs. Impacts on specific industries and on model boilers were also analyzed. This paper focuses on these analyses and their results. The Agency's conclusions from these analyses, which led to the decision to establish percent reduction standards, are provided, and the proposed SO₂ standards are summarized. The proposed standards also include an emission limit for particulate matter from oil-fired boilers (0.1 lb/MM Btu). However, this article focuses only on the SO₂ standards.     

An Assessment of the Economic Effects of Ozone on U.S. Agriculture

Past attempts to measure the economic consequences of ozone on agriculture have been based on limited plant science information. This paper reports on an economic assessment of ozone on U.S. agriculture using recent crop response data from the National Crop Loss Assessment Network (NCLAN). The results are derived from a U.S. agricultural sector model that includes major crop and livestock production as well as domestic consumption, livestock feeding and export uses. The economic effects of four hypothetical ambient ozone levels are investigated. The analysis Indicates that the benefits to society of moderate (25%) ozone reductions are approximately $1.7 billion. A 25% Increase in ozone pollution results in costs (negative benefits) of $2.1 billion. These estimates do not reflect compliance costs of achieving the ozone changes and hence are not net benefits.     

机械清洗法对MBR膜泥饼层的影响

膜污染是制约MBR发展的瓶颈。考察投加ABS颗粒对MBR膜组件上膜泥饼层的影响,并设对照实验。结果表明,对照MBR膜通量下降速度快,膜污染严重,膜表面上累积厚厚的泥饼层,而在ABS MBR中膜通量下降速度则缓慢的多,且膜上泥饼层积累量则明显少于对照MBR;曝气量越大,颗粒运行的速度也越快,泥饼层被撞落量也越多;颗粒以碰撞角度为45°冲刷膜的情况下,泥饼层掉落效果明显增加;泥饼层包裹的膜丝根数越多,泥饼层的静摩擦力和保持泥饼层不被破坏的力也越大,泥饼层就越难被冲刷掉。SEM照片显示,ABS MBR的膜孔堵塞要严重于对照MBR,表面的褶皱要较对照MBR多。     

胶合竹材GluBam甲醛释放影响因素的气候箱实验与分析

胶合竹材GluBam的甲醛释放情况是现代竹结构住宅环保性的一个重要方面,也是竹结构住宅推广中最受关注的指标之一。采用1 m3气候箱对温度、相对湿度和封边情况与GluBam的甲醛释放量和释放速率的相关关系进行了测试,并以一阶单衰减模型为基础提出了GluBam的甲醛释放分析模型。测试和分析结果表明:GluBam板材在各模拟条件下甲醛浓度峰值均小于规范要求;初始甲醛释放量E0和衰减率常数k可以用来评价GluBam的甲醛释放特征;GluBam的醛释放量和释放速率随环境温度和湿度增加而显著增大,且温度因素的影响更大;封边处理可以有效降低GluBam板材的甲醛释放量。     

电吸附对水中盐类、氨氮、COD的去除效果分析

电吸附技术作为高效、环境友好型的除盐、除氨氮技术,可应用与水的深度处理领域内。为了使污水回用达到工业用水的水质标准,对电吸附去除水中盐类、氨氮、COD的效果进行分析,结果表明,电吸附设备处理不同氨氮浓度的废水,对中低浓度的氨氮去除效果稳定,当进水氨氮浓度低于20 mg/L时,处理后出水氨氮浓度低于5 mg/L,COD浓度小于25 mg/L,达到回用标准;随着进水盐浓度的增大电吸附处理效果逐渐变差,在电导率低于2 500 μS/cm时除盐率在75%左右,氨氮去除率达到70%左右,COD去除率达到60%左右。经电吸附处理后的低氨氮浓度废水,TDS、氨氮浓度均可达到工业回用水标准。     

利用钢铁盐酸酸洗废液在填料塔中制备FeCl3

以钢铁盐酸酸洗废液为原料,亚硝酸钠为催化剂,氧气为氧化剂,在填料塔中催化氧化制备三氯化铁。考察了反应温度、催化剂加入量和添加方式、循环流量等对制备三氯化铁的影响。实验结果表明,在优化的工艺条件为料液预热温度为60 ℃、催化剂加入量为钢铁盐酸酸洗废液总质量的0.30%、料液循环流量6.0 m³/h的条件下,反应80~120 min,酸洗废液中的Fe²⁺完全氧化为Fe³⁺。