Enhanced cross-flow filtration with flat-sheet ceramic membranes by titanium-based coagulation for membrane fouling control

• Ceramic membrane filtration showed high performance for surface water treatment. • PTC pre-coagulation could enhance ceramic membrane filtration performance. • Ceramic membrane fouling was investigated by four varied mathematical models. • PTC pre-coagulation was high-effective for ceramic membrane fouling control. Application of ceramic membrane (CM) with outstanding characteristics, such as high flux and chemical-resistance, is inevitably restricted by membrane fouling. Coagulation was an economical and effective technology for membrane fouling control. This study investigated the filtration performance of ceramic membrane enhanced by the emerging titanium-based coagulant (polytitanium chloride, PTC). Particular attention was paid to the simulation of ceramic membrane fouling using four widely used mathematical models. Results show that filtration of the PTC-coagulated effluent using flat-sheet ceramic membrane achieved the removal of organic matter up to 78.0%. Permeate flux of ceramic membrane filtration reached 600 L/(m²·h), which was 10-fold higher than that observed with conventional polyaluminum chloride (PAC) case. For PTC, fouling of the ceramic membrane was attributed to the formation of cake layer, whereas for PAC, standard filtration/intermediate filtration (blocking of membrane pores) was also a key fouling mechanism. To sum up, cross-flow filtration with flat-sheet ceramic membranes could be significantly enhanced by titanium-based coagulation to produce both high-quality filtrate and high-permeation flux.     

Impact of different pretreatments on the anaerobic digestion performance of cucumber vine

Environmental Science and Pollution Research - Copious amounts of cucumber vine (CV) derived from crop growing and harvesting are casually discarded in the field, posing severely negative impacts...     

上海市城镇污水处理厂氨气排放定量研究

通过对上海市3家城镇污水处理厂主要污水处理工艺臭气收集处理装置进出口有组织排放和二沉池等敞开液面无组织排放氨采样,研究污水处理厂氨气排放特征,建立污水处理厂分季节本地化氨排放系数,并计算2019年上海市城镇污水厂氨排放量。结果表明:3家污水处理厂氨排放系数平均为4.8 mg/m³,其中污水处理环节氨排放系数为3.3 mg/m³,污泥处理环节氨排放系数为1.5 mg/m³。2019年上海市城镇污水处理厂氨排放量为10.3 t。     

Structural investigation of catalyst deactivation of Pt/SDB for catalytic oxidation of VOC-containing wastewater

The stability of styrene-divinyl benzene copolymer (SDB)-supported Pt (Pt/SDB) catalysts for destruction of volatile-organic-compound (VOC) in wastewater was examined. The test reaction was wet oxidation of water-containing aliphatic alcohol and formaldehyde at 140 degrees C and 90 psig for 40 h. The catalytic performance tests indicated that activity of the Pt/SDB catalysts could be maintained for VOC concentration of 3 wt.%, whereas the catalysts deactivated rapidly for 10 wt.% VOC containing wastewater. In order to investigate the nature of catalyst deactivation, extended X-ray absorption fine structure (EXAFS) and X-ray absorption near edge (XANES) spectroscopy were used to characterize the fresh and used catalysts. After the reaction, there is no oxidation of Pt clusters observed in EXAFS and XANES spectroscopy suggesting that the oxidation reaction takes places via the adsorbed oxygen. The spectroscopy results further indicated that deactivation of the catalysts were mainly caused by the increase of Pd particle size. After the reaction, the Pt-Pt coordination number has no significant change for the 3 wt.% wastewater whereas increase from 5.6 to 6.2 for 10 wt.% wastewater. Combined with the fact that the catalysts fractured during the reactions, we suggested that Pt agglomeration was mainly caused by thermal migration of the metal clusters.     

Adsorption of acid dye onto activated carbons prepared from agricultural waste bagasse by ZnCl2 activation

A series of activated carbons were prepared from agricultural waste sugarcane bagasse by chemical activation with zinc chloride (ZnCl2) as an activating agent at 500 degrees C and 0.5 h soaking time. The Langmuir surface area and total pore volume were used to estimate the average pore diameter of the carbon products. The values of the surface area and pore volume increased linearly with increase in the impregnation ratio (IR) up to 100 wt%. The adsorption capacities of the derived adsorbents for Acid Orange 10 were measured at 20 degrees C and 40 degrees C to gain further insights into the acidic surface oxides of the adsorbent from the results of Fourier transform infrared (FTIR) spectroscopy analysis and pH measurement. Adsorption isotherms of the acid dye on adsorbents prepared were determined and correlated with common isotherm equations. It was found that the Langmuir model appears to fit the isotherm data better than the Freundlich model. The physical properties of these adsorbents were consistent with the parameters obtained from the isotherm equations.     

溶解有机质对生物富集因子计算的影响:以东江鱼体中多溴联苯醚的生物富集为例

准确获取化合物的生物富集因子(BAF)对于判定化合物是否属于潜在毒害性污染物、评价其生态环境风险都具有重要的意义。为探究水体中溶解有机质(DOM)对BAF值的影响,以东江三角洲流域为研究区域,以多溴联苯醚(PBDEs)为目标化合物,研究了PBDEs各单体在3种鱼体中的富集特征。结果表明,PBDEs在3种鱼体中的浓度范围为42~825 ng·g-1脂肪,log BAF值位于5.0~7.4之间。由于脱溴代谢的种间差异,3种鱼类表现出2种PBDE的组成模式。在缺乏脱溴代谢途径的鱼体内,log BAF与化合物辛醇/水分配系数(log KOW)之间存在统计意义上的抛物线关系。但当BAF进行DOM的校正之后,二者之间抛物线形式的相关性消失,而呈现出显著的正线性相关性。以往研究对BAF值在化合物的log KOW达到一定程度后(7~8附近)出现下降的解释是高KOW化合物较大的分子体积降低了其穿过生物膜的可能性,但我们的研究结果表明,这种下降很可能是由于忽视了水体中DOM影响的结果。     

圆孔多孔板水力空化杀灭大肠杆菌的实验研究

在以圆形孔口多孔板为空化空蚀发生器的水力空化装置中,对含有大肠杆菌的水样进行灭菌处理.通过检测大肠杆菌的灭菌率,研究了水力空化对水中大肠杆菌的灭活效果.分析了大肠杆菌初始浓度,水流空化数,孔口流速,孔口排布,孔口数量,孔口大小,空化空蚀作用时间等参数对灭菌效果的影响.试验结果表明：提高流速,降低空化数,选取适当的初始浓度,延长空化空蚀作用时间,增加孔口数量,减小孔口大小以及改进孔口排布可以进一步提高大肠杆菌的杀灭率.水力空化的空化空蚀作用能够杀灭水中的大肠杆菌,是一种饮用水消毒的新技术.     

人体呼出气中内源性挥发性有机物筛选研究

人体代谢产生的内源性挥发性有机物（VOCs）可用作健康状况的标志物.本研究选择17~26岁无呼吸系统疾病的高校学生（73人）作为观察对象,使用气相色谱-火焰离子化检测器/质谱联用仪（GC-FID/MS）分析收集到的呼出气样本,对呼出气中VOCs的种类、浓度进行研究,发现了其5种卤代物的浓度高于室内浓度,其次是室外浓度.其中,在人体呼出气中1,1-二氯乙烯的浓度为室内浓度的近20倍,是室外浓度的近300倍,人体呼出气是环境中1,1-二氯乙烯的一个重要源.定量分析健康人呼出气,对比其与环境空气样本的浓度差异,并进行统计学检验,共筛选出1,1二氯乙烯、丙酮、1-己烯、甲基环己烷、2-戊酮、反-2-戊烯、2,4-二甲基戊烷、3-戊酮、四氯乙烯、对二氯苯、间二氯苯11种特征性内源性VOCs.     

Novel synthetic approaches and TWC catalytic performance of flower-like Pt/CeO2

A novel Ultrasonic Assisted Membrane Reduction （UAMR）-hydrothermal method was used to prepare flower-like Pt/CeO2 catalysts. The texture, physical/chemical properties, and reducibility of the flower-like Pt/CeO2 catalysts were characterized by X-Ray Diffraction （XRD）, Scanning Electron Microscope （SEM）, Transmission Electron Microscope （TEM）, N2 adsorption, and hydrogen temperature programmed reduction （HE-TPR） techniques. The catalytic performance of the catalysts for treating automobile emission was studied relative to samples prepared by the conventional wetness impregnation method. The Pt/CeO2 catalysts fabricated by this novel method showed high specific surface area and metal dispersion, excellent three-way catalytic activity, and good thermal stability. The strong interaction between the Pt nanoparticles and CeO2 improved the thermal stability. The Ce4＋ ions were incorporated into the surfactant chains and the Pt nanoparticles were stabilized through an exchange reaction of the surface hydroxyl groups. The SEM results demonstrated that the Pt/CeO2 catalysts had a typical three-dimensional （3D） hierarchical porous struc- ture, which was favorable for surface reaction and enhanced the exposure degree of the Pt nanoparticles. In brief, the flower-like Pt/CeO2 catalysts prepared by UAMR-hydrothermal method exhibited a higher Pt metal dispersion, smaller particle size, better three-way catalytic activity, and improved thermal stability versus conven- tional materials.     

Analyses of PAHs (polycyclic aromatic hydrocarbons) and mutagenicity in raw and chlorinated water

Both raw water and chlorinated drinking water samples were collected from and the Liu‐Du water treatment plant in northern Taiwan from October 1990 to April 1992. The polycyclic aromatic hydrocarbons (PAHs) and mutagenicity in these water samples were analyzed by GC/MS and Ames test. The Mutagenicity/DMSO (Dimethyl Sulfoxide) ratio in S. typhimurium TA98 and TA100 with or without S9 mixture increased, even higher than 2, following the sequence of unit process. It was observed that the mutagenicity with TA98 (S9+) was highly related to most of PAHs in the raw water; while the mutagenicity with TA98 (S9+) was only correlated with DbA and BghiPr in the treated water. It could be expected that the mutagenicity level was controlled by other predominant components after the raw water was treated, for example, the chlorination process.