Partition coefficients of organochlorine pesticides on soil and on the dissolved organic matter in water

The partition coefficients of organochlorine pesticides (OCPs) between the organic matter of Taichung soil and water (K_oc) were evaluated with batch-type experiments. The partition coefficients of OCPs between Aldrich humic acid and water (K_doc) were estimated with solubility enhancement method as well. In this study, the K_ocs of aldrin, heptachlor, and p,p′-DDT are greater than their K_docs, and the relationship of dieldrin and heptachlor epoxide are opposite. The variations of partition coefficients are discussed. For predicting K_doc, a log-log regression relationship of K_doc and K_ow is determined.     

Inactivation of fungi associated with barley grain by gaseous ozone

The use of gaseous ozone as a fungicide to preserve stored barley was studied. The effects of the following operating parameters on the fungicidal efficacy of ozone were examined: 1) the applied ozone dose, 2) ozonation time, 3) water activity of barley, and 4) temperature of barley. The effect of ozonation on germination of barley was also investigated. The experimental results showed that ozone was very effective in inactivation of fungi associated with the barley regardless of whether the fungi were in the forms of spores or mycelia. However, the mycelia were less resistant to ozone. With 5 minutes of ozonation, 96% of inactivation were achieved for spores as well as for mixtures of spores and small amount of mycelia by applying 0.16 and 0.10 mg of ozone/(g barley) x min, respectively. In addition, for sealed storage silos, inactivation of fungi continued when the ozone-containing gas was held inside the silos following a continuous ozone supply. The experimental results also revealed that increases in water activity and temperature of barley enhanced the fungicidal efficacy of ozone. Results of this study also indicated that the inactivation processes could be controlled by simply monitoring the exit ozone from the reactor instead of performing the time-consuming microbial examination. This finding would make the application of ozone in the preservation of cereal grains easier, simpler, and more practically applicable. The experimental results demonstrated that although ozonation above certain strength may reduce barley germination, inactivation of fungi was achieved with ozonation strengths far below the critical point.     

中低温厌氧处理城市污水污泥颗粒化的研究

用高径比为3：1的UASB反应器分别在35℃和室温条件下处理模拟城市污水,研究了污泥的颗粒化过程.比较了在不同温度、浓度下形成的颗粒污泥的特征.水温为9～25℃,进水浓度为100～200 mg COD/L,水力上流速度（Vup）在0.013～0.11 m/h的4^#UASB反应器在60 d内在形成了成熟的颗粒污泥.研究表明,进水中低的有机物浓度,低的Ca^2＋、Mg^2＋浓度和低的Vup没有抑制颗粒化进程.     

垃圾堆放发酵机理与应用工艺研究

对垃圾的发酵机理进行了实验研究,对渗沥液的析出量及其酸碱度、堆酵后垃圾热值的变化以及堆内温度的变化进行了观测,并对堆酵过程的机理进行了初步分析,给出了垃圾堆酵应用工艺的建议.     

A triple-continuum approach for modeling flow and transport processes in fractured rock

This paper presents a triple-continuum conceptual model for simulating flow and transport processes in fractured rock. Field data collected from the unsaturated zone of Yucca Mountain, a repository site of high-level nuclear waste, show a large number of small-scale fractures. The effect of these small fractures has not been considered in previous modeling investigations within the context of a continuum approach. A new triple-continuum model (consisting of matrix, small-fracture, and large-fracture continua) has been developed to investigate the effect of these small fractures. This paper derives the model formulation and discusses the basic triple-continuum behavior of flow and transport processes under different conditions, using both analytical solutions and numerical approaches. The simulation results from the site-scale model of the unsaturated zone of Yucca Mountain indicate that these small fractures may have an important effect on radionuclide transport within the mountain.     

Application and evaluation of two air quality models for particulate matter for a southeastern U.S. episode

The Models-3 Community Multiscale Air Quality (CMAQ) Modeling System and the Particulate Matter Comprehensive Air Quality Model with extensions (PMCAMx) were applied to simulate the period June 29-July 10, 1999, of the Southern Oxidants Study episode with two nested horizontal grid sizes: a coarse resolution of 32 km and a fine resolution of 8 km. The predicted spatial variations of ozone (O3), particulate matter with an aerodynamic diameter less than or equal to 2.5 microm (PM2.5), and particulate matter with an aerodynamic diameter less than or equal to 10 microm (PM10) by both models are similar in rural areas but differ from one another significantly over some urban/suburban areas in the eastern and southern United States, where PMCAMx tends to predict higher values of O3 and PM than CMAQ. Both models tend to predict O3 values that are higher than those observed. For observed O3 values above 60 ppb, O3 performance meets the U.S. Environmental Protection Agency's criteria for CMAQ with both grids and for PMCAMx with the fine grid only. It becomes unsatisfactory for PMCAMx and marginally satisfactory for CMAQ for observed O3 values above 40 ppb. Both models predict similar amounts of sulfate (SO4(2-)) and organic matter, and both predict SO4(2-) to be the largest contributor to PM2.5. PMCAMx generally predicts higher amounts of ammonium (NH4+), nitrate (NO3-), and black carbon (BC) than does CMAQ. PM performance for CMAQ is generally consistent with that of other PM models, whereas PMCAMx predicts higher concentrations of NO3-, NH4+, and BC than observed, which degrades its performance. For PM10 and PM2.5 predictions over the southeastern U.S. domain, the ranges of mean normalized gross errors (MNGEs) and mean normalized bias are 37-43% and -33-4% for CMAQ and 50-59% and 7-30% for PMCAMx. Both models predict the largest MNGEs for NO3- (98-104% for CMAQ 138-338% for PMCAMx). The inaccurate NO3- predictions by both models may be caused by the inaccuracies in the ammonia emission inventory and the uncertainties in the gas/particle partitioning under some conditions. In addition to these uncertainties, the significant PM overpredictions by PMCAMx may be attributed to the lack of wet removal for PM and a likely underprediction in the vertical mixing during the daytime.     

废水除磷技术的研究与发展

目前 ,人们越来越重视污水除磷技术。本文介绍与评述了化学和生物两种除磷方式及其除磷机理和工艺 ,并着重介绍了生物除磷的现状、发展和研究动向     

混凝-生物接触氧化法处理城市污水的研究

采用混凝-生物接触氧化法处理生活小区废水,考察了不同混凝剂用量对COD、NH4-N、SS、TP的去除效果,同时研究了生物接触氧化法对COD、NH4-N等的去除以及耐冲击负荷能力.结果表明,随混凝剂用量的增加,COD、SS、TP的去除率随之增加,生物接触氧化法具有较高的抗冲击负荷能力,最大NH4-N去除负荷达到0.55 kg/(m3·d),最大有机去除负荷达到4.32 kg/(m3·d)     

含重金属水处理污泥的固化和浸出毒性研究

工业危险固体废物在进行安全填埋前需要进行固化稳定处理。针对电镀厂和皮革厂含重金属的水处理污泥 ,用不同比例的水泥、粉煤灰进行固化稳定处理。考虑酸雨环境 ,浸出实验采用TCLP标准。电镀厂污泥单独固化时 ,其浸出液中铜离子浓度由 78 0mg/L下降到 1 5mg/L ;镍离子浓度由 2 2 4 5mg/L下降到 2 2 2mg/L ,高于危险废物允许进入填埋区 15mg/L的控制限值。电镀厂污泥与皮革厂污泥混合后固化 ,浸出液毒性明显降低。铜离子的浸出浓度降低到1 98mg/L ,镍离子降低到 4 10mg/L ,总铬降低到 0 4 0mg/L ,各项指标均低于国家危险废物允许进入填埋区的控制限值 ,可安全填埋。