长江三峡花岗岩地区土壤流失时间分布特性

长江三峡花岗岩地区坡面土壤流失以耕地砂砾化面蚀和有部分植物覆盖坡面的鳞片状面蚀为主，该地土壤流失研究结果表明，由以上两类面蚀导致的土壤流失量月分布与月降雨量的分布基本趋势一致，二者呈现较为明显的线性相关关系。地面坡度＞３０°的裸地土壤流失量达５０００ｔ／ｋｍ３·ａ以上，覆盖度≥０．７０的林地土壤流失量＜５００ｔ／ｋｍ２·ａ，该流域土壤流失量为１５４４．１４ｔ／ｋｍ２·ａ，产沙量为６９４．８６ｔ／ｋｍ２·ａ     

催化光度法测定桂林风景点水中痕量铁(Ⅲ)

本文以过氧化氢-甲基红,在活化剂α、α~1-联吡啶存在下,建立了催化光度法测定痕量铁(Ⅲ)的方法,其灵敏度为2.68×10~(-11)gFe(Ⅲ)/ml,线性范围为0～0.6μgFe(Ⅲ)/25ml。用于桂林风景点水中痕量铁测定,结果令人满意。     

Steady performance of a zero valent iron packed anaerobic reactor for azo dye wastewater treatment under variable influent quality

Zero valent iron (ZVI) is expected to help create an enhanced anaerobic environment that might improve the performance of anaerobic treatment. Based on this idea, a novel ZVI packed upflow anaerobic sludge blanket (ZVI-UASB) reactor was developed to treat azo dye wastewater with variable influent quality. The results showed that the reactor was less influenced by increases of Reactive Brilliant Red X-3B concentration from 50 to 1000 mg/L and chemical oxygen demand (COD) from 1000 to 7000 mg/L in the feed than a reference UASB reactor without the ZVI. The ZVI decreased oxidation-reduction potential in the reactor by about 80 mV. Iron ion dissolution from the ZVI could buffer acidity in the reactor, the amount of which was related to the COD concentration. Fluorescence in situ hybridization test showed the abundance of methanogens in the sludge of the ZVI-UASB reactor was significantly greater than that of the reference one. Denaturing gradient gel electrophoresis showed that the ZVI increased the diversity of microbial strains responsible for high efficiency.     

Degradation kinetics and mechanism of aniline by heat-assisted persulfate oxidation

Oxidation of aniline by persulfate in aqueous solutions was investigated and the reaction kinetic rates under different temperature, persulfate concentration and pH conditions were examined in batch experiments. The results showed that, the aniline degradation followed pseudo first-order reaction model. Aniline degradation rate increased with increasing temperature or persulfate concentration. In the pH range of 3 to 11, a low aniline degradation rate was obtained at strong acid system (pH 3), while a high degradation rate was achieved at strong alkalinity (pH 11). Maximum aniline degradation occurred at pH 7 when the solution was in a weak level of acid and alkalinity (pH 5, 7 and 9). Produced intermediates during the oxidation process were identified using liquid chromatography-mass spectrometry technology. And nitrobenzene, 4-4’-diaminodiphenyl and 1-hydroxy-1,2-diphenylhydrazine have been identified as the major intermediates of aniline oxidation by persulfate and the degradation mechanism of aniline was also tentatively proposed.     

SBR在高校中水回用领域的工程应用研究

采用SBR工艺对高校校园废水进行了处理,运行结果表明:废水中COD含量从200～360mg/L降至60mg/L以下,BOD5含量从70～110mg/L降至20mg/L以下,氨氮含量从60～80mg/L降至10mg/L以下,SS含量从75～160mg/L降至50mg/L以下,达到了北京市DB11307—2005《水污染物排放标准》的二级排放标准。     

城市再生水景观利用水华识别和预警方法探讨

城市再生水景观回用的主要问题是水体富营养化导致水华的暴发。为了抑制藻类的大规模生长,需要提前采取预防措施,以便将有可能爆发水华的藻类及时杀死或除去。目前,人们已经对景观水体中常见藻类的生长规律做了深入的研究,发现水体中藻数量(藻密度)的多少与水体的pH值和DO值的变化有密切而相对稳定的关系。通过在线实时监控pH值和DO值,找到△pH、△DO与藻类生长之间的关系,并结合pH、DO、温度、正磷酸盐和总氮等指标,实现实时识别和预测水华爆发的目的。     

The ignored emission of volatile organic compounds from iron ore sinter process

Iron ore sintering is a major source of gaseous and particulate pollutants emission in iron smelt plant. The aim of present study is to characterize the volatile organic compounds(VOCs) emission profiles from iron ore sintering process. Both sinter pot test and sinter simulation experiment were conducted and compared. Out results showed that sinter process produced large quantity of VOCs together with NOxand SO_2. VOCs and NO were produced simultaneously in sinter pot test from 3 to 24 min after ignition, flowed by SO_2 production from 15 min to the end of sintering. Total VOCs(TVOC) concentration in sinter flue gas was affected by the coal and coke ratio in sinter raw material. The maximum TVOC concentration was 34.5 ppm when using 100% coal as fuel. Sinter simulation experiments found that the number of VOCs species and their concentrations were found by sinter temperature. The largest VOCs species varieties were obtained at 500 °C. Benzene, toluene,xylene and ethylbenzene were major VOCs in sinter flue gas based on the results from both simulation test and sinter pot. It thus demonstrated that in addition to NO_x, SO_2 and metal oxide particles, sinter flue gas also contained significant amount of VOCs whose environmental impact cannot be ignored. Based on our work, it is timely needed to establish a new VOC emission standard for sinter flue gas and develop advanced techniques to simultaneously eliminate multi-pollutants in iron ore sinter process.     

Characteristics of volatile organic compounds, NO2, and effects on ozone formation at a site with high ozone level in Chengdu

Chengdu is a megacity in the southwest of China with high ozone (O₃) mixing ratio. Observation of volatile organic compounds (VOCs), NO₂ and O₃ with high temporal resolution was conducted in Chengdu to investigate the chemical processes and causes of high O₃ levels. The hourly mixing ratios of VOCs, NO₂, and O₃ were monitored by an online system from 28 August to 7 October, 2016. According to meteorological conditions, Chengdu, with relative warm weather and low wind speed, is favorable to O₃ formation. Part of the O₃ in Chengdu may be transported from the downtown area. In O₃ episodes, the average mixing ratios of NO₂ and O₃ were 20.20?ppbv and 47.95?ppbv, respectively. In non-O₃ episodes, the average mixing ratios of NO₂ and O₃ were 16.38?ppbv and 35.15?ppbv, respectively. The average mixing ratio of total VOCs (TVOCs) was 40.29?ppbv in non-O₃ episodes, which was lower than that in O₃ episodes (53.19?ppbv). Alkenes comprised 51.7% of the total O₃ formation potential (OFP) in Chengdu, followed by aromatics which accounted for 24.2%. Ethylene, trans-pentene, propene, and BTEX (benzene, ethylbenzene, toluene, m/p-xylene, o-xylene) were also major contributors to the OFP in Chengdu. In O₃ episodes, intensive secondary formations were observed during the campaign. Oxygenated VOCs (OVOCs), such as acetone, Methylethylketone (MEK), and Methylvinylketone (MVK) were abundant. Isoprene rapidly converted to MVK and Methacrolein (MACR) during O₃ episodes. Acetone was mainly the oxidant of C3-C5 hydrocarbons.     

2,3,7,8-Tetrachlorodibenzo-p-dioxin promotes migration ability of primary cultured rat astrocytes via aryl hydrocarbon receptor

Emerging evidence showed that 2,3,7,8-Tetrachlorodibenzo-p-dioxin (TCDD) could induce expression of certain reactivation-associated genes in astrocytes, however, the consequent cellular effects and molecular mechanisms are still unclear. During the process of astrocyte reactivation, migration is a critical cellular event. In the present study, we employed wound-healing assay and Transwell® motility assay to explore the effects of TCDD on cell migration in primary cultured rat cortical astrocytes. We found that upon TCDD treatments at relative low concentrations (10^? 10 and/or 10^? 9?mol/L), the ability of primary astrocytes to migrate horizontally and vertically was promoted. In line with this cellular effect, the mRNA expression of two pro-migratory genes, including cell division cycle 42 (CDC42) and matrix metalloproteinase 2 (MMP2) was induced by TCDD treatment. Dioxin exerts its toxic effects mainly through aryl hydrocarbon receptor (AhR) pathway. So the role of AhR pathway in the pro-migratory effects of TCDD was examined using an AhR antagonist, CH223191. We found that application of CH223191 significantly reversed the pro-migratory effects of TCDD. Interestingly, the basal ability of horizontal migration as well as basal levels of CDC42 and MMP2 expression were dramatically reduced suggesting a possible physiological role of AhR in maintaining the endogenous migration ability of the primary astrocytes. These findings support the notion that dioxin promotes astrocyte reactivation at molecular and cellular levels.     

Effect of preparation methods on the performance of CuFe-SSZ-13 catalysts for selective catalytic reduction of NOx with NH3

CuFe-SSZ-13 catalyst showed excellent performance in the selective catalytic reduction of NO_x with NH₃ (NH₃-SCR) for diesel engine exhaust purification. To investigate the effect of preparation methods on NH₃-SCR performance, Fe was loaded into one-pot synthesized Cu-SSZ-13 catalysts through solid-state ion-exchange (SSIE), homogeneous deposition precipitation (HDP) and liquid ion-exchange (IE), respectively. Three CuFe-SSZ-13 catalysts showed similar SO₂ resistance, which was better than that of Cu-SSZ-13. The improvement was attributed to the protection of Fe species. Hydrothermal stability of three CuFe-SSZ-13 catalysts was significantly different, which was attributed to the state of active species caused by different preparation methods. Compared with the other two catalysts, more active species existed inside the zeolite pores of CuFe-SSZ-13_SSIE. During hydrothermal aging, the aggregation of these active species in the pores caused the collapse of catalyst structure, ultimately leading to the deactivation of CuFe-SSZ-13_SSIE. In contrast, Fe species was dispersed better on the surface over CuFe-SSZ-13_IE, enhancing the hydrothermal stability of catalysts. Consequently, Fe loading effectively improved the resistance of SO₂ and H₂O over Cu-SSZ-13. For CuFe-SSZ-13, large amounts of active species located inside the zeolite pores are not beneficial for the hydrothermal stability.