数学规划在水网络优化设计中的应用进展

综述了数学规划在连续过程水网络优化设计中的应用进展。分析了树搜索、线性规划、非线性规划、混合整数非线性规划、基于数学规划的复合方法等方法设计水网络的特点、求解策略及应用情况,探讨了模型求解的优化算法。     

电动力学作用下多溴联苯醚在土壤中的迁移特性

以4,4′-二溴联苯醚(BDE-15)为研究对象,探讨了电极电压、初始土壤pH、β-环糊精加入量、NaCl加入量等工艺条件对多溴联苯醚在土壤中迁移效果的影响。实验结果表明:在电极电压为5~15V范围内,随着电极电压的升高,土壤中BDE-15的迁移效果增强;初始土壤为酸性时、加入β-环糊精或NaCl后,土壤中BDE-15的迁移效果均增强。本实验选择的最佳工作条件为:电极电压15V,初始土壤pH3,β-环糊精的加入量3g,NaCl加入量5g。     

利用盐泥制取轻质氧化镁

采用二氧化碳法提取盐泥中的镁,研究了使之转化为轻质氧化镁的影响因素以及主要反应的动力学性质。实验确定的最佳条件为固液比1∶15、二氧化碳通入时间90min、水解温度90℃、水解时间25min,在此条件下,盐泥中镁的总提取率为75%;采用微分法求得氢氧化镁与二氧化碳反应的反应级数和活化能分别为1.7和68.1kJ/mol。     

Preliminary environmental impact assessment of PFOS waste treatment in a lab-scale batch subcritical water decomposition operation

Life cycle assessment (LCA) was carried out by SimaPro 7.3 to study the environmental impact of a lab-scale batch subcritical water decomposition operation for a kilogram of Perfluorooctane sulfonic acid (PFOS) waste treatment in this study, a proven process for the decomposition of PFOS pollutants with high concentration. This LCA focuses on not only the main environmental factors from emissions of toxic pollutants, but also the influence from technical characteristics of the iron-induced subcritical water technology including energy and substances consumption during the subcritical water decomposition treatment process. The IMPACT 2002+ environmental model was used to evaluate the 15 midpoint and 4 end-point environmental damages. It was found that the energy consumption to sustain the high temperature (350 °C) and high pressure (23 MPa) in the subcritical water process contributes 99.8 % of the damages. The total negative impact of the SCWD process for 1 kg of PFOS waste treatment to human health, ecological quality, climate change and resources amounts to 1.11 × 10^?3, 8.43 × 10^?5, 9.76 × 10^?4, 9.05 × 10^?4 Pt, respectively. And the improvement of energy efficiency and catalytic effectiveness are two important factors to reduce the environmental impact from the SCWD process for the treatment of PFOS waste.     

Source,distribution, and health risk assessment of polycyclic aromatic hydrocarbons in urban street dust from Tianjin,China

To better assess and understand potential health risk of urban residents exposed to urban street dust, the total concentration, sources, and distribution of 16 polycyclic aromatic hydrocarbons (PAHs) in 87 urban street dust samples from Tianjin as a Chinese megacity that has undergone rapid urbanization were investigated. In the meantime, potential sources of PAHs were identified using the principal component analysis (PCA), and the risk of residents’ exposure to PAHs via urban street dust was calculated using the Incremental Lifetime Cancer Risk (ILCR) model. The results showed that the total PAHs (∑PAHs) in urban street dust from Tianjin ranged from 538 μg kg^?1 to 34.3 mg kg^?1, averaging 7.99 mg kg^?1. According to PCA, the two to three- and four to six-ring PAHs contributed 10.3 and 89.7 % of ∑PAHs, respectively. The ratio of the sum of major combustion specific compounds (ΣCOMB)?/?∑PAHs varied from 0.57 to 0.79, averaging 0.64. The ratio of Ant/(Ant?+?Phe) varied from 0.05 to 0.41, averaging 0.10; Fla/(Fla?+?Pyr) from 0.40 to 0.68, averaging 0.60; BaA/(BaA?+?Chry) from 0.29 to 0.51, averaging 0.38; and IcdP/(IcdP?+?BghiP) from 0.07 to 0.37, averaging 0.22. The biomass combustion, coal combustion, and traffic emission were the main sources of PAHs in urban street dust with the similar proportion. According to the ILCR model, the total cancer risk for children and adults was up to 2.55?×?10^?5 and 9.33?×?10^?5, respectively.     

The kinetic stability of colloid-associated plutonium: settling characteristics and species transformation

The colloid-associated plutonium-239, as the dominant species of Pu in natural environment, was formed through sorption of Pu onto in situ colloids. In case of chemical perturbations present in pore water, the fate and transport of Pu would be therefore impacted by changes in sorption affinity of Pu for the colloid surfaces. The present study reveals that colloidal ²³⁹Pu exhibited the kinetic stability in two respects. First, in situ colloids isolated from the vadose zone sediments at Lop Nor, when in contact with solutions of high ion concentrations or low pH, were significantly aggregated and then exhibited fast settling. Kinetics settling characteristics were described by the parameters, including settling index and characteristic time. Second, Pu dissociation from colloid surfaces occurred immediately after the introduction of Na⁺. However, the dissolved species was still unstable and had the potential for re-association with the fraction of colloids that had not settled out from the suspensions due to small size and then remained in suspension. This implies that Pu sorption sites on initial colloids were changed to the sites of suspended colloids.     

以养殖废水为底料的微生物燃料电池产电性能与水质净化效果

以养殖场沼泥为接种物,构建了乙二胺、三氯化铁改性碳毡阳极的单室无膜微生物燃料电池,探讨了2种阳极改性电池的产电规律,考察了其去除养殖废水中COD、氨氮的效果以及臭味的表观性状变化。结果表明,以葡萄糖为底物时,乙二胺、三氯化铁改性阳极微生物燃料电池在启动20 d和22 d后分别达到稳定,输出电压分别为0.514 V和0.527V(外阻为500Ω),对应输出功率密度分别为332 mW/m2和349 mW/m2。逐渐增大废水投加比例至原水时,2个电池的最大功率密度分别为208 mW/m2和158 mW/m2,COD去除率分别为85%和78%,氨氮去除率分别为52%和45%。此外,养殖废水的臭味去除效果明显。因此,构建的2种改性阳极微生物燃料电池可以利用养殖废水产电,同时使水质得到一定程度的净化。     

钾掺杂对铈锆固溶体催化性能的影响

为研究钾掺杂对铈锆固溶体催化性能的影响,以Ce0.7Zr0.3O2为基体制备了一系列钾掺杂的铈锆固溶体xK-Ce0.7Zr0.3O2(x=0.05、0.10、0.15、0.20、0.25、0.30)催化剂样品,通过程序升温氧化(TPO)过程进行活性评价,并通过XRD、BET、H2-TPR和O2-TPD进行分析表征。结果表明,采用溶胶凝胶法制备的催化剂的催化性能比络合燃烧法所制备的稍好;当钾的掺杂量为0.10≤x≤0.30时,xK-Ce0.7Zr0.3O2催化碳烟颗粒燃烧的活性得到提高,起燃温度和最大燃烧速率温度分别在315℃和375℃附近,明显优于Ce0.7Zr0.3O2;掺杂钾后的催化剂样品均能形成萤石结构,并且随钾掺杂量的增大比表面积减小。     

阳离子交换膜对Cu2+离子交换的动力学及热力学研究

对阳离子交换膜离子交换Cu2+的动力学及热力学现象进行了研究,结果表明:温度25℃,溶液pH=6时,干膜对Cu2+饱和交换容量为0.506 mmol/g;随Cu2+初始浓度的升高,离子交换速率常数随之增加;随温度升高,离子交换速率常数随之增加;随转速升高,离子交换速率常数随之增加;离子交换过程与一级反应速率方程拟合结果良好;△G0<0,表明离子交换反应能自发进行;△H0m>0,表明的交换反应为吸热反应;△S0>0,表明交换反应是熵变增加的反应。     

Polyfluorinated compounds in the atmosphere along a cruise pathway from the Japan Sea to the Arctic Ocean

Neutral polyfluorinated alkyl substances (PFASs) were measured in high-volume air samples collected on board the research vessel Snow Dragon during the 4th Chinese National Arctic Expedition from the Japan Sea to the Arctic Ocean in 2010. Four volatile and semi-volatile PFASs (fluorotelomer alcohols (FTOHs), fluorotelomer acids (FTAs), perfluoroalkyl sulfonamides (FASAs), and sulfonamidoethanols (FASEs)) were analyzed respectively in the gas and particle phases. FTOHs were the dominant PFASs in the gas phase (61-358 pg m⁻³), followed by FTAs (5.2-47.9 pg m⁻³), FASEs (1.9-15.0 pg m⁻³), and FASAs (0.5-2.1 pg m⁻³). In the particle phase, the dominant PFAS class was FTOHs (1.0-9.9 pg m⁻³). The particle-associated fraction followed the general trend of FASEs > FASAs > FTOHs. Compared with other atmospheric PFAS measurements, the ranges of concentrations of ∑FTOH in this study were similar to those reported from Toronto, north America (urban), the northeast Atlantic Ocean, and northern Germany. Significant correlations between FASEs in the gas phase and ambient air temperature indicate that cold surfaces such as sea-ice, snowpack, and surface seawater influence atmospheric FASEs.