Comparison of the purification performance and microbial community functional diversity in flow-directional-switching and unidirectional-flow biotrickling filters

Because of the characteristics of low operating cost and convenient operation, the biotrickling filter is extensively researched and used to treat low concentration waste gas contaminated by volatile organic compounds (VOCs) and other odors. In this paper, two laboratory-scale biotrickling filters were constructed and toluene was selected as the sole carbon source, and the effects of different waste-gas flow configuration patterns on the purification capacity and the microbial community functional diversity of biotrickling filters were evaluated. The results indicated that the flow-directional-switching (FDS) biotrickling filter had better purification performance, and the maximum elimination capacity reached 480 g·m^?3·hr^?1, which was 17.1% higher than conventional unidirectional-flow (UF) biotrickling filter. Comparing the purification capacities of different sections in two biotrickling filters, the maximum toluene elimination capacity of section III in FDS system could reach 542 g·m^?3·hr^?1, which was 2.8 times as great as that in UF system, which resulted from the difference of elimination capacity in two systems. By analyzing the metabolic activity of two systems by community-level physiological profiling (CLPP) with Biolog (Biolog Inc., Hayward, CA) ECO-plate technique, metabolic activity in three sections of FDS system was higher than that of UF system. The metabolic activity was the highest in section III of FDS system and 46.8% higher than that of UF system. Shannon index and McIntosh index of section III in FDS system were 6.2% and 31.5% higher, respectively, than those of UF system.

Implications: The flow-directional-switching (FDS) biotrickling filter had a better purification performance than unidirectional-flow (UF) biotrickling filter at high inlet loadings, because FDS produced a more uniform distribution of biomass and microbial metabolic capacity along the length of the packed bed without diminishing activity and removal capacity in the inlet section.     

Characteristics and management of domestic waste in a rural area of the Tibetan Plateau

In the rural area of the Tibetan Plateau (RATP), the characteristics of domestic waste, people’s environmental awareness, people’s willingness to pay and their influence factors were firstly studied by questionnaires, field samplings and laboratory tests. The results showed that, in the RATP, the generation of domestic waste was 85 g?d-1 per capita and it was mainly composed of plastics, inert waste, kitchen waste, glass and paper. The waste bulk density, moisture content, ash, combustible and low calorific value were 65 kg?m-3, 19.25%, 44.90%, 35.85% and 10,520 kJ?kg-1 respectively. These characteristics are influenced by income sources and geographical position to some extent. Classified collection should be promoted widely on the household and the village basis. Compost, fermentation, landfill, bioreactor landfill and semi-aerobic landfill have been approved as effective techniques to treat domestic waste, except incineration. The distance of 50–800 m between each collection facility and the disposal fee of around $0.8 per month per household are suggested. For suburbs or large population villages, it’s better to treat domestic waste by the centralized way. But for the remote rural areas, a decentralized way is proposed. Significantly, the educational and economic influence should be considered into an effective domestic waste management program.

Implications:?The current situatio n of the environment in the rural areas of the Tibetan Plateau (RATP) was surveyed. There, the generation of organics and moisture of domestic waste were low but ash, recyclables, and combustibles were high. People’s knowledge of domestic waste was absent but their participation in management was strong. Based on the current situation, compost, fermentation, and landfill were effective but incineration was inappropriate. Also, a localized mini landfill for a cluster of villages and or settlements was the best method there.     

微电解预处理靛蓝牛仔布印染废水

靛蓝牛仔布印染废水组分复杂,浓度高、水量大,属于难处理的工业废水,为了有效降低后续生物处理单元的负荷,采用铁炭微电解工艺对该废水进行预处理;通过正交实验考察pH、反应时间及铁炭比处理效果的影响规律及COD去除反应动力学,并对各因素作了单因素影响实验,确定了最佳工艺条件.结果表明,铁炭微电解法是预处理靛蓝牛仔布印染废水的一种有效方法,在Fe/C为2:1、pH为3的条件下反应90 min,铁炭微电解出水COD的去除率在49.2％,色度去除率达到80％,该印染废水经微电解处理后,BOD5/COD比值可从原来的0.248上升至0.436,可生化性明显提高.此外,微电解预处理靛蓝牛仔布印染废水中COD的去除反应符合二级反应动力学规律.     

Fenton氧化法深度处理抗生素废水二级出水

采用Fenton氧化法对青霉素和土霉素混合废水二级处理出水进行深度处理,通过正交和单因素实验研究了废水初始反应pH值、H2O2投加量、Fe2+/H2O2摩尔比及反应时间等因素对废水处理效果的影响。实验结果表明,Fenton氧化法处理的最佳反应条件为:初始pH值4、H2O2(30%)投加量50 mL/L、Fe2+/H2O2摩尔比1/20和反应时间60 min,处理后出水COD小于120 mg/L,COD去除率在75%以上,急性毒性(HgCl2毒性当量)小于0.07 mg/L,满足《发酵类制药工业水污染物排放标准》(GB21903-2008)表2标准要求。     

湿法净化黑烟中添加剂对炭黑沉降性能的影响

湿法净化黑烟中炭黑颗粒物的关键在于降低吸收液的表面张力并以高性能絮凝剂使其从溶液中絮凝、沉降以利于分离。选用十六烷基三甲基溴化胺(CTAB)为主要表面活性剂,使之与十二烷基苯磺酸钠(SDBS)和月桂醇聚氧乙烯(9)醚(AEO-9)进行复配实验,研究了复配液的表面张力,再向最低表面张力的复配表面活性剂溶液中投加絮凝剂聚合氯化铝(PAC)和聚丙烯酰胺(PAM),探讨絮凝剂的添加对黑烟颗粒沉降和絮凝的影响.实验结果表明:同时添加表面活性剂CTAB,SDBS和PAC,并使之浓度分别为0.5 mmol/L,0.4 mmol/L和200 mg/L时,炭黑颗粒的沉降效果最好,沉降率高达94%,且絮凝体较大,沉降时间仅为2 min。     

工业废水中多金属离子的吸附净化

以含有Si、Al、Ca、C元素的矿物材料作为基质,经特定条件处理后造粒成型加工成轻质多孔Si-Al-Ca-C结构的吸附材料。研究了该吸附材料对工业废水中多种金属离子的吸附性能,探讨了影响吸附性能的因素。研究结果表明,在一定条件下,Si-Al-Ca-C吸附材料对工业废水中Al3+、Ca2+、Mn2+、Cu2+、Fe3+、Mg2+、As3+和Zn2+的净化率分别高达99.34%、99.82%、98.26%、98.16%、97.76%、97.01%、100%和89.09%。金属离子残留浓度分别为0.152、0.07、0.012、0.02、0.119、0.311、0和0.259 mg/L,均低于国家污水综合排放标准(GB8978-1996)一级标准。     

固定化微生物修复石油污染土壤影响因素研究

针对石油污染土壤修复,利用实验室已筛选的高效石油降解单菌SM-3,以天然有机材料为载体,吸附法制备固定化微生物。将游离与固定化微生物应用于室内花盆模拟修复石油污染土壤,对C/N/P、微生物投加量、石油含量、氧化剂和表面活性剂设计5因素4水平正交实验,探讨不同修复时期各影响因素的重要性顺序,最佳条件下各菌株的修复效果。结果表明,不同微生物在不同降解时期,各影响因素的重要性会发生变化;经过21 d的修复,固定化单菌SM-3石油降解率为22.77%,修复过程中,接种量是最重要的影响因素,营养元素N、P投加影响较大,表面活性剂和氧化剂影响次之。     

萃取净化电镀含镉废水

研究了二壬基萘磺酸(DNNSA)形成的微乳液从模拟含镉废水中萃取镉离子的工艺条件。分别考察了相体积比(O/A)、萃取时间、温度及萃取剂浓度对废水中镉离子萃取的影响。结果表明,萃取平衡时间为10 mim,降低温度及增加萃取剂浓度均有利于萃取。紫外光谱证实当DNNSA萃取镉时,所形成萃合物对萘环的结构无影响,且不会破坏微乳相的结构;分子荧光光谱表明镉离子对配体DNNSA有荧光猝灭作用。     

高速公路路面沉积物的污染特性

对湖南省长潭西高速公路不同采样点的路面沉积物进行取样分析,并检测了样品的颗粒级配、COD、重金属(Cu、Zn、Pb和Cd)和有机质。结果表明,路面沉积物主要以粒径<0.15 mm的颗粒为主;较小颗粒物中的COD含量高于较大颗粒中的COD含量;粒径在0.15 mm以下的颗粒物所含重金属Cu、Zn、Pb和Cd的浓度普遍高于所选的土壤标准值,降雨一旦形成径流将会产生严重的污染危害;沉积物中的有机质含量对重金属的吸附有一定的影响,有机质含量越高,沉积物中重金属含量相对也高。     

青萍(Lemna minor L.)对氮磷的吸收特征

以西部地区优势浮萍品种青萍为实验对象,研究了青萍对不同浓度硝态氮和磷酸盐的吸收特征。结果表明,硝态氮浓度在1～10 mg/L范围内,青萍对硝态氮有较好的吸收效果,M-M方程可以较好地描述硝态氮浓度与青萍对硝态氮的吸收速率之间的关系,通过M-M方程拟合得到青萍对硝态氮的最大吸收速率为0.1167 mg/(g FW.h),亲和力常数为6.9274。磷酸盐浓度在0.1～1.0 mg/L范围内,青萍对磷酸盐也有较好的吸收效果,二次多项式回归可以较好地描述青萍吸收速率与磷酸盐浓度的关系,回归方程得到青萍对磷酸盐的最大吸收速率为0.0193 mg/(g FW.h),对应磷酸盐浓度为0.6 mg/L。