改性土-膨润土阻隔墙阻控离子型稀土矿氨氮污染

以土-膨润土为阻隔材料,使用硅灰及水泥对其进行固化改性,研究改性后阻隔墙对离子型稀土矿原地浸矿氨氮污染的阻控效果。通过了解阻隔墙材料的渗透性能、力学性能,并结合阻隔材料对氨氮的吸附效果、穿透效果和数值模拟结果,探讨改性土-膨润土阻隔材料对氨氮污染的阻控性能。结果表明:硅灰改性土-膨润土阻隔材料,最佳质量配比为硅灰∶土=1∶10,最佳含水率为67.80%;改性阻隔材料生成的铝硅酸盐提高了阻隔墙防渗性能,渗透系数为2.36×10~(-9) m·s~(-1);CaCO_3提高了材料的力学性能,使抗压强度达到0.896 MPa;改性阻隔材料对氨氮的吸附过程符合准二级动力学模型及Langmuir等温模型。这说明该吸附过程以化学吸附为主,并且该吸附是放热过程。在不同氨氮浓度的穿透下,渗透系数呈逐渐减小的趋势,实验期间并未达到穿透浓度。利用Visual MODFLOW数值模型对阻隔墙的阻控效果进行模拟发现,7 300 d后NH_4~+扩散范围小,未穿透阻隔墙。硅灰改性土-膨润土阻隔墙用于对离子型稀土矿氨氮污染阻控的效果较好。     

反硝化生物滤池中生物膜量与脱氮效果和脱氢酶活性的关系

采用自主研发的中试反硝化生物滤池处理传统活性污泥法的二沉池出水,研究了稳定运行下生物膜量与脱氮效果和脱氢酶活性之间的关系。结果表明:根据VSS/SS=0.78、VSS/SS0.78、VSS/SS0.78,将SS分为3个区域,分别为区域1(232.5～1 246.6 mg·L~(-1))、区域2(1 246.6～2 542.7 mg·L~(-1))、区域3(2 542.7～3 523.9 mg·L~(-1))。在区域2内能获得最大的NO_3~--N和TN去除能力,去除率分别为95.0%和85.7%及最大的总脱氢酶活性(TDHA),为112.5 g;单位质量生物膜脱氢酶活性(DHA)与SS和VSS之间显著负相关,R~2分别为0.822和0.876;TDHA随SS的增加而增加,直至VSS/SS开始减小时随之减小。DHA能较好地从微观层面反应微生物的活性,TDHA可从宏观层面反映整个反应器的生物活性,为反硝化生物滤池运行提供参考。     

Locally enhanced electric field treatment (LEEFT) for water disinfection

• Nanowire-assisted LEEFT is applied for water disinfection with low voltages. • LEEFT inactivates bacteria by disrupting cell membrane through electroporation. • Multiple electrodes and device configurations have been developed for LEEFT. • The LEEFT is low-cost, highly efficient, and produces no DBPs. • The LEEFT can potentially be applicable for water disinfection at all scales. Water disinfection is a critical step in water and wastewater treatment. The most widely used chlorination suffers from the formation of carcinogenic disinfection by-products (DBPs) while alternative methods (e.g., UV, O₃, and membrane filtration) are limited by microbial regrowth, no residual disinfectant, and high operation cost. Here, a nanowire-enabled disinfection method, locally enhanced electric field treatment (LEEFT), is introduced with advantages of no chemical addition, no DBP formation, low energy consumption, and efficient microbial inactivation. Attributed to the lightning rod effect, the electric field near the tip area of the nanowires on the electrode is significantly enhanced to inactivate microbes, even though a small external voltage (usually<5 V) is applied. In this review, after emphasizing the significance of water disinfection, the theory of the LEEFT is explained. Subsequently, the recent development of the LEEFT technology on electrode materials and device configurations are summarized. The disinfection performance is analyzed, with respect to the operating parameters, universality against different microorganisms, electrode durability, and energy consumption. The studies on the inactivation mechanisms during the LEEFT are also reviewed. Lastly, the challenges and future research of LEEFT disinfection are discussed.     

高燃速推进剂成型过程中的安全性分析

为研究高燃速推进剂成型过程中的安全性,根据配方组成和工艺条件,对其压伸过程的热点形成因素进行了理论分析,并采用热-结构耦合方法,选择有限元软件ABAQUS对其不同工艺条件下的压伸过程进行了建模分析。结果表明:在压伸过程中,物料在收缩段承受的压力最大,且温度变化显著。物料中残留的气泡是影响高燃速推进剂压伸成型过程安全性的主要因素。当物料中有残留气泡时,随压伸过程所加的载荷不同,气泡的最高温度会显著上升,载荷为15MPa时,气泡的最高温度可达139.3℃;载荷为20 MPa时,温度可达264.2℃。     

磁絮凝处理废水工艺条件的响应曲面法优化研究

以聚硅硫酸铁(PFSS)为絮凝剂、磁流体为磁种,采用磁絮凝法处理模拟废水。在正交实验基础上,利用Matlab软件进行响应曲面分析,研究磁絮凝法处理模拟废水的各因素间具有的交互作用关系。回归拟合结果表明最佳工艺条件为:PFSS加入量36.8g/L,模拟废水pH7.4,磁种加入量14.7mg/L,搅拌转速266r/min。在最佳工艺条件下进行实验,TP去除率为97.70%。     

固定化白腐真菌反应器与接触氧化反应器联用处理癸二酸生产废水

采用固定化白腐真菌(WRF)反应器与接触氧化反应器联用处理癸二酸废水。在WRF反应器中,以汽曝玉米秸秆为载体,并添加铜、铁促进白腐真菌生长和产酶作用,载体的使用寿命约为45 d。在进水苯酚平均质量浓度为69.36 mg/L、平均进水COD为1 648.81 mg/L的条件下,经WRF反应器处理后,苯酚平均质量浓度降至7.59 mg/L,平均出水COD降至478.03 mg/L;再经接触氧化反应器处理后,苯酚平均质量浓度降至1.65 mg/L,平均出水COD降至297.31 mg/L。     

Sulfamethoxazole sorption by sediment fractions in comparison to pyrene and bisphenol A

The environmental behavior of antibiotics has attracted great research attention. However, their sorption mechanisms in soils/sediments are still unknown. Comparison of the sorption properties between the widely-studied hydrophobic organic contaminants (HOCs) and antibiotics may provide valuable insight to antibiotic sorption mechanisms. Thus, in this study batch experiments for pyrene (PYR), bisphenol A (BPA), and sulfamethoxazole (SMX) sorption were conducted on a sediment sample and its separated fractions. Our results showed the high sorption of PYR on black carbon and organic matter. Although high sorption of SMX was observed for both separated organic fractions (humic acids) and inorganic mineral particles, the original sediment particles showed relatively low sorption. Competitive sorption between SMX and dissolved humic acid on mineral particles was observed in this study. This competitive interaction is a unique process for antibiotic sorption in soils/sediments compared with apolar HOCs and may be one of the important factors controlling the antibiotic sorption.     

维生素和酮苷生产废水中难降解污染物的溯源研究

研究了维生素和酮苷生产过程中各生产工段排水的生物降解特性,评价了各生产工段对生产废水中难降解有机物的贡献率,追溯了可能的难降解特征污染物。结果表明,维生素生产废水中的难降解物质主要来自W1-1、W1-3、W1-5和W1-6生产工段,甲醛、丁烯酮、醛酮聚合物和吡啶可能是导致生产废水难降解的重要原因;酮苷生产废水中的难降解物质主要来自W2-1、W2-3和W2-7生产工段,氯代有机溶剂和苯环类物质可能是导致生产废水难降解的重要原因。建议根据具体生产工段排水的水质特征,有针对性地进行物化处理,提高废水可生化性。     

CCS scenarios optimization by spatial multi-criteria analysis: Application to multiple source sink matching in Hebei province

A method, based on spatial analysis of the different criteria to be taken into consideration for building scenarios of CO₂ capture and storage (CCS), has been developed and applied to real case studies in the Hebei province. Totally 88 point sources (42 from power sector, 9 from iron and steel, 18 from cement, 16 from ammonia, and 3 from oil refinery) are estimated and their total emission amounts to 231.7 MtCO₂/year with power, iron and steel, cement, ammonia and oil refinery sharing 59.13%, 25.03%, 11.44%, 3.5%, and 0.91%, respectively. Storage opportunities can be found in Hebei province, characterised by a strong tectonic subsidence during the Tertiary, with several kilometres of accumulated clastic sediments. Carbon storage potential for 25 hydrocarbon fields selected from the Huabei complex is estimated as 215 MtCO₂ with optimistic assumption that all recovered hydrocarbon could be replaced by an equivalent volume of CO₂ at reservoir conditions. Storage potential for aquifers in the Miocene Guantao formation is estimated as 747 MtCO₂ if closed aquifer assumed or 371 MtCO₂ if open aquifer and single highly permeable horizon assumed. Due to poor knowledge on deep hydrogeology and to pressure increase in aquifer, injecting very high rates requested by the major CO₂ sources (>10 MtCO₂/year) is the main challenge, therefore piezometry and discharge must be carefully controlled. A source sink matching model using ArcGIS software is designed to find the least-cost pathway and to estimate transport route and cost accounting for the additional costs of pipeline construction due to landform and land use. Source sink matching results show that only 15–25% of the emissions estimated for the 88 sources can be sequestrated into the hydrocarbon fields and the aquifers if assuming sinks should be able to accommodate at least 15 years of the emissions of a given source.