不同挂膜方式生物滴滤塔处理含H2S恶臭气体

采用菌剂挂膜,活性污泥挂膜和自然挂膜3种不同方式形成生物滴滤塔,考察挂膜方式对生物滴滤塔去除H2s恶臭气体的影响。结果表明,当进气H2S浓度为5mg／m3时,菌剂挂膜、活性污泥挂膜、自然挂膜形成的生物滴滤塔出气H2s浓度分别为15．7～17．4、11．6～14．8和15．0～15．9μg／m3;塔内压降分别为3—4mm水柱、6mm水柱和4—5mm水柱;喷淋后滤出液中硫酸根的浓度分别为14、22和17mg／L,硫的转化率分别为45％、60％和50％。当进气H2S浓度增大至7mg／m3时,3个塔经过7d的调整后,均能达到稳定状态,稳定后3个塔中出气H2s浓度和压降基本没变,喷淋后滤出液中硫酸根浓度依次增大至25、31和30mg／L左右。采用活性污泥挂膜形成的生物滴滤塔处理H2s的能力比菌剂挂膜和自然挂膜的高。     

Process analysis of a regional air pollution episode over Pearl River Delta Region,China, using the MM5-CMAQ model

This study focuses on the influences of a warm high-pressure meteorological system on aerosol pollutants, employing the simulations by the Models-3/CMAQ system and the observations collected during October 10–12, 2004, over the Pearl River Delta (PRD) region. The results show that the spatial distributions of air pollutants are generally circular near Guangzhou and Foshan, which are cities with high emissions rates. The primary pollutant is particulate matter (PM) over the PRD. MM5 shows reasonable performance for major meteorological variables (i.e., temperature, relative humidity, wind direction) with normalized mean biases (NMB) of 4.5–38.8% and for their time series. CMAQ can capture one peak of all air pollutant concentrations on October 11, but misses other peaks. The CMAQ model systematically underpredicts the mass concentrations of all air pollutants. Compared with chemical observations, SO₂ and O₃ are predicted well with a correlation coefficient of 0.70 and 0.65. PM_2.5 and NO are significantly underpredicted with an NMB of 43% and 90%, respectively. The process analysis results show that the emission, dry deposition, horizontal transport, and vertical transport are four main processes affecting air pollutants. The contributions of each physical process are different for the various pollutants. The most important process for PM₁₀ is dry deposition, and for NO_x it is transport. The contributions of horizontal and vertical transport processes vary during the period, but these two processes mostly contribute to the removal of air pollutants at Guangzhou city, whose emissions are high. For this high-pressure case, the contributions of the various processes show high correlations in cities with the similar geographical attributes. According to the statistical results, cities in the PRD region are divided into four groups with different features. The contributions from local and nonlocal emission sources are discussed in different groups.

Implications: The characteristics of aerosol pollution episodes are intensively studied in this work using the high-resolution modeling system MM5/SMOKE/CMAQ, with special efforts on examining the contributions of different physical and chemical processes to air concentrations for each city over the PRD region by a process analysis method, so as to provide a scientific basis for understanding the formation mechanism of regional aerosol pollution under the high-pressure system over PRD.     

改性矿物吸附法和 O3氧化法对维生素 B12废水脱色处理简

采用改性矿物吸附法和O₃氧化法对某制药厂维生素B₁₂废水进行脱色处理。以废水色度去除率大于50%为目的,通过实验确定改性矿物吸附法和O₃氧化法处理维生素B₁₂废水的最佳工艺条件：废水的pH为3.00,有机化膨润土的投加量为5 g/L,PAC的投加量为6 g/L,投加有机化膨润土后搅拌时间为30 min时,废水的色度去除率可达到51.3%,处理成本为12.85元/t。O₃氧化法的最佳条件：废水的pH保持不变,O₃流量为5 g/h,反应时间为2 min,废水的色度去除率可达到68.8%,处理成本为0.96元/t。对比这2种方法,O₃氧化法处理该废水成本更低、效率更高,并且能提高废水的可生化性以便后续处理。     

金属铁铝对混凝强化初沉污泥中温厌氧消化的影响简

选取FeCl₃和AlCl₃·6H₂O作为混凝剂对城市污水进行一级强化混凝处理,降低二级生物处理的进水负荷,减少污水生物处理系统的能量消耗。主要研究混凝过程投加的金属盐对一级强化混凝产生的初沉污泥中温厌氧消化的影响。和剩余污泥相比,初沉污泥更适合厌氧消化处理,污泥降解性能和产气性能更高。当采用城市污水一级强化混凝处理时,污泥中的金属和金属盐水解引起的pH降低,使混凝强化初沉污泥的厌氧消化受到一定抑制。随着污泥中铝含量的降低和铁含量的增加,厌氧消化的COD降解率和挥发性固体（VS）降解率逐渐升高,生物气产量逐渐增大,产气速率加快。当混凝强化初沉污泥只含有铁时（铁含量为10.16 mg/L）,混凝强化初沉污泥厌氧消化效果最好,产气稳定,而且产气速率高,生物气产量为237 mL,生物气甲烷含量为55.5%,降解单位VS产气量为0.80 L/g,均高于其他含铝的混凝强化初沉污泥。污泥中的铁对初沉污泥厌氧消化的抑制作用远远小于铝的作用,说明铁盐适合用于城市污水的一级强化混凝处理。     

染料厂污染土壤中六氯苯的水淹法厌氧降解

以乙酸为碳源,采用正交实验的方法,探讨了水淹法厌氧降解某染料厂污染土壤中六氯苯的效果,研究考察了初始pH、反应温度和固液比3个环境因素对六氯苯降解率的影响,确定了六氯苯最佳的厌氧降解条件。结果表明,初始pH对土壤中六氯苯的降解率影响最大。在初始pH为5,反应温度为45℃,固液比为1∶1的最佳反应条件下,六氯苯的降解率最高达到52.56%。     

Fenton-超声联合处理金刚烷胺制药废水

近年来,流感常用药盐酸金刚烷胺的产量不断增大,然而,其生产过程中产生的废水由于得不到有效处理,引起较大污染。以盐酸金刚烷胺生产过程中产生的胺化废水和溴化废水为原水,利用Fenton-超声联合工艺进行处理,主要研究反应时间、初始pH、H2O2投加量和H2O2/Fe2+的投加比和声能密度等操作条件对于金刚烷胺制药废水处理效果的影响。实验结果表明,优化处理条件下,Fenton-超声联合工艺对金刚烷胺制药废水中TOC去除效果最高达到65.6%。超声和Fenton的联合产生了良好的协同效果,Fenton-超声联合工艺对金刚烷胺制药废水的处理效果比单独超声和单独Fenton处理效果之和高18%,大大提高了废水中有机物的去除效果。     

污泥淤砂分离器对分离分流污泥性质的影响

为解决我国很多城镇污水厂活性污泥的MLVSS/MLSS普遍偏低,污泥中泥沙淤积严重的问题,根据水力旋流器的分离原理,开发了污泥淤砂分离器,实现污泥中生物基质和淤砂的分离分流,研究污泥淤砂分离器主要结构参数排口比(底流口直径/溢流管直径)对分离分流污泥性质的影响。实验结果表明,排口比为0.4时,污泥经过污泥淤砂分离器后,得到的底流污泥MLVSS/MLSS比原污泥减小了34%,溢流污泥MLVSS/MLSS增大了16.8%,污泥中的生物基质富集在溢流污泥中,淤砂富集在底流污泥中;底流污泥浓度MLSS比原污泥增加了2.6倍,底流污泥SVI和CST分别减小了68%和70%,底流污泥浓缩效果明显,沉降性能和脱水性能大幅提高,有利于底流污泥的处理处置;进一步减小排口比,底流污泥浓缩效果、沉降性能和脱水性能均进一步提高。     

乙二胺还原的氧化石墨烯对镉离子的动态吸附

以乙二胺(EDA)还原氧化石墨烯(GO)制得一种吸附剂材料,即还原态氧化石墨烯(RGO)。考察了动态条件下Cd2+溶液的初始浓度、流速及吸附床高度对穿透曲线的影响,同时利用Bed-Depth-Service Time(BDST)模型对吸附床高度与穿透时间的关系进行线性拟合分析,研究了RGO对Cd2+溶液的动态吸附性能。结果表明,RGO可以有效地去除水溶液中的Cd2+,随着吸附床高度的增加,离子的去除率增大,穿透时间延长;当溶液初始浓度增大时穿透时间缩短,离子的去除率减小;而溶液的流速加快,穿透时间和去除率都相应减小。吸附床高度与穿透时间的关系可用BDST模型较好地进行描述,预测新的操作条件下的穿透时间与实验值误差均小于5%。     

Fered-Fenton法处理石化废水反渗透浓水

以Ti金属网为阴极、Ti负载RuO2金属网为阳极,构建Fered-Fenton反应系统,处理石化废水反渗透膜法浓水.考察H2O2浓度、Fe2+浓度、初始pH值和电流密度等因素对废水处理效果的影响,并分析了废水可生化性及污染物降解规律.结果表明,在H2O2浓度为75.0 mmol/L,Fe2+浓度为7.5 mmol/L,初始pH值为3.0,电流密度为5.1 mA/cm2的条件下,反应120 min后废水TOC可由198.2 mg/L降到99.6 mg/L,有机污染物矿化率达到49.7％,BOD5/COD由0.11提高至0.31,废水可生化性明显改善.三维荧光光谱(EEM)分析结果表明,Fered-Fenton法对废水中类蛋白、类富里酸等荧光有机物去除率达到66.7％,该类大分子难降解有机物的氧化降解有利于改善废水可生化性,为进一步的生化处理创造了良好的条件.