尿素基纤维的制备及对水中Cu2+和Cd2+的吸附

以棉纤维为原料，经氯化和取代反应，制得尿素基纤维并用于水中Cu^2＋和Cd^2＋的吸附，考察了各种因素对吸附效果的影响。尿素基纤维对Cu^2＋和Cd^2＋的吸附可用Langmuir等温吸附方程描述，吸附过程可看成单层吸附。较佳吸附条件：重金属离子溶液pH为5，流量为7mL／min。用过的尿素基纤维经2mol／L的盐酸洗脱再生后，对Cu^2＋的吸附、解吸、再吸附的性能良好，可重复使用。     

Effects of Nitrogen Deposition on Bryophyte Species Composition of Calcareous Grasslands

Regular additions of NH₄NO₃ (35–140 kg N ha⁻¹ yr⁻¹) and (NH₄)₂SO₄ (140 kg N ha⁻¹ yr⁻¹) to a calcareous grassland in northern England over a period of 12 years have resulted in a decline in the frequency of the indigenous bryophyte species and the establishment of non-indigenous calcifuge species, with implications for the structure and composition of this calcareous bryophyte community. The lowest NH₄NO₃ additions of 35 kg N ha⁻¹ yr⁻¹ produced significant declines in frequency of Hypnum cupressiforme, Campylium chrysophyllum, and Calliergon cuspidatum. Significant reductions in frequency at higher NH₄NO₃ application rates were recorded for Pseudoscleropodium purum, Ctenidum molluscum, and Dicranum scoparium. The highest NH₄NO₃ and (NH₄)₂SO₄ additions provided conditions conducive for the establishment of two typical calcifuges – Polytrichum spp. and Campylopus introflexus, respectively. Substrate-surface pH measurements showed a dose-related reduction in pH with increasing NH₄NO₃ deposition rates of 1.6 pH units between the control and highest deposition rate, and a further significant fall in pH, of >1 pH unit, between the NH₄NO₃ and (NH₄)₂SO₄ treatments. These results suggest that indigenous bryophyte composition may be at risk from nitrogen deposition rates of 35 kg N ha⁻¹ yr⁻¹ or less. These effects are of particular concern for rare or endangered species of low frequency.     

含碳纳米TiO2光催化降解甲醇

采用管式光催化反应器，在石英玻璃管壁上涂镀含碳纳米TiO2薄膜，研究含碳纳米TiO2对甲醇气体的光催化降解性能。实验结果表明：随气体流量增加，甲醇降解率呈线性降低；在气体流量为200mL／min、相对湿度为40％、甲醇初始质量浓度为90～170mg／m^3的较佳条件下，甲醇降解率维持在80％以上，最高达85％；在甲醇初始质量浓度为150mg／m^3、气体流餐为200mL／min、相对湿度为40％的条件下，德国Degusa—P25光催化剂对甲醇的平均降解率为89％，含碳纳米TiO2对甲醇的平均降解率为82％，最人降解率为85％。     

盐效萃取法从电子产品清洗废液中回收异丙醇

用盐效萃取法从电子产品清洗废液中回收片丙醇，考察了碳酸钾水溶液与该清洗废液的质量比对脱水率的影响，测定了异丙醇-水-碳酸钾体系存40℃时的液液相平衡数据，用Pitzer理论和NRTL方程对液液相平衡数据进行了理论计算。结果表明：当质量分数为60．00％的碳酸钾水溶液与该废液的质晕比为2．00时，脱水率高达90．00％；将有机相进行精馏可得到质量分数为99．50％的异丙醇；计算值与实测值接近，水相和有机相的绝对平均偏差分别为0．62％和0．46％。     

Remediation with cyclodextrin: Recovery of the remedial agent by membrane filtration

Cyclodextrin‐enhanced flushing of contaminants from the subsurface is a promising innovative remediation technology. It will become more economically viable at more sites if methods can be developed to recover and reconcentrate the cyclodextrin solution after it has been flushed through an aquifer. The goal of this study was to determine if membrane technology is capable of meeting that need. Five membranes with different material properties were tested for this purpose in the laboratory. The results of these tests indicate that there are large differences both in the efficiency of these membranes to extract hydroxpropyl‐β‐cyclodextrin (HPCD) and their stability when exposed to trichloroethylene (TCE) at concentrations near aqueous solubility. Not only does the molecular weigh cutoff (MWCO) of a membrane determine if HPCD can be retained, but crucial selection criteria are the membrane's resistance and compatibility with TCE. Of the five membrane materials tested, only two (polymer composite membrane and polysulfone) met both these requirements. The polymer composite membrane (MPF‐44) showed reliable and stable HPCD recoveries (>95 percent) even when exposed to high TCE concentrations. The polysulfone membrane showed high HPCD recoveries, 88.5 ± 0.4 percent to 97 percent ±1 percent for ultrafiltration and nanofiltration membranes, respectively. However, membrane swelling and deterioration became a problem at high TCE concentrations (>1,000 mg/L). These problems diminished when the TCE concentration was less than 1 mg/L. Field tests demonstrated that batch mode treatment by ultrafiltration doubled the cyclodextrin concentration from 5 to 10 percent within three hours at a constant operating pressure of 13 psi. Under continuous single‐pass treatment conditions, cyclodextrin concentration also increased, although the rate of increase was much smaller than in batch mode. Overall, these tests showed that cyclodextrin recovery is possible under field conditions. © 2007 Wiley Periodicals, Inc.     

关于城市应急供水系统建设的思考

从城市应急供水系统建设的紧迫性和重要性出发,分析了目前我国城市应急供水系统存在的问题和造成城市非常供水的原因。构建了城市应急供水系统的框架,将其分成工程措施和非工程措施两部分,并阐述了工程措施的类型和实施方法,以及非工程措施的各项应急机制,对建立、健全城市应急供水系统进行了探讨。     

山东潍坊紫外线辐射特征及影响因素

近10多年来,随着人类居住环境的恶化,紫外线给人类造成了巨大的伤害。利用潍坊市气象台2004~2006年逐日紫外线观测资料,分析了太阳紫外线辐射到达地面的强度指数和等级,同时分析了这些量的年、月、日变化特征,研究了影响紫外线辐射的主要的几种因子。影响紫外线辐射强度的主要因素是臭氧、地表反射率、大气气溶胶和云,这些影响因素的变化对太阳紫外线到达地面的辐射起着举足轻重的作用。     

Technological improvements in automotive battery recycling

Recycling of automotive batteries for the recovery of secondary lead is extremely important in Brazil, for the country does not possess large reserves of this metal. Lead is one of the most widely used metals in the world, but it is highly toxic, posing risks for humans and for the environment if not utilized or treated adequately. Industrial waste containing lead in Brazil are classified by the Brazilian Residue Code (NBR—10004:2004) as hazardous. The lead recycling process employed by the recycling industry in Brazil is the pyrometallurgical process in a rotary furnace. This process consists of four stages: (1) grinding of the battery to separate plastic, electrolyte and lead plates; (2) lead reduction in a rotary furnace; (3) separation of metallic lead from slag; and (4) refining of recycled lead. The purpose of this work is to propose process improvements aimed primarily at increasing production output by reducing the loss of lead in slag and particulates, thereby providing a healthier work environment in line with Brazilian environmental and labor laws.